Media · CVSS 5.5EPSS 0,12%Sin corrección publicada
udp: Fix wildcard bind conflict check when using hash2
In the Linux kernel, the following vulnerability has been resolved:
udp: Fix wildcard bind conflict check when using hash2
When binding a udp_sock to a local address and port, UDP uses
two hashes (udptable->hash and udptable->hash2) for collision
detection. The current code switches to "hash2" when
hslot->count > 10.
"hash2" is keyed by local address and local port.
"hash" is keyed by local port only.
The issue can be shown in the following bind sequence (pseudo code):
bind(fd1, "[fd00::1]:8888")
bind(fd2, "[fd00::2]:8888")
bind(fd3, "[fd00::3]:8888")
bind(fd4, "[fd00::4]:8888")
bind(fd5, "[fd00::5]:8888")
bind(fd6, "[fd00::6]:8888
team: fix header_ops type confusion with non-Ethernet ports
In the Linux kernel, the following vulnerability has been resolved:
team: fix header_ops type confusion with non-Ethernet ports
Similar to commit 950803f72547 ("bonding: fix type confusion in
bond_setup_by_slave()") team has the same class of header_ops type
confusion.
For non-Ethernet ports, team_setup_by_port() copies port_dev->header_ops
directly. When the team device later calls dev_hard_header() or
dev_parse_header(), these callbacks can run with the team net_device
instead of the real lower device, so netdev_priv(dev) is interpreted as
the wrong private type and can crash.
The syzbot report shows a crash in bond_header_create(), but
Bluetooth: btintel: serialize btintel_hw_error() with hci_req_sync_lock
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: serialize btintel_hw_error() with hci_req_sync_lock
btintel_hw_error() issues two __hci_cmd_sync() calls (HCI_OP_RESET
and Intel exception-info retrieval) without holding
hci_req_sync_lock(). This lets it race against
hci_dev_do_close() -> btintel_shutdown_combined(), which also runs
__hci_cmd_sync() under the same lock. When both paths manipulate
hdev->req_status/req_rsp concurrently, the close path may free the
response skb first, and the still-running hw_error path hits a
slab-use-after-free in kfree_skb().
Wrap the whole recovery sequence in hci_r
Bluetooth: L2CAP: Fix ERTM re-init and zero pdu_len infinite loop
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Fix ERTM re-init and zero pdu_len infinite loop
l2cap_config_req() processes CONFIG_REQ for channels in BT_CONNECTED
state to support L2CAP reconfiguration (e.g. MTU changes). However,
since both CONF_INPUT_DONE and CONF_OUTPUT_DONE are already set from
the initial configuration, the reconfiguration path falls through to
l2cap_ertm_init(), which re-initializes tx_q, srej_q, srej_list, and
retrans_list without freeing the previous allocations and sets
chan->sdu to NULL without freeing the existing skb. This leaks all
previously allocated ERTM resources.
Ad
Media · CVSS 5.5EPSS 0,12%Sin corrección publicada
netfilter: nf_conntrack_expect: skip expectations in other netns via proc
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_expect: skip expectations in other netns via proc
Skip expectations that do not reside in this netns.
Similar to e77e6ff502ea ("netfilter: conntrack: do not dump other netns's
conntrack entries via proc").
Media · CVSS 5.5EPSS 0,13%Sin corrección publicada
netfilter: ctnetlink: use netlink policy range checks
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ctnetlink: use netlink policy range checks
Replace manual range and mask validations with netlink policy
annotations in ctnetlink code paths, so that the netlink core rejects
invalid values early and can generate extack errors.
- CTA_PROTOINFO_TCP_STATE: reject values > TCP_CONNTRACK_SYN_SENT2 at
policy level, removing the manual >= TCP_CONNTRACK_MAX check.
- CTA_PROTOINFO_TCP_WSCALE_ORIGINAL/REPLY: reject values > TCP_MAX_WSCALE
(14). The normal TCP option parsing path already clamps to this value,
but the ctnetlink path accepted 0-255, causing undefined
In the Linux kernel, the following vulnerability has been resolved:
net: macb: use the current queue number for stats
There's a potential mismatch between the memory reserved for statistics
and the amount of memory written.
gem_get_sset_count() correctly computes the number of stats based on the
active queues, whereas gem_get_ethtool_stats() indiscriminately copies
data using the maximum number of queues, and in the case the number of
active queues is less than MACB_MAX_QUEUES, this results in a OOB write
as observed in the KASAN splat.
