ipv4: icmp: validate reply type before using icmp_pointers
In the Linux kernel, the following vulnerability has been resolved:
ipv4: icmp: validate reply type before using icmp_pointers
Extended echo replies use ICMP_EXT_ECHOREPLY as the outbound reply type.
That value is outside the range covered by icmp_pointers[], which only
describes the traditional ICMP types up to NR_ICMP_TYPES.
Avoid consulting icmp_pointers[] for reply types outside that range, and
use array_index_nospec() for the remaining in-range lookup. Normal ICMP
replies keep their existing behavior unchanged.
crypto: authencesn - reject short ahash digests during instance creation
In the Linux kernel, the following vulnerability has been resolved:
crypto: authencesn - reject short ahash digests during instance creation
authencesn requires either a zero authsize or an authsize of at least
4 bytes because the ESN encrypt/decrypt paths always move 4 bytes of
high-order sequence number data at the end of the authenticated data.
While crypto_authenc_esn_setauthsize() already rejects explicit
non-zero authsizes in the range 1..3, crypto_authenc_esn_create()
still copied auth->digestsize into inst->alg.maxauthsize without
validating it. The AEAD core then initialized the tfm's default
authsize from that value.
As a resul
Media · CVSS 5.5EPSS 0,13%Sin corrección publicada
KVM: nSVM: Triple fault if restore host CR3 fails on nested #VMEXIT
In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Triple fault if restore host CR3 fails on nested #VMEXIT
If loading L1's CR3 fails on a nested #VMEXIT, nested_svm_vmexit()
returns an error code that is ignored by most callers, and continues to
run L1 with corrupted state. A sane recovery is not possible in this
case, and HW behavior is to cause a shutdown. Inject a triple fault
instead, and do not return early from nested_svm_vmexit(). Continue
cleaning up the vCPU state (e.g. clear pending exceptions), to handle
the failure as gracefully as possible.
From the APM:
Upon #VMEXIT, the processor performs the
net: ks8851: Reinstate disabling of BHs around IRQ handler
In the Linux kernel, the following vulnerability has been resolved:
net: ks8851: Reinstate disabling of BHs around IRQ handler
If the driver executes ks8851_irq() AND a TX packet has been sent, then
the driver enables TX queue via netif_wake_queue() which schedules TX
softirq to queue packets for this device.
If CONFIG_PREEMPT_RT=y is set AND a packet has also been received by
the MAC, then ks8851_rx_pkts() calls netdev_alloc_skb_ip_align() to
allocate SKBs for the received packets. If netdev_alloc_skb_ip_align()
is called with BH enabled, then local_bh_enable() at the end of
netdev_alloc_skb_ip_align() will trigger the pending softirq pro
crypto: algif_aead - snapshot IV for async AEAD requests
In the Linux kernel, the following vulnerability has been resolved:
crypto: algif_aead - snapshot IV for async AEAD requests
AF_ALG AEAD AIO requests currently use the socket-wide IV buffer during
request processing. For async requests, later socket activity can
update that shared state before the original request has fully
completed, which can lead to inconsistent IV handling.
Snapshot the IV into per-request storage when preparing the AEAD
request, so in-flight operations no longer depend on mutable socket
state.
net/smc: avoid early lgr access in smc_clc_wait_msg
In the Linux kernel, the following vulnerability has been resolved:
net/smc: avoid early lgr access in smc_clc_wait_msg
A CLC decline can be received while the handshake is still in an early
stage, before the connection has been associated with a link group.
The decline handling in smc_clc_wait_msg() updates link-group level sync
state for first-contact declines, but that state only exists after link
group setup has completed. Guard the link-group update accordingly and
keep the per-socket peer diagnosis handling unchanged.
This preserves the existing sync_err handling for established link-group
contexts and avoids touching link-group sta
net: qrtr: ns: Limit the maximum number of lookups
In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: ns: Limit the maximum number of lookups
Current code does no bound checking on the number of lookups a client can
perform. Though the code restricts the lookups to local clients, there is
still a possibility of a malicious local client sending a flood of
NEW_LOOKUP messages over the same socket.
