bpf: Skip detached progs in trampoline images that are still in use
In the Linux kernel, the following vulnerability has been resolved:
bpf: Skip detached progs in trampoline images that are still in use
bpf_tramp_image_put() makes sure a trampoline image is not freed while
a task may still be running in it, but nothing similar is done for the
progs called by that image. Detach drops the last prog reference right
away and the prog is freed after grace periods, on the basis that a
task still in the traced function skips the fexit progs once the nop at
ip_after_call is patched to a jump.
That leaves out a task sleeping in a sleepable prog that runs before
the detached one, which no grace period waits for:
net: bcmgenet: fix NULL dereference in set_coalesce before first open
In the Linux kernel, the following vulnerability has been resolved:
net: bcmgenet: fix NULL dereference in set_coalesce before first open
The Rx ring priv and index are only set in bcmgenet_init_rx_ring(),
which runs at open. Setting the Rx coalescing parameters on an interface
that was never opened, e.g. "ethtool -C eth0 rx-usecs 50", dereferences
a NULL ring->priv. The oops happens with RTNL held, so networking
stays stuck until a reboot:
Unable to handle kernel paging request at virtual address 0000000000002788
pc : bcmgenet_set_rx_coalesce.isra.0+0x10/0x88
lr : bcmgenet_set_coalesce+0xe8/0x180
Call trace:
bcmgenet_set_rx_coa
net: cap skb->queue_mapping when the tx queue is picked
In the Linux kernel, the following vulnerability has been resolved:
net: cap skb->queue_mapping when the tx queue is picked
skbedit can set skb->queue_mapping and raise the per-CPU skip_txqueue
flag so __dev_queue_xmit() honours the mapping. __dev_queue_xmit()
cleared the flag before sch_handle_egress() and only read it afterwards,
so the flag was not confined to the xmit that set it: a nested xmit
(mirred redirect or mirror, or a drop after skbedit) could set the flag
and the outer xmit would consume it for an skb that never went through
skbedit.
A forwarded packet still carries the ingress NIC's rx_queue + 1 in
skb->queue_mapping, so the
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_eth_soc: allocate dummy netdev sooner
The RX rings and the shared NAPI are carried by an internal "dummy" netdev
(eth->dummy_dev). mtk_probe() creates that dummy device, and adds the
shared tx/rx NAPI to it, only after the MAC netdevs have been registered.
That order has been there since the MT7623 support was added and leaves a
window in which the netdevs are visible to the network core before the
shared NAPI and the dummy device exist.
If anything brings the first netdev up during that window (e.g. netifd
opening the WAN link the instant the interface
In the Linux kernel, the following vulnerability has been resolved:
net: sparx5: skip ptp deinit if init was skipped
sparx5_ptp_init() returns early on the base lan969x variants
because they do not have the SPX5_FEATURE_PTP flag. It also returns early
when no "ptp" interrupt is described. Unbinding the driver then causes a
NULL pointer dereference when cleaning up uninitialized tx_skbs queues:
Unable to handle kernel NULL pointer dereference at virtual address
0000000000000008
Call trace:
skb_queue_purge_reason+0x68/0x120 (P)
sparx5_ptp_deinit+0x64/0xc0
mchp_sparx5_remove+0x38/0x70
platform_remove+0x20/0x30
ipvs: filter some flags received in the backup server
In the Linux kernel, the following vulnerability has been resolved:
ipvs: filter some flags received in the backup server
While the IPVS SYNC protocol is not secure by design
we can still protect the backup server from messages that
can wreak havoc.
This commit addresses problems from received connection flags
or their combinations. We now drop messages as follows:
1. the NO_CPORT+TEMPLATE combination allows lookups for normal
connections to hit template which can break in many ways.
While the master does not sync connections with NO_CPORT flag,
i.e. before they are established, we still accept NO_CPORT
without TEMPLATE.
