memstick: ms_block: reject a card that reports too many blocks
In the Linux kernel, the following vulnerability has been resolved:
memstick: ms_block: reject a card that reports too many blocks
msb_ftl_initialize() computes the zone count from the card block count
with no bound:
msb->zone_count = msb->block_count / MS_BLOCKS_IN_ZONE;
...
for (i = 0; i < msb->zone_count; i++)
msb->free_block_count[i] = MS_BLOCKS_IN_ZONE;
msb->block_count is a card value. msb_read_boot_blocks() reads
number_of_blocks from the card boot page and byte swaps it.
free_block_count is a fixed int[MS_MAX_ZONES]. MS_MAX_ZONES is 16, so the
valid indices are 0 to 15. The init loop above indexes it by zone_count.
msb_mark_b
ipvs: fix more places with wrong ipv6 transport offsets
In the Linux kernel, the following vulnerability has been resolved:
ipvs: fix more places with wrong ipv6 transport offsets
Sashiko reports for more incorrect IPv6 transport offsets.
The app code for TCP was assuming IPv4 network header
even after the ipvsh argument was provided. This can
cause problems with apps over IPv6. As for the only
official app in the kernel tree (FTP) this problem is
harmless because we use Netfilter to mangle the FTP
ports and we do not adjust the TCP seq numbers.
Also, provide correct offset of the ICMPV6 header in
ip_vs_out_icmp_v6() for correct checksum checks when
the IPv6 packet has extension headers.
reset: sunxi: fix memory region leak on ioremap failure
In the Linux kernel, the following vulnerability has been resolved:
reset: sunxi: fix memory region leak on ioremap failure
In sunxi_reset_init(), when ioremap() fails, the memory region obtained
via request_mem_region() is not released, leading to a resource leak.
Add an err_mem_region label to properly release the memory region before
freeing the data structure.
powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access()
In the Linux kernel, the following vulnerability has been resolved:
powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access()
spufs_mem_mmap_access() computes the local store offset as
address - vma->vm_start, but bounds-checks it against vma->vm_end
instead of the local store size. On 64-bit, offset is always well
below vma->vm_end, so the clamp never fires and len stays unbounded
against the LS_SIZE buffer returned by ctx->ops->get_ls().
Reject offsets at or beyond LS_SIZE and clamp len to the remaining
space, mirroring the guard already used by spufs_mem_mmap_fault() and
spufs_ps_fault().
wifi: mwifiex: fix permanently busy scans after multiple roam iterations
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: fix permanently busy scans after multiple roam iterations
In order for the firmware to sleep, the driver has to confirm a
previously received sleep request. The normal sequence of evets goes
like this:
EVENT_SLEEP -> adapter->ps_state = PS_STATE_PRE_SLEEP -> sleep-confirm
-> SLEEP -> EVENT_AWAKE -> AWAKE.
Before sending the sleep-confirm command, the driver must make sure
there are no commands either running or waiting to be completed.
mwifiex_ret_802_11_associate() unconditionally sets
ps_state = PS_STATE_AWAKE when it processes the association command
resp
mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout
lpc32xx_xmit_dma() waits for the DMA completion callback but ignores
wait_for_completion_timeout(). A timed out DMA transfer is therefore
unmapped and reported as successful to the NAND read/write path.
Return -ETIMEDOUT when the completion wait expires. Terminate the DMA
channel before unmapping the scatterlist so the timed out transfer cannot
continue to access the buffer after the error is returned.
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix potential deadlock in f2fs_balance_fs()
When the f2fs filesystem space is nearly exhausted, we encounter deadlock
issues as below:
INFO: task A:1890 blocked for more than 120 seconds.
