Bluetooth: Fix race condition in hidp_session_thread
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: Fix race condition in hidp_session_thread
There is a potential race condition in hidp_session_thread that may
lead to use-after-free. For instance, the timer is active while
hidp_del_timer is called in hidp_session_thread(). After hidp_session_put,
then 'session' will be freed, causing kernel panic when hidp_idle_timeout
is running.
The solution is to use del_timer_sync instead of del_timer.
Here is the call trace:
? hidp_session_probe+0x780/0x780
call_timer_fn+0x2d/0x1e0
__run_timers.part.0+0x569/0x940
hidp_session_probe+0x780/0x780
call_timer_fn+0x1e0/0x1e0
In the Linux kernel, the following vulnerability has been resolved:
inotify: Avoid reporting event with invalid wd
When inotify_freeing_mark() races with inotify_handle_inode_event() it
can happen that inotify_handle_inode_event() sees that i_mark->wd got
already reset to -1 and reports this value to userspace which can
confuse the inotify listener. Avoid the problem by validating that wd is
sensible (and pretend the mark got removed before the event got
generated otherwise).
serial: sc16is7xx: setup GPIO controller later in probe
In the Linux kernel, the following vulnerability has been resolved:
serial: sc16is7xx: setup GPIO controller later in probe
The GPIO controller component of the sc16is7xx driver is setup too
early, which can result in a race condition where another device tries
to utilise the GPIO lines before the sc16is7xx device has finished
initialising.
This issue manifests itself as an Oops when the GPIO lines are configured:
Unable to handle kernel read from unreadable memory at virtual address
...
pc : sc16is7xx_gpio_direction_output+0x68/0x108 [sc16is7xx]
lr : sc16is7xx_gpio_direction_output+0x4c/0x108 [sc16is7xx]
...
Call
Media · CVSS 6.8EPSS 0,22%Sin corrección publicada
net: nsh: Use correct mac_offset to unwind gso skb in nsh_gso_segment()
In the Linux kernel, the following vulnerability has been resolved:
net: nsh: Use correct mac_offset to unwind gso skb in nsh_gso_segment()
As the call trace shows, skb_panic was caused by wrong skb->mac_header
in nsh_gso_segment():
invalid opcode: 0000 [#1] PREEMPT SMP KASAN PTI
CPU: 3 PID: 2737 Comm: syz Not tainted 6.3.0-next-20230505 #1
RIP: 0010:skb_panic+0xda/0xe0
call Trace:
skb_push+0x91/0xa0
nsh_gso_segment+0x4f3/0x570
skb_mac_gso_segment+0x19e/0x270
__skb_gso_segment+0x1e8/0x3c0
validate_xmit_skb+0x452/0x890
validate_xmit_skb_list+0x99/0xd0
sch_direct_xmit+0x294/0x7c0
__dev_queue_xmit+0x16f0/0x1d70
packet_xmit+0x185/0x21
pinctrl: rockchip: Fix refcount leak in rockchip_pinctrl_parse_groups
In the Linux kernel, the following vulnerability has been resolved:
pinctrl: rockchip: Fix refcount leak in rockchip_pinctrl_parse_groups
of_find_node_by_phandle() returns a node pointer with refcount incremented,
We should use of_node_put() on it when not needed anymore.
Add missing of_node_put() to avoid refcount leak.
media: rcar_fdp1: Fix refcount leak in probe and remove function
In the Linux kernel, the following vulnerability has been resolved:
media: rcar_fdp1: Fix refcount leak in probe and remove function
rcar_fcp_get() take reference, which should be balanced with
rcar_fcp_put(). Add missing rcar_fcp_put() in fdp1_remove and
the error paths of fdp1_probe() to fix this.
[hverkuil: resolve merge conflict, remove() is now void]
can: isotp: check CAN address family in isotp_bind()
In the Linux kernel, the following vulnerability has been resolved:
can: isotp: check CAN address family in isotp_bind()
Add missing check to block non-AF_CAN binds.
Syzbot created some code which matched the right sockaddr struct size
but used AF_XDP (0x2C) instead of AF_CAN (0x1D) in the address family
field:
bind$xdp(r2, &(0x7f0000000540)={0x2c, 0x0, r4, 0x0, r2}, 0x10)
^^^^
This has no funtional impact but the userspace should be notified about
the wrong address family field content.
powerpc/iommu: Fix notifiers being shared by PCI and VIO buses
In the Linux kernel, the following vulnerability has been resolved:
powerpc/iommu: Fix notifiers being shared by PCI and VIO buses
fail_iommu_setup() registers the fail_iommu_bus_notifier struct to both
PCI and VIO buses. struct notifier_block is a linked list node, so this
causes any notifiers later registered to either bus type to also be
registered to the other since they share the same node.
This causes issues in (at least) the vgaarb code, which registers a
notifier for PCI buses. pci_notify() ends up being called on a vio
device, converted with to_pci_dev() even though it's not a PCI device,
and finally makes a bad access in vga_ar
media: anysee: fix null-ptr-deref in anysee_master_xfer
In the Linux kernel, the following vulnerability has been resolved:
media: anysee: fix null-ptr-deref in anysee_master_xfer
In anysee_master_xfer, msg is controlled by user. When msg[i].buf
is null and msg[i].len is zero, former checks on msg[i].buf would be
passed. Malicious data finally reach anysee_master_xfer. If accessing
msg[i].buf[0] without sanity check, null ptr deref would happen.
We add check on msg[i].len to prevent crash.
Similar commit:
commit 0ed554fd769a
("media: dvb-usb: az6027: fix null-ptr-deref in az6027_i2c_xfer()")
[hverkuil: add spaces around +]
drm/client: Fix memory leak in drm_client_target_cloned
In the Linux kernel, the following vulnerability has been resolved:
drm/client: Fix memory leak in drm_client_target_cloned
dmt_mode is allocated and never freed in this function.
