In the Linux kernel, the following vulnerability has been resolved:
sockmap: Fix use-after-free in udp_bpf_recvmsg()
syzbot reported use-after-free of struct sk_msg in sk_msg_recvmsg(). [0]
sk_msg_recvmsg() peeks sk_msg from psock->ingress_msg under a lock,
but its processing is lockless.
Thus, sk_msg_recvmsg() must be serialised by callers, otherwise
multiple threads could touch the same sk_msg.
For example, TCP uses lock_sock(), and AF_UNIX uses unix_sk(sk)->iolock.
Initially, udp_bpf_recvmsg() had used lock_sock(), but the cited
commit removed it.
Let's serialise sk_msg_recvmsg() with lock_sock() in udp_bpf_recvmsg().
Note that hol
bpf, sockmap: fix integer overflow in bpf_msg_pop_data() bounds check
In the Linux kernel, the following vulnerability has been resolved:
bpf, sockmap: fix integer overflow in bpf_msg_pop_data() bounds check
start and len are u32, so
u64 last = start + len;
evaluates start + len in 32-bit and wraps before storing it in last.
The bounds check
if (start >= offset + l || last > msg->sg.size)
return -EINVAL;
can then be passed with an out-of-range start/len, after which the pop
loop runs off the end of the scatterlist and sk_msg_shift_left() calls
put_page() on the empty msg->sg.end slot:
Oops: general protection fault, probably for non-canonical address
0xdffffc0000000001: 0000 [#1] SMP KASAN PTI
In the Linux kernel, the following vulnerability has been resolved:
tipc: fix UAF in tipc_l2_send_msg()
Syzbot reported a slab-use-after-free in ipvlan_hard_header() when
called from tipc_l2_send_msg().
The root cause is that tipc_disable_l2_media() calls synchronize_net()
while b->media_ptr is still valid. This allows concurrent RCU readers
to obtain the device pointer after synchronize_net() has finished.
The pointer is cleared later in bearer_disable(), but without any
subsequent synchronization, allowing the device to be freed while
still in use by readers.
Fix this by clearing b->media_ptr in tipc_disable_l2_media() before
calling sy
tcp: ipv6: clamp default adverting MSS to avoid GSO_BY_FRAGS (0xFFFF)
In the Linux kernel, the following vulnerability has been resolved:
tcp: ipv6: clamp default adverting MSS to avoid GSO_BY_FRAGS (0xFFFF)
When MTU is large, ip6_default_advmss() can return IPV6_MAXPLEN (65535).
This is interpreted by TCP as mss_clamp, allowing the MSS to reach 65535.
However, 0xFFFF is also used as a magic value GSO_BY_FRAGS in the kernel.
If a TCP packet with gso_size=0xFFFF is passed to skb_segment(), it will
be mistakenly treated as GSO_BY_FRAGS, leading to a NULL pointer
dereference because local TCP packets do not use frag_list.
Fix this by returning min(IPV6_MAXPLEN, GSO_BY_FRAGS - 1) (65534) from
ip6_default_advmss
Media · CVSS 4.8EPSS 0,21%Sin corrección publicada
RDMA/bnxt_re: Initialize dpi variable to zero
In the Linux kernel, the following vulnerability has been resolved:
RDMA/bnxt_re: Initialize dpi variable to zero
dpi is initialized only for BNXT_RE_ALLOC_WC_PAGE, but copied
for all the cases. So initialize the dpi to 0.
RDMA/bnxt_re: Free CQ toggle page after firmware teardown
In the Linux kernel, the following vulnerability has been resolved:
RDMA/bnxt_re: Free CQ toggle page after firmware teardown
Free the toggle page only after firmware teardown completes so that
an NQ interrupt arriving during bnxt_qplib_destroy_cq() won't write
the toggle value to an already-freed page. Move free_page() after
bnxt_qplib_destroy_cq.
RDMA/bnxt_re: Proper rollback if the ioremap fails
In the Linux kernel, the following vulnerability has been resolved:
RDMA/bnxt_re: Proper rollback if the ioremap fails
bnxt_qplib_alloc_dpi returns success even if ioremap fails.