Tainted: G O 6.12.41-g3fe07ddf05ab #1
"echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message.
task:A state:D stack:0 pid:1890 tgid:1626 ppid:1153 flags:0x00000204
Call trace:
__switch_to+0xf4/0x158
__schedule+0x27c/0x908
schedule+0x3c/0x118
io_schedule+0x44/0x68
folio_wait_bit_common+0x174/0x370
folio_wait_bit+0x20/0x38
folio
f2fs: fix potential deadlock in gc_merge path of f2fs_balance_fs()
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix potential deadlock in gc_merge path of f2fs_balance_fs()
When we mount device w/ gc_merge mount option, we may suffer below
potential deadlock:
Kworker GC trehad Truncator
- f2fs_write_cache_pages
- f2fs_write_single_data_page
- f2fs_do_write_data_page
- folio_start_writeback --- set writeback flag on folio
- f2fs_outplace_write_data
: cached folio in internal bio cache
- f2fs_balance_fs
- wake_up(gc_thread)
: wake up gc thread to run foreground GC
- finish_wait(fggc_wq)
: wait on the waitqueue --- wait on GC thread to finish the
usb: atm: ueagle-atm: wait for pre-firmware load in .disconnect()
In the Linux kernel, the following vulnerability has been resolved:
usb: atm: ueagle-atm: wait for pre-firmware load in .disconnect()
ueagle-atm uses the asynchronous request_firmware_nowait() in .probe(),
but does not wait for its completion, not even in .disconnect(); so, if the
device is unplugged meanwhile, its teardown runs concurrently with that.
Even though this inconsistency is worth addressing on its own, it has also
triggered several bug reports in syzbot over the years (some auto-closed)
where the firmware sysfs fallback mechanism (CONFIG_FW_LOADER_USER_HELPER)
creates a firmware subdirectory in the device directory during its r
ata: sata_dwc_460ex: fix infinite loop in NCQ tag completion bit-scanning
In the Linux kernel, the following vulnerability has been resolved:
ata: sata_dwc_460ex: fix infinite loop in NCQ tag completion bit-scanning
The hand-rolled bit-scanning loop in the NCQ completion path has an
infinite loop bug. When tag_mask has only high bits set (e.g.
0x80000000), the inner while loop left-shifts tag_mask until it
overflows to 0. At that point !(0 & 1) is always true and 0 <<= 1
stays 0, causing an infinite loop in hardirq context with a spinlock
held.
Replace the open-coded bit-scanning with __ffs() which correctly
finds the least significant set bit and is bounded by the width of
the argument.
drm/amdkfd: clamp v9 CRIU control stack checkpoint copy to BO size
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: clamp v9 CRIU control stack checkpoint copy to BO size
CRIU checkpoint copies the MQD control stack using cp_hqd_cntl_stack_size
from hardware without bounding it to the allocated BO region. If the HW
field is larger than the queue's control stack allocation, memcpy reads
past the BO into adjacent GTT memory and can leak kernel data to userspace.
Store the page-aligned control stack BO size in mqd_manager and clamp
checkpoint copies and reported checkpoint sizes to
min(cp_hqd_cntl_stack_size, mm->ctl_stack_size). Apply the same bound
for multi-XCC v9.4.3 checkp
net/sched: Handle TC_ACT_REDIRECT from qdisc filter chains
In the Linux kernel, the following vulnerability has been resolved:
net/sched: Handle TC_ACT_REDIRECT from qdisc filter chains
When a TC filter attached to a qdisc filter chain returns
TC_ACT_REDIRECT (ex: via an eBPF program calling bpf_redirect() or an
act_bpf action), the redirect was silently lost i.e no qdisc classify
function handled TC_ACT_REDIRECT, so the packet fell through the
switch and was enqueued normally instead of being redirected.
