Vulnerabilidades de linux · Página 146

UBUNTU-CVE-2024-50089

Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.

nilfs2: fix kernel bug due to missing clearing of buffer delay flag

In the Linux kernel, the following vulnerability has been resolved: nilfs2: fix kernel bug due to missing clearing of buffer delay flag Syzbot reported that after nilfs2 reads a corrupted file system image and degrades to read-only, the BUG_ON check for the buffer delay flag in submit_bh_wbc() may fail, causing a kernel bug. This is because the buffer delay flag is not cleared when clearing the buffer state flags to discard a page/folio or a buffer head. So, fix this. This became necessary when the use of nilfs2's own page clear routine was expanded. This state inconsistency does not occur if the buffer is written normally by log writing

KVM: nSVM: Ignore nCR3[4:0] when loading PDPTEs from memory

In the Linux kernel, the following vulnerability has been resolved: KVM: nSVM: Ignore nCR3[4:0] when loading PDPTEs from memory Ignore nCR3[4:0] when loading PDPTEs from memory for nested SVM, as bits 4:0 of CR3 are ignored when PAE paging is used, and thus VMRUN doesn't enforce 32-byte alignment of nCR3. In the absolute worst case scenario, failure to ignore bits 4:0 can result in an out-of-bounds read, e.g. if the target page is at the end of a memslot, and the VMM isn't using guard pages. Per the APM: The CR3 register points to the base address of the page-directory-pointer table. The page-directory-pointer table is aligned on a 3

RDMA/mad: Improve handling of timed out WRs of mad agent

In the Linux kernel, the following vulnerability has been resolved: RDMA/mad: Improve handling of timed out WRs of mad agent Current timeout handler of mad agent acquires/releases mad_agent_priv lock for every timed out WRs. This causes heavy locking contention when higher no. of WRs are to be handled inside timeout handler. This leads to softlockup with below trace in some use cases where rdma-cm path is used to establish connection between peer nodes Trace: ----- BUG: soft lockup - CPU#4 stuck for 26s! [kworker/u128:3:19767] CPU: 4 PID: 19767 Comm: kworker/u128:3 Kdump: loaded Tainted: G OE ------- --- 5.14.0-427.13.1.el9_4.x86

tty: n_gsm: Fix use-after-free in gsm_cleanup_mux

In the Linux kernel, the following vulnerability has been resolved: tty: n_gsm: Fix use-after-free in gsm_cleanup_mux BUG: KASAN: slab-use-after-free in gsm_cleanup_mux+0x77b/0x7b0 drivers/tty/n_gsm.c:3160 [n_gsm] Read of size 8 at addr ffff88815fe99c00 by task poc/3379 CPU: 0 UID: 0 PID: 3379 Comm: poc Not tainted 6.11.0+ #56 Hardware name: VMware, Inc. VMware Virtual Platform/440BX Desktop Reference Platform, BIOS 6.00 11/12/2020 Call Trace: <TASK> gsm_cleanup_mux+0x77b/0x7b0 drivers/tty/n_gsm.c:3160 [n_gsm] __pfx_gsm_cleanup_mux+0x10/0x10 drivers/tty/n_gsm.c:3124 [n_gsm] __pfx_sched_clock_cpu+0x10/0x10 kernel/sched/clock.c:389 updat

nfc: nci: fix possible NULL pointer dereference in send_acknowledge()

In the Linux kernel, the following vulnerability has been resolved: nfc: nci: fix possible NULL pointer dereference in send_acknowledge() Handle memory allocation failure from nci_skb_alloc() (calling alloc_skb()) to avoid possible NULL pointer dereference.

media: pci: cx23885: check cx23885_vdev_init() return

In the Linux kernel, the following vulnerability has been resolved: media: pci: cx23885: check cx23885_vdev_init() return cx23885_vdev_init() can return a NULL pointer, but that pointer is used in the next line without a check. Add a NULL pointer check and go to the error unwind if it is NULL.

UBUNTU-CVE-2022-48993

Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.

hwmon: (ibmpex) Fix possible UAF when ibmpex_register_bmc() fails

In the Linux kernel, the following vulnerability has been resolved: hwmon: (ibmpex) Fix possible UAF when ibmpex_register_bmc() fails Smatch report warning as follows: drivers/hwmon/ibmpex.c:509 ibmpex_register_bmc() warn: '&data->list' not removed from list If ibmpex_find_sensors() fails in ibmpex_register_bmc(), data will be freed, but data->list will not be removed from driver_data.bmc_data, then list traversal may cause UAF. Fix by removeing it from driver_data.bmc_data before free().

net: phy: fix null-ptr-deref while probe() failed

In the Linux kernel, the following vulnerability has been resolved: net: phy: fix null-ptr-deref while probe() failed I got a null-ptr-deref report as following when doing fault injection test: BUG: kernel NULL pointer dereference, address: 0000000000000058 Oops: 0000 [#1] PREEMPT SMP KASAN PTI CPU: 1 PID: 253 Comm: 507-spi-dm9051 Tainted: G B N 6.1.0-rc3+ Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.13.0-1ubuntu1.1 04/01/2014 RIP: 0010:klist_put+0x2d/0xd0 Call Trace: <TASK> klist_remove+0xf1/0x1c0 device_release_driver_internal+0x23e/0x2d0 bus_remove_device+0x1bd/0x240 device_del+0x357/0x770 phy_device

net/9p: Fix a potential socket leak in p9_socket_open

In the Linux kernel, the following vulnerability has been resolved: net/9p: Fix a potential socket leak in p9_socket_open Both p9_fd_create_tcp() and p9_fd_create_unix() will call p9_socket_open(). If the creation of p9_trans_fd fails, p9_fd_create_tcp() and p9_fd_create_unix() will return an error directly instead of releasing the cscoket, which will result in a socket leak. This patch adds sock_release() to fix the leak issue.

