ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps()
In the Linux kernel, the following vulnerability has been resolved:
ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps()
ceph_handle_caps() reads snap_trace_len from the wire-format
ceph_mds_caps header and uses it unconditionally to build a fake
end pointer (snaptrace + snaptrace_len) that is later handed to
ceph_update_snap_trace() in the CEPH_CAP_OP_IMPORT case:
snaptrace = h + 1;
snaptrace_len = le32_to_cpu(h->snap_trace_len);
p = snaptrace + snaptrace_len;
...
case CEPH_CAP_OP_IMPORT:
if (snaptrace_len) {
...
if (ceph_update_snap_trace(mdsc, snaptr
libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE
In the Linux kernel, the following vulnerability has been resolved:
libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE
__decode_pg_temp() decodes an user-controlled length but only rejects
values large enough to overflow the allocation; it does not bound it to
CEPH_PG_MAX_SIZE. The helper backs both pg_temp and pg_upmap decoding, and
apply_upmap()/get_temp_osds() later copy the decoded list into the fixed-size
on-stack array struct ceph_osds.osds[CEPH_PG_MAX_SIZE]. A monitor that sends
an OSDMap with a pg_temp/pg_upmap entry longer than 32 thus causes a stack
out-of-bounds write.
An OSD set for a single PG can never exce
libceph: Fix multiplication overflow in decode_new_up_state_weight()
In the Linux kernel, the following vulnerability has been resolved:
libceph: Fix multiplication overflow in decode_new_up_state_weight()
If a message of type CEPH_MSG_OSD_MAP contains a (maliciously) corrupted
osdmap, out-of-bounds memory accesses may occur in
decode_new_up_state_weight(). This happens because the bounds check for
the new_state part is based on calculating its length depending on a len
value read from the incoming message. This calculation may overflow
leading to an incorrect bounds check. Subsequently, out-of-bounds reads
may occur when decoding this part.
This patch switches the multiplication to use check_mul_overflow()
libceph: refresh auth->authorizer_buf{,_len} after authorizer update
In the Linux kernel, the following vulnerability has been resolved:
libceph: refresh auth->authorizer_buf{,_len} after authorizer update
ceph_x_create_authorizer() caches au->buf->vec.iov_base and
au->buf->vec.iov_len in struct ceph_auth_handshake. These
cached values are then used by the messenger connect code when
sending the authorizer.
ceph_x_update_authorizer() can rebuild the authorizer when a newer
service ticket is available. If the rebuilt authorizer no longer
fits in the existing buffer, ceph_x_build_authorizer() drops its
reference to au->buf and allocates a new one. If this is the final
reference, ceph_buffer_put() frees the
In the Linux kernel, the following vulnerability has been resolved:
libceph: Reject monmaps advertising zero monitors
A message of type CEPH_MSG_MON_MAP contains a monmap that is sent from a
monitor to the client. This monmap contains information about the
existing monitors in the cluster. Currently, a monmap indicating that
there are zero monitors in the cluster is treated as valid. However, it
is impossible to have zero monitors in the cluster and still receive a
valid monmap from a monitor. Therefore, such a monmap must be corrupted
and should be treated as invalid. Furthermore, a monmap with a monitor
count of zero can subsequently cras
In the Linux kernel, the following vulnerability has been resolved:
libceph: reject zero bucket types in crush_decode
CRUSH bucket type 0 is reserved for devices. The mapper relies on
that invariant and uses type 0 to identify leaf devices.
If crush_decode() accepts a bucket with type 0, a malformed CRUSH map
can make the mapper treat a negative bucket ID as a device and pass it
to is_out(), which then indexes the OSD weight array with a negative
value.
Reject zero bucket types while decoding the CRUSH map so the invalid
state never reaches the mapper.
libceph: remove debugfs files before client teardown
In the Linux kernel, the following vulnerability has been resolved:
libceph: remove debugfs files before client teardown
ceph_destroy_client() tears down the monitor client before removing
the per-client debugfs files. A concurrent read of the monmap debugfs
file can enter monmap_show() after ceph_monc_stop() has freed
monc->monmap, triggering a use-after-free.
Remove the debugfs files before stopping the OSD and monitor clients.
debugfs_remove() drains active handlers and prevents new accesses, so
the debugfs callbacks can no longer race the rest of client teardown.
