dm-crypt: reject the lmk IV mode with AEAD ciphers
In the Linux kernel, the following vulnerability has been resolved:
dm-crypt: reject the lmk IV mode with AEAD ciphers
A "capi:" table line that pairs an AEAD cipher with the lmk IV mode,
for example "capi:gcm(aes)-lmk" with the integrity:28:aead option,
causes an oops when it is loaded. lmk sets tfms_count to 64, but
crypt_alloc_tfms_aead only allocates one transform, so crypt_setkey
reads past the end of the tfms_aead array and calls crypto_aead_setkey
on the values it finds there.
lmk exists for compatibility with Loop-AES, which uses CBC, so refuse
it with an AEAD cipher rather than allocate 64 AEAD transforms. The
check cannot go in c
In the Linux kernel, the following vulnerability has been resolved:
dm: fix reading free memory in do_resume
When do_resume calls dm_table_get_mode(new_map), the call is done without
holding any locks (it only holds a reference to the md). It may be
possible that another concurrent ioctl on the same device will swap table
after dm_swap_table and before dm_table_get_mode. In this case,
dm_table_get_mode(new_map) reads freed memory.
This race condition was triggered by syzbot.
This commit fixes the race by reading mode of the new table before
dm_swap_table. Note that new_map is also passed to dm_ima_need_measure,
but this function doesn't a
mmc: mtk-sd: Cancel request timeout work on remove
In the Linux kernel, the following vulnerability has been resolved:
mmc: mtk-sd: Cancel request timeout work on remove
The driver queues req_timeout while a request is active.
msdc_request_done() uses cancel_delayed_work(), which does not wait for
a timeout callback that has already started.
The timeout callback calls mmc_request_done(), which wakes the request
waiter, and then continues to use host->dev_comp and check the SDIO IRQ.
During unbind, msdc_drv_remove() can return and the managed mmc_host can
be freed before the callback finishes.
KASAN reported use-after-free accesses in msdc_request_done() and
msdc_recheck_sdio_irq() in each
In the Linux kernel, the following vulnerability has been resolved:
mmc: sdhci-sprd: disable runtime PM on remove
sdhci_sprd_probe() enables runtime PM, while sdhci_sprd_remove() does
not perform the corresponding runtime PM cleanup.
The probe failure path disables runtime PM before disabling the clocks,
but the normal remove path directly disables clocks that are also
managed by the runtime PM callbacks. If the device is runtime
suspended, those clocks may already be disabled.
Resume the device before removal, disable runtime PM and drop the
temporary runtime PM reference before disabling the clocks.
This issue was found by manual code
net/packet: guard the ll header push in packet_rcv_spkt()
In the Linux kernel, the following vulnerability has been resolved:
net/packet: guard the ll header push in packet_rcv_spkt()
packet_rcv_spkt() restores the link layer header with
skb_push(skb, skb->data - skb_mac_header(skb));
That subtraction is only meaningful when the device actually has a link
layer header. packet_rcv() and tpacket_rcv() both wrap it in
dev_has_header(), which is also the predicate the block comment at the
top of the file states the restore in terms of; packet_rcv_spkt() does
not. commit d549699048b4 ("net/packet: fix packet receive on L3
devices without visible hard header") introduced the helper and changed
the
In the Linux kernel, the following vulnerability has been resolved:
net/smc: protect clcsock lifetime in smc_getname
smc_getname() dereferences smc->clcsock without holding
clcsock_release_lock. Link-group termination can release the CLC socket
through smc_close_active_abort() while the SMC socket is still open,
for example after shutdown(SHUT_WR).
A getsockname() caller can load smc->clcsock, then the termination worker
can clear the pointer and call sock_release() before the caller accesses
clcsock->ops or invokes getname(). This causes a use-after-free; if the
worker clears the pointer before the load, it causes a NULL dereference.
The
net: bridge: avoid recursive multicast port cleanup
In the Linux kernel, the following vulnerability has been resolved:
net: bridge: avoid recursive multicast port cleanup
br_multicast_sg_del_exclude_ports() removes automatically added STAR_EXCL
port groups by calling br_multicast_del_pg(). For S,G entries, that
deletion calls back into br_multicast_sg_del_exclude_ports(), so a large
number of STAR_EXCL ports consumes one kernel stack frame per port and can
hit the stack guard page.
Keep the complete port-group deletion path for cleanup, but suppress the
S,G exclude-port cleanup while that helper is already walking the same
entry. Normal deletion callers retain the existing behavior.
In the Linux kernel, the following vulnerability has been resolved:
net: team: stop reusing skb after queue override
A nonzero dev_queue_xmit() result does not return ownership of the skb.
When an override port's qdisc drops it, the queue override helper used to
try another port or the mode transmit op with the freed skb.
Return the handoff decision separately from transmit success. Select only
the first override port under RCU and stop after handing it the skb,
regardless of the lower transmit result. Keep the existing success and
drop accounting.
