Input: rmi_smbus - fix out-of-bounds read in rmi_smb_write_block()
In the Linux kernel, the following vulnerability has been resolved:
Input: rmi_smbus - fix out-of-bounds read in rmi_smb_write_block()
When chunking writes into SMBus blocks in rmi_smb_write_block(), the
loop calculates block_len using the original total length (len) instead
of the remaining length (cur_len).
If len is greater than 32 bytes (SMB_MAX_COUNT), block_len remains 32
for every iteration, even on the final partial chunk where fewer than 32
bytes remain. This causes smb_block_write() to read 32 bytes from the
advanced data buffer pointer, reading past the end of the input buffer.
Fix this by calculating block_len using cur_len an
In the Linux kernel, the following vulnerability has been resolved:
Input: soc_button_array - check btns_desc->package.count
Check that btns_desc->package.count is not 0 before accessing
btns_desc->package.elements[0].
Input: synaptics-rmi4 - fix GPF in suspend and resume when unbound
In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - fix GPF in suspend and resume when unbound
Transport drivers (such as rmi_i2c and rmi_spi) invoke
rmi_driver_suspend() and rmi_driver_resume() on their child rmi_dev
device during system power management events. However, transport drivers
are fully registered and operational even if the physical RMI driver
failed to bind or probe the rmi_dev device.
When rmi_driver_suspend() or rmi_driver_resume() is called on an unbound
rmi_dev, dev_get_drvdata() returns NULL. Calling rmi_disable_irq() or
rmi_enable_irq() without driver data attached causes a NULL
Input: zero ff_effect before compat copy in input_ff_effect_from_user
In the Linux kernel, the following vulnerability has been resolved:
Input: zero ff_effect before compat copy in input_ff_effect_from_user
In the compat path input_ff_effect_from_user() aliases the caller's
native struct ff_effect with the smaller struct ff_effect_compat and
copies only the compat sized prefix:
compat_effect = (struct ff_effect_compat *)effect;
if (copy_from_user(compat_effect, buffer,
sizeof(struct ff_effect_compat)))
The tail of the native structure is never written. Callers pass an
uninitialized on-stack object, for example evdev_do_ioctl() for
EVIOCSFF, so those bytes keep their previous stack contents.
input_
hwmon: (w83791d) remove fan/pwm 4-5 sysfs group on remove
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (w83791d) remove fan/pwm 4-5 sysfs group on remove
When the fan/pwm 4-5 pins are not used as GPIO, w83791d_probe()
creates the w83791d_group_fanpwm45 sysfs group on the I2C client
device.
The probe error path removes this group when a later initialization
step fails, but the normal remove path only removes w83791d_group.
As a result, the optional fan/pwm 4-5 sysfs files can remain after the
driver is unbound.
The callbacks associated with these files access the driver data,
which is devm allocated and released after driver unbind. Leaving the
sysfs files behind can
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmsmac: fix UAF in brcms_free_timer()
brcms_free_timer() calls brcms_del_timer() which uses the non-synchronous
cancel_delayed_work() to cancel the timer's underlying delayed work. If
the work callback (_brcms_timer) is already running, cancel_delayed_work()
returns false without waiting, and brcms_free_timer() proceeds to kfree(t)
while the callback still accesses t through container_of().
Add an explicit cancel_delayed_work_sync() after brcms_del_timer() to
guarantee that any in-flight callback has completed before the timer
structure is freed.
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlegacy: fix broadcast stations deallocation
On the error path of __il4965_up(), il_dealloc_bcast_stations() clears
only IL_STA_UCODE_ACTIVE, leaving IL_STA_BCAST set. This causes the
same broadcast stations to be deallocated again by __il4965_down().
This can occur when RF_KILL is toggled during driver startup.
To fix clear the entire 'used' field, since we will not do any
other operations on the station.
