wifi: cfg80211: stop PMSR before P2P and NAN teardown
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: stop PMSR before P2P and NAN teardown
PMSR request teardown must abort active measurements while the
wireless_dev is still present in the driver. cfg80211_leave_locked() and
cfg80211_stop_pd() already do this before invoking the driver's stop
callback, but cfg80211_stop_p2p_device() and cfg80211_stop_nan() do not.
Those helpers are also called directly by nl80211, rfkill shutdown, and
wireless_dev unregister paths. If one of these paths stops a P2P device
or NAN interface with a pending request, it removes the mac80211
subinterface from the driver first. Su
In the Linux kernel, the following vulnerability has been resolved:
firmware: coreboot: Validate table bounds
The existing coreboot_table_populate() bounds checks limit individual
entries to the mapped length. However, coreboot_table_probe() replaces
the platform resource length with header and table sizes supplied by
firmware before mapping the full table.
A malformed table can overflow the 32-bit size addition or advertise an
extent beyond the resource, causing the driver to map and parse memory
outside the resource. A resource shorter than the fixed header is also
mapped as though it contained a complete header.
Reject resources shor
serial: core: do fallible allocations before the console can be registered
In the Linux kernel, the following vulnerability has been resolved:
serial: core: do fallible allocations before the console can be registered
serial_core_add_one_port() allocates uport->tty_groups after
uart_configure_port(), which may register the console. If the allocation
fails, the driver unwinds the port while its console remains registered.
The earlier uport->name allocation has a related failure path that leaves
state->uart_port linked to a port being freed.
Failslab reproduced a NULL dereference in PL011 console output and a KASAN
use-after-free in i.MX console output after failed binds.
Allocate the name and tty_groups before li
serial: core: clear freed pointers on uart_register_driver() failure
In the Linux kernel, the following vulnerability has been resolved:
serial: core: clear freed pointers on uart_register_driver() failure
uart_register_driver() leaves drv->state pointing to freed memory when
tty_alloc_driver() fails. If tty_register_driver() fails, drv->tty_driver
also retains a pointer after its reference is dropped.
Drivers that use drv->state as an "already registered" flag can then skip
registration on the next probe and pass the freed state to
uart_add_one_port().
This issue was found with failslab on QEMU's raspi1ap board by
failing registration and binding the PL011 port again.
Clear both pointers on their failure
In the Linux kernel, the following vulnerability has been resolved:
tty: skip cdev_del() when no cdev is registered
TTY device registration can fail before a cdev is allocated.
Serial core keeps the port so setserial can still use it, and later
removal passes the NULL cdev slot to cdev_del(), causing a NULL-pointer
dereference.
Only delete the cdev when the slot is not NULL.
In the Linux kernel, the following vulnerability has been resolved:
tty: clear cdev pointer after cdev_add() failure
tty_cdev_add() drops the cdev reference when cdev_add() fails, but
leaves driver->cdevs[index] pointing to freed memory.
tty_unregister_device() later passes that stale pointer to cdev_del(),
causing a use-after-free.
Clear the slot after dropping the reference.
Media · CVSS 5.1EPSS 0,17%Sin corrección publicada
dm-integrity: replace forgeable discard filler with a keyed sector marker
In the Linux kernel, the following vulnerability has been resolved:
dm-integrity: replace forgeable discard filler with a keyed sector marker
The discard-block check in dm_integrity_rw_tag() treats a stored tag
of all 0xf6 bytes (DISCARD_FILLER) as proof a block was discarded and
skips HMAC verification. allow_discards is only accepted in
dm-integrity's standalone mode. An attacker with raw write access to
the backing device, but without the integrity key, can stamp any block
with an all-0xf6 tag and have it served as authentic.
Add a new "allow_discards_keyed" target argument that marks discarded
blocks with a keyed checksum of (salt || s
Media · CVSS 4.1EPSS 0,21%Sin corrección publicada
HID: logitech-hidpp: Fix FF device cleanup on init failure
In the Linux kernel, the following vulnerability has been resolved:
HID: logitech-hidpp: Fix FF device cleanup on init failure
hidpp_ff_init() creates the input force-feedback device with
input_ff_create(), then allocates the HID++ FF private data,
effect ID array, and workqueue.
If any of those allocations fail after input_ff_create() succeeds,
the function returns an error without destroying the FF device.
Add an unwind path that frees the private allocations made by
hidpp_ff_init() and calls input_ff_destroy() for failures after
input_ff_create() succeeds.
HID: synchronize input before cleaning up a failed probe
In the Linux kernel, the following vulnerability has been resolved:
HID: synchronize input before cleaning up a failed probe
hid_device_io_start() allows reports to run concurrently with probe. If
the probe subsequently fails, __hid_device_probe() releases driver
resources and clears hdev->driver without first excluding those report
callbacks.
For example, a report may enter hidraw_report_event() while the failure
path frees the associated hidraw object, leading to a use-after-free when
the report takes the object's list lock.
Stop input before performing failed-probe cleanup. This reacquires
driver_input_lock and waits for any report cal
In the Linux kernel, the following vulnerability has been resolved:
HID: steam: Reject short reads
Steam Controller FEATURE reports encode the size of the message in the
message itself. Previously we were trusting that the size reported matched
the size we actually read, leading to a potential issue with short reads.
Instead, we should actually verify the length of the read.
phonet: pep: do not write beyond optlen in getsockopt
In the Linux kernel, the following vulnerability has been resolved:
phonet: pep: do not write beyond optlen in getsockopt
pep_getsockopt() clamps the reported length to the caller's buffer with
min_t(), but then stores the value with put_user(val, (int __user *)
optval), which always writes sizeof(int) bytes. A getsockopt() call with
an optlen smaller than sizeof(int) thus reports the clamped length yet
writes a full int, one to three bytes past the user buffer.
