Vulnerabilidades de linux · Página 139

wifi: cfg80211: cancel sched scan results work on unregister

In the Linux kernel, the following vulnerability has been resolved: wifi: cfg80211: cancel sched scan results work on unregister cfg80211_sched_scan_results() can queue rdev->sched_scan_res_wk from a driver result notification while a scheduled scan request is present. The work callback recovers the containing cfg80211_registered_device and then locks the wiphy and walks the scheduled-scan request list. wiphy_unregister() already makes the wiphy unreachable and drains rdev work items before cfg80211_dev_free() can release the object, but it does not drain sched_scan_res_wk. A queued or running result work item can therefore cross the unreg

• Actualiza a 6.1.187-1

wifi: ipw2100: fix potential memory leak in ipw2100_pci_init_one()

In the Linux kernel, the following vulnerability has been resolved: wifi: ipw2100: fix potential memory leak in ipw2100_pci_init_one() The memory allocated in the ipw2100_alloc_device() function is not freed in some of the error paths in ipw2100_pci_init_one(). Fix that by converting the direct return into a goto to the error path return. The error path when pci_enable_device() fails cannot jump to fail, since at this point priv is not set, so perform error handling inline.

• Actualiza a 6.1.187-1

wifi: cfg80211: Fix an error handling path in cfg80211_wext_siwscan()

In the Linux kernel, the following vulnerability has been resolved: wifi: cfg80211: Fix an error handling path in cfg80211_wext_siwscan() If the test against IEEE80211_MAX_SSID_LEN fails, then 'creq' leaks. Use the existing error handling path to fix it.

wifi: mac80211_hwsim: clamp virtio RX length before skb_put

In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211_hwsim: clamp virtio RX length before skb_put hwsim_virtio_rx_work() passes the virtqueue used-ring length reported by the device straight to skb_put() on a fixed-size receive skb. A backend reporting a length larger than the skb tailroom drives skb_put() past the buffer end and hits skb_over_panic() -- a host-triggerable guest panic (denial of service). Clamp the length to the skb's available room before skb_put(). A conforming device never reports more than the posted buffer size, so valid frames are unaffected; a truncated over-report then fails the length

• Actualiza a 6.1.187-1

wifi: libertas: fix memory leak in helper_firmware_cb()

In the Linux kernel, the following vulnerability has been resolved: wifi: libertas: fix memory leak in helper_firmware_cb() helper_firmware_cb() neglects to free the single-stage firmware image after a successful async load, leading to a memory leak in the USB firmware-download path. Fix this memory leak by calling release_firmware() immediately after lbs_fw_loaded() returns. The bug was first flagged by an experimental analysis tool we are developing for kernel memory-management bugs while analyzing v6.13-rc1. The tool is still under development and is not yet publicly available. Manual inspection confirms that the bug is still present i

• Actualiza a 6.1.187-1

wifi: mac80211: defer link RX stats percpu free to RCU

In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: defer link RX stats percpu free to RCU sta_remove_link() frees a removed MLO link's RX stats percpu buffer right away, but defers only the link container to RCU: sta_info_free_link(&alloc->info); kfree_rcu(alloc, rcu_head); The RX fast path reads link_sta under rcu_read_lock and writes the percpu stats. A reader that resolved link_sta before the removal keeps the pointer. The container stays alive from the kfree_rcu, so the read still works. But the percpu block it points to is already freed. This needs uses_rss. That is when pcpu_rx_stats exists. The f

wifi: cfg80211: convert pmsr_free_wk to wiphy_work to fix deadlock

In the Linux kernel, the following vulnerability has been resolved: wifi: cfg80211: convert pmsr_free_wk to wiphy_work to fix deadlock When a netlink socket that owns a PMSR session is closed, cfg80211_release_pmsr() clears the request's nl_portid and queues pmsr_free_wk to call cfg80211_pmsr_process_abort() asynchronously. If the interface tears down concurrently, cfg80211_pmsr_wdev_down() is called under wiphy_lock and calls cancel_work_sync(&pmsr_free_wk) to wait for any running work. The work function acquires wiphy_lock via guard(wiphy) before calling process_abort. This is a deadlock: wdev_down holds wiphy_lock and blocks inside can

wifi: nl80211: free RNR data on MBSSID mismatch

In the Linux kernel, the following vulnerability has been resolved: wifi: nl80211: free RNR data on MBSSID mismatch nl80211_parse_beacon() rejects EMA RNR data when there are fewer RNR entries than MBSSID entries. The rejected RNR allocation has not been attached to the beacon data yet, so free it before returning the error.

