usb: usbtmc: check URB actual_length for interrupt-IN notifications
In the Linux kernel, the following vulnerability has been resolved:
usb: usbtmc: check URB actual_length for interrupt-IN notifications
USBTMC devices can use an optional interrupt endpoint for notification
messages. These typically contain two-byte headers indicating the
payload format, but the driver does not check if these headers are
present before accessing the data buffers. In cases where the URB
actual_length is not enough to fit these headers, the driver will either
cause an out-of-bounds read, or consume stale leftover data from a
previous notification.
Fix by checking if actual_data contains enough bytes for the headers,
otherwis
USB: serial: belkin_sa: validate interrupt status length
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: belkin_sa: validate interrupt status length
The Belkin interrupt callback treats interrupt data as a four-byte
status report and reads LSR/MSR fields at offsets 2 and 3. The
interrupt-in buffer length is derived from endpoint wMaxPacketSize, and
short interrupt transfers may complete successfully with a smaller
actual_length.
Check the completed interrupt packet length before parsing status
fields so short interrupt endpoints and short successful packets are
ignored instead of causing out-of-bounds or stale status-byte reads.
KASAN report as below:
BUG: KASA
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: cypress_m8: validate interrupt packet headers
cypress_read_int_callback() parses the interrupt-in buffer according to
the selected Cypress packet format. Format 1 has a two-byte status/count
header and format 2 has a one-byte combined status/count header. The
usb-serial core sizes the interrupt-in buffer from the endpoint
descriptor's wMaxPacketSize, and successful interrupt transfers can
complete short when URB_SHORT_NOT_OK is not set.
Check that the completed packet contains the selected header before
reading it. Malformed short reports are ignored and the i
USB: serial: digi_acceleport: fix memory corruption with small endpoints
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix memory corruption with small endpoints
Add the missing bulk-out buffer size sanity checks to avoid
out-of-bounds memory accesses or slab corruption should a malicious
device report smaller buffers than expected.
Media · CVSS 5.5EPSS 0,17%Sin corrección publicada
USB: serial: keyspan: fix missing indat transfer sanity check
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: keyspan: fix missing indat transfer sanity check
Add the missing sanity check on the size of usa49wg indat transfers to
avoid parsing stale or uninitialised slab data.
USB: serial: mxuport: fix memory corruption with small endpoint
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: mxuport: fix memory corruption with small endpoint
Make sure that the bulk-out endpoint max packet size is at least eight
bytes to avoid user-controlled slab corruption should a malicious device
report a smaller size.
USB: serial: mct_u232: fix memory corruption with small endpoint
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: mct_u232: fix memory corruption with small endpoint
The driver overrides the maximum transfer size for a specific device
which only accepts 16 byte packets for its 32 byte bulk-out endpoint.
Make sure to never increase the maximum transfer size to prevent slab
corruption should a malicious device report a smaller endpoint max
packet size than expected.
Media · CVSS 5.5EPSS 0,17%Sin corrección publicada
USB: serial: mct_u232: fix missing interrupt-in transfer sanity check
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: mct_u232: fix missing interrupt-in transfer sanity check
Add the missing sanity check on the size of interrupt-in transfers to
avoid parsing stale or uninitialised slab data (and leaking it to user
space).
usb: gadget: f_fs: copy only received bytes on short ep0 read
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_fs: copy only received bytes on short ep0 read
ffs_ep0_read() allocates its control-OUT data buffer with
kmalloc() (not kzalloc) at the Length value from the Setup
packet, then copies that full len to userspace regardless of
how many bytes were actually received:
data = kmalloc(len, GFP_KERNEL);
...
ret = __ffs_ep0_queue_wait(ffs, data, len);
if ((ret > 0) && (copy_to_user(buf, data, len)))
ret = -EFAULT;
__ffs_ep0_queue_wait() returns req->actual, which on a short
control OUT transfer is strictly less than len. The
copy_to_user
thunderbolt: property: Reject u32 wrap in tb_property_entry_valid()
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: property: Reject u32 wrap in tb_property_entry_valid()
entry->value is u32 and entry->length is u16; the sum is performed in
u32 and wraps. A malicious XDomain peer can pick
value = 0xffffff00, length = 0x100 so the sum 0x100000000 wraps to 0
and passes the > block_len check. tb_property_parse() then passes
entry->value to parse_dwdata() as a dword offset into the property
block, reading attacker-directed memory far past the allocation.
For TEXT-typed entries with the "deviceid" or "vendorid" keys this
lands in xd->device_name / xd->vendor_name and is readab
thunderbolt: property: Reject dir_len < 4 to prevent size_t underflow
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: property: Reject dir_len < 4 to prevent size_t underflow
On the non-root path, __tb_property_parse_dir() takes dir_len from
entry->length (u16 widened to size_t). Two distinct OOB conditions
follow when entry->length < 4:
1. The non-root path begins with kmemdup(&block[dir_offset],
sizeof(*dir->uuid), ...) which always reads 4 dwords from
dir_offset. tb_property_entry_valid() only enforces
dir_offset + entry->length <= block_len, so a crafted entry
with dir_offset close to the end of the property block and
entry->length in 0..3 passes that gat
thunderbolt: property: Cap recursion depth in __tb_property_parse_dir()
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: property: Cap recursion depth in __tb_property_parse_dir()
A DIRECTORY entry's value field is used as the dir_offset for a
recursive call into __tb_property_parse_dir() with no depth counter.
A crafted peer that chains DIRECTORY entries into a back-reference
loop drives the parser until the kernel stack is exhausted and the
guard page fires. Any untrusted XDomain peer (cable, dock, in-line
inspector, adjacent host) that reaches the PROPERTIES_REQUEST
control-plane exchange can trigger this without authentication.
