riscv: errata: select RISCV_ALTERNATIVE_EARLY for THEAD GHOSTWRITE
In the Linux kernel, the following vulnerability has been resolved:
riscv: errata: select RISCV_ALTERNATIVE_EARLY for THEAD GHOSTWRITE
errata_probe_ghostwrite() only marks the CPU as vulnerable when it is
called at the RISCV_ALTERNATIVES_EARLY_BOOT stage, and the mitigation
in ghostwrite_enable_mitigation() only takes effect if the vulnerable
state was recorded before the boot alternatives are patched.
The early boot stage is only executed when CONFIG_RISCV_ALTERNATIVE_EARLY
is enabled, which currently is only selected by ERRATA_THEAD_MAE. In a
kernel built with ERRATA_THEAD_GHOSTWRITE=y but ERRATA_THEAD_MAE=n, the
early alternatives never
riscv: futex: untag the user pointer before the atomic access
In the Linux kernel, the following vulnerability has been resolved:
riscv: futex: untag the user pointer before the atomic access
access_ok() checks untagged_addr(uaddr), but arch_futex_atomic_op_inuser()
and futex_atomic_cmpxchg_inatomic() hand the raw uaddr to the inline asm
amoswap/amoadd/.../lr.w+sc.w through the "+m" (*uaddr) operand. When the
tagged address ABI is enabled (CONFIG_RISCV_ISA_SUPM, prctl
PR_SET_TAGGED_ADDR_CTRL with PMLEN != 0), those two addresses differ: a
user pointer whose top PMLEN bits hold a tag passes access_ok() after
untagging, but the atomic is then performed on the still-tagged raw
address.
Supervisor-mode
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sock: Serialize dead-device detachment
Rebinding an HCI socket after its controller is unregistered can race
monitor control replay and crash the kernel. hci_sock_bind() clears
hci_pi(sk)->hdev and drops the device reference under only the socket
lock, whereas send_monitor_control_replay() holds hci_sk_list.lock for
reading.
Replay can observe a non-NULL hdev, then bind can clear it and drop the
last reference before create_monitor_ctrl_open() reads hdev->id. This
can cause a NULL pointer dereference if the pointer is reloaded, or a
use-after-free if the old
Bluetooth: hci_sync: Fix command skb lifetime during scan setup
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: Fix command skb lifetime during scan setup
During PA sync scan setup, hci_le_set_ext_scan_param_sync() gets the
address used for the PA_LINK lookup from hci_sent_cmd_data(). The
returned pointer borrows storage from sent_cmd or req_skb, without
holding a reference to either skb.
The scan worker runs on req_workqueue while hci_cmd_work() runs on the
separate device workqueue. After the scan worker loads sent_cmd, the
command worker can free and replace it before hci_sent_cmd_data()
dereferences the skb. The command payload can also be freed between
retu
Bluetooth: ISO: Reject concurrent BIS listener setup
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: Reject concurrent BIS listener setup
iso_sock_listen() drops the socket lock before calling iso_listen_bis()
to preserve the hdev->lock ordering. Two concurrent listen() calls on
the same broadcast socket can therefore both observe BT_BOUND. Caller
A can attach connA and release the locks, then caller B can acquire
them and attach connB before A publishes BT_LISTEN.
__iso_chan_add() checks whether connB already has a socket, but not
whether the socket already has a connection. The second attachment
overwrites iso_pi(sk)->conn, leaking the connA reference an
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: Serialize concurrent connect calls
iso_sock_connect() checks the socket state before taking the socket lock
and drops the lock again before setting up a connection. Two callers can
both pass the admission check while the socket is open or bound.
Caller A can copy its destination for route selection, then caller B can
replace the socket destination before A binds or connects the CIS. A
then uses B's destination with the route selected for its own request.
B can also proceed after A attaches a connection and sets BT_CONNECT.
