regulator: ltc3676: don't read the write-only HRST and CLIRQ registers
In the Linux kernel, the following vulnerability has been resolved:
regulator: ltc3676: don't read the write-only HRST and CLIRQ registers
HRST (0x1e) and CLIRQ (0x1f) are write-only command strobes. Writing HRST
triggers a hard reset of the chip and writing CLIRQ clears the interrupt;
reading them returns nothing useful, and the read itself fires the command.
The result is that a plain register dump resets the board:
cat /sys/kernel/debug/regmap/2-003c/registers
walks every readable register, hits HRST, and the board reboots.
Split the callback back in two so HRST and CLIRQ stay writable but are no
longer readable. The readable range
regulator: of: fill in supply names in of_regulator_bulk_get_all()
In the Linux kernel, the following vulnerability has been resolved:
regulator: of: fill in supply names in of_regulator_bulk_get_all()
of_regulator_bulk_get_all() returns an array it allocated itself, and
fills in only the consumer of each entry. Every other way of getting a
bulk array has the supply name set, because the caller provides it, and
the core expects it to be there: regulator_bulk_enable() prints it when
a supply fails to enable, so a caller that hands such an array to it
dereferences uninitialised memory on that path.
Copy each name into the array's own allocation, right behind the
entries, so that it shares the array's lifeti
scsi: ch: Do not keep references to data transfer element devices
In the Linux kernel, the following vulnerability has been resolved:
scsi: ch: Do not keep references to data transfer element devices
ch_readconfig() looks up the scsi_device of every data transfer element
whose SCSI id the changer reports in READ ELEMENT STATUS, and stores it in
ch->dt[]. scsi_device_lookup() takes a reference, and nothing ever drops
it: ch_destroy() frees the array with kfree(). ch->dt[] is read nowhere
else - it only supplies the vendor, model and revision printed in the same
loop.
Once such a drive is removed, its scsi_device can never be released. It
stays on the host's device list at its address, so a new device ther
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sock: Serialize dead-device detachment
Rebinding an HCI socket after its controller is unregistered can race
monitor control replay and crash the kernel. hci_sock_bind() clears
hci_pi(sk)->hdev and drops the device reference under only the socket
lock, whereas send_monitor_control_replay() holds hci_sk_list.lock for
reading.
Replay can observe a non-NULL hdev, then bind can clear it and drop the
last reference before create_monitor_ctrl_open() reads hdev->id. This
can cause a NULL pointer dereference if the pointer is reloaded, or a
use-after-free if the old
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: Serialize concurrent connect calls
iso_sock_connect() checks the socket state before taking the socket lock
and drops the lock again before setting up a connection. Two callers can
both pass the admission check while the socket is open or bound.
Caller A can copy its destination for route selection, then caller B can
replace the socket destination before A binds or connects the CIS. A
then uses B's destination with the route selected for its own request.
B can also proceed after A attaches a connection and sets BT_CONNECT.
For deferred BIS setup, B can bind
Bluetooth: RFCOMM: free the skb when the DLC has no owner
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: free the skb when the DLC has no owner
rfcomm_recv_data() hands the skb to d->data_ready() and returns 0
without freeing it, so the callback owns the skb from that point on.
The tty implementation frees it when the DLC has been detached from its
device:
static void rfcomm_dev_data_ready(struct rfcomm_dlc *dlc,
struct sk_buff *skb)
{
struct rfcomm_dev *dev = dlc->owner;
if (!dev) {
kfree_skb(skb);
return;
}
The socket implementation returns without
Bluetooth: RFCOMM: connect the session socket without rfcomm_mutex
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: connect the session socket without rfcomm_mutex
An RFCOMM connect() issued while a BR/EDR link is being authenticated
makes lockdep report a circular dependency, and the reported cycle is a
real AB/BA between rfcomm_mutex and hdev->lock.
