PatchFirst · Vulnerabilidades recientes
Vulnerabilidades publicadas para linux-6.12 en los últimos 30 días: 483. Incluidas en el catálogo KEV: 0.
Vulnerabilidades: 2889
In the Linux kernel, the following vulnerability has been resolved: mtd: maps: vmu-flash: fix fault in unaligned fixup Use kzalloc_obj() / kzalloc_objs() to allocate the memcard structs, instead of kmalloc_obj() / kmalloc_objs() to prevent access to uninitialized data. Fixes runtime error: Fault in unaligned fixup: 0000 [#1] at mtd_get_fact_prot_info.
In the Linux kernel, the following vulnerability has been resolved: dmaengine: dw-edma-pcie: Reject devices without driver data dw_edma_pcie_probe() treats the PCI device ID driver_data as the template for the controller layout and copies it unconditionally. A device bound dynamically via sysfs can match the driver without that data, which leads to a NULL pointer dereference. Reject such matches before enabling the device.
In the Linux kernel, the following vulnerability has been resolved: dmaengine: sh: rz-dmac: Move interrupt request after everything is set up Once the interrupt is requested, the interrupt handler may run immediately. Since the IRQ handler can access channel->ch_base, which is initialized only after requesting the IRQ, this may lead to invalid memory access. Likewise, the IRQ thread may access uninitialized data (the ld_free, ld_queue, and ld_active lists), which may also lead to issues. Request the interrupts only after everything is set up. To keep the error path simpler, use dmam_alloc_coherent() instead of dma_alloc_coherent().
In the Linux kernel, the following vulnerability has been resolved: i2c: imx: fix locked bus on SMBus block-read of 0 (atomic) SMBus 3.1 6.5.7 allows a Block Read byte count of 0, but the atomic (polling) path rejects it as -EPROTO. Worse, it returns without a NACK+STOP: the next receive cycle has already started, so the target keeps holding SDA and the bus stays stuck until a power cycle for this i2c controller. Reading I2DR to obtain the count likewise arms the next byte on the count > I2C_SMBUS_BLOCK_MAX path, which also returned -EPROTO directly and left the bus held. Handle both: NACK the in-flight dummy byte (TXAK) and extend msgs->
In the Linux kernel, the following vulnerability has been resolved: xfrm: nat_keepalive: avoid double free on send error nat_keepalive_send() frees the keepalive skb whenever the IPv4 or IPv6 send helper reports an error. That cleanup is only correct before the skb is handed to the output path. Once ip_build_and_send_pkt() or ip6_xmit() takes ownership, the networking stack may already have consumed the skb before returning an error, so freeing it again is unsafe. Handle the pre-handoff failure cases inside nat_keepalive_send_ipv4() and nat_keepalive_send_ipv6(), where the caller still owns the skb, and keep nat_keepalive_send() responsib
In the Linux kernel, the following vulnerability has been resolved: nvmet-auth: reject short AUTH_RECEIVE buffers nvmet_execute_auth_receive() trusts the AUTH_RECEIVE allocation length after checking only that it is nonzero and matches the transfer length. In the SUCCESS1 and FAILURE1/default states, that lets a remote NVMe-oF initiator reach the fixed-size DH-HMAC-CHAP response builders with a kmalloc() buffer shorter than the response, so nvmet_auth_success1() and nvmet_auth_failure1() write past the allocation; both only WARN_ON the short length and then format the message anyway. Impact: A remote NVMe-oF initiator with access to an aut
In the Linux kernel, the following vulnerability has been resolved: can: isotp: fix use-after-free race with concurrent NETDEV_UNREGISTER isotp_release() looked up the bound network device via dev_get_by_index() using the stored ifindex. During device unregistration the device is unlisted from the ifindex hash before the NETDEV_UNREGISTER notifier chain runs, so a concurrent isotp_release() could find no device, skip can_rx_unregister() entirely, and still proceed to free the socket. Since isotp_release() had already removed itself from the isotp notifier list at that point, isotp_notify() would never get a chance to clean up either, leavin
In the Linux kernel, the following vulnerability has been resolved: can: isotp: serialize TX state transitions under so->rx_lock The TX state machine (so->tx.state) is driven from three contexts: sendmsg() claiming and progressing a transfer, the RX path consuming Flow Control/echo frames, and two hrtimers timing out a stalled transfer. Mixing a lock-free cmpxchg() claim in sendmsg() with hrtimer_cancel() calls made under so->rx_lock elsewhere left windows where a frame or timer callback could act on a state that had already moved on, corrupting an unrelated transfer. so->rx_lock now covers the full lifecycle of a TX claim: sendmsg() takes
In the Linux kernel, the following vulnerability has been resolved: can: bcm: add locking when updating filter and timer values KCSAN detected a simultaneous access to timer values that can be overwritten in bcm_rx_setup() when updating timer and filter content while bcm_rx_handler(), bcm_rx_timeout_handler() or bcm_rx_thr_handler() run concurrently on incoming CAN traffic. Protect the timer (ival1/ival2/kt_ival1/kt_ival2/kt_lastmsg) and filter (nframes/flags/frames/last_frames) updates in bcm_rx_setup() with a new per-op bcm_rx_update_lock, taken with the matching scope in the RX handlers. memcpy_from_msg() is staged into a temporary buff
In the Linux kernel, the following vulnerability has been resolved: can: bcm: extend bcm_tx_lock usage for data and timer updates Stage new CAN frame content for an existing tx op into a kmalloc()'d buffer and validate it there, mirroring the approach already used in bcm_rx_setup(). Only copy the validated data into op->frames while holding op->bcm_tx_lock, so bcm_can_tx() and bcm_tx_timeout_handler() can no longer observe a partially updated or unvalidated frame. Add a missing error path for memcpy_from_msg() when copying CAN frame data from userspace. Also move the kt_ival1/kt_ival2/ival1/ival2 updates in bcm_tx_setup() under op->bcm_tx