This has been broken since bpf_redirect() was introduced for TC in
commit 27b29f63058d ("bpf: add bpf_redirect() helper"). We got lucky
for a long time because bpf_net_context was a per-CPU varia
drm/amd/display: use kvzalloc to allocate struct dc
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use kvzalloc to allocate struct dc
struct dc has grown large over time (most of it the two inlined
dc_scratch_space copies) and now sits close to the page allocator's 4 MiB
contiguous allocation limit. Its actual size is not fixed by the source
alone, it also depends on the compiler and the .config, so it can easily
cross 4 MiB, e.g. with a newer GCC or a config change.
dc_create() allocates it with kzalloc(). Once struct dc exceeds 4 MiB the
request is rounded up to order 11 (8 MiB), which is above MAX_PAGE_ORDER,
so the page allocator warns and returns N
libceph: bound get_version reply decode to front len
In the Linux kernel, the following vulnerability has been resolved:
libceph: bound get_version reply decode to front len
handle_get_version_reply() uses msg->front_alloc_len as the decode
boundary for MON_GET_VERSION_REPLY. That is the size of the reused
reply buffer, not the number of bytes actually received.
A truncated reply can therefore pass ceph_decode_need() and decode the
second u64 from stale tail bytes left in the buffer by an earlier
message, causing an uninitialized memory read.
Use msg->front.iov_len as the receive-side decode boundary, matching
other libceph reply handlers and limiting decoding to the bytes that
were actual
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/gfx8: drop unecessary BUG_ON()
There's no need to crash the kernel for this case.
(cherry picked from commit 4d7c25208ca612b754f3bf39e9f16e725b828891)
KVM: x86/mmu: Fix use-after-free on vendor module reload
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86/mmu: Fix use-after-free on vendor module reload
mmu_destroy_caches() destroys pte_list_desc_cache and
mmu_page_header_cache, but leaves both pointers unchanged. The pointers
live in kvm.ko, and therefore survive when a vendor module is unloaded
while kvm.ko remains loaded.
If creation of pte_list_desc_cache fails during a subsequent vendor
module load, its assignment sets pte_list_desc_cache to NULL and the
error path calls mmu_destroy_caches(). mmu_page_header_cache still
points to the cache destroyed during the preceding vendor module
unload. Passing that sta
gpu: host1x: Fix use-after-free in host1x_bo_clear_cached_mappings
In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Fix use-after-free in host1x_bo_clear_cached_mappings
__host1x_bo_unpin() drops the last reference to the mapping and frees
it, so we can't dereference mapping afterwards. The cache itself
outlives the mapping, so use the cache local variable instead.
IB/mad: Drop unmatched RMPP responses before reassembly
In the Linux kernel, the following vulnerability has been resolved:
IB/mad: Drop unmatched RMPP responses before reassembly
Kernel-handled RMPP receive processing starts reassembly for active
DATA responses before the response is matched to an outstanding send.
The normal match happens later, after ib_process_rmpp_recv_wc() has
either assembled a complete message or consumed the segment.
That ordering lets an unsolicited response that routes to a kernel
RMPP agent by the high TID bits allocate or extend RMPP receive state
before the full TID and source address are checked against a real
request. A reordered burst can therefore reach the re
wifi: cfg80211: cancel sched scan results work on unregister
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: cancel sched scan results work on unregister
cfg80211_sched_scan_results() can queue rdev->sched_scan_res_wk from a
driver result notification while a scheduled scan request is present. The
work callback recovers the containing cfg80211_registered_device and then
locks the wiphy and walks the scheduled-scan request list.
wiphy_unregister() already makes the wiphy unreachable and drains rdev work
items before cfg80211_dev_free() can release the object, but it does not
drain sched_scan_res_wk. A queued or running result work item can therefore
cross the unreg
wifi: ipw2100: fix potential memory leak in ipw2100_pci_init_one()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ipw2100: fix potential memory leak in ipw2100_pci_init_one()
The memory allocated in the ipw2100_alloc_device() function is not freed
in some of the error paths in ipw2100_pci_init_one(). Fix that by
converting the direct return into a goto to the error path return.
The error path when pci_enable_device() fails cannot jump to fail, since
at this point priv is not set, so perform error handling inline.