In the Linux kernel, the following vulnerability has been resolved:
binfmt_elf_fdpic: only honour the first PT_INTERP
The program header scan handles PT_INTERP from a switch nested in the
scan loop, so its break leaves the switch and not the loop. A binary
carrying more than one PT_INTERP runs the case again and overwrites both
interpreter_name and interpreter. The previous name allocation leaks and
so does the previous interpreter reference, along with the write denial
open_exec() took on it. The denial is never released, so the file stays
unwritable for as long as the system runs.
An unprivileged caller reaches this with a crafted binary
ftrace: Add global mutex to serialize trace_parser access
In the Linux kernel, the following vulnerability has been resolved:
ftrace: Add global mutex to serialize trace_parser access
In ftrace, the trace_parser structure is allocated and initialized when
a trace file is opened, and is subsequently used across write and release
handlers to parse user input.
The affected handler paths and their specific functions are:
- Open paths: ftrace_regex_open(), ftrace_graph_open()
- Write paths: ftrace_regex_write(), ftrace_graph_write()
- Release paths: ftrace_regex_release(), ftrace_graph_release()
If userspace opens a trace file descriptor and shares it across multiple
threads, concurrent write c
In the Linux kernel, the following vulnerability has been resolved:
phonet: pep: fix use-after-free in pep_get_sb()
pep_get_sb() doesn't consider that pskb_may_pull() might have relocated
the skb data, and continue to access the older pointer, causing UAF.
Reproduced under KASAN:
BUG: KASAN: slab-use-after-free in pep_get_sb+0x234/0x3b0
Read of size 1 at addr ff11000105510f50 by task repro/157
pep_get_sb+0x234/0x3b0
pipe_handler_do_rcv+0x5f7/0xa10
pep_do_rcv+0x203/0x410
__sk_receive_skb+0x471/0x4a0
phonet_rcv+0x5b3/0x6c0
__netif_receive_skb+0xcc/0x1d0
Refetch the header with skb_header_pointer() after pskb_may_pull(
net: slip: serialize receive against buffer reallocation
In the Linux kernel, the following vulnerability has been resolved:
net: slip: serialize receive against buffer reallocation
sl_realloc_bufs() replaces rbuff and updates buffsize while holding
sl->lock. slip_receive_buf() reads those fields and writes through rbuff
without holding the lock.
An MTU change can therefore race with receive processing. An MTU shrink
can expose the new smaller rbuff with the old larger bound, causing an
out-of-bounds write. A receive callback which already loaded the old
rbuff can instead continue writing after that buffer has been freed.
Serialize receive processing with sl_realloc_bufs() by holding sl->lock
w
geneve: require CAP_NET_ADMIN in the device netns for changelink
In the Linux kernel, the following vulnerability has been resolved:
geneve: require CAP_NET_ADMIN in the device netns for changelink
A tunnel changelink() operates on at most two netns, dev_net(dev) and
the sticky underlay netns geneve->net. They differ once the device is
created in or moved to a netns other than the one the request runs in.
The rtnl changelink path checks CAP_NET_ADMIN only against dev_net(dev),
so a caller privileged there but not in geneve->net can rewrite a geneve
device whose underlay lives in geneve->net.
geneve_changelink() applies the new configuration against geneve->net:
geneve_link_config() and the geneve_quiesc
net/af_iucv: fix NULL deref in afiucv_hs_callback_syn()
In the Linux kernel, the following vulnerability has been resolved:
net/af_iucv: fix NULL deref in afiucv_hs_callback_syn()
afiucv_hs_callback_syn() allocates the child socket with GFP_ATOMIC.
If the allocation fails, nsk is NULL.
The connection-refused path is entered when the listen state check
fails, the accept backlog is full, or nsk is NULL. The code
unconditionally calls iucv_sock_kill(nsk) in that path.
iucv_sock_kill() does not accept a NULL socket pointer and immediately
dereferences sk via sock_flag(sk, SOCK_ZAPPED). When nsk is NULL,
calling iucv_sock_kill(nsk) results in a NULL pointer dereference.
Only call iucv_sock_kill()
net/iucv: fix use-after-free of a severed iucv_path
In the Linux kernel, the following vulnerability has been resolved:
net/iucv: fix use-after-free of a severed iucv_path
af_iucv queues not-yet-received message notifications on iucv->message_q,
each holding a raw pointer to the connection's iucv_path. When the peer
severs the connection, iucv_sever_path() frees that path with
iucv_path_free() but leaves the notifications queued. A later recvmsg()
drains message_q via iucv_process_message_q() and hands the stale path to
message_receive() -- a use-after-free of the freed iucv_path.
