wifi: mac80211: drain PS delivery work during station teardown
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: drain PS delivery work during station teardown
Removing an AP or mesh station can notify the driver and wake TXQs after
the station has already been removed from the driver, and can update
num_sta_ps and the power-save queues after station cleanup has purged
them.
sta_deliver_ps_frames() tests sta->dead only before it starts delivery. A
worker that passes that test can be delayed while teardown sets sta->dead
and removes the station from the driver; when it resumes it still runs the
full delivery.
The existing cancel_work_sync() sits near the end of
__clea
wifi: mac80211: account proxy paths against the mesh path limit
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: account proxy paths against the mesh path limit
Proxy-path churn can drive the interface path counter negative and let
later mesh path additions exceed MESH_MAX_MPATHS.
mesh_path_free_rcu() decrements the interface mpaths counter for entries
from both the mesh and proxy path tables, but mpp_path_add() never
reserves a slot in that counter. Removing or expiring a proxy path
therefore returns a slot that was never charged.
mesh_path_add() uses the same counter to enforce MESH_MAX_MPATHS, so once
it falls below the number of installed paths the limit no longe
wifi: mac80211: minstrel_ht: validate fixed rate index
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: minstrel_ht: validate fixed rate index
The fixed_rate_idx debugfs file is a plain u32 attribute, so any value
can be written to it. minstrel_ht_update_stats() then copies the value
into mi->max_tp_rate[] and mi->max_prob_rate, and
minstrel_ht_set_rate() uses MI_RATE_GROUP()/MI_RATE_IDX() to index
minstrel_mcs_groups[] (42 entries) and mi->groups[].rates[] (10 entries)
with it.
Writing e.g. 65535 selects group 4095 and rate index 15, far outside
both arrays. The out-of-bounds entries are dereferenced and updated as
struct minstrel_rate_stats (retry counts,
wifi: mac80211: release mesh path quota on failed additions
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: release mesh path quota on failed additions
Repeated failed or duplicate mesh path additions can exhaust
MESH_MAX_MPATHS while the path table holds fewer paths, which stops new
paths to reachable destinations from being created.
mesh_path_add() reserves a slot before allocating and inserting a path.
If allocation fails, the function returns without releasing the slot. If
the rhashtable insertion reports an error or an existing destination, the
function discards its candidate but retains the reservation. No new path
is installed in any of these cases.
Relea
Media · CVSS 6.7EPSS 0,17%Sin corrección publicada
wifi: mac80211: handle empty FILS association request payload
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: handle empty FILS association request payload
fils_encrypt_assoc_req() accepts a (Re)Association Request frame whose
last element is the FILS Session element. crypt_len is then zero and
aes_siv_encrypt() is called with an empty plaintext.
kmemdup() returns ZERO_SIZE_PTR for a zero-length allocation, so the
unconditional sg_init_one() puts an invalid page into the scatterlist.
With CONFIG_DEBUG_SG this triggers a kernel BUG in sg_set_buf();
without the debug check the bogus page is handed to the crypto backend.
AES-SIV is defined for empty plaintext and th
USB: serial: fix dynamic id driver deregistration race
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix dynamic id driver deregistration race
Only free the dynamic ids after having deregistered the driver and
removed the "new_id" attribute to avoid leaking any id added by a racing
write to the attribute.
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix driver deregistration order
USB serial driver modules register one driver for the USB bus and one or
more drivers for the ports on the USB serial bus.
When unloading a driver module, the USB driver must be deregistered
before the USB serial bus drivers so that I/O is stopped before
unbinding the ports to avoid use-after-free in completion handlers
accessing port data.
Note that the "new_id" attributes must first be removed to prevent new
ids from being added and triggering a probe of the USB driver after it
has been deregistered.
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix ioctl hangup race
The tty ioctls can race with hangup and end up calling into a tty driver
for a device that is already gone or powered down.