In the Linux kernel, the following vulnerability has been resolved:
wifi: libertas_tf: fix UAF in lbtf_free_adapter()
lbtf_free_adapter() calls lbtf_free_cmd_buffer() to free the command
buffers before calling timer_delete_sync() to wait for the command
timer callback. If the timer callback (command_timer_fn) is already
running when lbtf_free_cmd_buffer() frees the command array, the
callback dereferences priv->cur_cmd->cmdbuf which points to freed
memory.
Swap the order so that timer_delete_sync() runs first, ensuring any
in-flight callback has completed before the command buffers are freed.
Media · CVSS 6.9EPSS 0,17%Sin corrección publicada
wifi: libipw: reject TKIP frames without a full MIC
In the Linux kernel, the following vulnerability has been resolved:
wifi: libipw: reject TKIP frames without a full MIC
libipw_michael_mic_verify() assumes that an skb contains an eight-byte
Michael MIC. A short TKIP frame makes the unsigned payload length wrap,
causing michael_mic() to read past the skb.
Check that the MIC is present before verifying it, and use the existing
MICHAEL_MIC_LEN constant for all MIC lengths in the verifier.
wifi: wlcore: release runtime PM ref on regdomain config failure
In the Linux kernel, the following vulnerability has been resolved:
wifi: wlcore: release runtime PM ref on regdomain config failure
wlcore_regdomain_config() gets a runtime PM reference before sending
the regulatory-domain command. When
wlcore_cmd_regdomain_config_locked() fails, the function queues recovery
and returns without dropping that reference.
Release the reference after handling the command result so both success
and failure paths balance the preceding
pm_runtime_resume_and_get(). The recovery worker takes a separate
runtime PM reference and cannot release the reference held here.
wifi: wilc1000: fix RX buffer OOB-write in wilc_wlan_handle_isr_ext()
In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix RX buffer OOB-write in wilc_wlan_handle_isr_ext()
wilc_wlan_handle_isr_ext() takes the RX transfer size from the
device-reported interrupt status register (a 15-bit field shifted left by 2,
up to 131068 bytes) and reads that many bytes from the device into
rx_buffer, which is only WILC_RX_BUFF_SIZE (96K) large. The wrap
check only handles the current offset; the size itself is never
compared against the buffer, so a bogus SDIO device can make the driver
OOB-write rx_buffer by up to ~32K with data it controls.
The oversized transfer also leaves rx_buffer
wifi: p54: validate curve data length in the calibration curve converters
In the Linux kernel, the following vulnerability has been resolved:
wifi: p54: validate curve data length in the calibration curve converters
p54_convert_rev0() and p54_convert_rev1() read calibration curve
data from the device-supplied EEPROM entry using channel and
points-per-channel counts taken verbatim from that same entry, so
an entry that declares more data than it carries drives an
out-of-bounds read past the EEPROM buffer (verified with a KASAN
reproducer of the conversion loop). The sibling converters
p54_convert_output_limits() and p54_convert_db() already validate
their counts against the entry length; this path was missed.
Rej
wifi: p54: require a full exp_if record in PDR_INTERFACE_LIST
In the Linux kernel, the following vulnerability has been resolved:
wifi: p54: require a full exp_if record in PDR_INTERFACE_LIST
The PDR_INTERFACE_LIST loop only checks that the record start is within
the entry before reading an entire struct exp_if from it. A truncated
trailing record makes the if_id/variant reads cross the entry boundary
into the heap beyond the EEPROM buffer (verified with a KASAN
reproducer of the loop). The variant also feeds the synth front-end
selection, so this is not only a leak.
Advance only while a full record still fits in the entry.
wifi: mwifiex: bound the pairwise-cipher OUI walk to the IE length
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: bound the pairwise-cipher OUI walk to the IE length
mwifiex_search_oui_in_ie() reads a pairwise-cipher (PTK) count from a
beacon/probe-response RSN or WPA information element and then walks that
many 4-byte OUIs, comparing each with memcmp(). The count comes straight
from the (attacker-supplied) IE and is never checked against the
element's own length, and the callers admit the element on element_id
alone (has_ieee_hdr() / has_vendor_hdr(), no length check). A crafted
RSN/WPA IE with a large pairwise count therefore makes the walk read up
to 255 * 4 bytes pas
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: validate scan response extents
mwifiex_ret_802_11_scan() subtracts the fixed response fields and the
firmware-provided BSS length from resp->size without first proving that
either extent fits. A short response or oversized BSS length can
therefore underflow tlv_buf_size and make the TLV parser walk beyond the
command response.