==================================================================
BUG: KASAN: vmalloc-out-of-bounds in
In the Linux kernel, the following vulnerability has been resolved:
spi: meson-spicc: Fix double-put in remove path
meson_spicc_probe() registers the controller with
devm_spi_register_controller(), so teardown already drops the
controller reference via devm cleanup.
Calling spi_controller_put() again in meson_spicc_remove()
causes a double-put.
Media · CVSS 5.5EPSS 0,12%Sin corrección publicada
spi: use generic driver_override infrastructure
In the Linux kernel, the following vulnerability has been resolved:
spi: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
Also note that we do not enable the driver_override feature of struct
bus_type, as SPI - in contrast to most other buses - pass
hwmon: (pmbus/core) Protect regulator operations with mutex
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/core) Protect regulator operations with mutex
The regulator operations pmbus_regulator_get_voltage(),
pmbus_regulator_set_voltage(), and pmbus_regulator_list_voltage()
access PMBus registers and shared data but were not protected by
the update_lock mutex. This could lead to race conditions.
However, adding mutex protection directly to these functions causes
a deadlock because pmbus_regulator_notify() (which calls
regulator_notifier_call_chain()) is often called with the mutex
already held (e.g., from pmbus_fault_handler()). If a regulator
callback then calls
spi: spi-fsl-lpspi: fix teardown order issue (UAF)
In the Linux kernel, the following vulnerability has been resolved:
spi: spi-fsl-lpspi: fix teardown order issue (UAF)
There is a teardown order issue in the driver. The SPI controller is
registered using devm_spi_register_controller(), which delays
unregistration of the SPI controller until after the fsl_lpspi_remove()
function returns.
As the fsl_lpspi_remove() function synchronously tears down the DMA
channels, a running SPI transfer triggers the following NULL pointer
dereference due to use after free:
| fsl_lpspi 42550000.spi: I/O Error in DMA RX
| Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
[
media: mc, v4l2: serialize REINIT and REQBUFS with req_queue_mutex
In the Linux kernel, the following vulnerability has been resolved:
media: mc, v4l2: serialize REINIT and REQBUFS with req_queue_mutex
MEDIA_REQUEST_IOC_REINIT can run concurrently with VIDIOC_REQBUFS(0)
queue teardown paths. This can race request object cleanup against vb2
queue cancellation and lead to use-after-free reports.
We already serialize request queueing against STREAMON/OFF with
req_queue_mutex. Extend that serialization to REQBUFS, and also take
the same mutex in media_request_ioctl_reinit() so REINIT is in the
same exclusion domain.
This keeps request cleanup and queue cancellation from running in
parallel for request-capabl
virtio_net: Fix UAF on dst_ops when IFF_XMIT_DST_RELEASE is cleared and napi_tx is false
In the Linux kernel, the following vulnerability has been resolved:
virtio_net: Fix UAF on dst_ops when IFF_XMIT_DST_RELEASE is cleared and napi_tx is false
A UAF issue occurs when the virtio_net driver is configured with napi_tx=N
and the device's IFF_XMIT_DST_RELEASE flag is cleared
(e.g., during the configuration of tc route filter rules).
When IFF_XMIT_DST_RELEASE is removed from the net_device, the network stack
expects the driver to hold the reference to skb->dst until the packet
is fully transmitted and freed. In virtio_net with napi_tx=N,
skbs may remain in the virtio transmit ring for an extended period.
