nvme-fc: unmap cmd_iu DMA on rsp_iu mapping failure in init_request
In the Linux kernel, the following vulnerability has been resolved:
nvme-fc: unmap cmd_iu DMA on rsp_iu mapping failure in init_request
__nvme_fc_init_request() maps cmd_iu and then rsp_iu for DMA. If the
rsp_iu mapping fails, the original code only recorded the error and fell
through: it left the already-mapped cmd_iu unmapped and still marked the
op as FCPOP_STATE_IDLE before returning. Since blk-mq does not call
.exit_request() when .init_request() fails, the cmd_iu mapping is leaked
for every op whose rsp_iu mapping fails.
Jump to an error path on rsp_iu mapping failure that unmaps cmd_iu and
returns the error without marking the op id
spi: davinci: switch to managed controller allocation
In the Linux kernel, the following vulnerability has been resolved:
spi: davinci: switch to managed controller allocation
The controller is allocated with the non-managed spi_alloc_host() while
the interrupt is registered with devm_request_threaded_irq(). During
removal, spi_bitbang_stop() only unregisters the controller; the
subsequent spi_controller_put() then frees the controller together with
its embedded davinci_spi devdata, which is the IRQ handler's dev_id.
The devm_request_threaded_irq() release action (free_irq()), which
drains the handler, does not run until after .remove() returns. A late
or latched interrupt can therefore reac
wifi: ath12k: fix overreads in ath12k_wmi_process_csa_switch_count_event()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: fix overreads in ath12k_wmi_process_csa_switch_count_event()
There is no policy entry for WMI_TAG_PDEV_CSA_SWITCH_COUNT_STATUS_EVENT, so
the parse infrastructure does not enforce a minimum length for the event
struct. Additionally, the num_vdevs field is taken directly from firmware
and used as a loop bound over the vdev_ids array without checking that it
fits within the TLV payload. Either condition can cause an out-of-bounds
read.
Add a TLV policy entry for WMI_TAG_PDEV_CSA_SWITCH_COUNT_STATUS_EVENT so
the parse infrastructure enforces a minimum length for
wifi: ath11k: fix overreads in ath11k_wmi_process_csa_switch_count_event()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix overreads in ath11k_wmi_process_csa_switch_count_event()
There is no policy entry for WMI_TAG_PDEV_CSA_SWITCH_COUNT_STATUS_EVENT, so
the parse infrastructure does not enforce a minimum length for the event
struct. Additionally, the num_vdevs field is taken directly from firmware
and used as a loop bound over the vdev_ids array without checking that it
fits within the TLV payload. Either condition can cause an out-of-bounds
read.
Add a TLV policy entry for WMI_TAG_PDEV_CSA_SWITCH_COUNT_STATUS_EVENT so
the parse infrastructure enforces a minimum length for
In the Linux kernel, the following vulnerability has been resolved:
platform/chrome: cros_ec_debugfs: Unregister panic notifier
cros_ec_debugfs_probe() registers notifier_panic with the EC panic
notifier chain. The remove path tears down debugfs and the console log,
but leaves the notifier registered. A later panic notification can call
back into the removed instance and queue work that accesses released
data.
Unregister the panic notifier before tearing down the debugfs and
console log state.
This issue was found by a static analysis tool.
wifi: rtlwifi: pci: fix error path in rtl_pci_probe()
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: pci: fix error path in rtl_pci_probe()
In the last error path in rtl_pci_probe(), the cleanup functions are
skipped due to a wrong goto label. Moreover, the successful call to
rtl_init_rfkill(), ieee80211_register_hw(), rtl_debug_add_one() have to
be reverted. Fix this issue by updating the labels and adding the
relevant cleanup functions to the last error path.
