can: bcm: fix data race on rx_stamp/rx_ifindex in bcm_rx_handler()
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix data race on rx_stamp/rx_ifindex in bcm_rx_handler()
For an rx op subscribed on all interfaces (ifindex == 0), the same op
is registered once in the shared per-netns wildcard filter list, so
bcm_rx_handler() can run concurrently on different CPUs for frames
arriving on different net devices.
op->rx_stamp and op->rx_ifindex were written before bcm_rx_update_lock was
taken, allowing concurrent writers to race each other - including a torn
store of the 64-bit rx_stamp on 32-bit platforms.
Beyond a torn store bcm_send_to_user() must report the timestamp/ifindex
can: bcm: fix stale rx/tx ops after device removal
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix stale rx/tx ops after device removal
RX: an RX_SETUP update(!) for an existing op skipped can_rx_register()
unconditionally, even when a concurrent NETDEV_UNREGISTER had already
torn down its registration (op->rx_reg_dev == NULL). This silently
did not re-enable frame delivery for that updated filter. bcm_rx_setup()
now re-registers in that case, while leaving rx_ops with ifindex = 0
(all CAN devices) which never carry a tracked rx_reg_dev registered as-is.
TX: bcm_notify() only handled bo->rx_ops on NETDEV_UNREGISTER, leaving
tx_ops with an active cyclic tra
can: bcm: track a single source interface for ANYDEV timeout/throttle ops
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: track a single source interface for ANYDEV timeout/throttle ops
An ANYDEV rx op (ifindex == 0) with an active RX timeout and/or
throttle timer has no defined semantics when matching frames arrive
from several interfaces: bcm_rx_handler() can run concurrently for
the same op on different CPUs, racing hrtimer_cancel()/
bcm_rx_starttimer() against bcm_rx_timeout_handler() and causing
spurious RX_TIMEOUT notifications and last_frames corruption. The
same concurrency lets throttled multiplex frames from different
interfaces clobber the single rx_ifindex/rx_stamp fields
can: bcm: validate frame length in bcm_rx_setup() for RTR replies
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: validate frame length in bcm_rx_setup() for RTR replies
bcm_tx_setup() validates cf->len against the CAN/CAN FD DLC limits
before installing frames for TX_SETUP, but bcm_rx_setup() never did
the same for the RTR-reply frame configured via RX_SETUP with
RX_RTR_FRAME.
can: bcm: add missing device refcount for CAN filter removal
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: add missing device refcount for CAN filter removal
sashiko-bot remarked a problem with a concurrent device unregistration
in isotp.c which also is present in the bcm.c code. A former fix for raw.c
commit c275a176e4b6 ("can: raw: add missing refcount for memory leak fix")
introduced a netdevice_tracker which solves the issue for bcm.c too.
bcm_release(), bcm_delete_rx_op() and bcm_notifier() relied on
dev_get_by_index(ifindex) to re-find the device for an rx_op before
unregistering its filter. If a concurrent NETDEV_UNREGISTER has already
unlisted the device from
dm thin metadata: fix metadata snapshot consistency on commit failure
In the Linux kernel, the following vulnerability has been resolved:
dm thin metadata: fix metadata snapshot consistency on commit failure
__reserve_metadata_snap() and __release_metadata_snap() modify the
superblock's held_root directly in the block_manager's buffer. If the
subsequent metadata commit fails, the held_root gets flushed to disk
through the abort_transaction path, resulting in inconsistent metadata.
Reproducer 1: __reserve_metadata_snap()
1. Create a 2 MiB metadata device and make the region after the 14th
block inaccessible, to trigger metadata commit failure in the
subsequent reserve_metadata_snap operation. The 14th
dm era: fix out-of-bounds memory access for non-zero start sector
In the Linux kernel, the following vulnerability has been resolved:
dm era: fix out-of-bounds memory access for non-zero start sector
dm-era tracks writes in target-relative blocks, but era_map() calculates
the writeset block before applying the target offset. Tables with a
non-zero start sector can therefore pass an absolute mapped-device block
to metadata_current_marked().
If the absolute block is beyond the current writeset size,
writeset_marked() tests past the end of the in-core bitset. KASAN reports
this as a vmalloc-out-of-bounds access.
Apply the target offset before calculating the era block so writeset
lookups use the target-r
dm-ioctl: fix a possible overflow in list_version_get_info
In the Linux kernel, the following vulnerability has been resolved:
dm-ioctl: fix a possible overflow in list_version_get_info
sizeof(tt->version) is 12 bytes, but the code writes 16 bytes into the
output buffer - info->vers->version[0], info->vers->version[1],
info->vers->version[2] and info->vers->next. This can cause buffer
overflow.
Fix this buffer overflow by replacing "sizeof(tt->version)" with
"sizeof(struct dm_target_versions)".