Add the proper rollback when the ioremap fails and return
-ENOMEM status.
RDMA/bnxt_re: Avoid repeated requests to allocate WC pages
In the Linux kernel, the following vulnerability has been resolved:
RDMA/bnxt_re: Avoid repeated requests to allocate WC pages
Applications can request multiple WC pages for the same ucontext.
As of now, only 1 WC page per ucontext is supported. Add a lock to
avoid concurrent access and a check to fail repeated requests.
Also, if the mmap entry insert fails for the WC, free the Doorbell
page index mapped for the WC page.
RDMA/irdma: Replace waitqueue and flag with completion
In the Linux kernel, the following vulnerability has been resolved:
RDMA/irdma: Replace waitqueue and flag with completion
The driver previously used a waitqueue along with an explicit
request_done flag, but without proper barriers around request_done.
An earlier patch by Gui-Dong Han <[email protected]> attempted
to fix this by adding the missing memory barriers. Rather than
adding the barriers, this patch replaces the waitqueue+flag with
a completion, which is designed for this exact purpose.
net: serialize netif_running() check in enqueue_to_backlog()
In the Linux kernel, the following vulnerability has been resolved:
net: serialize netif_running() check in enqueue_to_backlog()
Syzbot reported a KASAN slab-use-after-free in fib_rules_lookup().
The root cause is a race condition where packets can escape the backlog
flushing during device unregistration (e.g., during netns exit).
Commit e9e4dd3267d0 ("net: do not process device backlog during unregistration")
introduced a lockless netif_running() check in enqueue_to_backlog() to
prevent queuing packets to an unregistering device.
However, this creates a TOCTOU race window.
A lockless transmitter (like veth_xmit) can pass
the check befo
ksmbd: fix use-after-free in same_client_has_lease()
In the Linux kernel, the following vulnerability has been resolved:
ksmbd: fix use-after-free in same_client_has_lease()
same_client_has_lease() returns an opinfo pointer from ci->m_op_list
after dropping ci->m_lock without taking a reference.
smb_grant_oplock() then dereferences that pointer in copy_lease() and
when checking breaking_cnt. A concurrent close can remove the old lease
from ci->m_op_list and drop the last reference before the caller uses
the returned pointer, leading to a use-after-free.
Take a reference when same_client_has_lease() selects an existing lease,
drop any previous match while scanning, and release the returned
r
net/9p: fix race condition on rdma->state in trans_rdma.c
In the Linux kernel, the following vulnerability has been resolved:
net/9p: fix race condition on rdma->state in trans_rdma.c
The rdma->state field is modified without holding req_lock in both
recv_done() and p9_cm_event_handler(), while rdma_request() accesses
the same field under the req_lock spinlock. This inconsistent locking
creates a race condition:
- recv_done() running in softirq completion context sets
rdma->state = P9_RDMA_FLUSHING without acquiring req_lock
- p9_cm_event_handler() modifies rdma->state at multiple points
(ADDR_RESOLVED, ROUTE_RESOLVED, ESTABLISHED, CLOSED) without
req_lock
- rdma_request() uses spin_lock_
staging: nvec: fix use-after-free in nvec_rx_completed()
In the Linux kernel, the following vulnerability has been resolved:
staging: nvec: fix use-after-free in nvec_rx_completed()
In nvec_rx_completed(), when an incomplete RX transfer is detected,
nvec_msg_free() is called to return the message back to the pool by
clearing its 'used' atomic flag. Immediately after this, the code
accesses nvec->rx->data[0] to check the message type.
Since nvec_msg_free() marks the pool slot as available via atomic_set(),
any concurrent or subsequent call to nvec_msg_alloc() could claim that
same slot and overwrite its data[] array. Reading nvec->rx->data[0] after
freeing the message is therefore a use-after-fre
soundwire: fix bug in sdw_add_element_group_count found by syzkaller
In the Linux kernel, the following vulnerability has been resolved:
soundwire: fix bug in sdw_add_element_group_count found by syzkaller
The original implementation caused an out-of-bounds memory access
in the sdw_add_element_group_count for-loop when i == num.
for (i = 0; i <= num; i++) {
if (rate == group->rates[i] && lane == group->lanes[i])
...