Thread a depth counter through tb_property_par
scsi: fcoe: Reject FIP descriptors with zero fip_dlen in CVL walker
In the Linux kernel, the following vulnerability has been resolved:
scsi: fcoe: Reject FIP descriptors with zero fip_dlen in CVL walker
drivers/scsi/fcoe/fcoe_ctlr.c::fcoe_ctlr_recv_clr_vlink() advanced the
descriptor cursor by an attacker-supplied fip_dlen without ever
requiring dlen >= sizeof(struct fip_desc) in the default branch. The
named descriptor cases (FIP_DT_MAC, FIP_DT_NAME, FIP_DT_VN_ID) checked
their per-type minimum lengths, but a FIP_DT_NON_CRITICAL descriptor
(fip_dtype >= 128, which the standard requires receivers to silently
ignore) skipped that check entirely.
An unauthenticated L2 peer on the FCoE control VLAN could ha
scsi: target: iscsi: Fix CRC overread and double-free in iscsit_handle_text_cmd()
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: iscsi: Fix CRC overread and double-free in iscsit_handle_text_cmd()
Two latent bugs in the Text-phase handler, both present since the
original LIO integration in commit e48354ce078c ("iscsi-target: Add
iSCSI fabric support for target v4.1"):
1) DataDigest CRC buffer overread (4 bytes past text_in).
text_in is kzalloc()'d at ALIGN(payload_length, 4). rx_size is then
incremented by ISCSI_CRC_LEN to make room for the received DataDigest
in the iovec, but the same (now-bumped) rx_size is passed as the
buffer length to iscsit_crc_buf():
if (c
scsi: target: iscsi: Bound iscsi_encode_text_output() appends to rsp_buf
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: iscsi: Bound iscsi_encode_text_output() appends to rsp_buf
iscsi_encode_text_output() concatenates "key=value\0" records into
login->rsp_buf, an 8192-byte kzalloc(MAX_KEY_VALUE_PAIRS) buffer
allocated in iscsit_alloc_login_setup_buffer(). The three sprintf() call
sites in this function (lines 1398, 1411, 1424 in v7.1-rc2) never check
the remaining buffer capacity:
*length += sprintf(output_buf, "%s=%s", er->key, er->value);
*length += 1;
output_buf = textbuf + *length;
The 8192-byte ceiling at iscsi_target_check_login_request() bounds the
*input* Login PD
ieee802154: 6lowpan: only accept IPv6 packets in lowpan_xmit()
In the Linux kernel, the following vulnerability has been resolved:
ieee802154: 6lowpan: only accept IPv6 packets in lowpan_xmit()
The aoe driver (or similar) generates a non-IPv6 packet
(e.g., ETH_P_AOE) and queues it for transmission via dev_queue_xmit()
on a 6LoWPAN interface (configured by the user or test case).
Since the packet is not IPv6, the 6LoWPAN header_ops->create function
(lowpan_header_create or header_create) returns early without initializing
the lowpan_addr_info structure in the skb headroom.
In the transmit function (lowpan_xmit), the driver calls lowpan_header
(or setup_header) which unconditionally copies and uses the
Media · CVSS 5.5EPSS 0,12%Sin corrección publicada
net: garp: fix unsigned integer underflow in garp_pdu_parse_attr
In the Linux kernel, the following vulnerability has been resolved:
net: garp: fix unsigned integer underflow in garp_pdu_parse_attr
The receive-side GARP attribute parser computes dlen with reversed
operands:
dlen = sizeof(*ga) - ga->len;
ga->len is the on-wire attribute length and includes the GARP attribute
header. For normal attributes with data, ga->len is larger than
sizeof(*ga), so the subtraction underflows in unsigned arithmetic.
The resulting value is later passed to garp_attr_lookup(), whose length
argument is u8. After truncation, the parsed data length usually no
longer matches the length stored for locally registere
In the Linux kernel, the following vulnerability has been resolved:
RDMA/core: Prefer NLA_NUL_STRING
These attributes are evaluated as c-string (passed to strcmp), but
NLA_STRING doesn't check for the presence of a \0 terminator.
Either this needs to switch to nla_strcmp() and needs to adjust printf fmt
specifier to not use plain %s, or this needs to use NLA_NUL_STRING.
As the code has been this way for long time, it seems to me that userspace
does include the terminating nul, even tough its not enforced so far, and
thus NLA_NUL_STRING use is the simpler solution.
batman-adv: tp_meter: avoid divide-by-zero for dec_cwnd
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tp_meter: avoid divide-by-zero for dec_cwnd
The cwnd is always MSS <= cwnd <= 0x20000000. But the calculation in
batadv_tp_update_cwnd() assumes unsigned 32 bit arithmetics.
((mss * 8) ** 2) / (cwnd * 8)
In case cwnd is actually 0x20000000, it will be shifted by 3 bit to the
left end up at 0x100000000 or U32_MAX + 1. It will therefore wrap around
and be 0 - resulting in:
((mss * 8) ** 2) / 0
This is of course invalid and cannot be calculated. The calculation should
must be simplified to avoid this overflow:
(mss ** 2) * 8 / cwnd
It will keep the
batman-adv: tp_meter: restrict number of unacked list entries
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tp_meter: restrict number of unacked list entries
When the unacked_list is unbound, an attacker could send messages with
small lengths and appropriated seqno + gaps to force the receiver to
allocate more and more unacked_list entries. And the end either causing an
out-of-memory situation or increase the management overhead for the (large)
list that significant portions of CPU cycles are wasted in searching
through the list.
When limiting the list to a specific number, it is important to still
correctly add a new entry to the list. But if the list became larger