tpm: tpm_i2c_infineon: Fix locality leak on get_burstcount() failure
In the Linux kernel, the following vulnerability has been resolved:
tpm: tpm_i2c_infineon: Fix locality leak on get_burstcount() failure
get_burstcount() can return -EBUSY on timeout. When this happens, the
function returns directly without releasing the locality that was
acquired at the beginning of tpm_tis_i2c_send().
Use goto out_err to ensure proper cleanup when get_burstcount() fails.
net: stmmac: fix oops when split header is enabled
In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: fix oops when split header is enabled
For GMAC4, when split header is enabled, in some rare cases, the
hardware does not fill buf2 of the first descriptor with payload.
Thus we cannot assume buf2 is always fully filled if it is not
the last descriptor. Otherwise, the length of buf2 of the second
descriptor will be calculated wrong and cause an oops:
Unable to handle kernel paging request at virtual address ffff00019246bfc0
...
x2 : 0000000000000040 x1 : ffff00019246bfc0 x0 : ffff00009246c000
Call trace:
dcache_inval_poc+0x28/0x58 (P)
dma_direct_sync_single_f
power: supply: goldfish: Fix use-after-free in power_supply_changed()
In the Linux kernel, the following vulnerability has been resolved:
power: supply: goldfish: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handler h
fs/ntfs3: Fix slab-out-of-bounds read in DeleteIndexEntryRoot
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: Fix slab-out-of-bounds read in DeleteIndexEntryRoot
In the 'DeleteIndexEntryRoot' case of the 'do_action' function, the
entry size ('esize') is retrieved from the log record without adequate
bounds checking.
Specifically, the code calculates the end of the entry ('e2') using:
e2 = Add2Ptr(e1, esize);
It then calculates the size for memmove using 'PtrOffset(e2, ...)',
which subtracts the end pointer from the buffer limit. If 'esize' is
maliciously large, 'e2' exceeds the used buffer size. This results in
a negative offset which, when cast to size_t for memmov
Media · CVSS 5.8EPSS 0,16%Sin corrección publicada
btrfs: fix EEXIST abort due to non-consecutive gaps in chunk allocation
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix EEXIST abort due to non-consecutive gaps in chunk allocation
I have been observing a number of systems aborting at
insert_dev_extents() in btrfs_create_pending_block_groups(). The
following is a sample stack trace of such an abort coming from forced
chunk allocation (typically behind CONFIG_BTRFS_EXPERIMENTAL) but this
can theoretically happen to any DUP chunk allocation.
[81.801] ------------[ cut here ]------------
[81.801] BTRFS: Transaction aborted (error -17)
[81.801] WARNING: fs/btrfs/block-group.c:2876 at btrfs_create_pending_block_groups+0x721/0x77
net: mctp: ensure our nlmsg responses are initialised
In the Linux kernel, the following vulnerability has been resolved:
net: mctp: ensure our nlmsg responses are initialised
Syed Faraz Abrar (@farazsth98) from Zellic, and Pumpkin (@u1f383) from
DEVCORE Research Team working with Trend Micro Zero Day Initiative
report that a RTM_GETNEIGH will return uninitalised data in the pad
bytes of the ndmsg data.
Ensure we're initialising the netlink data to zero, in the link, addr
and neigh response messages.
ksmbd: call ksmbd_vfs_kern_path_end_removing() on some error paths
In the Linux kernel, the following vulnerability has been resolved:
ksmbd: call ksmbd_vfs_kern_path_end_removing() on some error paths
There are two places where ksmbd_vfs_kern_path_end_removing() needs to be
called in order to balance what the corresponding successful call to
ksmbd_vfs_kern_path_start_removing() has done, i.e. drop inode locks and
put the taken references. Otherwise there might be potential deadlocks
and unbalanced locks which are caught like:
BUG: workqueue leaked lock or atomic: kworker/5:21/0x00000000/7596
last function: handle_ksmbd_work
2 locks held by kworker/5:21/7596:
#0: ffff8881051ae448 (sb_writers#3){.+.
In the Linux kernel, the following vulnerability has been resolved:
net: usb: catc: enable basic endpoint checking
catc_probe() fills three URBs with hardcoded endpoint pipes without
verifying the endpoint descriptors:
- usb_sndbulkpipe(usbdev, 1) and usb_rcvbulkpipe(usbdev, 1) for TX/RX
- usb_rcvintpipe(usbdev, 2) for interrupt status
A malformed USB device can present these endpoints with transfer types
that differ from what the driver assumes.
Add a catc_usb_ep enum for endpoint numbers, replacing magic constants
throughout. Add usb_check_bulk_endpoints() and usb_check_int_endpoints()
calls after usb_set_interface() to verify endp
ext4: fix dirtyclusters double decrement on fs shutdown
In the Linux kernel, the following vulnerability has been resolved:
ext4: fix dirtyclusters double decrement on fs shutdown
fstests test generic/388 occasionally reproduces a warning in
ext4_put_super() associated with the dirty clusters count:
WARNING: CPU: 7 PID: 76064 at fs/ext4/super.c:1324 ext4_put_super+0x48c/0x590 [ext4]
Tracing the failure shows that the warning fires due to an
s_dirtyclusters_counter value of -1. IOW, this appears to be a
spurious decrement as opposed to some sort of leak. Further tracing
of the dirty cluster count deltas and an LLM scan of the resulting
output identified the cause as a double decrement in the
sched/rt: Skip currently executing CPU in rto_next_cpu()
In the Linux kernel, the following vulnerability has been resolved:
sched/rt: Skip currently executing CPU in rto_next_cpu()
CPU0 becomes overloaded when hosting a CPU-bound RT task, a non-CPU-bound
RT task, and a CFS task stuck in kernel space. When other CPUs switch from
RT to non-RT tasks, RT load balancing (LB) is triggered; with
HAVE_RT_PUSH_IPI enabled, they send IPIs to CPU0 to drive the execution
of rto_push_irq_work_func. During push_rt_task on CPU0,
if next_task->prio < rq->donor->prio, resched_curr() sets NEED_RESCHED
and after the push operation completes, CPU0 calls rto_next_cpu().