To fix this error, the function now checks for existing rate/lane
entries in the group(a function parameter) using a for-loop before
adding them.
No functional changes apart from this fix.
PCI: Check ROM header and data structure addr before accessing
In the Linux kernel, the following vulnerability has been resolved:
PCI: Check ROM header and data structure addr before accessing
We meet a crash when running stress-ng on x86_64 machine:
BUG: unable to handle page fault for address: ffa0000007f40000
RIP: 0010:pci_get_rom_size+0x52/0x220
Call Trace:
<TASK>
pci_map_rom+0x80/0x130
pci_read_rom+0x4b/0xe0
kernfs_file_read_iter+0x96/0x180
vfs_read+0x1b1/0x300
Our analysis reveals that the ROM space's start address is
0xffa0000007f30000, and size is 0x10000. Because of broken ROM space,
before calling readl(pds), the pds's value is 0xffa0000007f3ffff, which is
already p
In the Linux kernel, the following vulnerability has been resolved:
mailbox: mtk-adsp: fix UAF during device teardown
When the SOF audio driver fails to initialize (e.g. firmware boot
timeout), its devres unwind frees the snd_sof_dev object that the
mailbox client (mtk-adsp-ipc) reaches via chan->cl->rx_callback.
The mtk-adsp-mailbox shutdown clears the mailbox command registers
but leaves the IRQ line unmasked, so a late interrupt can still
queue a threaded handler after mbox_free_channel() had cleared
chan->cl, and mbox_chan_received_data() would then trigger UAF:
BUG: KASAN: slab-use-after-free in sof_ipc3_validate_fw_version
sof_i
coresight: platform: defer connection counter increment until alloc succeeds
In the Linux kernel, the following vulnerability has been resolved:
coresight: platform: defer connection counter increment until alloc succeeds
coresight_add_out_conn() increments nr_outconns before calling
devm_krealloc_array() and again before devm_kmalloc(). If either
allocation fails, the counter is already bumped while the corresponding
array entry is NULL or uninitialized garbage.
coresight_add_in_conn() has the same problem with nr_inconns and
devm_krealloc_array().
In both cases the probe returns -ENOMEM, which causes
coresight_get_platform_data() to call coresight_release_platform_data()
for cleanup. That function iterates up to
staging: most: video: avoid double free on video register failure
In the Linux kernel, the following vulnerability has been resolved:
staging: most: video: avoid double free on video register failure
comp_register_videodev() allocates a video_device with
video_device_alloc() and releases it if video_register_device() fails.
This can double free the video_device when __video_register_device()
reaches device_register() and that call fails:
video_register_device()
-> __video_register_device()
-> device_register() fails
-> put_device(&vdev->dev)
-> v4l2_device_release()
-> vdev->release(vdev)
-> video_device_release(vdev)
comp_registe
usb: host: max3421: Fix shift-out-of-bounds in max3421_hub_control()
In the Linux kernel, the following vulnerability has been resolved:
usb: host: max3421: Fix shift-out-of-bounds in max3421_hub_control()
The `max3421_hub_control()` function handles USB hub class requests
to the virtual root hub. In the `default` branches of both the
`ClearPortFeature` and `SetPortFeature` switch statements, it modifies
`max3421_hcd->port_status` by left shifting 1 by the request's `value`
parameter. However, it does not validate whether this shift will exceed
the width of `port_status`.
So if a malicious userspace task with access to the root hub via
/dev/bus/usb/.../001 issues a USBDEVFS_CONTROL ioctl with `wValue`
great
In the Linux kernel, the following vulnerability has been resolved:
iio: magnetometer: ak8975: fix potential kernel stack memory leak
Currently in the AK8975 driver there are four instances where potential
uninitialized kernel stack memory leaks can occur. If
i2c_smbus_read_i2c_block_data_or_emulated() returns a value less than
the size of the buffer, uninitialized bytes are retained in the buffer
and later the buffer is passed on to IIO buffers, potentially leaking
memory to userspace.
Fix this by adding checks whether the return value of the function is
equal to the size of the buffer and subsequently if the value is
lesser than zero to