For deferred BIS setup, B can bind
Bluetooth: SCO: serialise sco_conn lifetime against sco_recv_scodata()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: SCO: serialise sco_conn lifetime against sco_recv_scodata()
sco_recv_scodata() upgrades the weak hcon->sco_data back-pointer to a
strong reference under hdev->lock:
hci_dev_lock(hdev);
hcon = hci_conn_hash_lookup_handle(hdev, handle);
...
conn = sco_conn_hold_unless_zero(hcon->sco_data);
hci_dev_unlock(hdev);
but the pointer is cleared from the other side without that lock. When
the last sco_conn reference is dropped, sco_conn_free() ran
conn->hcon->sco_data = NULL;
with no hdev->lock held, so the RX path could read hcon->sco_data and
Bluetooth: RFCOMM: free the skb when the DLC has no owner
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: free the skb when the DLC has no owner
rfcomm_recv_data() hands the skb to d->data_ready() and returns 0
without freeing it, so the callback owns the skb from that point on.
The tty implementation frees it when the DLC has been detached from its
device:
static void rfcomm_dev_data_ready(struct rfcomm_dlc *dlc,
struct sk_buff *skb)
{
struct rfcomm_dev *dev = dlc->owner;
if (!dev) {
kfree_skb(skb);
return;
}
The socket implementation returns without
Bluetooth: RFCOMM: connect the session socket without rfcomm_mutex
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: connect the session socket without rfcomm_mutex
An RFCOMM connect() issued while a BR/EDR link is being authenticated
makes lockdep report a circular dependency, and the reported cycle is a
real AB/BA between rfcomm_mutex and hdev->lock.
rfcomm_security_cfm() is called from the HCI event path, which already
holds hdev->lock:
hci_rx_work()
hci_event_packet()
hci_cc_read_enc_key_size() [hdev->lock]
hci_encrypt_cfm() [hci_cb_list_lock]
rfcomm_security_cfm() [rfcomm_mutex]
while an RFCOMM connect() from userspace
Bluetooth: RFCOMM: Fix NULL tty_dev dereference in rfcomm_dev_shutdown
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix NULL tty_dev dereference in rfcomm_dev_shutdown
syzbot hit a NULL pointer dereference in rfcomm_dev_shutdown() when an
RFCOMM tty is closed.
rfcomm_dev_add() puts the new device on rfcomm_dev_list first and only
then registers the tty device and saves it in dev->tty_dev. If that
registration fails, dev->tty_dev is never set at all. The device can be
looked up in the meantime, so an open() of /dev/rfcommN gets through
rfcomm_tty_install() and attaches to it. When that tty is closed again,
rfcomm_dev_shutdown() uses dev->tty_dev without checking it:
drm/fb-helper: defer setup when fbdev_probe() fails, not just on -EAGAIN
In the Linux kernel, the following vulnerability has been resolved:
drm/fb-helper: defer setup when fbdev_probe() fails, not just on -EAGAIN
__drm_fb_helper_initial_config_and_unlock() calls
drm_client_modeset_probe() first, which already fills in each
mode_set->mode/num_connectors for every connected output, and only
afterwards calls drm_fb_helper_single_fb_probe() to create
fb_helper->fb and wire it into those mode_sets via
drm_setup_crtcs_fb().
If drm_fb_helper_single_fb_probe() fails with anything other than
-EAGAIN (e.g. dev->driver->fbdev_probe() itself fails), the function
bails out before drm_setup_crtcs_fb() runs and before settin
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gem: Prevent overstepping exec array boundary
It is possible for eb_relocate_parse_slow() to call kvfree() on
entries outside the original exec array during following
scenario inside eb_relocate_parse_slow():
1) eb_copy_relocations() allocates as many as eb->buffer_count
copies for exec entries;
2) eb_parse() appends up to two VMAs, right after incrementing
eb->buffer_count;
3) cleanup under "out" label uses this incremented buffer_count
to release relocation pointers from exec array via kvfree(),
not from VMA array.
To amend this problem, ensure that
drm/i915/gt: Unmask interrupts only when ACTIVE is true
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gt: Unmask interrupts only when ACTIVE is true
There is a small race window between intel_rps_boost() reading
a stale ACTIVE state and queuing rps->work, where ACTIVE may be
changed via asynchronous calls triggered by wakeref drop.