Drop the queued notifications when the path is severed; once the path is
gone they can no longer be received.
net/sched: serialize qdisc_rtab_list against concurrent get/put
In the Linux kernel, the following vulnerability has been resolved:
net/sched: serialize qdisc_rtab_list against concurrent get/put
qdisc_get_rtab() and qdisc_put_rtab() mutate the process-global singly
linked list qdisc_rtab_list and a plain non-atomic 'int refcnt' with no
lock. This was only safe because every caller historically held the RTNL
mutex, which serialized all rate-table lookups, inserts and frees.
That invariant no longer holds. cls_flower sets
TCF_PROTO_OPS_DOIT_UNLOCKED, so tc_new_tfilter() keeps rtnl_held == false
for it and sets TCA_ACT_FLAGS_NO_RTNL. That flag propagates through
tcf_exts_validate_ex() -> tcf_action_init(
net: hip04: fix RX buffer leak on build_skb failure
In the Linux kernel, the following vulnerability has been resolved:
net: hip04: fix RX buffer leak on build_skb failure
When build_skb() fails in hip04_rx_poll(), the driver jumps to the
refill path without releasing the current RX buffer and its DMA mapping.
Installing a replacement buffer then overwrites the slot references and
leaks both resources.
Keep the current slot intact and return budget so NAPI retries the same
buffer. Also free a newly allocated RX fragment when dma_map_single()
fails.
This issue was found by an in-house static analysis tool.
super: fix emergency thaw deadlock on frozen block devices
In the Linux kernel, the following vulnerability has been resolved:
super: fix emergency thaw deadlock on frozen block devices
do_thaw_all_callback() calls bdev_thaw() while holding sb->s_umount
exclusively. If the block device was frozen via bdev_freeze() dropping
the last block layer freeze reference calls fs_bdev_thaw() which
reacquires s_umount:
do_thaw_all_callback(sb)
super_lock_excl(sb) # holds sb->s_umount
bdev_thaw(sb->s_bdev)
mutex_lock(&bdev->bd_fsfreeze_mutex)
# bd_fsfreeze_count drops 1 -> 0
bd_holder_ops->thaw == fs_bdev_thaw
get_bdev_super(bdev)
bdev_super_loc
rbd: Reset positive result codes to zero in object map update path
In the Linux kernel, the following vulnerability has been resolved:
rbd: Reset positive result codes to zero in object map update path
In a reply message to an RBD request, a positive result code indicates
a data payload, which is not allowed for writes. While
rbd_osd_req_callback() already resets a positive result code for writes
to zero, rbd_object_map_callback() does not. This allows a corrupted
reply to an object map update to trigger the rbd_assert(*result < 0) in
__rbd_obj_handle_request(). This happens, because
rbd_object_map_callback() calls rbd_obj_handle_request() ->
__rbd_obj_handle_request() and passes this positive result code.
ila: reload IPv6 header after pskb_may_pull in checksum adjust
In the Linux kernel, the following vulnerability has been resolved:
ila: reload IPv6 header after pskb_may_pull in checksum adjust
ila_csum_adjust_transport() caches ip6h = ipv6_hdr(skb) before calling
pskb_may_pull(). On a non-linear skb whose transport header sits in a page
fragment, pskb_may_pull() can call __pskb_pull_tail() / pskb_expand_head()
and free the old skb head, leaving ip6h dangling; the following
get_csum_diff(ip6h, p) then reads freed memory. ila_update_ipv6_locator()
uses ip6h (and the iaddr derived from it) again after the csum-adjust
call and additionally writes the new locator through that pointer.
Impact: a remote IPv
mac802154: llsec: reject frames shorter than the authentication tag
In the Linux kernel, the following vulnerability has been resolved:
mac802154: llsec: reject frames shorter than the authentication tag
llsec_do_decrypt_auth() computes the associated-data length for the
AEAD request as
assoclen += datalen - authlen;
where datalen is the number of bytes after the MAC header and authlen
(4, 8 or 16) is the length of the authentication tag. Nothing verifies
that the frame actually carries at least authlen payload bytes. A
secured frame whose payload is shorter than the tag makes
datalen - authlen negative; assoclen is then passed to
aead_request_set_ad() as an unsigned value close to 4 GiB, so
crypto_aead_