Since only CPU0 is overloaded in this scenario
Media · CVSS 5.7EPSS 0,16%Sin corrección publicada
ipvs: do not keep dest_dst if dev is going down
In the Linux kernel, the following vulnerability has been resolved:
ipvs: do not keep dest_dst if dev is going down
There is race between the netdev notifier ip_vs_dst_event()
and the code that caches dst with dev that is going down.
As the FIB can be notified for the closed device after our
handler finishes, it is possible valid route to be returned
and cached resuling in a leaked dev reference until the dest
is not removed.
To prevent new dest_dst to be attached to dest just after the
handler dropped the old one, add a netif_running() check
to make sure the notifier handler is not currently running
for device that is closing.
power: supply: sbs-battery: Fix use-after-free in power_supply_changed()
In the Linux kernel, the following vulnerability has been resolved:
power: supply: sbs-battery: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handle
In the Linux kernel, the following vulnerability has been resolved:
fat: avoid parent link count underflow in rmdir
Corrupted FAT images can leave a directory inode with an incorrect
i_nlink (e.g. 2 even though subdirectories exist). rmdir then
unconditionally calls drop_nlink(dir) and can drive i_nlink to 0,
triggering the WARN_ON in drop_nlink().
Add a sanity check in vfat_rmdir() and msdos_rmdir(): only drop the
parent link count when it is at least 3, otherwise report a filesystem
error.
Revert "hwmon: (ibmpex) fix use-after-free in high/low store"
In the Linux kernel, the following vulnerability has been resolved:
Revert "hwmon: (ibmpex) fix use-after-free in high/low store"
This reverts commit 6946c726c3f4c36f0f049e6f97e88c510b15f65d.
Jean Delvare points out that the patch does not completely
fix the reported problem, that it in fact introduces a
(new) race condition, and that it may actually not be needed in
the first place.
Various AI reviews agree. Specific and relevant AI feedback:
"
This reordering sets the driver data to NULL before removing the sensor
attributes in the loop below.
ibmpex_show_sensor() retrieves this driver data via dev_get_drvdata() but
does not check if
In the Linux kernel, the following vulnerability has been resolved:
ext4: don't cache extent during splitting extent
Caching extents during the splitting process is risky, as it may result
in stale extents remaining in the status tree. Moreover, in most cases,
the corresponding extent block entries are likely already cached before
the split happens, making caching here not particularly useful.
Assume we have an unwritten extent, and then DIO writes the first half.
[UUUUUUUUUUUUUUUU] on-disk extent U: unwritten extent
[UUUUUUUUUUUUUUUU] extent status tree
|<- ->| ----> dio write this range
First, when ext4_split_extent_at()
In the Linux kernel, the following vulnerability has been resolved:
usb: cdns3: fix role switching during resume
If the role change while we are suspended, the cdns3 driver switches to the
new mode during resume. However, switching to host mode in this context
causes a NULL pointer dereference.
The host role's start() operation registers a xhci-hcd device, but its
probe is deferred while we are in the resume path. The host role's resume()
operation assumes the xhci-hcd device is already probed, which is not the
case, leading to the dereference. Since the start() operation of the new
role is already called, the resume operation can be skipp
xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path
In the Linux kernel, the following vulnerability has been resolved:
xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path
icmp_route_lookup() performs multiple route lookups to find a suitable
route for sending ICMP error messages, with special handling for XFRM
(IPsec) policies.
The lookup sequence is:
1. First, lookup output route for ICMP reply (dst = original src)
2. Pass through xfrm_lookup() for policy check
3. If blocked (-EPERM) or dst is not local, enter "reverse path"
4. In reverse path, call xfrm_decode_session_reverse() to get fl4_dec
which reverses the original packet's flow (saddr<->daddr swapped)
5. If fl4_dec.saddr
powerpc/eeh: fix recursive pci_lock_rescan_remove locking in EEH event handling
In the Linux kernel, the following vulnerability has been resolved:
powerpc/eeh: fix recursive pci_lock_rescan_remove locking in EEH event handling
The recent commit 1010b4c012b0 ("powerpc/eeh: Make EEH driver device
hotplug safe") restructured the EEH driver to improve synchronization
with the PCI hotplug layer.
However, it inadvertently moved pci_lock_rescan_remove() outside its
intended scope in eeh_handle_normal_event(), leading to broken PCI
error reporting and improper EEH event triggering. Specifically,
eeh_handle_normal_event() acquired pci_lock_rescan_remove() before
calling eeh_pe_bus_get(), but eeh_pe_bus_get() itself attempts t
power: supply: bq256xx: Fix use-after-free in power_supply_changed()
In the Linux kernel, the following vulnerability has been resolved:
power: supply: bq256xx: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handler ha
Media · CVSS 5.5EPSS 0,18%Sin corrección publicada
netfilter: nf_tables: revert commit_mutex usage in reset path
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_tables: revert commit_mutex usage in reset path
It causes circular lock dependency between commit_mutex, nfnl_subsys_ipset
and nlk_cb_mutex when nft reset, ipset list, and iptables-nft with '-m set'
rule run at the same time.
Previous patches made it safe to run individual reset handlers concurrently
so commit_mutex is no longer required to prevent this.