ipv6: reject malicious packets in ipv6_gso_segment()
In the Linux kernel, the following vulnerability has been resolved:
ipv6: reject malicious packets in ipv6_gso_segment()
syzbot was able to craft a packet with very long IPv6 extension headers
leading to an overflow of skb->transport_header.
This 16bit field has a limited range.
Add skb_reset_transport_header_careful() helper and use it
from ipv6_gso_segment()
WARNING: CPU: 0 PID: 5871 at ./include/linux/skbuff.h:3032 skb_reset_transport_header include/linux/skbuff.h:3032 [inline]
WARNING: CPU: 0 PID: 5871 at ./include/linux/skbuff.h:3032 ipv6_gso_segment+0x15e2/0x21e0 net/ipv6/ip6_offload.c:151
Modules linked in:
CPU: 0 UID: 0 PID: 5871
In the Linux kernel, the following vulnerability has been resolved:
perf/core: Exit early on perf_mmap() fail
When perf_mmap() fails to allocate a buffer, it still invokes the
event_mapped() callback of the related event. On X86 this might increase
the perf_rdpmc_allowed reference counter. But nothing undoes this as
perf_mmap_close() is never called in this case, which causes another
reference count leak.
Return early on failure to prevent that.
In the Linux kernel, the following vulnerability has been resolved:
perf/core: Prevent VMA split of buffer mappings
The perf mmap code is careful about mmap()'ing the user page with the
ringbuffer and additionally the auxiliary buffer, when the event supports
it. Once the first mapping is established, subsequent mapping have to use
the same offset and the same size in both cases. The reference counting for
the ringbuffer and the auxiliary buffer depends on this being correct.
Though perf does not prevent that a related mapping is split via mmap(2),
munmap(2) or mremap(2). A split of a VMA results in perf_mmap_open() calls,
which take refer
HID: core: Harden s32ton() against conversion to 0 bits
In the Linux kernel, the following vulnerability has been resolved:
HID: core: Harden s32ton() against conversion to 0 bits
Testing by the syzbot fuzzer showed that the HID core gets a
shift-out-of-bounds exception when it tries to convert a 32-bit
quantity to a 0-bit quantity. Ideally this should never occur, but
there are buggy devices and some might have a report field with size
set to zero; we shouldn't reject the report or the device just because
of that.
Instead, harden the s32ton() routine so that it returns a reasonable
result instead of crashing when it is called with the number of bits
set to 0 -- the same as what snto32() does.
usb: gadget : fix use-after-free in composite_dev_cleanup()
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget : fix use-after-free in composite_dev_cleanup()
1. In func configfs_composite_bind() -> composite_os_desc_req_prepare():
if kmalloc fails, the pointer cdev->os_desc_req will be freed but not
set to NULL. Then it will return a failure to the upper-level function.
2. in func configfs_composite_bind() -> composite_dev_cleanup():
it will checks whether cdev->os_desc_req is NULL. If it is not NULL, it
will attempt to use it.This will lead to a use-after-free issue.
BUG: KASAN: use-after-free in composite_dev_cleanup+0xf4/0x2c0
Read of size 8 at addr 0000004827837a00
Media · CVSS 6.7EPSS 0,17%Sin corrección publicada
atm: clip: Fix memory leak of struct clip_vcc.
In the Linux kernel, the following vulnerability has been resolved:
atm: clip: Fix memory leak of struct clip_vcc.
ioctl(ATMARP_MKIP) allocates struct clip_vcc and set it to
vcc->user_back.
The code assumes that vcc_destroy_socket() passes NULL skb
to vcc->push() when the socket is close()d, and then clip_push()
frees clip_vcc.
However, ioctl(ATMARPD_CTRL) sets NULL to vcc->push() in
atm_init_atmarp(), resulting in memory leak.
Let's serialise two ioctl() by lock_sock() and check vcc->push()
in atm_init_atmarp() to prevent memleak.
net: appletalk: Fix device refcount leak in atrtr_create()
In the Linux kernel, the following vulnerability has been resolved:
net: appletalk: Fix device refcount leak in atrtr_create()
When updating an existing route entry in atrtr_create(), the old device
reference was not being released before assigning the new device,
leading to a device refcount leak. Fix this by calling dev_put() to
release the old device reference before holding the new one.
Media · CVSS 6.8EPSS 0,17%Sin corrección publicada
HID: quirks: Add quirk for 2 Chicony Electronics HP 5MP Cameras
In the Linux kernel, the following vulnerability has been resolved:
HID: quirks: Add quirk for 2 Chicony Electronics HP 5MP Cameras
The Chicony Electronics HP 5MP Cameras (USB ID 04F2:B824 & 04F2:B82C)
report a HID sensor interface that is not actually implemented.
Attempting to access this non-functional sensor via iio_info causes
system hangs as runtime PM tries to wake up an unresponsive sensor.
Add these 2 devices to the HID ignore list since the sensor interface is
non-functional by design and should not be exposed to userspace.
tracing: Add down_write(trace_event_sem) when adding trace event
In the Linux kernel, the following vulnerability has been resolved:
tracing: Add down_write(trace_event_sem) when adding trace event
When a module is loaded, it adds trace events defined by the module. It
may also need to modify the modules trace printk formats to replace enum
names with their values.
If two modules are loaded at the same time, the adding of the event to the
ftrace_events list can corrupt the walking of the list in the code that is
modifying the printk format strings and crash the kernel.
The addition of the event should take the trace_event_sem for write while
it adds the new event.
