can: bcm: track a single source interface for ANYDEV timeout/throttle ops
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: track a single source interface for ANYDEV timeout/throttle ops
An ANYDEV rx op (ifindex == 0) with an active RX timeout and/or
throttle timer has no defined semantics when matching frames arrive
from several interfaces: bcm_rx_handler() can run concurrently for
the same op on different CPUs, racing hrtimer_cancel()/
bcm_rx_starttimer() against bcm_rx_timeout_handler() and causing
spurious RX_TIMEOUT notifications and last_frames corruption. The
same concurrency lets throttled multiplex frames from different
interfaces clobber the single rx_ifindex/rx_stamp fields
can: bcm: validate frame length in bcm_rx_setup() for RTR replies
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: validate frame length in bcm_rx_setup() for RTR replies
bcm_tx_setup() validates cf->len against the CAN/CAN FD DLC limits
before installing frames for TX_SETUP, but bcm_rx_setup() never did
the same for the RTR-reply frame configured via RX_SETUP with
RX_RTR_FRAME.
can: bcm: add missing device refcount for CAN filter removal
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: add missing device refcount for CAN filter removal
sashiko-bot remarked a problem with a concurrent device unregistration
in isotp.c which also is present in the bcm.c code. A former fix for raw.c
commit c275a176e4b6 ("can: raw: add missing refcount for memory leak fix")
introduced a netdevice_tracker which solves the issue for bcm.c too.
bcm_release(), bcm_delete_rx_op() and bcm_notifier() relied on
dev_get_by_index(ifindex) to re-find the device for an rx_op before
unregistering its filter. If a concurrent NETDEV_UNREGISTER has already
unlisted the device from
bpf,fork: wipe ->bpf_storage before bailouts that access it
In the Linux kernel, the following vulnerability has been resolved:
bpf,fork: wipe ->bpf_storage before bailouts that access it
Currently, copy_process() can bail out to free_task() before p->bpf_storage
has been initialized, with this call graph (shown here for the
!CONFIG_MEMCG case):
copy_process
dup_task_struct
arch_dup_task_struct
[copies the entire task_struct, including ->bpf_storage member]
[RLIMIT_NPROC check fails]
delayed_free_task
free_task
bpf_task_storage_free
rcu_dereference(task->bpf_storage)
bpf_local_storage_destroy
In this case, the nascent task's ->bpf_storage member that
bpf_l
net: sparx5: unregister blocking notifier on init failure
In the Linux kernel, the following vulnerability has been resolved:
net: sparx5: unregister blocking notifier on init failure
sparx5_register_notifier_blocks() registers the switchdev blocking
notifier before allocating the ordered workqueue. If the workqueue
allocation fails, the error path unregisters the switchdev and netdevice
notifiers, but leaves the blocking notifier registered.
Add a separate error label for the workqueue allocation failure path and
unregister the switchdev blocking notifier there.
dm thin metadata: fix metadata snapshot consistency on commit failure
In the Linux kernel, the following vulnerability has been resolved:
dm thin metadata: fix metadata snapshot consistency on commit failure
__reserve_metadata_snap() and __release_metadata_snap() modify the
superblock's held_root directly in the block_manager's buffer. If the
subsequent metadata commit fails, the held_root gets flushed to disk
through the abort_transaction path, resulting in inconsistent metadata.
Reproducer 1: __reserve_metadata_snap()
1. Create a 2 MiB metadata device and make the region after the 14th
block inaccessible, to trigger metadata commit failure in the
subsequent reserve_metadata_snap operation. The 14th
dm era: fix out-of-bounds memory access for non-zero start sector
In the Linux kernel, the following vulnerability has been resolved:
dm era: fix out-of-bounds memory access for non-zero start sector
dm-era tracks writes in target-relative blocks, but era_map() calculates
the writeset block before applying the target offset. Tables with a
non-zero start sector can therefore pass an absolute mapped-device block
to metadata_current_marked().
If the absolute block is beyond the current writeset size,
writeset_marked() tests past the end of the in-core bitset. KASAN reports
this as a vmalloc-out-of-bounds access.
Apply the target offset before calculating the era block so writeset
lookups use the target-r
dm-ioctl: fix a possible overflow in list_version_get_info
In the Linux kernel, the following vulnerability has been resolved:
dm-ioctl: fix a possible overflow in list_version_get_info
sizeof(tt->version) is 12 bytes, but the code writes 16 bytes into the
output buffer - info->vers->version[0], info->vers->version[1],
info->vers->version[2] and info->vers->next. This can cause buffer
overflow.
Fix this buffer overflow by replacing "sizeof(tt->version)" with
"sizeof(struct dm_target_versions)".
dm-log: fix a bitset_size overflow on 32bit machines
In the Linux kernel, the following vulnerability has been resolved:
dm-log: fix a bitset_size overflow on 32bit machines
Commit c20e36b7631d ("dm log: fix out-of-bounds write due to
region_count overflow") made sure that region_count could fit in an
unsigned int. But the bitmap memory isn't allocated based on
region_count. It uses bitset_size (a size_t variable). The first step of
calculating bitset_size is to set it to region_count, rounded up to a
multiple of BITS_PER_LONG. If region_size is less than BITS_PER_LONG
smaller than UINT_MAX, it will get rounded up to 2^32. On a 32bit
architecture, this will make bitset_size wrap around to 0 a
dm_early_create: fix freeing used table on dm_resume failure
In the Linux kernel, the following vulnerability has been resolved:
dm_early_create: fix freeing used table on dm_resume failure
If dm_resume fails, the kernel attempts to free table with
dm_table_destroy, but the table was already instantiated with
dm_swap_table. This commit skips the call to dm_table_destroy in this
case.