In the Linux kernel, the following vulnerability has been resolved:
dm-verity: fix buffer overflow in FEC calculation
There's a buffer overflow in dm-verity-fec:
if (neras && *neras <= v->fec->roots)
fio->erasures[(*neras)++] = i;
This allows *neras to reach roots + 1 (the post-increment pushes it past
roots). This value is then passed as no_eras to decode_rs8(). Inside the
RS decoder (lib/reed_solomon/decode_rs.c:113-121), the erasure locator
polynomial loop writes lambda[j] where j can reach nroots + 1 — one
element past the end of lambda[] (which is sized nroots + 1, valid
indices 0..nroots). The out-of-bounds write lands on syn[0], c
In the Linux kernel, the following vulnerability has been resolved:
dm-verity: make error counter atomic
The error counter "v->corrupted_errs" was not atomic, thus it could be
subject to race conditions. The call to
dm_audit_log_target("max-corrupted-errors") may be skipped due to the
races.
scsi: xen: scsiback: Free the command tag on the TMR submit-failure path
In the Linux kernel, the following vulnerability has been resolved:
scsi: xen: scsiback: Free the command tag on the TMR submit-failure path
scsiback_device_action() obtains a command tag in
scsiback_get_pend_req() and submits a task-management request with
target_submit_tmr(). When target_submit_tmr() fails it returns < 0 and
scsiback jumps to the err: label, which sends a response but frees
nothing, leaking the tag.
Impact: a pvSCSI guest can leak the command tags of a LUN's session,
stopping the LUN, by issuing VSCSIIF_ACT_SCSI_ABORT or RESET requests
whenever target_submit_tmr() fails.
transport_generic_free_cmd() cannot be used here.
scsi: xen: scsiback: Free unsubmitted command instead of double-putting it
In the Linux kernel, the following vulnerability has been resolved:
scsi: xen: scsiback: Free unsubmitted command instead of double-putting it
scsiback_get_pend_req() obtains a command tag and returns a vscsibk_pend
whose embedded se_cmd has only been memset to 0, so its cmd_kref is 0;
the se_cmd is initialised (kref_init() via target_init_cmd()) only
later, in scsiback_cmd_exec(), on the successful VSCSIIF_ACT_SCSI_CDB
path. The two error paths in scsiback_do_cmd_fn() taken before the
command is submitted -- a failed scsiback_gnttab_data_map() and an
unknown ring_req.act -- call
transport_generic_free_cmd(&pending_req->se_cmd, 0), which kr
scsi: target: Bound PR-OUT TransportID parsing to the received buffer
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: Bound PR-OUT TransportID parsing to the received buffer
core_scsi3_decode_spec_i_port() and core_scsi3_emulate_register_and_move()
hand the raw PERSISTENT RESERVE OUT parameter buffer to
target_parse_pr_out_transport_id() without telling it how many bytes are
valid. For an iSCSI TransportID (FORMAT CODE 01b),
iscsi_parse_pr_out_transport_id() locates the ",i,0x" ISID separator with
an unbounded strstr() (and on the error path prints the name with a further
unbounded "%s"). An initiator can submit a TransportID whose iSCSI name
contains neither a ",i,0x" subs
scsi: target: core: Fix iSCSI ISID use-after-free in REGISTER AND MOVE
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: core: Fix iSCSI ISID use-after-free in REGISTER AND MOVE
core_scsi3_emulate_pro_register_and_move() maps the PERSISTENT RESERVE OUT
parameter list with transport_kmap_data_sg() and parses the destination
TransportID with target_parse_pr_out_transport_id(). For an iSCSI
TransportID (FORMAT CODE 01b), iscsi_parse_pr_out_transport_id() returns
the ISID in iport_ptr as a raw pointer into that mapped buffer.
The function then unmaps the buffer with transport_kunmap_data_sg() before
dereferencing iport_ptr in strcmp(), __core_scsi3_locate_pr_reg() and
core_scsi3_al
Input: ims-pcu - fix use-after-free and double-free in disconnect
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix use-after-free and double-free in disconnect
ims_pcu_disconnect() only intended to perform cleanup when the primary
(control) interface is unbound. However, it currently relies on the
interface class to distinguish between control and data interfaces.
A malicious device could present a data interface with the same class
as the control interface, leading to premature cleanup and potential
use-after-free or double-free.
Switch to verifying that the interface being disconnected is indeed
the control interface.
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - validate control endpoint type
The driver currently assumes that the first endpoint of the control
interface is an interrupt IN endpoint without verifying it. A malicious
device could provide a different endpoint type, which would then be
passed to usb_fill_int_urb(), potentially leading to kernel warnings
or undefined behavior.
Verify that the control endpoint is an interrupt IN endpoint.
Input: ims-pcu - fix firmware leak in async update
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix firmware leak in async update
The firmware object was not being released if validation failed.
Use __free(firmware) to ensure the firmware is always released.
Input: ims-pcu - fix out-of-bounds read in ims_pcu_irq() debug logging
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix out-of-bounds read in ims_pcu_irq() debug logging
The debug logging in ims_pcu_irq() unconditionally prints data from
pcu->urb_in_buf. However, if the interrupt fired for pcu->urb_ctrl, the
actual data resides in pcu->urb_ctrl_buf. If urb->actual_length for the
control URB exceeds pcu->max_in_size, this leads to an out-of-bounds
read.
Fix this by printing from the correct buffer associated with the URB.
Input: ims-pcu - fix race condition in reset_device sysfs callback
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix race condition in reset_device sysfs callback
The ims_pcu_reset_device() sysfs callback calls ims_pcu_execute_command()
without acquiring pcu->cmd_mutex. This can lead to data races and
corruption of the shared command buffer if triggered concurrently with
other commands.
Acquire pcu->cmd_mutex before calling ims_pcu_execute_command().
Input: ims-pcu - fix type confusion in CDC union descriptor parsing
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix type confusion in CDC union descriptor parsing
The driver currently trusts the bMasterInterface0 from the CDC union
descriptor without verifying that it matches the interface being
probed. This could lead to the driver overwriting the private data of
another interface.
Validate that the control interface found in the descriptor is indeed
the one we are probing.