In the Linux kernel, the following vulnerability has been resolved:
md: remove REQ_NOWAIT support from raid1/10/456
REQ_NOWAIT support in md personalities that can block internally is
fundamentally incomplete. While reads can avoid some blocking paths,
write requests can still encounter cases where one mirror succeeds while
another returns -EAGAIN. At that point md cannot distinguish queue
pressure from a real device failure, so it can neither record a bad
block nor safely retry the write without REQ_NOWAIT, leaving mirrors
with divergent data.
Rather than continue advertising REQ_NOWAIT support for personalities
that cannot implement it c
In the Linux kernel, the following vulnerability has been resolved:
md: recheck spare changes before starting sync
remove_spares() and remove_and_add_spares() modify the array's rdev
configuration. These operations are only safe after the array has been
suspended.
md_start_sync() checks whether spare configuration changes are needed
before taking reconfig_mutex. However, the rdev state can change before
the mutex is acquired, so the initial check can become stale. In that
case, md_choose_sync_action() may remove or replace rdevs while normal
I/O is still accessing them.
The race can occur as follows:
raid10d Worker
wifi: ath12k: fix stride mismatch in mac_phy_caps_parse()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: fix stride mismatch in mac_phy_caps_parse()
Currently, in ath12k_wmi_mac_phy_caps_parse(), kzalloc() sizes the
mac_phy_caps buffer as tot_phy_id * len, where len is clamped to
min(firmware_len, sizeof(struct ath12k_wmi_mac_phy_caps_params)). The
subsequent memcpy() destination advances by sizeof(full struct) per slot
via C pointer arithmetic, not by the clamped len. When firmware sends
short TLVs, the second and later slots are written past the end of the
allocation.
The reader in ath12k_pull_mac_phy_cap_svc_ready_ext() also indexes the
buffer with full-struc
wifi: ath11k: fix stride mismatch in mac_phy_caps_parse()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix stride mismatch in mac_phy_caps_parse()
Currently, in ath11k_wmi_tlv_mac_phy_caps_parse(), kcalloc() sizes the
mac_phy_caps buffer as tot_phy_id * len, where len is clamped to
min(firmware_len, sizeof(struct wmi_mac_phy_capabilities)). The subsequent
memcpy() destination advances by sizeof(full struct) per slot via C
pointer arithmetic, not by the clamped len. When firmware sends short
TLVs, the second and later slots are written past the end of the
allocation.
The reader in ath11k_pull_mac_phy_cap_svc_ready_ext() also indexes the
buffer with full-struct
firmware: qcom: scm: Fix NULL dereference in IRQ handler before __scm is published
In the Linux kernel, the following vulnerability has been resolved:
firmware: qcom: scm: Fix NULL dereference in IRQ handler before __scm is published
In qcom_scm_probe(), devm_request_threaded_irq() is called before
smp_store_release(&__scm, scm). Two paths can dereference __scm before
it is published, both causing a NULL pointer dereference.
The IRQ handler receives scm via its data argument but passes only wq_ctx
to qcom_scm_waitq_wakeup() and qcom_scm_get_completion(), which then
dereference __scm directly. Thread scm through both functions so the IRQ
handler path never touches __scm.
Non-atomic SMC calls made during probe (e.g. from
power: supply: isp1704_charger: cancel work on remove
In the Linux kernel, the following vulnerability has been resolved:
power: supply: isp1704_charger: cancel work on remove
The USB notifier and initial VBUS detection can schedule isp->work. The
remove path unregisters the notifier and power supply, but does not wait
for queued or running work before tearing down the power supply state.
Cancel the work after unregistering the notifier. Do this before
unregistering the power supply.
This issue was found by a static analysis tool.
power: supply: sc2731_charger: cancel work on remove
In the Linux kernel, the following vulnerability has been resolved:
power: supply: sc2731_charger: cancel work on remove
The USB notifier and initial charger detection can schedule info->work.
The remove path unregisters the notifier, but does not cancel queued or
running work before the devm-allocated driver data is released.
Set the platform drvdata used by remove, then cancel the work after
unregistering the notifier.