Serialise the callbacks using the tty port mutex and add the missing
checks to make sure the port has not been hung up before accessing port
driver data or hardware.
This specifically avoids dereferencing a NULL-pointer if a device is
disconnected during lengthy break signalling.
Note that TIOCGICOUNT and TIOCMIWAIT do not access port driver data or
hardware and are therefore not affected by the race.
Media · CVSS 4.3EPSS 0,17%Sin corrección publicada
thunderbolt: Fix KASAN reported use-after-free when request is canceled
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Fix KASAN reported use-after-free when request is canceled
Alan reported that when doing stress testing sometimes KASAN notices
use-after-free during control channel operation (stripped down keeping
the relevant parts):
BUG: KASAN: slab-use-after-free in tb_cfg_request_sync+0x240/0x250 [thunderbolt]
Read of size 24 at addr ffff88811067f290 by task kworker/u40:2/1760
<TASK>
tb_cfg_request_sync+0x240/0x250 [thunderbolt]
tb_cfg_read_raw+0x367/0x510 [thunderbolt]
tb_cfg_read+0xec/0x240 [thunderbolt]
tb_port_get_link_generation+0x258/0x420 [thunderbolt]
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Reject oversized XDomain properties responses
tb_xdp_properties_request() allocates room for 45 data dwords in its
252-byte response buffer. The XDomain length field is six bits wide,
however, and a malicious peer can set it to 63. After the fixed response
fields are subtracted, the driver treats this as 48 data dwords.
Commit 322e93448d90 ("thunderbolt: Clamp XDomain response data copy to
allocation size") only bounds the copy against data_len. If data_len is
at least 48, memcpy() reads 192 bytes from the 180-byte res->data array,
causing a 12-byte heap ou
Media · CVSS 5.8EPSS 0,17%Sin corrección publicada
smb: client: split cifsFileInfo bitfields to avoid shared-byte RMW races
In the Linux kernel, the following vulnerability has been resolved:
smb: client: split cifsFileInfo bitfields to avoid shared-byte RMW races
The invalidHandle, swapfile, oplock_break_cancelled, offload,
and status_file_deleted fields are stored in the same bitfield byte
in struct cifsFileInfo, but are updated in different code paths that
may run simultaneously, and are protected by different locks. Since
bitfield assignments generate byte-level read-modify-write operations,
a modification to one flag can overwrite a concurrent modification to
another flag.
To avoid these races, convert these flags from a bitfield to
separate bool fields.
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: kxcjk-1013: reject duplicate event disable
The IIO core does not filter duplicate writes to the event enable
attribute. kxcjk1013_write_event_config() already ignores repeated
enable requests, but a repeated disable request still calls
kxcjk1013_set_power_state(data, false), dropping a runtime PM reference
that was not acquired for this request. This can underflow the runtime
PM usage count and trigger a "Runtime PM usage count underflow" warning.
Return early when the requested state already matches ev_enable_state.
iio: adc: sun4i-gpadc-iio: clean up on thermal zone registration failure
In the Linux kernel, the following vulnerability has been resolved:
iio: adc: sun4i-gpadc-iio: clean up on thermal zone registration failure
If devm_thermal_of_zone_register() fails, probe returns without
unregistering the IIO map array or disabling runtime PM.
Jump to err_map to release them.
iio: light: gp2ap020a00f: drain irq_work after free_irq
In the Linux kernel, the following vulnerability has been resolved:
iio: light: gp2ap020a00f: drain irq_work after free_irq
The threaded IRQ handler queues data->work through irq_work_queue() so
the trigger is polled from a per-CPU context. free_irq() does not flush
an irq_work the handler already queued, so after gp2ap020a00f_remove()
returns that work may still run and call iio_trigger_poll() on data->trig,
which the devm cleanup has already freed, causing a use-after-free.