In the Linux kernel, the following vulnerability has been resolved:
dm-integrity: don't increment hash_offset twice
hash_offset is already incremented in the loop "for (i = 0; i < to_copy;
i++, ts--)". Do not increment it again.
In the Linux kernel, the following vulnerability has been resolved:
dm-verity: fix buffer overflow in FEC calculation
There's a buffer overflow in dm-verity-fec:
if (neras && *neras <= v->fec->roots)
fio->erasures[(*neras)++] = i;
This allows *neras to reach roots + 1 (the post-increment pushes it past
roots). This value is then passed as no_eras to decode_rs8(). Inside the
RS decoder (lib/reed_solomon/decode_rs.c:113-121), the erasure locator
polynomial loop writes lambda[j] where j can reach nroots + 1 — one
element past the end of lambda[] (which is sized nroots + 1, valid
indices 0..nroots). The out-of-bounds write lands on syn[0], c
dm-verity: fix a possible NULL pointer dereference
In the Linux kernel, the following vulnerability has been resolved:
dm-verity: fix a possible NULL pointer dereference
Fix a possible NULL pointer dereference dm_verity_loadpin_is_bdev_trusted
if the device has no table.
In the Linux kernel, the following vulnerability has been resolved:
dm-verity: make error counter atomic
The error counter "v->corrupted_errs" was not atomic, thus it could be
subject to race conditions. The call to
dm_audit_log_target("max-corrupted-errors") may be skipped due to the
races.
scsi: hpsa: Fix DMA mapping leak on IOACCEL2 reset path
In the Linux kernel, the following vulnerability has been resolved:
scsi: hpsa: Fix DMA mapping leak on IOACCEL2 reset path
If phys_disk->in_reset is set, the function returns directly without
undoing the resources acquired for the command. Add the missing error
cleanup by unmapping the IOACCEL2 SG chain block when needed, unmapping
the SCSI command, and dropping the outstanding IOACCEL command count
before returning.
scsi: lpfc: Fix memory leak in lpfc_sli4_driver_resource_setup()
In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Fix memory leak in lpfc_sli4_driver_resource_setup()
The memory allocated for mboxq using mempool_alloc() is not freed in
some of the early exit error paths. Fix that by moving the
mempool_free() call to an earlier point after last use.
scsi: xen: scsiback: Free the command tag on the TMR submit-failure path
In the Linux kernel, the following vulnerability has been resolved:
scsi: xen: scsiback: Free the command tag on the TMR submit-failure path
scsiback_device_action() obtains a command tag in
scsiback_get_pend_req() and submits a task-management request with
target_submit_tmr(). When target_submit_tmr() fails it returns < 0 and
scsiback jumps to the err: label, which sends a response but frees
nothing, leaking the tag.
Impact: a pvSCSI guest can leak the command tags of a LUN's session,
stopping the LUN, by issuing VSCSIIF_ACT_SCSI_ABORT or RESET requests
whenever target_submit_tmr() fails.
transport_generic_free_cmd() cannot be used here.
scsi: xen: scsiback: Free unsubmitted command instead of double-putting it
In the Linux kernel, the following vulnerability has been resolved:
scsi: xen: scsiback: Free unsubmitted command instead of double-putting it
scsiback_get_pend_req() obtains a command tag and returns a vscsibk_pend
whose embedded se_cmd has only been memset to 0, so its cmd_kref is 0;
the se_cmd is initialised (kref_init() via target_init_cmd()) only
later, in scsiback_cmd_exec(), on the successful VSCSIIF_ACT_SCSI_CDB
path. The two error paths in scsiback_do_cmd_fn() taken before the
command is submitted -- a failed scsiback_gnttab_data_map() and an
unknown ring_req.act -- call
transport_generic_free_cmd(&pending_req->se_cmd, 0), which kr
scsi: target: Bound PR-OUT TransportID parsing to the received buffer
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: Bound PR-OUT TransportID parsing to the received buffer
core_scsi3_decode_spec_i_port() and core_scsi3_emulate_register_and_move()
hand the raw PERSISTENT RESERVE OUT parameter buffer to
target_parse_pr_out_transport_id() without telling it how many bytes are
valid. For an iSCSI TransportID (FORMAT CODE 01b),
iscsi_parse_pr_out_transport_id() locates the ",i,0x" ISID separator with
an unbounded strstr() (and on the error path prints the name with a further
unbounded "%s"). An initiator can submit a TransportID whose iSCSI name
contains neither a ",i,0x" subs
scsi: target: core: Fix iSCSI ISID use-after-free in REGISTER AND MOVE
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: core: Fix iSCSI ISID use-after-free in REGISTER AND MOVE
core_scsi3_emulate_pro_register_and_move() maps the PERSISTENT RESERVE OUT
parameter list with transport_kmap_data_sg() and parses the destination
TransportID with target_parse_pr_out_transport_id(). For an iSCSI
TransportID (FORMAT CODE 01b), iscsi_parse_pr_out_transport_id() returns
the ISID in iport_ptr as a raw pointer into that mapped buffer.
The function then unmaps the buffer with transport_kunmap_data_sg() before
dereferencing iport_ptr in strcmp(), __core_scsi3_locate_pr_reg() and
core_scsi3_al