• Actualiza a 6.1.187-1

wifi: cfg80211: validate PMSR FTM preamble range

In the Linux kernel, the following vulnerability has been resolved: wifi: cfg80211: validate PMSR FTM preamble range PMSR FTM request parsing accepts preamble values outside the enumerated nl80211 preamble range. Reject out-of-range values before using them in the parser capability bit test using the policy. [drop unnecessary check]

• Actualiza a 6.1.187-1

wifi: mac80211: free AP_VLAN bc_buf SKBs outside IRQ lock

In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: free AP_VLAN bc_buf SKBs outside IRQ lock ieee80211_do_stop() removes AP_VLAN packets from the parent AP ps->bc_buf while holding ps->bc_buf.lock with IRQs disabled. It then calls ieee80211_free_txskb() before dropping the lock. ieee80211_free_txskb() is not just a passive SKB release. For SKBs with TX status state it can report a dropped frame through cfg80211/nl80211, and that path can reach netlink tap transmit. This is the same reason the pending queue cleanup in ieee80211_do_stop() already unlinks SKBs under the queue lock and frees them after IRQ stat

• Actualiza a 6.1.187-1

wifi: cfg80211: use wiphy work for socket owner autodisconnect

In the Linux kernel, the following vulnerability has been resolved: wifi: cfg80211: use wiphy work for socket owner autodisconnect nl80211_netlink_notify() walks the cfg80211 wireless device list when a NETLINK_GENERIC socket is released. If the socket owns a connection, the notifier queues the embedded wdev->disconnect_wk work item. That work is a plain work_struct today. NETDEV_GOING_DOWN cancels it, but a NETLINK_URELEASE notifier that already observed conn_owner_nlportid can queue it after that cancel returns. _cfg80211_unregister_wdev() then removes the wdev from the list and waits for RCU readers, but synchronize_net() does not drain

wifi: brcmfmac: initialize SDIO data work before cleanup

In the Linux kernel, the following vulnerability has been resolved: wifi: brcmfmac: initialize SDIO data work before cleanup brcmf_sdio_probe() stores the newly allocated bus in sdiodev->bus before allocating the ordered workqueue. If that allocation fails, the function jumps to fail and calls brcmf_sdio_remove(). brcmf_sdio_remove() unconditionally cancels bus->datawork. Initialize the work item before the first failure path that can reach brcmf_sdio_remove(), so the cleanup path always observes a valid work object. This issue was found by our static analysis tool and then confirmed by manual review of the probe error path and the remove

• Actualiza a 6.1.187-1

wifi: cfg80211: bound element ID read when checking non-inheritance

In the Linux kernel, the following vulnerability has been resolved: wifi: cfg80211: bound element ID read when checking non-inheritance cfg80211_is_element_inherited() reads the first data octet of the candidate element (id = elem->data[0]) to look it up in an extension non-inheritance list. It does so after testing elem->id, but without verifying that the element actually has a data octet. A zero-length extension element (WLAN_EID_EXTENSION with length 0) therefore makes it read one octet past the end of the element. _ieee802_11_parse_elems_full() runs this check for every element of a frame once a non-inheritance context exists -- e.g. w

• Actualiza a 6.1.187-1

firmware: arm_ffa: Fix out-of-bound writes in ffa_setup_and_transmit()

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_ffa: Fix out-of-bound writes in ffa_setup_and_transmit() Sashiko (locally) reports multiple out-of-bound issues in ffa_setup_and_transmit: 1) Writing ep_mem_access->reserved can write out of bounds for FFA versions < 1.2 as ffa_emad_size_get() returns 16 bytes in that case while reserved has an offset of 24. Instead of zeroing fields, memset the struct to zero first based on the FFA version. 2) Make sure there is enough size to write constituents. While at it, convert the only sizeof() in the driver that uses a type instead of variable.