Fix this issue by limiting the maximum number of lookups to 64 globally.
Since the nameserver allows only atmost one local observer, this global
lookup count will ensure that the lookups stay within the limit.
Note that, limit of 64 is chosen based on the current platfo
libceph: Prevent potential null-ptr-deref in ceph_handle_auth_reply()
In the Linux kernel, the following vulnerability has been resolved:
libceph: Prevent potential null-ptr-deref in ceph_handle_auth_reply()
If a message of type CEPH_MSG_AUTH_REPLY contains a zero value for both
protocol and result, this is currently not treated as an error. In case
of ac->negotiating == true and ac->protocol > 0, this leads to setting
ac->protocol = 0 and ac->ops = NULL. Thereafter, the check for
ac->protocol != protocol returns false, and init_protocol() is not
called. Subsequently, ac->ops->handle_reply() is called, which leads to
a null pointer dereference, because ac->ops is still NULL.
This patch changes the check for
dm mirror: fix integer overflow in create_dirty_log()
In the Linux kernel, the following vulnerability has been resolved:
dm mirror: fix integer overflow in create_dirty_log()
The argument count calculation in create_dirty_log() performs
`*args_used = 2 + param_count` before validating against argc. When a
user provides a param_count close to UINT_MAX via the device mapper
table string, this unsigned addition wraps around to a small value,
causing the subsequent `argc < *args_used` check to be bypassed.
The overflowed param_count is then passed as argc to dm_dirty_log_create(),
where it can cause out-of-bounds reads on the argv array.
Fix by comparing param_count against argc - 2 before perf
misc: ibmasm: fix OOB MMIO read in ibmasm_handle_mouse_interrupt()
In the Linux kernel, the following vulnerability has been resolved:
misc: ibmasm: fix OOB MMIO read in ibmasm_handle_mouse_interrupt()
ibmasm_handle_mouse_interrupt() performs an out-of-bounds MMIO read
when the queue reader or writer index from hardware exceeds
REMOTE_QUEUE_SIZE (60).
A compromised service processor can trigger this by writing an
out-of-range value to the reader or writer MMIO register before
asserting an interrupt. Since writer is re-read from hardware on
every loop iteration, it can also be set to an out-of-range value
after the loop has already started.
The root cause is that get_queue_reader() and get_queue_writer()
thermal: core: Fix thermal zone governor cleanup issues
In the Linux kernel, the following vulnerability has been resolved:
thermal: core: Fix thermal zone governor cleanup issues
If thermal_zone_device_register_with_trips() fails after adding
a thermal governor to the thermal zone being registered, the
governor is not removed from it as appropriate which may lead to
a memory leak.
In turn, thermal_zone_device_unregister() calls thermal_set_governor()
without acquiring the thermal zone lock beforehand which may race with
a governor update via sysfs and may lead to a use-after-free in that
case.
Address these issues by adding two thermal_set_governor() calls, one to
thermal_release() to remove
crypto: atmel-aes - Fix 3-page memory leak in atmel_aes_buff_cleanup
In the Linux kernel, the following vulnerability has been resolved:
crypto: atmel-aes - Fix 3-page memory leak in atmel_aes_buff_cleanup
atmel_aes_buff_init() allocates 4 pages using __get_free_pages() with
ATMEL_AES_BUFFER_ORDER, but atmel_aes_buff_cleanup() frees only the
first page using free_page(), leaking the remaining 3 pages. Use
free_pages() with ATMEL_AES_BUFFER_ORDER to fix the memory leak.
ALSA: usb-audio: stop parsing UAC2 rates at MAX_NR_RATES
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: stop parsing UAC2 rates at MAX_NR_RATES
parse_uac2_sample_rate_range() caps the number of enumerated
rates at MAX_NR_RATES, but it only breaks out of the current
rate loop. A malformed UAC2 RANGE response with additional
triplets continues parsing the remaining triplets and repeatedly
prints "invalid uac2 rates" while probe still holds
register_mutex.
