staging: rtl8723bs: fix OOB read / stack overflow in rtw_get_wps_attr()
In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix OOB read / stack overflow in rtw_get_wps_attr()
rtw_get_wps_attr() walks WPS attributes inside a WPS IE taken from
a wireless management frame. For each candidate attribute it only
checks that the fixed 4-byte attribute header (2-byte ID + 2-byte
length) fits inside the IE:
if (attr_ptr + 4 > wps_ie + wps_ielen)
break;
u16 attr_id = get_unaligned_be16(attr_ptr);
u16 attr_data_len = get_unaligned_be16(attr_ptr + 2);
u16 attr_len = attr_data_len + 4;
attr_data_len (and therefore attr_len) is read directly from the
wire and is never checked agai
staging: rtl8723bs: fix OOB read in rtw_action_frame_parse()
In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix OOB read in rtw_action_frame_parse()
rtw_action_frame_parse() takes a frame_len parameter but never
actually checks it before indexing into the frame body:
const u8 *frame_body = frame + sizeof(struct ieee80211_hdr_3addr);
...
c = frame_body[0];
...
a = frame_body[1];
frame_body already points 24 bytes (sizeof(struct
ieee80211_hdr_3addr)) into frame, so reading frame_body[0] and
frame_body[1] requires frame_len >= 26. A management action frame
shorter than that (e.g. exactly 24 bytes, the minimum a malicious
peer can send) causes a 1-2 byte ou
staging: rtl8723bs: fix OOB read in rtw_restruct_wmm_ie()
In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix OOB read in rtw_restruct_wmm_ie()
rtw_restruct_wmm_ie() scans in_ie for a WMM IE with:
while (i < in_len) {
...
if (i + 5 < in_len && in_ie[i] == 0xDD && ...) {
...
break;
}
i += (in_ie[i + 1] + 2); /* to the next IE element */
}
When the "i + 5 < in_len" match check fails simply because i is
within 5 bytes of the end of the buffer (i.e. no WMM IE was found
near the tail of in_ie), execution falls through to
"i += (in_ie[i + 1] + 2)", which reads in_ie[i + 1]. If i == in_len
- 1 at that point, this is a 1-byte out-of-bounds read of
xhci: fix lost bounce buffers on TDs spanning several ring segments
In the Linux kernel, the following vulnerability has been resolved:
xhci: fix lost bounce buffers on TDs spanning several ring segments
When a TD reaches a link TRB with data that is not aligned to the
endpoint's wMaxPacketSize, xhci_align_td() stages the unalignable tail
through the bounce buffer of the ring segment holding that link TRB.
xhci_unmap_td_bounce_buffer() later unmaps it and, for IN transfers,
copies the data back into the URB's buffer.
The enqueue path records the segment that was bounced in td->bounce_seg,
under the assumption that a TD never spans more than two ring segments.
That assumption does not hold: a TD large enoug
tracing: Take trace_array reference when opening options file
In the Linux kernel, the following vulnerability has been resolved:
tracing: Take trace_array reference when opening options file
The options files do not take the trace_array reference for the options
they represent. This could cause a use-after-free kernel crash if one of
these files is opened by one task and another task removes the instance
that the option is for. Because it doesn't take a reference upon opening,
it will not stop the removal which will free the options descriptor that
is being used.
As the options are somewhat dynamic in their creation at boot up, each
file represents a flag in the trace_array. The trace_array has an a
scsi: target: iscsi: Reserve a terminator byte for the login payload
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: iscsi: Reserve a terminator byte for the login payload
iscsi_target_check_login_request() rejects a login PDU whose
DataSegmentLength exceeds MAX_KEY_VALUE_PAIRS, but the test is '>' and
login->req_buf is allocated with exactly MAX_KEY_VALUE_PAIRS
bytes. Since iscsit_get_login_rx() receives payload_length + padding
bytes, where
padding = ((-payload_length) & 3);
any payload_length from 8189 to 8192 fills the whole 8192 byte
buffer. The write stays in bounds, but no byte is left for a NUL
terminator.
The buffer is subsequently consumed as a C string. In the
scsi: pm8001: Use rollback index when freeing MSI-X vectors
In the Linux kernel, the following vulnerability has been resolved:
scsi: pm8001: Use rollback index when freeing MSI-X vectors
pm8001_request_msix() unwinds previously registered handlers with
free_irq() when request_irq() fails. The rollback loop uses the failing
index i for every iteration instead of the already registered vector
index j.