This issue was found by a static analysis tool.
bpf: Fix potential UAF in bpf_netns_link_update_prog
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix potential UAF in bpf_netns_link_update_prog
In bpf_netns_link_update_prog, the checks for old_prog and prog type
are currently performed locklessly before acquiring netns_bpf_mutex.
This creates a race condition that can lead to a UAF issue.
If two threads concurrently execute BPF_LINK_UPDATE on the same netns
link, the following execution path can trigger a UAF:
CPU0 CPU1
bpf_netns_link_update_prog
if (old_prog && old_prog != link->prog)
return -EPERM;
bpf_netns_link_upd
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix potential UAF when reading bpf link info
In bpf_link_show_fdinfo and bpf_link_get_info_by_fd, link->prog is
accessed without holding any locks. If the prog is concurrently replaced
via bpf_link_update, the old prog can be freed, leading to a potential
UAF issue.
Fix this by accessing link->prog under RCU protection to safely fetch
the pointer and guarantee its lifetime while reading its fields.
lib/test_hmm: fail dmirror_fault() when the mirrored mm is gone
In the Linux kernel, the following vulnerability has been resolved:
lib/test_hmm: fail dmirror_fault() when the mirrored mm is gone
dmirror_fault() is called from the dmirror_read() and dmirror_write()
retry loops after dmirror_do_read() or dmirror_do_write() finds a missing
device page table entry.
If the mirrored mm has already exited, mmget_not_zero() fails. The
current code returns 0 in that case, which tells the caller that faulting
succeeded even though no page was faulted and no device page table entry
was installed. The caller then retries the same address, hits -ENOENT
again, and can loop forever without making progress.
Return
md/bitmap: resume array on backlog_store() error path
In the Linux kernel, the following vulnerability has been resolved:
md/bitmap: resume array on backlog_store() error path
backlog_store() suspends the array before checking whether a write-mostly
device exists. If no such device exists, the error path only unlocks
reconfig_mutex and leaves the array suspended, blocking subsequent I/O.
Use mddev_unlock_and_resume() to release both states.
md: scope memalloc_noio to allocation critical sections
In the Linux kernel, the following vulnerability has been resolved:
md: scope memalloc_noio to allocation critical sections
Storing a memalloc_noio_save() token in mddev->noio_flags lets one task
save the token and another task restore it. With concurrent suspend sysfs
writes, task A can enter PF_MEMALLOC_NOIO, return to userspace still in
that scope, and later task B can restore A's saved token.
Avoid tying the token lifetime to mddev. Keep mddev_suspend() and
mddev_resume() only responsible for array suspension, and enter
PF_MEMALLOC_NOIO only in the MD paths that allocate memory after the array
has been suspended. Restore the token befo
iommu/dma: Check atomic pool allocation result directly
In the Linux kernel, the following vulnerability has been resolved:
iommu/dma: Check atomic pool allocation result directly
The non-blocking, non-coherent allocation path uses dma_alloc_from_pool(),
which returns the allocated page and fills cpu_addr only on success.
Do not rely on cpu_addr to detect allocation failure in this path. Check
the returned page directly before using it for the IOMMU mapping.
swiotlb: Preserve allocation virtual address for dynamic pools
In the Linux kernel, the following vulnerability has been resolved:
swiotlb: Preserve allocation virtual address for dynamic pools
swiotlb_alloc_tlb() can allocate from the DMA atomic pool when a decrypted
pool is needed from atomic context. With CONFIG_DMA_DIRECT_REMAP, the
atomic pool is backed by remapped virtual addresses, which are not the same
as the direct-map addresses returned by phys_to_virt().
swiotlb_init_io_tlb_pool() currently reconstructs the pool virtual address
from the physical start address. For atomic-pool backed allocations this
stores the wrong address in pool->vaddr. Later, swiotlb_free_tlb() passes
that address to d