Add irq_work_sync(&data->work) after free_irq() in remove() and in the
probe error path, mirroring commit 78601726d4a5 ("iio: trigger: sysfs:
fix use-after-free on r
iio: proximity: pulsedlight: fix iio_device left registered on PM setup failure
In the Linux kernel, the following vulnerability has been resolved:
iio: proximity: pulsedlight: fix iio_device left registered on PM setup failure
pm_runtime_set_active() failing in probe() jumps to error_unreg_buffer,
which only calls iio_triggered_buffer_cleanup() -- it does not undo the
iio_device_register() that already succeeded a few lines above. probe()
then returns the error, the devm-managed indio_dev is freed, but the
iio core still has it registered: the sysfs/chardev nodes stay live and
point at freed memory.
Add an error_unreg_dev label that unregisters the iio device before
falling through to the existing buffer cleanup, mir
KVM: s390: Add missing srcu in kvm_s390_set_irq_state()
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Add missing srcu in kvm_s390_set_irq_state()
Like kvm_s390_inject_vcpu(), kvm_s390_set_irq_state() also needs the
kvm->srcu or the slots lock when performing the Store status operation.
Fix by taking kvm->srcu in kvm_s390_set_irq_state().
squashfs: Add dictionary size range check to prevent shift-out-of-bounds
In the Linux kernel, the following vulnerability has been resolved:
squashfs: Add dictionary size range check to prevent shift-out-of-bounds
When an abnormal SquashFS image (COMP_OPTS flag is 1 but dictionary size
is 0) is mounted, and performs shift operations using dictionarysize, the
shift exponent is -1, causing a shift-out-of-bounds.
Detail as below:
squashfs_comp_opts(msblk, buffer, length)
squashfs_xz_comp_opts()
if (comp_opts)
n = ffs(opts->dict_size) - 1;<----opts->dict_size=0, n=-1
if (opts->dict_size != (1 << n) && opts->dict_size !=
(1 << n) + (1 << (n + 1))) <----shift-out-of-bounds
Fix it by adding a di
In the Linux kernel, the following vulnerability has been resolved:
scsi: sd_zbc: Reject disks with too many zones
sd_zbc_read_zones() computes the number of zones with 64-bit arithmetic and
stores the result in the unsigned int nr_zones field of struct
zoned_disk_info, silently truncating counts that exceed 32 bits. The
truncated count is later used to size per-zone resources, while the device
may still report more zones than fit.
Moreover, sd_zbc_report_zones() counts the reported zones with a signed int
zone_idx, which overflows past INT_MAX. Reject devices reporting more than
INT_MAX zones at scan time; such a device is not realistic f
netfilter: nfnetlink_queue: hold nfnl mutex in event notifier
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nfnetlink_queue: hold nfnl mutex in event notifier
We must serialize the release notifier and the config netlink function.
A concurrent thread can issue close() which can call the release function
while unrelated socket processes UNBIND request for same portid:
Oops: general protection fault, [..]
RIP: 0010:__instance_destroy+0x60/0x210 [nfnetlink_queue]
Call Trace:
nfqnl_recv_config+0x9b0/0xdc0 [nfnetlink_queue]
nfnetlink_rcv_msg+0x7c2/0xeb0
? __pfx_nfnetlink_rcv_msg+0x10/0x10
After this, parallel UNBIND and URELEASE events are impossible.
This change isn'
drm/nouveau/clk: fix list cursor use after loop in nvkm_clk_ustate_update
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/clk: fix list cursor use after loop in nvkm_clk_ustate_update
If list_for_each_entry() exits without hitting a break then "pstate" is
not a valid pstate pointer. Introduce a "found" variable instead.
The check is reachable from userspace: nvkm_clk_ustate_update() takes the
pstate id straight from the 'pstate' debugfs file, so requesting an id
that is not in clk->states - or any id at all when the perf tables are
broken and the list is empty - makes the pstate->pstate != req test
dereference the list head cast to a struct nvkm_pstate, which is an
out-of-bounds