Media · CVSS 5.7EPSS 0,15%Sin corrección publicada
net/sched: act_ife: avoid possible NULL deref
In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_ife: avoid possible NULL deref
tcf_ife_encode() must make sure ife_encode() does not return NULL.
syzbot reported:
Oops: general protection fault, probably for non-canonical address 0xdffffc0000000000: 0000 [#1] SMP KASAN NOPTI
KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007]
RIP: 0010:ife_tlv_meta_encode+0x41/0xa0 net/ife/ife.c:166
CPU: 3 UID: 0 PID: 8990 Comm: syz.0.696 Not tainted syzkaller #0 PREEMPT(full)
Call Trace:
<TASK>
ife_encode_meta_u32+0x153/0x180 net/sched/act_ife.c:101
tcf_ife_encode net/sched/act_ife.c:841 [inline
In the Linux kernel, the following vulnerability has been resolved:
can: kvaser_usb: kvaser_usb_read_bulk_callback(): fix URB memory leak
Fix similar memory leak as in commit 7352e1d5932a ("can: gs_usb:
gs_usb_receive_bulk_callback(): fix URB memory leak").
In kvaser_usb_set_{,data_}bittiming() -> kvaser_usb_setup_rx_urbs(), the
URBs for USB-in transfers are allocated, added to the dev->rx_submitted
anchor and submitted. In the complete callback
kvaser_usb_read_bulk_callback(), the URBs are processed and resubmitted. In
kvaser_usb_remove_interfaces() the URBs are freed by calling
usb_kill_anchored_urbs(&dev->rx_submitted).
However, this d
Media · CVSS 6.8EPSS 0,18%Sin corrección publicada
crypto: authencesn - reject too-short AAD (assoclen<8) to match ESP/ESN spec
In the Linux kernel, the following vulnerability has been resolved:
crypto: authencesn - reject too-short AAD (assoclen<8) to match ESP/ESN spec
authencesn assumes an ESP/ESN-formatted AAD. When assoclen is shorter than
the minimum expected length, crypto_authenc_esn_decrypt() can advance past
the end of the destination scatterlist and trigger a NULL pointer dereference
in scatterwalk_map_and_copy(), leading to a kernel panic (DoS).
Add a minimum AAD length check to fail fast on invalid inputs.
In the Linux kernel, the following vulnerability has been resolved:
can: ems_usb: ems_usb_read_bulk_callback(): fix URB memory leak
Fix similar memory leak as in commit 7352e1d5932a ("can: gs_usb:
gs_usb_receive_bulk_callback(): fix URB memory leak").
In ems_usb_open(), the URBs for USB-in transfers are allocated, added to
the dev->rx_submitted anchor and submitted. In the complete callback
ems_usb_read_bulk_callback(), the URBs are processed and resubmitted. In
ems_usb_close() the URBs are freed by calling
usb_kill_anchored_urbs(&dev->rx_submitted).
However, this does not take into account that the USB framework unanchors
the URB before
iio: adc: at91-sama5d2_adc: Fix potential use-after-free in sama5d2_adc driver
In the Linux kernel, the following vulnerability has been resolved:
iio: adc: at91-sama5d2_adc: Fix potential use-after-free in sama5d2_adc driver
at91_adc_interrupt can call at91_adc_touch_data_handler function
to start the work by schedule_work(&st->touch_st.workq).
If we remove the module which will call at91_adc_remove to
make cleanup, it will free indio_dev through iio_device_unregister but
quite a bit later. While the work mentioned above will be used. The
sequence of operations that may lead to a UAF bug is as follows:
CPU0 CPU1
| at91_adc_workq_handler
at91
In the Linux kernel, the following vulnerability has been resolved:
net: hv_netvsc: reject RSS hash key programming without RX indirection table
RSS configuration requires a valid RX indirection table. When the device
reports a single receive queue, rndis_filter_device_add() does not
allocate an indirection table, accepting RSS hash key updates in this
state leads to a hang.
