xfrm: validate selector family and prefixlen during match
In the Linux kernel, the following vulnerability has been resolved:
xfrm: validate selector family and prefixlen during match
syzbot reported a shift-out-of-bounds in xfrm_selector_match()
due to AF_UNSPEC selector with large prefixlen (e.g. 128) matched
against IPv4 flow (when XFRM_STATE_AF_UNSPEC is set).
Fix this by:
- Rejecting mismatched families in xfrm_selector_match.
- Returning false in addr4_match if prefixlen > 32.
- Returning false in addr_match if prefixlen > 128 (prevents overflow).
sctp: hold socket lock when dumping endpoints in sctp_diag
In the Linux kernel, the following vulnerability has been resolved:
sctp: hold socket lock when dumping endpoints in sctp_diag
SCTP_DIAG endpoint dumping was traversing endpoint address lists without
holding lock_sock(), while those lists could change concurrently via
socket operations (e.g., bindx changes). This creates a race where
nla_reserve() counts addresses under RCU protection, but the subsequent
copy may see fewer entries, potentially leaking uninitialized memory to
userspace.
Fix this by:
- Taking a reference on each endpoint during hash traversal
- Moving socket operations (lock_sock()) outside read_lock_bh()
- Serializing addr
flow_dissector: check device type before reading ETH_ADDRS
In the Linux kernel, the following vulnerability has been resolved:
flow_dissector: check device type before reading ETH_ADDRS
__skb_flow_dissect() unconditionally reads 12 bytes from eth_hdr(skb)
when FLOW_DISSECTOR_KEY_ETH_ADDRS is requested. This assumes the skb
has a valid Ethernet header at mac_header, which is not always the case.
The problem can be triggered by:
1. Creating a TUN device in L3 mode (IFF_TUN, hard_header_len=0)
2. Attaching a multiq qdisc with a flower filter matching on eth_src
3. Sending a packet through AF_PACKET
Since TUN in L3 mode has no link-layer header, mac_header points to
the L3 data area. The flow diss
ieee802154: fix kernel-infoleak in dgram_recvmsg()
In the Linux kernel, the following vulnerability has been resolved:
ieee802154: fix kernel-infoleak in dgram_recvmsg()
KMSAN reported a kernel-infoleak in move_addr_to_user():
BUG: KMSAN: kernel-infoleak in instrument_copy_to_user
include/linux/instrumented.h:131 [inline]
BUG: KMSAN: kernel-infoleak in _inline_copy_to_user
include/linux/uaccess.h:205 [inline]
BUG: KMSAN: kernel-infoleak in _copy_to_user+0xcc/0x120
lib/usercopy.c:26
instrument_copy_to_user include/linux/instrumented.h:131 [inline]
_inline_copy_to_user include/linux/uaccess.h:205 [inline]
_copy_to_user+0xcc/0x120 lib/usercopy.c:26
copy_to_user include/linux/uaccess.h:236
netfilter: ipset: Don't use test_bit() in lockless RCU readers in hash types
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ipset: Don't use test_bit() in lockless RCU readers in hash types
Sashiko pointed out that there are a few lockless RCU readers
using test_bit() which is a relaxed atomic operation and
provides no memory barrier guarantees. Use test_bit_acquire()
instead where the operation may run parallel with add/del/gc,
i.e. is not one from the next cases
- protected by region lock
- in a set destroy phase
- in a new/temporary set creation phase
netfilter: ipset: fix order of kfree_rcu() and rcu_assign_pointer()
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ipset: fix order of kfree_rcu() and rcu_assign_pointer()
Sashiko pointed out that kfree_rcu() was called before
rcu_assign_pointer() in handling the comment extension.
Fix the order so that rcu_assign_pointer() called first.
ipv4: fib: Don't ignore error route in local/main tables.
In the Linux kernel, the following vulnerability has been resolved:
ipv4: fib: Don't ignore error route in local/main tables.
When CONFIG_IP_MULTIPLE_TABLES is enabled but no rule is added,
fib_lookup() performs route lookup directly on two tables.