It was found with the ast driver, but most drivers using generic fbdev
setup are probably affected.
This fixes the following kmemleak report:
backtrace:
[<00000000b391296d>] drm_mode_duplicate+0x45/0x220 [drm]
[<00000000e45bb5b3>] drm_client_target_cloned.constprop.0+0x27b/0x480 [drm]
[<00000000ed2d3a37>] drm_client_modeset_probe+0x6bd/0xf50 [drm]
[<0000000010e5cc9d>] __drm_fb_helper_initial_config_and_unlock+0xb4/0x2c0 [drm_kms_helper]
[<00
blk-cgroup: hold queue_lock when removing blkg->q_node
In the Linux kernel, the following vulnerability has been resolved:
blk-cgroup: hold queue_lock when removing blkg->q_node
When blkg is removed from q->blkg_list from blkg_free_workfn(), queue_lock
has to be held, otherwise, all kinds of bugs(list corruption, hard lockup,
..) can be triggered from blkg_destroy_all().
ubi: Fix possible null-ptr-deref in ubi_free_volume()
In the Linux kernel, the following vulnerability has been resolved:
ubi: Fix possible null-ptr-deref in ubi_free_volume()
It willl cause null-ptr-deref in the following case:
uif_init()
ubi_add_volume()
cdev_add() -> if it fails, call kill_volumes()
device_register()
kill_volumes() -> if ubi_add_volume() fails call this function
ubi_free_volume()
cdev_del()
device_unregister() -> trying to delete a not added device,
it causes null-ptr-deref
So in ubi_free_volume(), it delete devices whether they are added
or not, it will causes null-ptr-deref.
Handle the error case whlie calling ubi_add_volume() to fix this
pro
Media · CVSS 5.7EPSS 0,21%Sin corrección publicada
xen: speed up grant-table reclaim
In the Linux kernel, the following vulnerability has been resolved:
xen: speed up grant-table reclaim
When a grant entry is still in use by the remote domain, Linux must put
it on a deferred list. Normally, this list is very short, because
the PV network and block protocols expect the backend to unmap the grant
first. However, Qubes OS's GUI protocol is subject to the constraints
of the X Window System, and as such winds up with the frontend unmapping
the window first. As a result, the list can grow very large, resulting
in a massive memory leak and eventual VM freeze.
To partially solve this problem, make the number of entries that the
power: supply: bq27xxx: Fix poll_interval handling and races on remove
In the Linux kernel, the following vulnerability has been resolved:
power: supply: bq27xxx: Fix poll_interval handling and races on remove
Before this patch bq27xxx_battery_teardown() was setting poll_interval = 0
to avoid bq27xxx_battery_update() requeuing the delayed_work item.
There are 2 problems with this:
1. If the driver is unbound through sysfs, rather then the module being
rmmod-ed, this changes poll_interval unexpectedly
2. This is racy, after it being set poll_interval could be changed
before bq27xxx_battery_update() checks it through
/sys/module/bq27xxx_battery/parameters/poll_interval
Fix this by added a removed at
ext4: fix bug_on in __es_tree_search caused by bad quota inode
In the Linux kernel, the following vulnerability has been resolved:
ext4: fix bug_on in __es_tree_search caused by bad quota inode
We got a issue as fllows:
==================================================================
kernel BUG at fs/ext4/extents_status.c:202!
invalid opcode: 0000 [#1] PREEMPT SMP
CPU: 1 PID: 810 Comm: mount Not tainted 6.1.0-rc1-next-g9631525255e3 #352
RIP: 0010:__es_tree_search.isra.0+0xb8/0xe0
RSP: 0018:ffffc90001227900 EFLAGS: 00010202
RAX: 0000000000000000 RBX: 0000000077512a0f RCX: 0000000000000000
RDX: 0000000000000002 RSI: 0000000000002a10 RDI: ffff8881004cd0c8
RBP: ffff888177512ac8 R08: 47fffffffffff
Media · CVSS 4.8EPSS 0,26%Sin corrección publicada
crypto: qat - fix DMA transfer direction
In the Linux kernel, the following vulnerability has been resolved:
crypto: qat - fix DMA transfer direction
When CONFIG_DMA_API_DEBUG is selected, while running the crypto self
test on the QAT crypto algorithms, the function add_dma_entry() reports
a warning similar to the one below, saying that overlapping mappings
are not supported. This occurs in tests where the input and the output
scatter list point to the same buffers (i.e. two different scatter lists
which point to the same chunks of memory).
The logic that implements the mapping uses the flag DMA_BIDIRECTIONAL
for both the input and the output scatter lists which leads to
overlapp
rcu: Fix __this_cpu_read() lockdep warning in rcu_force_quiescent_state()
In the Linux kernel, the following vulnerability has been resolved:
rcu: Fix __this_cpu_read() lockdep warning in rcu_force_quiescent_state()
Running rcutorture with non-zero fqs_duration module parameter in a
kernel built with CONFIG_PREEMPTION=y results in the following splat:
BUG: using __this_cpu_read() in preemptible [00000000]
code: rcu_torture_fqs/398
caller is __this_cpu_preempt_check+0x13/0x20
CPU: 3 PID: 398 Comm: rcu_torture_fqs Not tainted 6.0.0-rc1-yoctodev-standard+
Call Trace:
<TASK>
dump_stack_lvl+0x5b/0x86
dump_stack+0x10/0x16
check_preemption_disabled+0xe5/0xf0
__this_cpu_preempt_check+0x13/0x20
rcu_force_quiescent_state.