PatchFirst · Vulnerabilidades recientes
Vulnerabilidades publicadas para linux-azure en los últimos 30 días: 395. Incluidas en el catálogo KEV: 0.
Vulnerabilidades: 7058
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: btintel: validate DDC record lengths Parse DDC record lengths in unsigned storage so 0xFF does not wrap. Reject records smaller than the mandatory three-byte header, records exceeding U8_MAX, and records exceeding remaining firmware bytes before issuing Intel_Write_DDC. This issue was reported by Claude Mythos.
In the Linux kernel, the following vulnerability has been resolved: bpf: Fix overflow of jump offset in constant blinding bpf_jit_blind_insn() rewrites 'if rX op imm goto off' into: AX = imm ^ rnd AX ^= rnd if rX op AX goto off and subtracts 2 from off when the jump is backward. off is s16, so -32767 and -32768 wrap and the jump goes 32767 insns forward, past the end of the prog. The jump is inside the patch, hence bpf_adj_branches() doesn't check it. The kernel crashes when such prog runs with bpf_jit_harden=2. Return -ERANGE in such case. bpf_jit_blind_constants() fails the same way when blinding of other insns moves a jump out o
In the Linux kernel, the following vulnerability has been resolved: nvme: fix cdev lifetime Sashiko bot reported a potential problem for the cdev lifetime in [0] - the code there is heavily based on the NVMe code. Currently the NS head .open and .release file_operations methods take and put a reference to the nvme_ns_head to ensure that this structure does not disappear while we open fds for that cdev. In multipath mode, when we teardown the NS head, we call nvme_cdev_del() -> cdev_device_del() -> cdev_del(). However after cdev_del() returns, cdevs already open will remain and their fops will still be callable. As such, we can still refer
In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: fix slab-out-of-bounds read in ieee80211_monitor_select_queue() ieee80211_monitor_select_queue() validates the skb length using skb->len before dereferencing pointers into skb->data to access the 802.11 header. However, skb->len includes data in both the linear head buffer and non-linear fragments/pages. When AF_PACKET sends a packet large enough to become non-linear, the 802.11 header at skb->data + len_rthdr may extend past the linear head buffer even though skb->len appears sufficient. This leads to a slab-out-of-bounds read when accessing hdr->frame_con
In the Linux kernel, the following vulnerability has been resolved: net: systemport: Fix buffer overflow in bcm_sysport_get_stats() When running on SYSTEMPORT Lite, certain statistics are unsupported and skipped during bcm_sysport_get_stats(). The variable 'j' tracks the compacted index into the destination data buffer, whereas 'i' iterates over all elements in bcm_sysport_gstrings_stats. Because the buffer allocated by ethtool is sized only according to bcm_sysport_get_sset_count(), storing values at data[i] instead of data[j] writes past the allocated array bounds, leading to memory corruption. Fix this by writing to data[j] instead of
In the Linux kernel, the following vulnerability has been resolved: seg6: ensure packet data is writable before modifying SRH and IPv6 DA advance_nextseg() modifies the SRH Segments Left field and the IPv6 destination address without ensuring the packet data is writable. seg6_next_csid_advance_arg() has the same problem when it advances the NEXT-C-SID argument in the destination address. The skb may be cloned, for example by an AF_PACKET socket receiving on the ingress device. advance_nextseg() and seg6_next_csid_advance_arg() then write into the packet data shared with the clone. A read from that socket can return the modified packet inst
In the Linux kernel, the following vulnerability has been resolved: net: ethernet: mtk_eth_soc: allocate dummy netdev sooner The RX rings and the shared NAPI are carried by an internal "dummy" netdev (eth->dummy_dev). mtk_probe() creates that dummy device, and adds the shared tx/rx NAPI to it, only after the MAC netdevs have been registered. That order has been there since the MT7623 support was added and leaves a window in which the netdevs are visible to the network core before the shared NAPI and the dummy device exist. If anything brings the first netdev up during that window (e.g. netifd opening the WAN link the instant the interface
In the Linux kernel, the following vulnerability has been resolved: ipvs: filter some flags received in the backup server While the IPVS SYNC protocol is not secure by design we can still protect the backup server from messages that can wreak havoc. This commit addresses problems from received connection flags or their combinations. We now drop messages as follows: 1. the NO_CPORT+TEMPLATE combination allows lookups for normal connections to hit template which can break in many ways. While the master does not sync connections with NO_CPORT flag, i.e. before they are established, we still accept NO_CPORT without TEMPLATE. 2. ONE_PACKET: i
In the Linux kernel, the following vulnerability has been resolved: drm/amdgpu/gfx6: fix firmware leak on teardown The firmware requested in gfx_v6_0_init_microcode() is not released when the GFX block is torn down, leaking the firmware resources. Add gfx_v6_0_free_microcode() and call it from gfx_v6_0_sw_fini() to release the PFP, ME, CE and RLC firmware. (cherry picked from commit 386e81346f95ab0be5a82c5535de932e7a456924)
In the Linux kernel, the following vulnerability has been resolved: drm/amdgpu: fix ACP MFD device leak on init failure acp_hw_init() registers ACP child devices with mfd_add_devices() before attaching them to the ACP power domain and initializing the hardware. If attaching a child to the power domain fails, or if the ACP reset or clock enable operation times out, the failure path frees only the source cell, resource, and platform-data allocations. The child platform devices already registered by mfd_add_devices() remain registered and are never released. Remove the children from the power domain and unregister the MFD devices on failures