Since the first lookup does not properly bail out, the result
of an error route in the merged local/main table could be
overwritten by another route in the default table:
# unshare -n
# ip link set lo up
# ip route add 192.168.0.0/24 dev lo table 253
# ip route add unreachable 192.168.0.0/24
# ip route get 192.168.0.1
192.168.0.1 dev lo table default uid 0
cache <local>
Once
md/raid5: avoid R5_Overlap races while breaking stripe batches
In the Linux kernel, the following vulnerability has been resolved:
md/raid5: avoid R5_Overlap races while breaking stripe batches
KCSAN report a race in break_stripe_batch_list() vs. raid5_make_request()
on sh->dev[i].flags (plain word write vs. atomic bit op)..
and .. one possible scenario is:
CPU1 CPU2
break_stripe_batch_list(sh1)
-> handle sh2
-> lock(sh2)
-> sh2->batch_head = NULL
-> unlock(sh2)
-> test_and_clear_bit(R5_Overlap, sh2->dev[i].flags)
-> wake_up_bit(sh2->dev[i].flags)
raid5_make_request()
-> add_all_stripe_bios(sh2)
netfilter: nft_compat: ebtables emulation must reject non-bridge targets
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_compat: ebtables emulation must reject non-bridge targets
xtables targets return netfilter verdicts: NF_ACCEPT, NF_DROP, and so
on. ebtables targets return incompatible verdicts: EBT_ACCEPT,
EBT_DROP, ... We cannot allow fallback to NFPROTO_UNSPEC.
ebtables doesn't permit this since
11ff7288beb2 ("netfilter: ebtables: reject non-bridge targets")
but that commit missed the nft_compat layer.
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix err_chunk memory leaks in INIT handling
When sctp_verify_init() encounters unrecognized parameters, it allocates an
err_chunk to report them. However, this chunk is leaked in several code
paths:
1. In sctp_sf_do_5_1B_init(), if security_sctp_assoc_request() fails after
sctp_verify_init() has populated err_chunk, the function returns
immediately without freeing it.
2. In sctp_sf_do_unexpected_init(), the same leak occurs on the
security_sctp_assoc_request() failure path.
3. In sctp_sf_do_unexpected_init(), on the success path after copying
unrecogniz
In the Linux kernel, the following vulnerability has been resolved:
net: mvneta: re-enable percpu interrupt on resume
On Marvell MPIC platforms (Armada 370/XP/38x), mvneta uses a percpu
IRQ disable/enable scheme for NAPI: the ISR (mvneta_percpu_isr) calls
disable_percpu_irq() to mask the MPIC per-CPU interrupt and schedules
NAPI poll, which calls enable_percpu_irq() on completion to unmask.
If suspend occurs while NAPI poll is pending (between
disable_percpu_irq in the ISR and enable_percpu_irq in poll
completion), the interrupt is never re-enabled:
1. mvneta_percpu_isr: disable_percpu_irq() + napi_schedule()
=> MPIC masked, percpu
In the Linux kernel, the following vulnerability has been resolved:
net: sungem: fix probe error cleanup
gem_init_one() calls gem_remove_one() when register_netdev() fails.
gem_remove_one() unregisters and frees resources owned by the net_device,
including the DMA block, MMIO mapping, PCI regions, and the net_device
itself. gem_init_one() then falls through to its own cleanup labels and
frees the same resources again.
Keep the register_netdev() error path in gem_init_one(): clear drvdata so
PM/remove paths do not see a half-registered device, remove the NAPI
instance added during probe, and let the existing cleanup labels release
the resou
sctp: add INIT verification after cookie unpacking
In the Linux kernel, the following vulnerability has been resolved:
sctp: add INIT verification after cookie unpacking
In SCTP handshake, the INIT chunk is initially processed by the server
and embedded into the cookie carried in INIT-ACK. The client then
returns this cookie via COOKIE-ECHO, where the server unpacks it and
reconstructs the original INIT chunk.
When cookie authentication is enabled, the cookie contents are protected
against tampering, so reusing the unpacked INIT without re-verification
is safe.
However, when cookie authentication is disabled, the reconstructed INIT
can no longer be trusted. In this case, the INIT must be
hwmon: (pmbus/core) honor vrm_version in pmbus_data2reg_vid()
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/core) honor vrm_version in pmbus_data2reg_vid()
pmbus_data2reg_vid() hardcoded the VR11 encoding regardless of the
vrm_version configured by the driver, while pmbus_reg2data_vid()
already switched on it. Any driver that selects a non-VR11 VID mode
and exposes a regulator (or hwmon vout setter) sent dangerously
wrong codes to PMBUS_VOUT_COMMAND -- e.g. an nvidia195mv part asked
for 200 mV got the VR11 clamp to 500 mV encoded as 0xB2, which the
chip interprets as 1080 mV.