2. ONE_PACKET: i
In the Linux kernel, the following vulnerability has been resolved:
netfilter: bpf: reject invalid NAT manipulation types
As bpf_ct_set_nat_info() is not validating the NAT manipulation type a
wrong value can be passed directly to nf_nat_setup_info(). This triggers
the WARN_ON() at nf_nat_setup_info() and if panic_on_warn isn't set,
then IPS_SRC_NAT_DONE is set without adding nat_bysource and conntrack
cleanup tries to unlink an uninitialized hlist node.
Fix this by checking that NAT manipulation type is correct before
calling nf_nat_setup_info(). In addition, if the WARN_ON is hit, return
NF_DROP instead of continuing with the processing
netfilter: flowtable: generalize pending status bit
In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: generalize pending status bit
Rename NF_FLOW_HW_PENDING to NF_FLOW_PENDING and use it to inhibit the
flowtable GC worker until pending hw offload work has been completed.
Apparently, nf_flow_offload_stats() can schedule work to retrieve stats
while the flow is being removed by GC.
And this bit can also be used in a follow up patch to disable GC until
the flow has been fully added in both directions.
Revert the reordering done in commit d644b23afe1e ("netfilter:
flowtable: publish HW_DEAD after worker is done") to prevent a race
between GC and hw off
In the Linux kernel, the following vulnerability has been resolved:
net/mlx5e: Fix AF_XDP TX timestamp teardown NULL dereference
During XSK TX queue teardown, outstanding descriptors are completed
without a CQE. If one requested a TX timestamp, the completion path
passes that NULL CQE to mlx5e_xsk_fill_timestamp(), which dereferences
it.
Return zero when no CQE is available, indicating that teardown did not
produce a TX timestamp.
perf: Fix race between perf_event_exit_task() and perf_pending_task()
In the Linux kernel, the following vulnerability has been resolved:
perf: Fix race between perf_event_exit_task() and perf_pending_task()
A race condition exists between perf_event_exit_task() and
perf_pending_task() during begin_new_exec().
During begin_new_exec(), perf_event_exit_task() may be called, and the
PF_EXITING flag is not set on task. So perf_sigtrap() continues to execute
and triggers WARN_ON_ONCE(event->ctx->task != current).
Since both task exit and exec paths can call perf_event_exit_task() which
sets ctx->task to TASK_TOMBSTONE, fix this by explicitly checking if
event->ctx->task equals TASK_TOMBSTONE and dropping the red
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix objects stuck in free_by_rcu_ttrace
do_call_rcu_ttrace() returns early when call_rcu_ttrace_in_progress is set
and leaves the objects in free_by_rcu_ttrace. __free_rcu() frees
waiting_for_gp_ttrace only and clears the flag. Hence the objects that
free_bulk() or __free_by_rcu() added while RCU tasks trace GP was in flight
stay in free_by_rcu_ttrace until free_bulk() or alloc_bulk() is called for
the same bpf_mem_cache again, which may never happen. The number of such
objects is not bounded.
Turn call_rcu_ttrace_in_progress into three states:
0 - idle
1 - __free_rcu
In the Linux kernel, the following vulnerability has been resolved:
futex: Fix private hash use-after-free on resize
poll_state_synchronize_rcu(mm->futex.phash.batches) is used by
futex_ref_drop() to check that a grace period has passed since the
current hash was published. This relies on batches referencing a grace
period which started after the hash pointer was assigned.
__futex_pivot_hash() sets mmph->batches before it replaces mmph->hash:
scoped_guard(rcu) {
mmph->batches = get_state_synchronize_rcu();
rcu_assign_pointer(mmph->hash, new);
}
The scoped_guard(rcu) doesn't stop new grace periods from star
bpf: Fix missing migration protection in __rhtab_map_lookup_and_delete_batch()
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix missing migration protection in __rhtab_map_lookup_and_delete_batch()
bpf_mem_cache_free_rcu() uses this_cpu_ptr() which requires migration
to be disabled. All callers of rhtab_delete_elem() disable migration
except __rhtab_map_lookup_and_delete_batch(), which calls it under
rcu_read_lock() only.