Write the value with copy_to_user() bounded by len, so at most optlen
bytes are copied, matching the length reported back to userspace.
In the Linux kernel, the following vulnerability has been resolved:
ocfs2/cluster: keep heartbeat local node stable
o2nm_node_local_store() handles local=0 by stopping o2net and setting
cl_local_node to O2NM_INVALID_NODE_NUM, but it leaves cl_has_local set.
That stale state makes o2nm_this_node() return 255, blocks a later local=1
attempt with -EBUSY, and can feed 255 to heartbeat users that call
o2nm_this_node() dynamically.
Clearing cl_has_local is required when the local node is reset. But
heartbeat threads can still be running at that point. They pin the local
node config item at startup, yet o2hb_do_disk_heartbeat() and thread
tear
ocfs2: validate inline xattrs during inode block validation
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate inline xattrs during inode block validation
Patch series "ocfs2: validate xattr entry bounds", v7.
This series validates OCFS2 xattr entry name/value bounds when xattr
metadata is read and validated, before getxattr() or listxattr() can walk
out-of-range entry arrays or offsets from corrupted metadata.
This patch (of 2):
ocfs2_validate_inode_block() verifies a dinode before OCFS2 users walk
metadata from it, but inline xattr metadata is still checked only in
operation-specific consumers. The existing ibody lookup helper validates
inline header placement
ocfs2: validate external xattr entries when reading metadata
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate external xattr entries when reading metadata
ocfs2_validate_xattr_block() checks the xattr block header before the
block reaches higher-level xattr users, but it does not verify that a
non-indexed block's xh_count and entry offsets fit inside the block.
Indexed buckets likewise reach list/get consumers after ECC without an
entry-bounds check.
Use the flat xattr entry validator for non-indexed external xattr blocks,
and use a bucket-specific validator for indexed buckets at metadata read
time. The bucket validator keeps the entry array bounded by the first
In the Linux kernel, the following vulnerability has been resolved:
fat: release buffer head after rebuilding parent
fat_scan_logstart() leaves the matching directory entry's buffer head in
sinfo.bh for the caller to release, just like fat_scan().
fat_rebuild_parent() uses the directory entry to rebuild the parent inode
for the nostale_ro NFS export path, but does not release sinfo.bh after a
successful scan. Release it once fat_build_inode() has consumed the
directory entry data.
In the Linux kernel, the following vulnerability has been resolved:
drm/omap: dsi: Do not copy isr table
To be able to unregister stuff from isrs, the corresponding table was
copied. Nobody seems to unregister stuff that way, so it does not help.
But there are stack-allocated objects passed to these isrs giving chances
of UAF of these objects if irqs are unregistered while they are handled,
so better do not copy that table.
PCI/sysfs: Add lockdown checks to legacy I/O and memory handlers
In the Linux kernel, the following vulnerability has been resolved:
PCI/sysfs: Add lockdown checks to legacy I/O and memory handlers
Currently, the legacy I/O and memory sysfs handlers do not check
security_locked_down(LOCKDOWN_PCI_ACCESS), leaving the legacy_io and
legacy_mem files unprotected when the kernel is locked down.
Commit eb627e17727e ("PCI: Lock down BAR access when the kernel is locked
down") added the check to pci_write_config(), pci_mmap_resource(), and
pci_write_resource_io() to prevent userspace from programming DMA-capable
hardware that could be used to modify kernel code, but did not cover the
legacy handlers.
As a resu
remoteproc: fix OOB read via signed offset in rsc_table_for_each_entry()
In the Linux kernel, the following vulnerability has been resolved:
remoteproc: fix OOB read via signed offset in rsc_table_for_each_entry()
table->offset[i] is a u32 from firmware, but was stored into a signed
int. A crafted offset like 0xFFFFFFF0 becomes -16, placing hdr 16 bytes
before the table buffer. The subsequent avail check was bypassed
because the negative int was promoted to a large size_t in the
expression "table_sz - offset - sizeof(*hdr)", yielding a large positive
avail and letting the out-of-bounds hdr->type read proceed undetected.
Store the offset as u32 and validate it with unsigned comparisons before
any pointer arith
bpf, cgroup: Fix invalid storage access after __cgroup_bpf_attach failed
In the Linux kernel, the following vulnerability has been resolved:
bpf, cgroup: Fix invalid storage access after __cgroup_bpf_attach failed
A potential invalid storage access issue can occur after replacing a
cgroup bpf prog.
This occurs in the following scenario:
1. prog1 with storage is attached to a cgroup in multi-attach mode.
2. prog1 is replaced with prog2 using BPF_F_REPLACE in multi-attach
mode, but fails midway (e.g. in bpf_trampoline_link_cgroup_shim or
update_effective_progs).
3. A new prog3 is attached to the cgroup in multi-attach mode.
The reason is that __cgroup_bpf_attach overwrites pl->storage with the
new storage
thermal: hwmon: Remove hwmon class device along with its parent
In the Linux kernel, the following vulnerability has been resolved:
thermal: hwmon: Remove hwmon class device along with its parent
The current code creates one hwmon device per thermal zone type and that
device is registered under the first thermal zone of the given type.
That turns out to be problematic when the thermal zone holding the
hwmon device is removed.
For example, say that there are two ACPI thermal zones on a system
/sys/devices/virtual/thermal/thermal_zone0/
/sys/devices/virtual/thermal/thermal_zone1/
The current code registers a hwmon class device for thermal_zone0 only:
/sys/devices/virtual/thermal/thermal_zone0/hwmo