Stop the whole parse once the cap is reached and return the
number of rates collected so far.
mm: fix deferred split queue races during migration
In the Linux kernel, the following vulnerability has been resolved:
mm: fix deferred split queue races during migration
migrate_folio_move() records the deferred split queue state from src and
replays it on dst. Replaying it after remove_migration_ptes(src, dst, 0)
makes dst visible before it is requeued, so a concurrent rmap-removal path
can mark dst partially mapped and trip the WARN in deferred_split_folio().
Move the requeue before remove_migration_ptes() so dst is back on the
deferred split queue before it becomes visible again.
Because migration still holds dst locked at that point, teach
deferred_split_scan() to requeue a folio wh
tcp: call sk_data_ready() after listener migration
In the Linux kernel, the following vulnerability has been resolved:
tcp: call sk_data_ready() after listener migration
When inet_csk_listen_stop() migrates an established child socket from
a closing listener to another socket in the same SO_REUSEPORT group,
the target listener gets a new accept-queue entry via
inet_csk_reqsk_queue_add(), but that path never notifies the target
listener's waiters. A nonblocking accept() still works because it
checks the queue directly, but poll()/epoll_wait() waiters and
blocking accept() callers can also remain asleep indefinitely.
Call READ_ONCE(nsk->sk_data_ready)(nsk) after a successful migration
in ine
KVM: SVM: Add missing save/restore handling of LBR MSRs
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Add missing save/restore handling of LBR MSRs
MSR_IA32_DEBUGCTLMSR and LBR MSRs are currently not enumerated by
KVM_GET_MSR_INDEX_LIST, and LBR MSRs cannot be set with KVM_SET_MSRS. So
save/restore is completely broken.
Fix it by adding the MSRs to msrs_to_save_base, and allowing writes to
LBR MSRs from userspace only (as they are read-only MSRs) if LBR
virtualization is enabled. Additionally, to correctly restore L1's LBRs
while L2 is running, make sure the LBRs are copied from the captured
VMCB01 save area in svm_copy_vmrun_state().
Note, for VMX, this also f
rxrpc: Fix memory leaks in rxkad_verify_response()
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix memory leaks in rxkad_verify_response()
Fix rxkad_verify_response() to free the ticket and the server key under all
circumstances by initialising the ticket pointer to NULL and then making
all paths through the function after the first allocation has been done go
through a single common epilogue that just releases everything - where all
the releases skip on a NULL pointer.
In the Linux kernel, the following vulnerability has been resolved:
PCI: endpoint: pci-epf-ntb: Remove duplicate resource teardown
epf_ntb_epc_destroy() duplicates the teardown that the caller is
supposed to do later. This leads to an oops when .allow_link fails or
when .drop_link is performed. Remove the helper.
Also drop pci_epc_put(). EPC device refcounting is tied to configfs EPC
group lifetime, and pci_epc_put() in the .drop_link path is sufficient.
drm/nouveau: fix u32 overflow in pushbuf reloc bounds check
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau: fix u32 overflow in pushbuf reloc bounds check
nouveau_gem_pushbuf_reloc_apply() validates each relocation with
if (r->reloc_bo_offset + 4 > nvbo->bo.base.size)
but reloc_bo_offset is __u32 (uapi/drm/nouveau_drm.h) and the integer
literal 4 promotes to unsigned int, so the addition is performed in 32
bits and wraps before the comparison against the size_t bo size.
Cast to u64 so the addition happens in 64-bit arithmetic.
[ Add Fixes: tag. - Danilo ]
In the Linux kernel, the following vulnerability has been resolved:
xfs: fix a resource leak in xfs_alloc_buftarg()
In the error path, call fs_put_dax() to drop the DAX
device reference.