PCI: Fix UAF when probe runs concurrent to dyn ID removal
In the Linux kernel, the following vulnerability has been resolved:
PCI: Fix UAF when probe runs concurrent to dyn ID removal
Dynamic IDs are only guaranteed to be valid when dynids.lock is held,
as remove_id_store() can free the node. Thus, make a copy in
pci_match_device(). Also, clarify that the id parameter is only valid
during probe.
nilfs2: fix infinite loop in nilfs_clean_segments()
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix infinite loop in nilfs_clean_segments()
syzbot reported a hung task in nilfs_transaction_begin(). This occurs
because the cleaner ioctl falls into an infinite loop if
nilfs_segctor_construct() repeatedly returns -EROFS (e.g. the device
is remounted as read-only after an I/O error).
Currently in nilfs_clean_segments(), if err is non-zero, it logs the
error and sleeps but doesn't abort when it encounters a terminal error
like -EROFS. This causes the thread to loop forever.
Fix this by breaking out of the loop if nilfs_segctor_construct()
returns -EROFS. This mat
nilfs2: prevent out-of-bounds read in super root block parsing
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: prevent out-of-bounds read in super root block parsing
super-root inode metadata size is trusted before nilfs_read_inode_common().
Reject super-root inode sizes whose computed on-disk footprint exceeds the
filesystem block size. This prevents malformed filesystem images from
making nilfs_read_inode_common() read past the end of the super-root block.
[ryusuke: clarify the commit title]
nilfs2: fix BUG in nilfs_copy_dirty_pages() on dirty state mismatch
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix BUG in nilfs_copy_dirty_pages() on dirty state mismatch
Syzbot reported a kernel BUG triggered within nilfs_copy_dirty_pages(),
which copies dirty DAT file folios/pages to its shadow page cache. The
BUG occurs when a retrieved dirty folio/page unexpectedly loses its
'dirty' status.
This issue arises because, since the commit referenced below, the 'dirty'
flag of a folio/page can be cleared asynchronously after the filesystem
detects metadata corruption and transitions to read-only mode.
Resolve the issue by returning an -EROFS error if the filesystem has
tran
RDMA/cxgb4: Fix dereg_skb leak and double free in write_tpt_entry()
In the Linux kernel, the following vulnerability has been resolved:
RDMA/cxgb4: Fix dereg_skb leak and double free in write_tpt_entry()
When the device is in the fatal error state, write_tpt_entry() returns -EIO
before handing the caller's preallocated skb to the transmit path; its
allocation-failure returns do the same. c4iw_dereg_mr() ignores the error
and frees mhp, leaking mhp->dereg_skb. c4iw_get_dma_mr() instead frees the
skb a second time after dereg_mem() already consumed it, a double free.
Make write_tpt_entry() the sole owner of a non-NULL skb, freeing it on
every return preceding handoff to c4iw_ofld_send(): fatal error, tpt and
RDMA/mlx5: Fix stack out-of-bounds read in cc_params debugfs
In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx5: Fix stack out-of-bounds read in cc_params debugfs
get_param() reads a congestion parameter as a u32 but formats it with the
signed "%d" into an 11-byte stack buffer. A value with bit 31 set, such as
0x80000000, renders as "-2147483648\n" whose full length is 12. snprintf()
stores only 11 bytes yet returns 12, so simple_read_from_buffer() treats 12
bytes as valid and reads one byte past lbuf[].
Size the buffer for the widest unsigned decimal, format with "%u" to match
the u32, and use scnprintf() so the length passed to
simple_read_from_buffer() reflects the byte
RDMA/cxgb4: free STAG index when TPT entry write fails
In the Linux kernel, the following vulnerability has been resolved:
RDMA/cxgb4: free STAG index when TPT entry write fails
write_tpt_entry() allocates a new STAG index with c4iw_get_resource() and
bumps stats.stag.cur before programming the entry. When
write_adapter_mem() fails, it returns the error without releasing the index
or reversing the statistic. No MR is inserted into rhp->mrs, so
deregistration never reclaims it, leaking the index until device teardown.
Record whether this call allocated the index and, on a failed write, return
it to tpt_table and decrement stats.stag.cur. Key the rollback on both the
write error and that flag
IB/isert: reject PDUs declaring more data than was received
In the Linux kernel, the following vulnerability has been resolved:
IB/isert: reject PDUs declaring more data than was received
isert_recv_done() hands each received PDU to the opcode handlers without
ever looking at wc->byte_len, the number of bytes the HCA actually placed
in the receive descriptor. The handlers then copy that many bytes - the
data-segment length the initiator declared in the BHS
(ntoh24(hdr->dlength), via the derived unsol_data_len / imm_data_len) -
out of the fixed-size descriptor:
isert_handle_iscsi_dataout():
sg_copy_from_buffer(sg_start, sg_nents, isert_get_data(rx_desc),
unsol_d
IB/isert: reject login PDUs declaring more data than was received
In the Linux kernel, the following vulnerability has been resolved:
IB/isert: reject login PDUs declaring more data than was received
isert_login_recv_done() records how many bytes the HCA actually placed in
the login buffer, but nothing compares that against the length the login
PDU's BHS declares. isert_rx_login_req() copies min(login_req_len,
MAX_KEY_VALUE_PAIRS) bytes into login->req_buf, and the login code then
reads the declared length back out of that buffer - for the first PDU in
iscsi_target_locate_portal(),
payload_length = ntoh24(login_req->dlength);
tmpbuf = kmemdup_nul(login->req_buf, payload_length, GFP_KERNEL);
and for t
nvme-fc: unmap cmd_iu DMA on rsp_iu mapping failure in init_request
In the Linux kernel, the following vulnerability has been resolved:
nvme-fc: unmap cmd_iu DMA on rsp_iu mapping failure in init_request
__nvme_fc_init_request() maps cmd_iu and then rsp_iu for DMA. If the
rsp_iu mapping fails, the original code only recorded the error and fell
through: it left the already-mapped cmd_iu unmapped and still marked the
op as FCPOP_STATE_IDLE before returning. Since blk-mq does not call
.exit_request() when .init_request() fails, the cmd_iu mapping is leaked
for every op whose rsp_iu mapping fails.
Jump to an error path on rsp_iu mapping failure that unmaps cmd_iu and
returns the error without marking the op id
spi: davinci: switch to managed controller allocation
In the Linux kernel, the following vulnerability has been resolved:
spi: davinci: switch to managed controller allocation
The controller is allocated with the non-managed spi_alloc_host() while
the interrupt is registered with devm_request_threaded_irq(). During
removal, spi_bitbang_stop() only unregisters the controller; the
subsequent spi_controller_put() then frees the controller together with
its embedded davinci_spi devdata, which is the IRQ handler's dev_id.
The devm_request_threaded_irq() release action (free_irq()), which
drains the handler, does not run until after .remove() returns. A late
or latched interrupt can therefore reac
wifi: ath11k: fix overreads in ath11k_wmi_process_csa_switch_count_event()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix overreads in ath11k_wmi_process_csa_switch_count_event()
There is no policy entry for WMI_TAG_PDEV_CSA_SWITCH_COUNT_STATUS_EVENT, so
the parse infrastructure does not enforce a minimum length for the event
struct. Additionally, the num_vdevs field is taken directly from firmware
and used as a loop bound over the vdev_ids array without checking that it
fits within the TLV payload. Either condition can cause an out-of-bounds
read.
Add a TLV policy entry for WMI_TAG_PDEV_CSA_SWITCH_COUNT_STATUS_EVENT so
the parse infrastructure enforces a minimum length for
wifi: rtlwifi: pci: fix error path in rtl_pci_probe()
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: pci: fix error path in rtl_pci_probe()
In the last error path in rtl_pci_probe(), the cleanup functions are
skipped due to a wrong goto label. Moreover, the successful call to
rtl_init_rfkill(), ieee80211_register_hw(), rtl_debug_add_one() have to
be reverted. Fix this issue by updating the labels and adding the
relevant cleanup functions to the last error path.
In the Linux kernel, the following vulnerability has been resolved:
md: remove REQ_NOWAIT support from raid1/10/456
REQ_NOWAIT support in md personalities that can block internally is
fundamentally incomplete. While reads can avoid some blocking paths,
write requests can still encounter cases where one mirror succeeds while
another returns -EAGAIN. At that point md cannot distinguish queue
pressure from a real device failure, so it can neither record a bad
block nor safely retry the write without REQ_NOWAIT, leaving mirrors
with divergent data.
Rather than continue advertising REQ_NOWAIT support for personalities
that cannot implement it c
wifi: ath11k: fix stride mismatch in mac_phy_caps_parse()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix stride mismatch in mac_phy_caps_parse()
Currently, in ath11k_wmi_tlv_mac_phy_caps_parse(), kcalloc() sizes the
mac_phy_caps buffer as tot_phy_id * len, where len is clamped to
min(firmware_len, sizeof(struct wmi_mac_phy_capabilities)). The subsequent
memcpy() destination advances by sizeof(full struct) per slot via C
pointer arithmetic, not by the clamped len. When firmware sends short
TLVs, the second and later slots are written past the end of the
allocation.
The reader in ath11k_pull_mac_phy_cap_svc_ready_ext() also indexes the
buffer with full-struct
power: supply: isp1704_charger: cancel work on remove
In the Linux kernel, the following vulnerability has been resolved:
power: supply: isp1704_charger: cancel work on remove
The USB notifier and initial VBUS detection can schedule isp->work. The
remove path unregisters the notifier and power supply, but does not wait
for queued or running work before tearing down the power supply state.
Cancel the work after unregistering the notifier. Do this before
unregistering the power supply.
This issue was found by a static analysis tool.
power: supply: sc2731_charger: cancel work on remove
In the Linux kernel, the following vulnerability has been resolved:
power: supply: sc2731_charger: cancel work on remove
The USB notifier and initial charger detection can schedule info->work.
The remove path unregisters the notifier, but does not cancel queued or
running work before the devm-allocated driver data is released.
Set the platform drvdata used by remove, then cancel the work after
unregistering the notifier.
This issue was found by a static analysis tool.
bpf: Fix potential UAF in bpf_netns_link_update_prog
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix potential UAF in bpf_netns_link_update_prog
In bpf_netns_link_update_prog, the checks for old_prog and prog type
are currently performed locklessly before acquiring netns_bpf_mutex.
This creates a race condition that can lead to a UAF issue.
If two threads concurrently execute BPF_LINK_UPDATE on the same netns
link, the following execution path can trigger a UAF:
CPU0 CPU1
bpf_netns_link_update_prog
if (old_prog && old_prog != link->prog)
return -EPERM;
bpf_netns_link_upd
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix potential UAF when reading bpf link info
In bpf_link_show_fdinfo and bpf_link_get_info_by_fd, link->prog is
accessed without holding any locks. If the prog is concurrently replaced
via bpf_link_update, the old prog can be freed, leading to a potential
UAF issue.
Fix this by accessing link->prog under RCU protection to safely fetch
the pointer and guarantee its lifetime while reading its fields.
lib/test_hmm: fail dmirror_fault() when the mirrored mm is gone
In the Linux kernel, the following vulnerability has been resolved:
lib/test_hmm: fail dmirror_fault() when the mirrored mm is gone
dmirror_fault() is called from the dmirror_read() and dmirror_write()
retry loops after dmirror_do_read() or dmirror_do_write() finds a missing
device page table entry.
If the mirrored mm has already exited, mmget_not_zero() fails. The
current code returns 0 in that case, which tells the caller that faulting
succeeded even though no page was faulted and no device page table entry
was installed. The caller then retries the same address, hits -ENOENT
again, and can loop forever without making progress.
Return