This means that rps_work() could be triggered after the GT has
been parked, so unmasking RPS PM interrupts would happen without
holding PM wakelock. This sequence of events may be observed
during live_rc6_ctx_wa() selftest:
1) live_rc6_ctx_wa()
-> intel_engine_pm_put()
-> wakeref_put()
ASYNC1) wakeref_put() callback
drm/imagination: Size page table preallocation by device address
In the Linux kernel, the following vulnerability has been resolved:
drm/imagination: Size page table preallocation by device address
Commit 0a8224058a58 ("drm/imagination: Fix page count for page table for
map() interface") passed the device address to
pvr_mmu_op_context_create(), but the preallocation is still sized from
device_addr + sgt_offset with an exclusive end. The offset into the
object's pages has no place in a device-virtual range, and the exclusive
end allocates one table too many when the range ends on a table
boundary.
Count the tables from device_addr and the inclusive end of the range.
The new calculation does not take pag
drm/panthor: validate userspace queue count against initialized firmware slot count
In the Linux kernel, the following vulnerability has been resolved:
drm/panthor: validate userspace queue count against initialized firmware slot count
In panthor_drv.c:panthor_ioctl_group_create(),
the queue count is validated against the hardcoded maximum:
if (!args->queues.count || args->queues.count > MAX_CS_PER_CSG)
return -EINVAL;
However, if the firmware reports fewer slots than MAX_CS_PER_CSG,
panthor_fw_init_ifaces() will only initialize that smaller number of
stream interfaces.
If unprivileged userspace requests more queues than the firmware reported
(but no more than MAX_CS_PER_CSG), cs_slot_prog_locked() fetches an
uniniti
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: validate pitch coming from userspace
Validate the pitch, alongside the box dimensions before trying
to copy data from the underlying surface. Fixes possible
out of bounds reads with cursor snooping.
In the Linux kernel, the following vulnerability has been resolved:
drm/xe/i2c: cancel the client work on remove
xe_i2c_notifier() stores the DesignWare adapter in i2c->adapter and
schedules i2c->work when the adapter is registered under the xe I2C
platform device, and xe_i2c_client_work() then instantiates the AMC
client device on that adapter.
xe_i2c_remove() tears down the AMC, unregisters the client devices,
the bus notifier and the adapter platform device, but it never drains
i2c->work. A work item that is still queued or running when the
adapter is unregistered dereferences i2c->adapter in
i2c_new_client_device() after platform_devic
drm/xe: Fix shrinker accounting double-subtraction on nested external pins
In the Linux kernel, the following vulnerability has been resolved:
drm/xe: Fix shrinker accounting double-subtraction on nested external pins
xe_bo_pin_external() and xe_bo_unpin_external() support nested pins,
since the underlying ttm_bo_pin()/ttm_bo_unpin() maintain a pin_count
refcount rather than a boolean. However, the shrinker accounting calls
xe_ttm_tt_account_subtract() and xe_ttm_tt_account_add() are invoked
unconditionally on every pin_external()/unpin_external() call, instead
of only on the transition into and out of the pinned state.
An external BO (dma-buf) can be pinned more than once while already
pinned, for example when i
drm/xe: Fix stale pinned_link entry when fb-pin performs the final unpin
In the Linux kernel, the following vulnerability has been resolved:
drm/xe: Fix stale pinned_link entry when fb-pin performs the final unpin
xe_bo_pin_external() and xe_bo_unpin_external() maintain the bo's
pinned_link list membership in xe->pinned.late.external, based on
whether the current call is the outermost pin or the final unpin.
However, the same external bo's pin_count can also be raised and
lowered directly by __xe_pin_fb_vma()/__xe_unpin_fb_vma(), which pin
the bo as a display scanout buffer without going through
xe_bo_pin_external()/xe_bo_unpin_external() at all, and have no
notion of, or ownership over, pinned_link.
If a bo is
In the Linux kernel, the following vulnerability has been resolved:
drm/bridge: th1520-dw-hdmi: Fix remove() callback
This driver stores struct th1520_hdmi * in platform drvdata, but
th1520_dw_hdmi_remove() was reading it back as struct dw_hdmi *
and passing it to dw_hdmi_remove(), so teardown runs on the wrong
pointer.
Retrieve struct th1520_hdmi * from platform drvdata and pass
hdmi->dw_hdmi to dw_hdmi_remove().