Fix this by gating netvsc_set_rxfh() on ndc->rx_table_sz and return
-EOPNOTSUPP when the table is absent. This aligns set_rxfh with the device
capabilities and prevents incorrect behavior.
pNFS: Fix a deadlock when returning a delegation during open()
In the Linux kernel, the following vulnerability has been resolved:
pNFS: Fix a deadlock when returning a delegation during open()
Ben Coddington reports seeing a hang in the following stack trace:
0 [ffffd0b50e1774e0] __schedule at ffffffff9ca05415
1 [ffffd0b50e177548] schedule at ffffffff9ca05717
2 [ffffd0b50e177558] bit_wait at ffffffff9ca061e1
3 [ffffd0b50e177568] __wait_on_bit at ffffffff9ca05cfb
4 [ffffd0b50e1775c8] out_of_line_wait_on_bit at ffffffff9ca05ea5
5 [ffffd0b50e177618] pnfs_roc at ffffffffc154207b [nfsv4]
6 [ffffd0b50e1776b8] _nfs4_proc_delegreturn at ffffffffc1506586 [nfsv4]
7 [ffffd0b50e177788] nfs4_proc_d
drm/panel-simple: fix connector type for DataImage SCF0700C48GGU18 panel
In the Linux kernel, the following vulnerability has been resolved:
drm/panel-simple: fix connector type for DataImage SCF0700C48GGU18 panel
The connector type for the DataImage SCF0700C48GGU18 panel is missing and
devm_drm_panel_bridge_add() requires connector type to be set. This leads
to a warning and a backtrace in the kernel log and panel does not work:
"
WARNING: CPU: 3 PID: 38 at drivers/gpu/drm/bridge/panel.c:379 devm_drm_of_get_bridge+0xac/0xb8
"
The warning is triggered by a check for valid connector type in
devm_drm_panel_bridge_add(). If there is no valid connector type
set for a panel, the warning is printed and panel is not ad
In the Linux kernel, the following vulnerability has been resolved:
phy: stm32-usphyc: Fix off by one in probe()
The "index" variable is used as an index into the usbphyc->phys[] array
which has usbphyc->nphys elements. So if it is equal to usbphyc->nphys
then it is one element out of bounds. The "index" comes from the
device tree so it's data that we trust and it's unlikely to be wrong,
however it's obviously still worth fixing the bug. Change the > to >=.
Media · CVSS 5.7EPSS 0,18%Sin corrección publicada
btrfs: fix deadlock in wait_current_trans() due to ignored transaction type
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix deadlock in wait_current_trans() due to ignored transaction type
When wait_current_trans() is called during start_transaction(), it
currently waits for a blocked transaction without considering whether
the given transaction type actually needs to wait for that particular
transaction state. The btrfs_blocked_trans_types[] array already defines
which transaction types should wait for which transaction states, but
this check was missing in wait_current_trans().
This can lead to a deadlock scenario involving two transactions and
pending ordered extents:
1. Transa
phy: qcom-qusb2: Fix NULL pointer dereference on early suspend
In the Linux kernel, the following vulnerability has been resolved:
phy: qcom-qusb2: Fix NULL pointer dereference on early suspend
Enabling runtime PM before attaching the QPHY instance as driver data
can lead to a NULL pointer dereference in runtime PM callbacks that
expect valid driver data. There is a small window where the suspend
callback may run after PM runtime enabling and before runtime forbid.
This causes a sporadic crash during boot:
```
Unable to handle kernel NULL pointer dereference at virtual address 00000000000000a1
[...]
CPU: 0 UID: 0 PID: 11 Comm: kworker/0:1 Not tainted 6.16.7+ #116 PREEMPT
Workqueue: pm pm_runtime_work
libceph: make calc_target() set t->paused, not just clear it
In the Linux kernel, the following vulnerability has been resolved:
libceph: make calc_target() set t->paused, not just clear it
Currently calc_target() clears t->paused if the request shouldn't be
paused anymore, but doesn't ever set t->paused even though it's able to
determine when the request should be paused. Setting t->paused is left
to __submit_request() which is fine for regular requests but doesn't
work for linger requests -- since __submit_request() doesn't operate
on linger requests, there is nowhere for lreq->t.paused to be set.