bpf: Fix UAF in sock clone early bailouts

In the Linux kernel, the following vulnerability has been resolved: bpf: Fix UAF in sock clone early bailouts Similar to recent commit 9b51a6155d14 ("bpf,fork: wipe ->bpf_storage before bailouts that access it"), sk_clone() performs an initial shallow copy of the socket field ->sk_bpf_storage via sock_copy() for the cloned socket newsk. If sk_clone() bails out early (e.g. if sk_filter_charge() fails) prior to calling bpf_sk_storage_clone(), newsk->sk_bpf_storage still points to the parent socket's BPF local storage. When newsk is subsequently freed via sk_free(), the deallocation path (__sk_destruct() -> bpf_sk_storage_free()) destroys the

ppp: defer channel free to an RCU grace period to fix pppol2tp RX UAF

In the Linux kernel, the following vulnerability has been resolved: ppp: defer channel free to an RCU grace period to fix pppol2tp RX UAF pppol2tp_recv() runs in the L2TP UDP-encap softirq RX path: l2tp_udp_encap_recv() -> l2tp_recv_common() -> pppol2tp_recv() -> ppp_input(&po->chan) It runs under rcu_read_lock() holding only an l2tp_session reference and takes NO reference on the internal PPP channel (struct channel, chan->ppp) that ppp_input() dereferences. The pppox socket is SOCK_RCU_FREE, so 'po' and the embedded ppp_channel are RCU-safe. But the internal struct channel is a separate allocation that ppp_release_channel() frees

• Actualiza a 6.1.187-1

net/iucv: take a reference on the socket found in afiucv_hs_rcv()

In the Linux kernel, the following vulnerability has been resolved: net/iucv: take a reference on the socket found in afiucv_hs_rcv() afiucv_hs_rcv() looks up the destination socket under iucv_sk_list.lock, drops the lock, and then passes the socket to the afiucv_hs_callback_*() handlers without holding a reference. AF_IUCV sockets are not RCU-protected and are freed synchronously by iucv_sock_kill() -> sock_put(), so a concurrent close can free the socket in the window between read_unlock() and the handler, which then dereferences freed memory (for example sk->sk_data_ready() in afiucv_hs_callback_syn()). Take a reference with sock_hold()

• Actualiza a 6.1.187-1

scsi: core: wake eh reliably when using scsi_schedule_eh

In the Linux kernel, the following vulnerability has been resolved: scsi: core: wake eh reliably when using scsi_schedule_eh Drivers which use the scsi_schedule_eh function to run the error handler currently risk the error handler thread never waking once all commands are timed out or inactive. There is no enforced memory order between setting the host into error recovery state and counting busy commands. This can result in a race with scsi_dec_host_busy where neither CPU sees both conditions of all commands inactive and the host error state to request waking the error handler. To fix this, run the scsi_schedule_eh's scsi_eh_wakeup from a

ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered

In the Linux kernel, the following vulnerability has been resolved: ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered sata_dwc_enable_interrupts() is called before platform_get_irq() and ata_host_activate(), leaving the SATA controller's interrupt mask enabled without a registered handler. If a later step fails (irq request, phy init, etc.) or if the controller asserts an interrupt during probe, the irq line may fire with no handler, causing a spurious interrupt storm. Move sata_dwc_enable_interrupts() after ata_host_activate() so that interrupts are only unmasked once the handler is registered and the core

• Actualiza a 6.1.187-1

Bluetooth: mgmt: hold reference for hci_conn in mgmt_pending_cmds

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: mgmt: hold reference for hci_conn in mgmt_pending_cmds Dereferencing RCU-protected pointers outside critical sections is invalid and may lead to UAF. Use of hci_conn in hci_sync callbacks also needs to hold refcount to avoid UAF. Take appropriate locks for hci_conn lookups, and take refcount for hci_conn pointers stored in mgmt_pending_cmd so that the pointer stays valid. When accessing conn->state, ensure hdev->lock is held to avoid data race.

• Actualiza a 6.1.190-1