Mirror pmbus_reg2data_vid() so writes round-trip with reads.
In the Linux kernel, the following vulnerability has been resolved:
hwmon: adm1275: Prevent reading uninitialized stack
While adding support for the ROHM BD127X0 hot-swap controllers, sashiko
reported an error in device-name comparison, which can lead to reading
uninitialized stack memory.
Quoting Sashiko:
This is a pre-existing issue, but I noticed that just before this block in
adm1275_probe(), there might be an out-of-bounds stack read:
ret = i2c_smbus_read_block_data(client, PMBUS_MFR_MODEL, block_buffer);
if (ret < 0) { ... }
for (mid = adm1275_id; mid->name[0]; mid++) {
if (!strncasecmp(mid->name, block_buff
ipv6: fib6: fix NULL deref in fib6_walk_continue() on multi-batch dump
In the Linux kernel, the following vulnerability has been resolved:
ipv6: fib6: fix NULL deref in fib6_walk_continue() on multi-batch dump
inet6_dump_fib() saves its progress in cb->args[1] as a positional
index within the current hash chain. Between batches, a concurrent
fib6_new_table() can insert a new table at the chain head, shifting
all existing entries. The saved index then lands on a different
table, causing fib6_dump_table() to set w->root to the wrong table
while w->node still points into the previous one.
fib6_walk_continue() dereferences w->node->parent (NULL) and panics:
BUG: kernel NULL pointer dereference, address: 00000
net/sched: sch_teql: Introduce slaves_lock to avoid race condition and UAF
In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_teql: Introduce slaves_lock to avoid race condition and UAF
The teql master->slaves singly linked list is not protected against
multiple writes. It can be mod'ed concurently from teql_master_xmit(),
teql_dequeue(), teql_init() and teql_destroy() without holding any list
lock or RCU protection.
[email protected] has demonstrated that the qdisc is freed
after an RCU grace period, but teql_master_xmit() running on another
CPU can still hold a stale pointer into the list, resulting in a
slab-use-after-free:
BUG: KASAN: slab-use-after-free in teql_m
bridge: stp: Fix a potential use-after-free when deleting a bridge
In the Linux kernel, the following vulnerability has been resolved:
bridge: stp: Fix a potential use-after-free when deleting a bridge
The three STP timers are not supposed to be armed while the bridge is
administratively down. They are synchronously deactivated when the
bridge is put administratively down and the various call sites check for
'IFF_UP' before arming them.
This check is missing from br_topology_change_detection() and it is
possible to engineer a situation in which the topology change timer is
armed while the bridge is administratively down, resulting in a
use-after-free [1] when the bridge is deleted.
Fix by adding the miss
irqchip/ts4800: Fix missing chained handler cleanup on remove
In the Linux kernel, the following vulnerability has been resolved:
irqchip/ts4800: Fix missing chained handler cleanup on remove
The driver installs a chained handler for the parent interrupt during probe
using irq_set_chained_handler_and_data(), but the remove function does not
clear this handler. This leaves a dangling handler that may be called when
the parent interrupt fires after the driver has been removed, potentially
accessing freed memory and causing a kernel crash.
Additionally, the parent_irq obtained via irq_of_parse_and_map() is not
stored, making it inaccessible in the remove function. Moreover, interrupt
mappings created du
sctp: fix addr_wq_timer race in sctp_free_addr_wq()
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix addr_wq_timer race in sctp_free_addr_wq()
sctp_free_addr_wq() previously removed addr_wq_timer using timer_delete()
while holding addr_wq_lock. However, timer_delete() does not guarantee that
a currently running timer handler has completed.
This allows a race with sctp_addr_wq_timeout_handler(), where the handler
may still run after addr_waitq has been freed, acquire addr_wq_lock, and
access freed memory, leading to a use-after-free.
Fix this by calling timer_shutdown_sync() before taking addr_wq_lock. This
guarantees that any in-flight timer handler has finish