In the Linux kernel, the following vulnerability has been resolved: can: bcm: fix CAN frame rx/tx statistics KCSAN detected a data race within the bcm_rx_handler() when two CAN frames have been simultaneously received and processed in a single rx op by two different CPUs. Use atomic operations with (signed) long data types to access the statistics in the hot path to fix the KCSAN complaint. Additionally simplify the update and check of statistics overflow by using the atomic operations in separate bcm_update_[rx|tx]_stats() functions. The rx variant runs under bcm_rx_update_lock to prevent races when resetting the two rx counters; the tx
In the Linux kernel, the following vulnerability has been resolved: can: bcm: fix data race on rx_stamp/rx_ifindex in bcm_rx_handler() For an rx op subscribed on all interfaces (ifindex == 0), the same op is registered once in the shared per-netns wildcard filter list, so bcm_rx_handler() can run concurrently on different CPUs for frames arriving on different net devices. op->rx_stamp and op->rx_ifindex were written before bcm_rx_update_lock was taken, allowing concurrent writers to race each other - including a torn store of the 64-bit rx_stamp on 32-bit platforms. Beyond a torn store bcm_send_to_user() must report the timestamp/ifindex
In the Linux kernel, the following vulnerability has been resolved: can: bcm: fix stale rx/tx ops after device removal RX: an RX_SETUP update(!) for an existing op skipped can_rx_register() unconditionally, even when a concurrent NETDEV_UNREGISTER had already torn down its registration (op->rx_reg_dev == NULL). This silently did not re-enable frame delivery for that updated filter. bcm_rx_setup() now re-registers in that case, while leaving rx_ops with ifindex = 0 (all CAN devices) which never carry a tracked rx_reg_dev registered as-is. TX: bcm_notify() only handled bo->rx_ops on NETDEV_UNREGISTER, leaving tx_ops with an active cyclic tra
In the Linux kernel, the following vulnerability has been resolved: can: bcm: track a single source interface for ANYDEV timeout/throttle ops An ANYDEV rx op (ifindex == 0) with an active RX timeout and/or throttle timer has no defined semantics when matching frames arrive from several interfaces: bcm_rx_handler() can run concurrently for the same op on different CPUs, racing hrtimer_cancel()/ bcm_rx_starttimer() against bcm_rx_timeout_handler() and causing spurious RX_TIMEOUT notifications and last_frames corruption. The same concurrency lets throttled multiplex frames from different interfaces clobber the single rx_ifindex/rx_stamp fields
In the Linux kernel, the following vulnerability has been resolved: can: bcm: validate frame length in bcm_rx_setup() for RTR replies bcm_tx_setup() validates cf->len against the CAN/CAN FD DLC limits before installing frames for TX_SETUP, but bcm_rx_setup() never did the same for the RTR-reply frame configured via RX_SETUP with RX_RTR_FRAME.
In the Linux kernel, the following vulnerability has been resolved: can: bcm: add missing device refcount for CAN filter removal sashiko-bot remarked a problem with a concurrent device unregistration in isotp.c which also is present in the bcm.c code. A former fix for raw.c commit c275a176e4b6 ("can: raw: add missing refcount for memory leak fix") introduced a netdevice_tracker which solves the issue for bcm.c too. bcm_release(), bcm_delete_rx_op() and bcm_notifier() relied on dev_get_by_index(ifindex) to re-find the device for an rx_op before unregistering its filter. If a concurrent NETDEV_UNREGISTER has already unlisted the device from
In the Linux kernel, the following vulnerability has been resolved: bpf: Reset register bounds before narrowing retval range in check_mem_access() When the BPF verifier processes a context load of an LSM hook return value, it calls __mark_reg_s32_range() to narrow the register to the hook's valid range. However, __mark_reg_s32_range() intersects the new range with the register's existing bounds using max_t()/min_t() rather than replacing them. If the destination register carries stale bounds from a prior instruction (e.g. BPF_MOV64_IMM), the intersection can produce a range narrower than reality. The verifier then believes it knows the reg
In the Linux kernel, the following vulnerability has been resolved: dm: avoid leaking the caller's thread keyring via the table device file The refactoring in commit a28d893eb327 ("md: port block device access to file") accidentally causes the caller's thread keyring to be kept alive long beyond the caller's lifetime. As a result, "cryptsetup luksSuspend" silently fails to wipe the LUKS volume key from memory. In detail: "cryptsetup luksOpen" uses its supposedly ephemeral thread keyring to pass the volume key to the kernel. dm-crypt's crypt_set_keyring_key() copies the key material into its own crypt_config structure and then drops its ow
In the Linux kernel, the following vulnerability has been resolved: dm-integrity: fix leaking uninitialized kernel memory If hash size is less than device's tuple size, dm-integrity is supposed to zero the remaining space. There was a bug in the code that zeroing didn't work. This commit fixes it.
In the Linux kernel, the following vulnerability has been resolved: wifi: libertas_tf: fix use-after-free in lbtf_free_adapter() lbtf_free_adapter() calls timer_delete(&priv->command_timer), which does not wait for a running command_timer_fn() callback. lbtf_free_adapter() runs on the teardown path right before ieee80211_free_hw() frees priv, both in lbtf_remove_card() and in the probe error path. command_timer is armed by mod_timer() in lbtf_cmd() whenever a firmware command is sent. command_timer_fn() dereferences priv. If a command times out as the device is removed, command_timer_fn() runs concurrently with teardown and dereferences pri
Compara tu pila y las versiones instaladas con las bases actuales de vulnerabilidades.