Also add a lockdep_assert_held() on t
dmaengine: nbpfaxi: Fix memory corruption in probe()
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: nbpfaxi: Fix memory corruption in probe()
The nbpf->chan[] array is allocated earlier in the nbpf_probe() function
and it has "num_channels" elements. These three loops iterate one
element farther than they should and corrupt memory.
The changes to the second loop are more involved. In this case, we're
copying data from the irqbuf[] array into the nbpf->chan[] array. If
the data in irqbuf[i] is the error IRQ then we skip it, so the iterators
are not in sync. I added a check to ensure that we don't go beyond the
end of the irqbuf[] array. I'm pretty sure thi
In the Linux kernel, the following vulnerability has been resolved:
comedi: pcl812: Fix bit shift out of bounds
When checking for a supported IRQ number, the following test is used:
if ((1 << it->options[1]) & board->irq_bits) {
However, `it->options[i]` is an unchecked `int` value from userspace, so
the shift amount could be negative or out of bounds. Fix the test by
requiring `it->options[1]` to be within bounds before proceeding with
the original test. Valid `it->options[1]` values that select the IRQ
will be in the range [1,15]. The value 0 explicitly disables the use of
interrupts.
In the Linux kernel, the following vulnerability has been resolved:
comedi: aio_iiro_16: Fix bit shift out of bounds
When checking for a supported IRQ number, the following test is used:
if ((1 << it->options[1]) & 0xdcfc) {
However, `it->options[i]` is an unchecked `int` value from userspace, so
the shift amount could be negative or out of bounds. Fix the test by
requiring `it->options[1]` to be within bounds before proceeding with
the original test. Valid `it->options[1]` values that select the IRQ
will be in the range [1,15]. The value 0 explicitly disables the use of
interrupts.
Media · CVSS 5.5EPSS 0,17%Sin corrección publicada
pinctrl: qcom: msm: mark certain pins as invalid for interrupts
In the Linux kernel, the following vulnerability has been resolved:
pinctrl: qcom: msm: mark certain pins as invalid for interrupts
On some platforms, the UFS-reset pin has no interrupt logic in TLMM but
is nevertheless registered as a GPIO in the kernel. This enables the
user-space to trigger a BUG() in the pinctrl-msm driver by running, for
example: `gpiomon -c 0 113` on RB2.
The exact culprit is requesting pins whose intr_detection_width setting
is not 1 or 2 for interrupts. This hits a BUG() in
msm_gpio_irq_set_type(). Potentially crashing the kernel due to an
invalid request from user-space is not optimal, so let's go through the
pins
Media · CVSS 5.7EPSS 0,17%Sin corrección publicada
wifi: zd1211rw: Fix potential NULL pointer dereference in zd_mac_tx_to_dev()
In the Linux kernel, the following vulnerability has been resolved:
wifi: zd1211rw: Fix potential NULL pointer dereference in zd_mac_tx_to_dev()
There is a potential NULL pointer dereference in zd_mac_tx_to_dev(). For
example, the following is possible:
T0 T1
zd_mac_tx_to_dev()
/* len == skb_queue_len(q) */
while (len > ZD_MAC_MAX_ACK_WAITERS) {
filter_ack()
spin_lock_irqsave(&q->lock, flags);
/* position == skb_queue_len(q) */
for (i=1; i<position; i++)
skb = __skb_dequeue(q)
if (mac->type == NL80211_IFTYPE_AP)
skb = __skb_dequeue(q);
spin_unl
clone_private_mnt(): make sure that caller has CAP_SYS_ADMIN in the right userns
In the Linux kernel, the following vulnerability has been resolved:
clone_private_mnt(): make sure that caller has CAP_SYS_ADMIN in the right userns
What we want is to verify there is that clone won't expose something
hidden by a mount we wouldn't be able to undo. "Wouldn't be able to undo"
may be a result of MNT_LOCKED on a child, but it may also come from
lacking admin rights in the userns of the namespace mount belongs to.
clone_private_mnt() checks the former, but not the latter.
There's a number of rather confusing CAP_SYS_ADMIN checks in various
userns during the mount, especially with the new mount API; they serve
different purpos
do_change_type(): refuse to operate on unmounted/not ours mounts
In the Linux kernel, the following vulnerability has been resolved:
do_change_type(): refuse to operate on unmounted/not ours mounts
Ensure that propagation settings can only be changed for mounts located
in the caller's mount namespace. This change aligns permission checking
with the rest of mount(2).
usb: gadget: configfs: Fix OOB read on empty string write
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: configfs: Fix OOB read on empty string write
When writing an empty string to either 'qw_sign' or 'landingPage'
sysfs attributes, the store functions attempt to access page[l - 1]
before validating that the length 'l' is greater than zero.
This patch fixes the vulnerability by adding a check at the beginning
of os_desc_qw_sign_store() and webusb_landingPage_store() to handle
the zero-length input case gracefully by returning immediately.
HID: core: ensure the allocated report buffer can contain the reserved report ID
In the Linux kernel, the following vulnerability has been resolved:
HID: core: ensure the allocated report buffer can contain the reserved report ID
When the report ID is not used, the low level transport drivers expect
the first byte to be 0. However, currently the allocated buffer not
account for that extra byte, meaning that instead of having 8 guaranteed
bytes for implement to be working, we only have 7.
In the Linux kernel, the following vulnerability has been resolved:
HID: core: do not bypass hid_hw_raw_request
hid_hw_raw_request() is actually useful to ensure the provided buffer
and length are valid. Directly calling in the low level transport driver
function bypassed those checks and allowed invalid paramto be used.