If the network namespace
Media · CVSS 5.7EPSS 0,09%Sin corrección publicada
mm/huge_memory: fix folio isn't locked in softleaf_to_folio()
In the Linux kernel, the following vulnerability has been resolved:
mm/huge_memory: fix folio isn't locked in softleaf_to_folio()
On arm64 server, we found folio that get from migration entry isn't locked
in softleaf_to_folio(). This issue triggers when mTHP splitting and
zap_nonpresent_ptes() races, and the root cause is lack of memory barrier
in softleaf_to_folio(). The race is as follows:
CPU0 CPU1
deferred_split_scan() zap_nonpresent_ptes()
lock folio
split_folio()
unmap_folio()
change ptes to migration entries
__split_folio_to_order()
scsi: ibmvfc: Fix OOB access in ibmvfc_discover_targets_done()
In the Linux kernel, the following vulnerability has been resolved:
scsi: ibmvfc: Fix OOB access in ibmvfc_discover_targets_done()
A malicious or compromised VIO server can return a num_written value in the
discover targets MAD response that exceeds max_targets. This value is
stored directly in vhost->num_targets without validation, and is then used
as the loop bound in ibmvfc_alloc_targets() to index into disc_buf[], which
is only allocated for max_targets entries. Indices at or beyond max_targets
access kernel memory outside the DMA-coherent allocation. The
out-of-bounds data is subsequently embedded in Implicit Logout and PLOGI
MADs tha
Media · CVSS 5.5EPSS 0,16%Sin corrección publicada
drm/amdgpu: prevent immediate PASID reuse case
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: prevent immediate PASID reuse case
PASID resue could cause interrupt issue when process
immediately runs into hw state left by previous
process exited with the same PASID, it's possible that
page faults are still pending in the IH ring buffer when
the process exits and frees up its PASID. To prevent the
case, it uses idr cyclic allocator same as kernel pid's.
(cherry picked from commit 8f1de51f49be692de137c8525106e0fce2d1912d)
ext4: convert inline data to extents when truncate exceeds inline size
In the Linux kernel, the following vulnerability has been resolved:
ext4: convert inline data to extents when truncate exceeds inline size
Add a check in ext4_setattr() to convert files from inline data storage
to extent-based storage when truncate() grows the file size beyond the
inline capacity. This prevents the filesystem from entering an
inconsistent state where the inline data flag is set but the file size
exceeds what can be stored inline.
Without this fix, the following sequence causes a kernel BUG_ON():
1. Mount filesystem with inode that has inline flag set and small size
2. truncate(file, 50MB) - grows size but inline flag rema
ext4: replace BUG_ON with proper error handling in ext4_read_inline_folio
In the Linux kernel, the following vulnerability has been resolved:
ext4: replace BUG_ON with proper error handling in ext4_read_inline_folio
Replace BUG_ON() with proper error handling when inline data size
exceeds PAGE_SIZE. This prevents kernel panic and allows the system to
continue running while properly reporting the filesystem corruption.
The error is logged via ext4_error_inode(), the buffer head is released
to prevent memory leak, and -EFSCORRUPTED is returned to indicate
filesystem corruption.
In the Linux kernel, the following vulnerability has been resolved:
ext4: publish jinode after initialization
ext4_inode_attach_jinode() publishes ei->jinode to concurrent users.
It used to set ei->jinode before jbd2_journal_init_jbd_inode(),
allowing a reader to observe a non-NULL jinode with i_vfs_inode
still unset.
The fast commit flush path can then pass this jinode to
jbd2_wait_inode_data(), which dereferences i_vfs_inode->i_mapping and
may crash.
Below is the crash I observe:
```
BUG: unable to handle page fault for address: 000000010beb47f4
PGD 110e51067 P4D 110e51067 PUD 0
Oops: Oops: 0000 [#1] SMP NOPTI
CPU: 1 UID: 0 PID: 4850 Co
ext4: validate p_idx bounds in ext4_ext_correct_indexes
In the Linux kernel, the following vulnerability has been resolved:
ext4: validate p_idx bounds in ext4_ext_correct_indexes
ext4_ext_correct_indexes() walks up the extent tree correcting
index entries when the first extent in a leaf is modified. Before
accessing path[k].p_idx->ei_block, there is no validation that
p_idx falls within the valid range of index entries for that
level.
If the on-disk extent header contains a corrupted or crafted
eh_entries value, p_idx can point past the end of the allocated
buffer, causing a slab-out-of-bounds read.
Fix this by validating path[k].p_idx against EXT_LAST_INDEX() at
both access sites: before the