rfcomm_security_cfm() is called from the HCI event path, which already
holds hdev->lock:
hci_rx_work()
hci_event_packet()
hci_cc_read_enc_key_size() [hdev->lock]
hci_encrypt_cfm() [hci_cb_list_lock]
rfcomm_security_cfm() [rfcomm_mutex]
while an RFCOMM connect() from userspace
Bluetooth: RFCOMM: Fix NULL tty_dev dereference in rfcomm_dev_shutdown
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix NULL tty_dev dereference in rfcomm_dev_shutdown
syzbot hit a NULL pointer dereference in rfcomm_dev_shutdown() when an
RFCOMM tty is closed.
rfcomm_dev_add() puts the new device on rfcomm_dev_list first and only
then registers the tty device and saves it in dev->tty_dev. If that
registration fails, dev->tty_dev is never set at all. The device can be
looked up in the meantime, so an open() of /dev/rfcommN gets through
rfcomm_tty_install() and attaches to it. When that tty is closed again,
rfcomm_dev_shutdown() uses dev->tty_dev without checking it:
drm/fb-helper: defer setup when fbdev_probe() fails, not just on -EAGAIN
In the Linux kernel, the following vulnerability has been resolved:
drm/fb-helper: defer setup when fbdev_probe() fails, not just on -EAGAIN
__drm_fb_helper_initial_config_and_unlock() calls
drm_client_modeset_probe() first, which already fills in each
mode_set->mode/num_connectors for every connected output, and only
afterwards calls drm_fb_helper_single_fb_probe() to create
fb_helper->fb and wire it into those mode_sets via
drm_setup_crtcs_fb().
If drm_fb_helper_single_fb_probe() fails with anything other than
-EAGAIN (e.g. dev->driver->fbdev_probe() itself fails), the function
bails out before drm_setup_crtcs_fb() runs and before settin
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gem: Prevent overstepping exec array boundary
It is possible for eb_relocate_parse_slow() to call kvfree() on
entries outside the original exec array during following
scenario inside eb_relocate_parse_slow():
1) eb_copy_relocations() allocates as many as eb->buffer_count
copies for exec entries;
2) eb_parse() appends up to two VMAs, right after incrementing
eb->buffer_count;
3) cleanup under "out" label uses this incremented buffer_count
to release relocation pointers from exec array via kvfree(),
not from VMA array.
To amend this problem, ensure that
drm/i915/gt: Unmask interrupts only when ACTIVE is true
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gt: Unmask interrupts only when ACTIVE is true
There is a small race window between intel_rps_boost() reading
a stale ACTIVE state and queuing rps->work, where ACTIVE may be
changed via asynchronous calls triggered by wakeref drop.
This means that rps_work() could be triggered after the GT has
been parked, so unmasking RPS PM interrupts would happen without
holding PM wakelock. This sequence of events may be observed
during live_rc6_ctx_wa() selftest:
1) live_rc6_ctx_wa()
-> intel_engine_pm_put()
-> wakeref_put()
ASYNC1) wakeref_put() callback
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: validate pitch coming from userspace
Validate the pitch, alongside the box dimensions before trying
to copy data from the underlying surface. Fixes possible
out of bounds reads with cursor snooping.
In the Linux kernel, the following vulnerability has been resolved:
fs: don't silently unmount busy mounts
The propagate_mount_busy() helper exists to decide whether a synchronous
can suceed. It does that by looking at the copies of the victims in the
mounts its parent propagates to. One of those functions from propagation
hell.
It skips a copy that has child mounts except for the case of a single
child mount covering the copy's root. That algorithm used to be exact.
It isn't anymore.
Originally only childless copies were unmounted during propagation.