On CONFIG_PREEMPT_RCU, rcu_read_lock() does not disable preemption or
migration, so the task can migrate between CPUs during the delete loop,
causing this_cpu_ptr() to trigger:
BUG: using smp_processor_id() in preemptible [00000000] code
Fix by wrapping the delete loo
drm/amd/display: guard dc_sink dereferences in MST mode validation
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: guard dc_sink dereferences in MST mode validation
dm_dp_mst_is_port_support_mode() reads
aconnector->dc_sink->dsc_caps... for the DSC branch-throughput check,
and get_conv_frl_bw()'s HDMI-PCON FRL-bandwidth path reads
aconnector->dc_sink->edid_caps.max_frl_rate, both without a NULL
check. dc_sink is cleared asynchronously on MST unplug, and both
functions run from paths that the driver's own comments document as
racing that teardown: the connector probe worker's ->mode_valid
callback and a compositor's atomic check, neither of which holds the
MST manager lo
drm/amd/display: check dc_state_create_copy() for NULL in dm_suspend
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: check dc_state_create_copy() for NULL in dm_suspend
dc_state_create_copy() can return NULL on allocation failure.
dm_suspend() only conditionally skips dm_gpureset_toggle_interrupts()
and continues execution, returning success. dm_resume() then
dereferences the NULL cached_dc_state in link_enc_cfg_copy() and the
following dc_state->stream_count loop, crashing during GPU reset
recovery.
Return -ENOMEM immediately if the copy fails, so the caller aborts
suspend instead of leaving a NULL cached state for resume.
(cherry picked from commit 84b6d7932fdd285779
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/gfx6: fix firmware leak on teardown
The firmware requested in gfx_v6_0_init_microcode() is not released
when the GFX block is torn down, leaking the firmware resources.
Add gfx_v6_0_free_microcode() and call it from gfx_v6_0_sw_fini()
to release the PFP, ME, CE and RLC firmware.
(cherry picked from commit 386e81346f95ab0be5a82c5535de932e7a456924)
drm/mediatek: Add missing IS_ERR check for ovl_adaptor platform device
In the Linux kernel, the following vulnerability has been resolved:
drm/mediatek: Add missing IS_ERR check for ovl_adaptor platform device
platform_device_register_data() can fail and return an ERR_PTR, but the
return value is used without checking, leading to an invalid pointer
being stored in ddp_comp[].dev and passed to component_match_add() and
mtk_ddp_comp_init(), which could result in a kernel crash.
Add an IS_ERR() check to jump to the error handling path on failure.
In the Linux kernel, the following vulnerability has been resolved:
drm/mediatek: Fix ovl adaptor platform device leak
mtk_drm_probe() creates an OVL adaptor platform device with
platform_device_register_data() when the display pipeline requires the
OVL adaptor.
If a later initialization step fails, the probe error path releases
the DRM resources without unregistering the already registered OVL
adaptor device. The normal remove path likewise leaves the device
registered after the DRM driver is unbound.
Keep track of whether the OVL adaptor was successfully registered and
unregister it on probe failure. Also recover the platform device fro
drm/mediatek: Fix pdev reference leak in mtk_drm_bind()
In the Linux kernel, the following vulnerability has been resolved:
drm/mediatek: Fix pdev reference leak in mtk_drm_bind()
When the device is not the mmsys master, mtk_drm_bind() returns early
after taking a reference on the disp-mutex device via
of_find_device_by_node(), without ever dropping it: mtk_drm_unbind()
only puts mutex_dev for the master. Drop the reference before returning
from the non-master path.
drm/amdgpu: fix IP instance memory leak on kobject add failure
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix IP instance memory leak on kobject add failure
amdgpu_discovery_sysfs_ips() allocates ip_hw_instance with
kzalloc_flex() and initializes its embedded kobject before calling
kobject_add().
If kobject_add() fails, the return value is ignored and execution
continues without dropping the initial kobject reference. The failed
kobject is not retained in the kset list, so the normal sysfs teardown
path cannot find it. As a result, ip_hw_instance_release() is never
called and the ip_hw_instance allocation is leaked.
Call kobject_put() when kobject_add() fails so t