net: hsr: Fix potential use-after-free

In the Linux kernel, the following vulnerability has been resolved: net: hsr: Fix potential use-after-free The skb is delivered to netif_rx() which may free it, after calling this, dereferencing skb may trigger use-after-free.

hwmon: (coretemp) Check for null before removing sysfs attrs

In the Linux kernel, the following vulnerability has been resolved: hwmon: (coretemp) Check for null before removing sysfs attrs If coretemp_add_core() gets an error then pdata->core_data[indx] is already NULL and has been kfreed. Don't pass that to sysfs_remove_group() as that will crash in sysfs_remove_group(). [Shortened for readability] [91854.020159] sysfs: cannot create duplicate filename '/devices/platform/coretemp.0/hwmon/hwmon2/temp20_label' <cpu offline> [91855.126115] BUG: kernel NULL pointer dereference, address: 0000000000000188 [91855.165103] #PF: supervisor read access in kernel mode [91855.194506] #PF: error_code(0x0000) -

nilfs2: fix NULL pointer dereference in nilfs_palloc_commit_free_entry()

In the Linux kernel, the following vulnerability has been resolved: nilfs2: fix NULL pointer dereference in nilfs_palloc_commit_free_entry() Syzbot reported a null-ptr-deref bug: NILFS (loop0): segctord starting. Construction interval = 5 seconds, CP frequency < 30 seconds general protection fault, probably for non-canonical address 0xdffffc0000000002: 0000 [#1] PREEMPT SMP KASAN KASAN: null-ptr-deref in range [0x0000000000000010-0x0000000000000017] CPU: 1 PID: 3603 Comm: segctord Not tainted 6.1.0-rc2-syzkaller-00105-gb229b6ca5abb #0 Hardware name: Google Compute Engine/Google Compute Engine, BIOS Google 10/11/2022 RIP: 0010:nil

tracing: Free buffers when a used dynamic event is removed

In the Linux kernel, the following vulnerability has been resolved: tracing: Free buffers when a used dynamic event is removed After 65536 dynamic events have been added and removed, the "type" field of the event then uses the first type number that is available (not currently used by other events). A type number is the identifier of the binary blobs in the tracing ring buffer (known as events) to map them to logic that can parse the binary blob. The issue is that if a dynamic event (like a kprobe event) is traced and is in the ring buffer, and then that event is removed (because it is dynamic, which means it can be created and destroyed),

ALSA: seq: Fix function prototype mismatch in snd_seq_expand_var_event

In the Linux kernel, the following vulnerability has been resolved: ALSA: seq: Fix function prototype mismatch in snd_seq_expand_var_event With clang's kernel control flow integrity (kCFI, CONFIG_CFI_CLANG), indirect call targets are validated against the expected function pointer prototype to make sure the call target is valid to help mitigate ROP attacks. If they are not identical, there is a failure at run time, which manifests as either a kernel panic or thread getting killed. seq_copy_in_user() and seq_copy_in_kernel() did not have prototypes matching snd_seq_dump_func_t. Adjust this and remove the casts. There are not resulting binar

• Actualiza a 3.13.0-204.255

ASoC: soc-pcm: Add NULL check in BE reparenting

In the Linux kernel, the following vulnerability has been resolved: ASoC: soc-pcm: Add NULL check in BE reparenting Add NULL check in dpcm_be_reparent API, to handle kernel NULL pointer dereference error. The issue occurred in fuzzing test.

HID: core: fix shift-out-of-bounds in hid_report_raw_event

In the Linux kernel, the following vulnerability has been resolved: HID: core: fix shift-out-of-bounds in hid_report_raw_event Syzbot reported shift-out-of-bounds in hid_report_raw_event. microsoft 0003:045E:07DA.0001: hid_field_extract() called with n (128) > 32! (swapper/0) ====================================================================== UBSAN: shift-out-of-bounds in drivers/hid/hid-core.c:1323:20 shift exponent 127 is too large for 32-bit type 'int' CPU: 0 PID: 0 Comm: swapper/0 Not tainted 6.1.0-rc4-syzkaller-00159-g4bbf3422df78 #0 Hardware name: Google Compute Engine/Google Compute Engine, BIOS Google 10/26/2022 Call Trace: <IR

gpio: amd8111: Fix PCI device reference count leak

In the Linux kernel, the following vulnerability has been resolved: gpio: amd8111: Fix PCI device reference count leak for_each_pci_dev() is implemented by pci_get_device(). The comment of pci_get_device() says that it will increase the reference count for the returned pci_dev and also decrease the reference count for the input pci_dev @from if it is not NULL. If we break for_each_pci_dev() loop with pdev not NULL, we need to call pci_dev_put() to decrease the reference count. Add the missing pci_dev_put() after the 'out' label. Since pci_dev_put() can handle NULL input parameter, there is no problem for the 'Device not found' branch. For

xen-netfront: Fix NULL sring after live migration

In the Linux kernel, the following vulnerability has been resolved: xen-netfront: Fix NULL sring after live migration A NAPI is setup for each network sring to poll data to kernel The sring with source host is destroyed before live migration and new sring with target host is setup after live migration. The NAPI for the old sring is not deleted until setup new sring with target host after migration. With busy_poll/busy_read enabled, the NAPI can be polled before got deleted when resume VM. BUG: unable to handle kernel NULL pointer dereference at 0000000000000008 IP: xennet_poll+0xae/0xd20 PGD 0 P4D 0 Oops: 0000 [#1] SMP PTI Call Trace: fin