Compute the fixed extent from the selected normal or background scan
response. Validate that the fixed fields and BSS data fit before deriving
the TLV extent and entering the parser.
wifi: mac80211: refuse to make a monitor active when it has no queue
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: refuse to make a monitor active when it has no queue
A monitor interface only gets a TXQ if it's created active, and one can't
be added later. Setting the flag on a down interface is still allowed, so
the driver is handed a monitor with no queue. ath9k dereferences it:
BUG: kernel NULL pointer dereference, address: 0000000000000066
RIP: 0010:ath_tx_node_init+0x49/0x170 [ath9k]
ath9k_add_interface+0x10c/0x140 [ath9k]
drv_add_interface+0x54/0x250 [mac80211]
ieee80211_do_open+0x32f/0x800 [mac80211]
Reached with CAP_NET_ADMIN by "iw dev X set moni
Media · CVSS 5.7EPSS 0,15%Sin corrección publicada
drm/amdkfd: Avoid integer underflow in EOP ring size calculation.
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Avoid integer underflow in EOP ring size calculation.
The low 6 bits of cp_hqd_eop_control store the base-2 logarithm
of the EOP ring size. This was calculated as
order_base_2(q->eop_ring_buffer_size / 4) - 1
But order_base_2 can in theory return 0, so this could underflow
(although in practice the ring buffer size cannot be less than 4096).
Change this to
order_base_2(q->eop_ring_buffer_size / 8)
using properties of logarithms.
Also add to the above comment to make the mathematics more clear.
(cherry picked from commit f0f43fcf8b2b3a924cad9444340921c96ed
Media · CVSS 4.8EPSS 0,15%Sin corrección publicada
drm/amdkfd: Avoid integer underflow with ffs in EOP ring size calc
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Avoid integer underflow with ffs in EOP ring size calc
The low 6 bits of cp_hqd_eop_control store the base-2 logarithm
of the EOP ring size. This was calculated as
ffs(q->eop_ring_buffer_size / sizeof(unsigned int)) - 1 - 1
But ffs can in theory return 1 or 0, so this could underflow
(although in practice the ring buffer size cannot be less than 4096).
Change this to
ffs(q->eop_ring_buffer_size / sizeof(unsigned int) / 4)
using properties of logarithms.
(cherry picked from commit 4f18c56630383c14bfc6b2d65f88f2f895d2121a)
smb: client: cancel reconnect work in clean_demultiplex_info()
In the Linux kernel, the following vulnerability has been resolved:
smb: client: cancel reconnect work in clean_demultiplex_info()
clean_demultiplex_info() cancels server->echo delayed work but not
server->reconnect, which can cause a use-after-free when the
demultiplex thread exits while a reconnect work is still queued:
cifs_demultiplex_thread()
cifs_readv_from_socket()
cifs_reconnect()
__cifs_reconnect()
cifs_queue_server_reconn()
mod_delayed_work(cifsiod_wq, &server->reconnect, 0)
clean_demultiplex_info()
cancel_delayed_work_sync(&server->echo) // echo canceled
smb: client: fix rlist race and missing initialization
In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix rlist race and missing initialization
TCP_Server_Info.rlist is allocated via kzalloc which zeros both ->next
and ->prev to NULL instead of pointing to itself, making list_empty()
always return false and list_add() dereference a NULL ->prev pointer.
Also, cifs_signal_cifsd_for_reconnect() can be called concurrently
from multiple cifsd threads, allowing the same server's rlist node to
be added twice into the local list, corrupting it.