And 1064f874abc0 ("mnt: Tuck mounts under others instead of creating
shadow/side mounts.
namespace: don't inherit MNT_UMOUNT in clone_mnt()
In the Linux kernel, the following vulnerability has been resolved:
namespace: don't inherit MNT_UMOUNT in clone_mnt()
MNT_UMOUNT gets raised on a mount that umount_tree() or umount_one() has
taken out of its namespace. It's never cleared. __detach_mounts()
unhooks a mount that carries it instead of unmounting it.
disconnect_mount() lets an unmounted child stay attached only if its
parent carries it. propagate_umount() takes it as the sign that a mount
is going to be unmounted when it decides what else can be unmounted,
where a chain of locked mounts ends and where a for reparenting an
overmount.
clone_mnt() copies the flags of the source
In the Linux kernel, the following vulnerability has been resolved:
namespace: don't copy an unmounted mount tree
may_copy_tree() accepts a mount whose root is an nsfs or pidfs file
before it checks whether that mount is mounted. This exception exists
for nsfs and pidfs mounts. They are part of no mount namespace so
neither check_mnt() nor is_mounted() would let them through and
bind-mounting a nsfsfd or a pidfd wouldn't work.
Problem is that exception also admits a bind mount of such a file when
it was lazily unmounted and is only kept alive by a file descriptor:
mount --bind /proc/self/ns/net /tmp/x
exec 3< /tmp/x
umount -l /tmp/x
namespace: check a submount for references right before unmounting it
In the Linux kernel, the following vulnerability has been resolved:
namespace: check a submount for references right before unmounting it
shrink_submounts() and mark_mounts_for_expiry() first collect all the
mounts they are allowed to unmount and then unmount them.
Whether a mount is busy is decided by propagate_mount_busy() on the
tree. But unmounting the first mount changes the tree that the second
one propagates into. propagate_umount()
moves a surviving overmount off a copy it unmounts and mounts it where
the copy was mounted. If that's where the propagated copy of the second
victim is looked up the overmount becomes a candidate of the
namespace: check a recursive bind mount for mount namespace loops
In the Linux kernel, the following vulnerability has been resolved:
namespace: check a recursive bind mount for mount namespace loops
do_loopback() refuses to bind mount the file of a mount namespace that
is as old as the caller's or older because a mount namespace that holds
a mount of its own file, or of an ancestor's, would cause a cycle. But
it only checks the dentry the bind mount starts from. With MS_REC
everything below it is copied and do_loopback() passes
CL_COPY_MNT_NS_FILE so mount namespace files below the source are
copied.
That's fine for a source in the caller's own mount namespace. Every
mount namespace file in there passed
namespace: check the mounts before reading their parents in pivot_root()
In the Linux kernel, the following vulnerability has been resolved:
namespace: check the mounts before reading their parents in pivot_root()
path_pivot_root() reads the parents of new_root and of the caller's root
and checks whether they are shared before it checks that either mount is
in the caller's mount namespace. Only namespace_sem is held. That's fine
for a mount that is in the caller's mount namespace.
But new_root can be a file descriptor to a mount that has been unmounted
and that only the file descriptor keeps alive. If that mount stayed
attached to its parent when it was unmounted nothing pins the parent for
it. The final mntput
dcache: don't put a mountpoint on a dentry that's being removed
In the Linux kernel, the following vulnerability has been resolved:
dcache: don't put a mountpoint on a dentry that's being removed
rmdir(), unlink() and rename() call dont_mount() on the victim and then
detach_mounts() with the victim's inode locked. do_lock_mount() takes
the inode lock of the mountpoint and checks cant_mount() so a mount
can't show up after detach_mounts().
But attach_recursive_mnt() makes a second mountpoint for the root of the
source mount so that the mounts already located at the destination can
be put on top of it. No inode is locked for that one and d_set_mounted()
only refuses a dentry that is unlinked. Between det
unshare: don't drop active namespace references that were never taken
In the Linux kernel, the following vulnerability has been resolved:
unshare: don't drop active namespace references that were never taken
Active references on the namespaces of an nsproxy are taken when the
nsproxy is installed into a task in switch_task_namespaces() and
copy_namespaces() and dropped again by put_nsproxy() through
deactivate_nsproxy().
But ksys_unshare() calls put_nsproxy() on an nsproxy that was never
installed when set_cred_ucounts() fails. The new namespaces of that
nsproxy go from zero to minus one and the namespaces shared with the
caller lose a reference that belongs to the nsproxy the caller keeps
using:
WARNING: