In the Linux kernel, the following vulnerability has been resolved:
ALSA: pcm: wake linked drain waiters on unlink
snd_pcm_drain() on a linked stream parks an on-stack wait entry on the
drained peer's runtime->sleep, and after schedule_timeout() removes it
only if that peer is still found in the caller's group. If group
membership changes during the wait and the sleep ends by signal or
timeout (so autoremove_wake_function() does not run), finish_wait() is
skipped and snd_pcm_drain() returns with the entry still queued on that
stream's sleep list; a later wake_up() then walks a freed stack frame.
This is reachable by unlinking either the dr
In the Linux kernel, the following vulnerability has been resolved:
igc: remove napi_synchronize() in igc_down()
When an AF_XDP zero-copy application is killed abruptly, the XSK pool is
torn down but NAPI keeps polling. igc_clean_rx_irq_zc() then returns the
full budget on every poll, so napi_complete_done() never clears
NAPI_STATE_SCHED.
igc_down() calls napi_synchronize() before napi_disable(), so it spins
forever waiting for that bit and the interface never goes down. Drop the
napi_synchronize() and let napi_disable() do the job -- it sets
NAPI_STATE_DISABLE, which forces the stuck poll to complete. Reorder it
ahead of igc_set_queue_nap
ipvs: do not propagate one-packet flag to synced conns
In the Linux kernel, the following vulnerability has been resolved:
ipvs: do not propagate one-packet flag to synced conns
Synced connections can be created before their destination exists. When
the destination is later added, ip_vs_bind_dest() copies connection flags
from the destination into cp->flags.
IP_VS_CONN_F_ONE_PACKET connections are not synced. If a synced
connection inherits IP_VS_CONN_F_ONE_PACKET while it is already hashed,
expiry can treat it as a one-packet connection and skip unlinking the
existing conn_tab node, leaving stale hash nodes pointing at a freed
struct ip_vs_conn.
Drop IP_VS_CONN_F_ONE_PACKET from destination
In the Linux kernel, the following vulnerability has been resolved:
s390/dasd: Fix undersized format-check buffer
fmt_buffer_size in dasd_eckd_check_device_format() is declared as
int, even though one of the multiplicands, sizeof(struct eckd_count),
is a size_t. The expression
trkcount * rpt_max * sizeof(struct eckd_count)
is therefore correctly evaluated at 64-bit width, but the result is
silently truncated when it is stored back into the 32-bit
fmt_buffer_size variable. For a sufficiently large track range
(start_unit/stop_unit are caller-controlled) this truncation
yields a buffer size far smaller than the number of tracks actually
s390/zcrypt: Fix wrong domain value verification with EP11 CPRBs
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix wrong domain value verification with EP11 CPRBs
There is a wrong upper limit check for the domain value when an EP11
CPRB is processed for sending to a crypto card. This check is only
active on custom device nodes but may lead to access heap memory
behind perms->adm when an administrative CPRB is sent.
Add correct limit (AP_DOMAINS = 256) checking to fix this.
s390/zcrypt: Fix missing mem scrub at clear key import in cca_clr2cipherkey()
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix missing mem scrub at clear key import in cca_clr2cipherkey()
The helper function _ip_cprb_helper() uses internal buffer memory for
building and processing CPRBs. After use this buffer was never
scrubbed which could lead to leaving for example clear key material in
memory which could be exposed via tricky reuse of this same memory.
Extend the _ip_cprb_helper() function with another parameter 'scrub'
used to steer scrubbing of this buffer. So now the caller has the
opportunity to decide if scrubbing is needed or not.
Extend the clear key to secure key token
In the Linux kernel, the following vulnerability has been resolved:
can: j1939: transport: j1939_session_fresh_new(): initialize receive buffer
Zero the allocated buffer in j1939_session_fresh_new() to ensure it
contains no residual data.
While there is a potential performance impact if users allocate maximum
sized ETP buffers, most real-world use cases are not noticeably affected
since the maximum known buffer size is typically around 65K.
[mkl: add Message-ID]
can: softing: fw_parse(): validate firmware record spans
In the Linux kernel, the following vulnerability has been resolved:
can: softing: fw_parse(): validate firmware record spans
fw_parse() reads a fixed record header, a firmware-provided payload,
and a trailing checksum without knowing the end of the firmware blob. A
truncated record can therefore make those reads exceed the blob.
The same record also supplies addresses and lengths for writes into
DPRAM. The generic loader uses wrap-prone mixed signed arithmetic for its
bounds check, while the application loader does not bound the staging
copy at all.
Pass the firmware end to the parser and validate the full source record.
Use a signed wide
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use proper context for logging
The same as the rest of the code, get_ss_info_from_atombios() uses
calc_pll_cs->ctx->logger for logging. But calc_pll_cs->ctx is
initialized only later in calc_pll_max_vco_construct(). Therefore, any
output using DC_LOG_SYNC() leads to a NULL pointer deference in
get_ss_info_from_atombios().
According to Sashiko, the very same problem exists in
dce112_get_pix_clk_dividers() and dcn3_get_pix_clk_dividers() too.
To avoid accessing the NULL context, use clk_src->base.ctx->logger
everywhere. That context in base is initialized e
dmaengine: idxd: fix double free of wq, engine, and group structs
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: fix double free of wq, engine, and group structs
The release callbacks for wq, engine, and group devices
(idxd_conf_wq_release, idxd_conf_engine_release,
idxd_conf_group_release) each call kfree() on the enclosing struct.
The setup error paths and cleanup functions also call kfree()
explicitly after put_device(), producing a double free whenever
put_device() drops the reference count to zero and fires the release.
In the setup functions, device_initialize() is called before
device_add(), so the reference count is exactly 1 at the error sites.
put_device()
Media · CVSS 5.7EPSS 0,21%Sin corrección publicada
hwmon: (sht3x) Fix unaligned accesses
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (sht3x) Fix unaligned accesses
Sashiko reports:
In sht3x_update_client(), the 16-bit temperature and humidity values are
extracted from a stack-allocated byte array using be16_to_cpup(). The
pointers passed to this function are calculated as buf and buf + 3. Since
the difference between the two pointers is an odd number of bytes, at
least one of them is guaranteed to be at an unaligned offset.
This will trigger an alignment fault on strict-alignment architectures
such as ARMv5 or SPARC, resulting in a kernel panic.
Fix the problem by using get_unaligned_be16() ins
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
mtk_handle_irq_rx expects a struct mtk_eth * (matching the request_irq
cookie), but mtk_poll_controller incorrectly passed the net_device *.
Calling ndo_poll_controller with CONFIG_NET_POLL_CONTROLLER enabled
would then crash.
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
In the Linux kernel, the following vulnerability has been resolved:
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
mmio_trace_rw() and mmio_trace_mapping() retrieve mmio_trace_array into
tr and pass it to __trace_mmiotrace_rw() and __trace_mmiotrace_map().
If these functions are invoked while mmio_trace_array is NULL (e.g. before
initialization or after disabled), accessing tr->array_buffer.buffer will
result in a NULL pointer dereference crash.
Fix this by adding an explicit NULL check for tr at the beginning of
__trace_mmiotrace_rw() and __trace_mmiotrace_map().
mm: migrate_device: fix pte_pfn/pte_dirty called on non-present PTE
In the Linux kernel, the following vulnerability has been resolved:
mm: migrate_device: fix pte_pfn/pte_dirty called on non-present PTE
pte_pfn() and pte_dirty() have undefined behaviour when called on a
non-present PTE. In migrate_vma_collect_pmd(), these functions may be
invoked on non-present entries (e.g., device-private entries), leading
to potential crashes from pte_pfn() or incorrect dirty folio accounting
from pte_dirty(). Fix both by guarding with pte_present() checks.
KVM: s390: pci: Fix NULL dereference on AIBV allocation failure
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: pci: Fix NULL dereference on AIBV allocation failure
The airq_iv_create() can return NULL on failure, but the return value was
never checked. If it fails, zdev->aibv will be NULL and fail when
dereferenced in kvm_zpci_set_airq(). Add a NULL check and free the
previously allocated AISB bit and zdev->aisb on failure.
vxlan: re-fetch eth header after route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: re-fetch eth header after route_shortcircuit()
Before route_shortcircuit(), the eth header pointer is cached from eth_hdr(skb).
Inside route_shortcircuit(), pskb_may_pull() can be called, which may
reallocate skb->head.
In this case, returning to vxlan_xmit() leaves the cached eth pointer pointing to
freed memory, leading to a use-after-free when dereferencing eth->h_dest.
Fix this by updating eth = eth_hdr(skb) after calling route_shortcircuit().
i2c: amd-mp2: Unregister callback on adapter add failure
In the Linux kernel, the following vulnerability has been resolved:
i2c: amd-mp2: Unregister callback on adapter add failure
amd_mp2_register_cb() stores the platform I2C context in the MP2 PCI
driver's callback table before the adapter is registered. If
i2c_add_adapter() fails, probe returns and devres frees the context,
but the PCI driver can still dereference the stale pointer from its IRQ
and system-sleep callbacks.
Unregister the callback before returning the adapter registration error.
In the Linux kernel, the following vulnerability has been resolved:
s390/dasd: Fix potential NULL pointer dereference
dasd_release_space() checks the implementation of the is_ese()
discipline function before calling it to determine if a given device is
an ESE DASD.
The current usage of the logical AND operator will lead to a NULL
pointer dereference as the function is called even if the function
pointer is NULL.
Fix this by using the logical OR operator.
i2c: imx: Fix slave registration race and error handling
In the Linux kernel, the following vulnerability has been resolved:
i2c: imx: Fix slave registration race and error handling
In i2c_imx_reg_slave(), the slave pointer was assigned before
pm_runtime_resume_and_get(). If pm_runtime_resume_and_get() failed,
the error path returned without clearing i2c_imx->slave, leaving it
non-NULL and causing all subsequent registration attempts to fail
with -EBUSY.
Additionally, because this driver uses a shared IRQ, the interrupt
handler i2c_imx_isr() can execute concurrently and, after acquiring
slave_lock, dereference i2c_imx->slave. The previous fix attempt
added a lockless i2c_imx->slave = NULL on t
driver core: use READ_ONCE() for dev->driver in dev_has_sync_state()
In the Linux kernel, the following vulnerability has been resolved:
driver core: use READ_ONCE() for dev->driver in dev_has_sync_state()
dev_has_sync_state() reads dev->driver twice without holding
device_lock() -- once for the NULL check and once to dereference
->sync_state. Some callers only hold device_links_write_lock, which
doesn't prevent a concurrent unbind from clearing dev->driver via
device_unbind_cleanup().
Fix it by reading dev->driver exactly once with READ_ONCE(), pairing
with the WRITE_ONCE() in device_set_driver().