That passes the wrong IRQ/dev_id pair to free_irq() and leaves the
earlier handlers installed. Use j for both pci_irq_vector() and the
matching irq_vector entry in the rollback loop.
ftrace: Take trace_array reference before accessing its ftrace_ops
In the Linux kernel, the following vulnerability has been resolved:
ftrace: Take trace_array reference before accessing its ftrace_ops
The trace instance files set_ftrace_filter and set_ftrace_notrace was
updated to work with specific trace instances (trace_arrays). The issue is
that when these files are opened, there is a small race window where it
will use the ftrace_ops from the inode->private pointer to get a reference
to the trace_array and then take its reference. The problem is that the
ftrace_ops itself could be freed. If the rmdir on the instance happens at
the same time the set_ftrace_filter file is opened, the rmdir could have
al
HID: rmi: fix OOB access with undersized RMI reports
In the Linux kernel, the following vulnerability has been resolved:
HID: rmi: fix OOB access with undersized RMI reports
The hid-rmi driver sizes its writeReport/readReport buffer purely from
the report descriptor supplied by the device, with no minimum bound:
data->input_report_size = hid_report_len(input_report);
data->output_report_size = hid_report_len(output_report);
alloc_size = data->output_report_size + data->input_report_size;
data->writeReport = devm_kzalloc(&hdev->dev, alloc_size, GFP_KERNEL);
data->readReport = data->writeReport + data->output_report_size;
but then reads and writes fixed offsets into it. A device declar
HID: wacom: validate report length in wacom_intuos_pro2_bt_irq
In the Linux kernel, the following vulnerability has been resolved:
HID: wacom: validate report length in wacom_intuos_pro2_bt_irq
wacom_intuos_pro2_bt_irq() receives the wire report length in `len`
but never consults it before parsing. After the report-id gate it
unconditionally calls wacom_intuos_pro2_bt_pen() and then, selected by
features.type, a fixed chain of sub-parsers, none of which receive
`len`:
wacom_intuos_pro2_bt_pen(wacom);
if (type == INTUOSP2_BT || type == INTUOSP2S_BT) {
wacom_intuos_pro2_bt_touch(wacom);
wacom_intuos_pro2_bt_pad(wacom);
wacom_intuos_pro2_bt_battery(wacom);
} else {
wacom_intuos_gen3_bt_pad(wac
In the Linux kernel, the following vulnerability has been resolved:
dm: fix resume-vs-remove race
If the user issues the resume ioctl and the remove ioctl at the same
time, it may be possible that the device is resumed after it is suspended
in __dm_destroy. The result is that the table is destroyed without
calling the postsuspend method.
Dm targets expect that they may be removed only after the postsuspend
method method was called. If we break this expectation, it can cause
misbehavior in various targets. For example - in the dm-integrity target,
the reboot notifier is not unregistered, leading to use-after-free.
Fix this bug by refusing
In the Linux kernel, the following vulnerability has been resolved:
kprobes: Protect kprobe_blacklist with RCU
__within_kprobe_blacklist() traverses kprobe_blacklist without holding
kprobe_mutex. When a module is unloaded, kprobe_remove_area_blacklist()
removes blacklist entries and immediately frees them with kfree().
A concurrent call to within_kprobe_blacklist() can therefore dereference
freed memory.
Furthermore, within_kprobe_blacklist() can be called in atomic or
non-preemptible contexts where the sleeping kprobe_mutex cannot be taken.
Protect kprobe_blacklist with RCU. Use guard(rcu)() and
list_for_each_entry_rcu() for traversal, l
Media · CVSS 5.7EPSS 0,22%Sin corrección publicada
mm/huge_memory: transfer the pmd dirty bit to the folio on zap
In the Linux kernel, the following vulnerability has been resolved:
mm/huge_memory: transfer the pmd dirty bit to the folio on zap
zap_huge_pmd_folio() propagates the pmd young bit to the folio for the
file case, but not the dirty bit. The pte path does propagate it, in
zap_present_folio_ptes() and so does the pmd split path, in
__split_huge_pmd_locked().
For most file mappings the omission is harmless, because writing to a
shared file mapping goes through page_mkwrite(), which dirties the folio.
tmpfs is different: it has no page_mkwrite(), and vma_wants_writenotify()
is false for it, so a *read* fault on a MAP_SHARED tmpfs mapping inst
i2c: mux: Fix channel node leak on adapter add failure
In the Linux kernel, the following vulnerability has been resolved:
i2c: mux: Fix channel node leak on adapter add failure
i2c_mux_add_adapter() takes a reference to the Device Tree channel node
before registering the new adapter. If adapter registration fails, the
error path frees the private data without dropping that reference.
Release the channel node before freeing the private data.
ALSA: pcm: Fix race between non-atomic ops and trigger-start
In the Linux kernel, the following vulnerability has been resolved:
ALSA: pcm: Fix race between non-atomic ops and trigger-start
We protect the races of the concurrent state transitions between
atomic PCM ops, but the checks between the non-atomic ops (hw_params,
hw_free and prepare) and the atomic ops aren't perfect; there is a
check of the conflicting PCM state at the beginning of hw_params & co,
but the atomic PCM ops can be still issued during the non-atomic PCM
operations. An example such scenario is that a thread A re-issues the
PREPARE or HW_PARAMS for the already prepared stream, while another
thread B triggers the PCM start in the
In the Linux kernel, the following vulnerability has been resolved:
nvme: add missing SRCU grace period in error path
nvme_alloc_ns() error path at out_unlink_ns removes ns from the
namespace head siblings list with list_del_rcu(&ns->siblings) but
does not wait for SRCU readers before freeing the namespace struct.
Multipath code iterates the head->list under srcu_read_lock() in
nvme_find_path() and nvme_mpath_revalidate_paths(), so a concurrent
reader can still hold a reference to ns when kfree(ns) runs.
The normal removal path in nvme_ns_remove() correctly calls
synchronize_srcu(&ns->head->srcu) after list_del_rcu() to wait for
in-progres
nvdimm/btt: reject an arena whose nfree is below the lane count
In the Linux kernel, the following vulnerability has been resolved:
nvdimm/btt: reject an arena whose nfree is below the lane count
The BTT info block's nfree field, the number of reserve free blocks, is
read from the medium without validation. btt_freelist_init() and
btt_rtt_init() size the per-lane freelist[] and rtt[] arrays by nfree,
but the I/O path indexes them by the lane from nd_region_acquire_lane(),
which is bounded by nd_region->num_lanes (ND_MAX_LANES), not by nfree.
A crafted or foreign arena whose nfree is below the lane count makes
freelist[lane]/rtt[lane] run past the allocation: an out-of-bounds write.
btt.rst documents t
parisc: eisa: Fix infinite loop when parsing invalid IRQ value
In the Linux kernel, the following vulnerability has been resolved:
parisc: eisa: Fix infinite loop when parsing invalid IRQ value
When an invalid value is passed via the "eisa_irq_edge=" kernel
command line parameter (e.g. "eisa_irq_edge=16,5"), eisa_irq_setup()
prints an error message and continues without advancing the current
position. As a result the same invalid value is parsed again and
again, causing an infinite loop while the kernel boots.
Advance to the next comma-separated entry, or stop parsing when there
is no next entry, before continuing so that the remaining entries are
processed normally.
mtd: mtdoops: free page bitmap when the backing MTD is removed
In the Linux kernel, the following vulnerability has been resolved:
mtd: mtdoops: free page bitmap when the backing MTD is removed
mtdoops_notify_add() allocates oops_page_used when the configured MTD
device is registered. mtdoops_notify_remove() detaches from that device
but leaves the bitmap allocated. If the same MTD device is later
registered again, the add path allocates a new bitmap and overwrites the
old pointer, leaking one vmalloc allocation per remove/add cycle.
This is only visible when the backing MTD device can disappear and be
registered again while mtdoops remains loaded, so the usual static MTD
case does not expose it.
F
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: validate ONFI extended parameter page sections
nand_flash_detect_ext_param_page() allocates the length declared by the
ONFI parameter page, then treats the data as a fixed header followed by
variable-length sections. It reads that header and advances over sections
without first proving that the fixed page and each current section fit in
the allocation.
Reject pages shorter than the fixed header, track the remaining variable
area while walking sections, and require the ECC section to contain every
field read from struct onfi_ext_ecc_info. Use device-scoped dia