In the Linux kernel, the following vulnerability has been resolved: USB: serial: fix port tear down use-after-free Some drivers for multiport devices access port driver data from completion handlers of shared URBs submitted at attach() or first open() and stopped at disconnect() or last close(), respectively. A simple NULL check before accessing the driver data makes sure that a port state container has at least been allocated, but a completion handler can still race with port tear down. Reorder the disconnect handling so that ports are not deregistered (and their driver data freed) until after all ports have been hung up and the driver d
In the Linux kernel, the following vulnerability has been resolved: usb: storage: sierra_ms: reject short SWoC info transfers sierra_get_swoc_info() requests sizeof(struct swoc_info) (60) bytes from the device via usb_control_msg(), but its callers only treat a negative return value as failure. A device that answers the vendor-specific GetSwocInfo request with a short IN transfer is therefore accepted, leaving the tail of the freshly allocated (kmalloc(), non-zeroing) swoc_info buffer uninitialized. truinst_show() subsequently prints swocInfo->rev, swocInfo->LinuxSKU and swocInfo->LinuxVer from that buffer into the world-readable (0444) "t
In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_uac1_legacy: validate bRequest index in generic_{set,get}_cmd generic_set_cmd() and generic_get_cmd() use the low nibble of ctrl->bRequest as an index into con->data[]: u8 cmd = (ctrl->bRequest & 0x0F); /* 0 .. 15 */ ... con->data[cmd] = value; /* OOB when cmd >= 5 */ struct usb_audio_control (include/linux/usb/audio.h) declares data as a 5-element array, so indices 5 through 15 write (or read) up to 44 bytes past the end of the array on the heap. A malicious USB host can craft a class-specific SET_CUR / GET_CUR request with an arbi
In the Linux kernel, the following vulnerability has been resolved: USB: gadget: dummy-hcd: Fix wait for outstanding request completions The dummy-hcd driver emulates synchronize_irq() by waiting until its private callback_usage counter drops to 0 (with the private lock not held). This counter is incremented whenever a gadget driver callback occurs (which requires the private lock to be dropped), but not when a request completion handler is called. This is an oversight. Request completion is triggered by timer interrupts (emulating device IRQs in a real UDC), and the interrupt handlers are supposed to have completed when the synchronize_
In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_fs: Fix NULL pointer dereference in FUNCTIONFS_ENDPOINT_DESC When user space sets up FunctionFS with only full-speed descriptors (e.g., flags = FUNCTIONFS_HAS_FS_DESC) and the gadget operates at a higher speed (such as USB_SPEED_HIGH or USB_SPEED_SUPER), config_ep_by_speed() detects that the function lacks descriptors for the current speed, logs a warning, and falls back to full-speed descriptors. The endpoint is then successfully enabled via usb_ep_enable(), and epfile->ep becomes valid. However, when user space subsequently issues the FUNCTIONFS_ENDPOINT_D
In the Linux kernel, the following vulnerability has been resolved: usb: core: clear both ep_in and ep_out for non-ep0 control endpoints In usb_enable_endpoint(), non-zero control endpoints (where usb_endpoint_xfer_control(&ep->desc) is true) populate both dev->ep_in[epnum] and dev->ep_out[epnum] with the same struct usb_host_endpoint pointer. However, usb_disable_endpoint() only clears either dev->ep_out[epnum] or dev->ep_in[epnum] depending on the direction bit of epaddr when reset_hardware is set, leaving the opposite direction's array slot pointing to the disabled/freed endpoint. Clear both dev->ep_out[epnum] and dev->ep_in[epnum] whe
In the Linux kernel, the following vulnerability has been resolved: USB: dwc2: shut down wakeup timer before freeing HCD state dwc2_wakeup_detected() accesses the DWC2 host state and can rearm the wakeup timer. dwc2_hcd_free() currently deletes the timer only after freeing host-owned state, and timer_delete() does not synchronize a callback or prevent it from being queued again. Stop and shut down the timer in dwc2_hcd_release(), before the HCD resources are freed. This covers both the HCD initialization error path and normal HCD removal.
In the Linux kernel, the following vulnerability has been resolved: usb: typec: tipd: fix uninitialized typec_partner_desc in tps6598x_connect() tps6598x_connect() passes a stack-allocated typec_partner_desc to typec_register_partner() after initializing only usb_pd, accessory and identity. typec_register_partner() copies attach and deattach from the descriptor into the partner. With those fields left unset, garbage function pointers may be stored and later invoked from typec_partner_link_device() when a USB device is linked to the port. Uninitialized pd_revision and usb_capability similarly leak stack data through partner sysfs. Zero-ini
In the Linux kernel, the following vulnerability has been resolved: tty: vcc: zero-initialize control packet in vcc_send_ctl() The stack-allocated struct vio_vcc pkt was partially initialized, leaving the tag.stype_env field uninitialized before being sent via ldc_write(), potentially leaking kernel stack data to the LDC peer.
In the Linux kernel, the following vulnerability has been resolved: tty: vcc: hold port lock when clearing tty pointer in vcc_cleanup vcc_cleanup() sets port->tty to NULL without holding port->lock, racing with vcc_event() LDC callbacks that read port->tty under port->lock and then use tty->port. This can cause a use-after-free when the callback dereferences tty->port after cleanup has already destroyed and freed it.
Compara tu pila y las versiones instaladas con las bases actuales de vulnerabilidades.