One consequence of this is that watches don't get reestablished on
paused -> unpaused transitions in
ALSA: ac97: fix a double free in snd_ac97_controller_register()
In the Linux kernel, the following vulnerability has been resolved:
ALSA: ac97: fix a double free in snd_ac97_controller_register()
If ac97_add_adapter() fails, put_device() is the correct way to drop
the device reference. kfree() is not required.
Add kfree() if idr_alloc() fails and in ac97_adapter_release() to do
the cleanup.
Found by code review.
pnfs/flexfiles: Fix memory leak in nfs4_ff_alloc_deviceid_node()
In the Linux kernel, the following vulnerability has been resolved:
pnfs/flexfiles: Fix memory leak in nfs4_ff_alloc_deviceid_node()
In nfs4_ff_alloc_deviceid_node(), if the allocation for ds_versions fails,
the function jumps to the out_scratch label without freeing the already
allocated dsaddrs list, leading to a memory leak.
Fix this by jumping to the out_err_drain_dsaddrs label, which properly
frees the dsaddrs list before cleaning up other resources.
dmaengine: omap-dma: fix dma_pool resource leak in error paths
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: omap-dma: fix dma_pool resource leak in error paths
The dma_pool created by dma_pool_create() is not destroyed when
dma_async_device_register() or of_dma_controller_register() fails,
causing a resource leak in the probe error paths.
Add dma_pool_destroy() in both error paths to properly release the
allocated dma_pool resource.
In the Linux kernel, the following vulnerability has been resolved:
can: gs_usb: gs_usb_receive_bulk_callback(): fix URB memory leak
In gs_can_open(), the URBs for USB-in transfers are allocated, added to the
parent->rx_submitted anchor and submitted. In the complete callback
gs_usb_receive_bulk_callback(), the URB is processed and resubmitted. In
gs_can_close() the URBs are freed by calling
usb_kill_anchored_urbs(parent->rx_submitted).
However, this does not take into account that the USB framework unanchors
the URB before the complete function is called. This means that once an
in-URB has been completed, it is no longer anchored and is u
Media · CVSS 5.5EPSS 0,21%Sin corrección publicada
dmaengine: at_hdmac: fix device leak on of_dma_xlate()
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: at_hdmac: fix device leak on of_dma_xlate()
Make sure to drop the reference taken when looking up the DMA platform
device during of_dma_xlate() when releasing channel resources.
Note that commit 3832b78b3ec2 ("dmaengine: at_hdmac: add missing
put_device() call in at_dma_xlate()") fixed the leak in a couple of
error paths but the reference is still leaking on successful allocation.
Media · CVSS 5.5EPSS 0,21%Sin corrección publicada
dmaengine: bcm-sba-raid: fix device leak on probe
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: bcm-sba-raid: fix device leak on probe
Make sure to drop the reference taken when looking up the mailbox device
during probe on probe failures and on driver unbind.
Media · CVSS 5.5EPSS 0,21%Sin corrección publicada
dmaengine: lpc18xx-dmamux: fix device leak on route allocation
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: lpc18xx-dmamux: fix device leak on route allocation
Make sure to drop the reference taken when looking up the DMA mux
platform device during route allocation.
Note that holding a reference to a device does not prevent its driver
data from going away so there is no point in keeping the reference.
Media · CVSS 5.5EPSS 0,21%Sin corrección publicada
dmaengine: stm32: dmamux: fix device leak on route allocation
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: stm32: dmamux: fix device leak on route allocation
Make sure to drop the reference taken when looking up the DMA mux
platform device during route allocation.
Note that holding a reference to a device does not prevent its driver
data from going away so there is no point in keeping the reference.