BUG: KASAN: slab-use-after-free in sk_skb_reason_drop
Write of size 4 by task poc/5040
net: team: free skb when broadcast has no txable port
In the Linux kernel, the following vulnerability has been resolved:
net: team: free skb when broadcast has no txable port
bc_transmit() sends the original skb through the last txable port.
When no port is txable, it returns false without consuming the skb, but
team_xmit() still returns NETDEV_TX_OK. AF_PACKET sends then retain the
skb and its socket write-memory charge.
A TX-enabled, link-down port keeps the broadcast transmit op installed.
Carrier can stay up through a second link-up, TX-disabled port or be
forced on by userspace. Free the original skb on the no-port path while
leaving the existing drop accounting intact.
Discovered by S
openvswitch: fix soft lockup in the netlink flow dump
In the Linux kernel, the following vulnerability has been resolved:
openvswitch: fix soft lockup in the netlink flow dump
A production compute node carrying a few thousand datapath flows hit a
soft lockup inside a single netlink flow dump and panicked.
ovs_flow_cmd_dump() calls ovs_flow_stats_get() for every flow it
emits, and that releases stats->lock with spin_unlock_bh() once per
CPU that has touched the flow. Every release is a local_bh_enable(),
and each one runs the pending softirq backlog in the dumping thread's
own context.
The skb bounds the flows one callback emits, but not the softirq work
it absorbs. On a CPU that carries the
optee: register TEE devices only once fully initialized
In the Linux kernel, the following vulnerability has been resolved:
optee: register TEE devices only once fully initialized
optee_probe() called tee_device_register() on both the client and the
supplicant device before the rest of struct optee had been initialized.
tee_device_register() calls cdev_device_add(), which does two things at
once: it creates /dev/tee0 and /dev/teepriv0, and it links the device
into the tee class so that class_find_device() can find it. From that
moment on the device is reachable both from user space via tee_open()
and from kernel space via tee_client_open_context(). The only gate in
teedev_open() is tee_device_g
regulator: ltc3676: don't read the write-only HRST and CLIRQ registers
In the Linux kernel, the following vulnerability has been resolved:
regulator: ltc3676: don't read the write-only HRST and CLIRQ registers
HRST (0x1e) and CLIRQ (0x1f) are write-only command strobes. Writing HRST
triggers a hard reset of the chip and writing CLIRQ clears the interrupt;
reading them returns nothing useful, and the read itself fires the command.
The result is that a plain register dump resets the board:
cat /sys/kernel/debug/regmap/2-003c/registers
walks every readable register, hits HRST, and the board reboots.
Split the callback back in two so HRST and CLIRQ stay writable but are no
longer readable. The readable range
scsi: ch: Do not keep references to data transfer element devices
In the Linux kernel, the following vulnerability has been resolved:
scsi: ch: Do not keep references to data transfer element devices
ch_readconfig() looks up the scsi_device of every data transfer element
whose SCSI id the changer reports in READ ELEMENT STATUS, and stores it in
ch->dt[]. scsi_device_lookup() takes a reference, and nothing ever drops
it: ch_destroy() frees the array with kfree(). ch->dt[] is read nowhere
else - it only supplies the vendor, model and revision printed in the same
loop.
Once such a drive is removed, its scsi_device can never be released. It
stays on the host's device list at its address, so a new device ther
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sock: Serialize dead-device detachment
Rebinding an HCI socket after its controller is unregistered can race
monitor control replay and crash the kernel. hci_sock_bind() clears
hci_pi(sk)->hdev and drops the device reference under only the socket
lock, whereas send_monitor_control_replay() holds hci_sk_list.lock for
reading.
Replay can observe a non-NULL hdev, then bind can clear it and drop the
last reference before create_monitor_ctrl_open() reads hdev->id. This
can cause a NULL pointer dereference if the pointer is reloaded, or a
use-after-free if the old
Bluetooth: RFCOMM: free the skb when the DLC has no owner
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: free the skb when the DLC has no owner
rfcomm_recv_data() hands the skb to d->data_ready() and returns 0
without freeing it, so the callback owns the skb from that point on.
The tty implementation frees it when the DLC has been detached from its
device:
static void rfcomm_dev_data_ready(struct rfcomm_dlc *dlc,
struct sk_buff *skb)
{
struct rfcomm_dev *dev = dlc->owner;
if (!dev) {
kfree_skb(skb);
return;
}
The socket implementation returns without
Bluetooth: RFCOMM: Fix NULL tty_dev dereference in rfcomm_dev_shutdown
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix NULL tty_dev dereference in rfcomm_dev_shutdown
syzbot hit a NULL pointer dereference in rfcomm_dev_shutdown() when an
RFCOMM tty is closed.
rfcomm_dev_add() puts the new device on rfcomm_dev_list first and only
then registers the tty device and saves it in dev->tty_dev. If that
registration fails, dev->tty_dev is never set at all. The device can be
looked up in the meantime, so an open() of /dev/rfcommN gets through
rfcomm_tty_install() and attaches to it. When that tty is closed again,
rfcomm_dev_shutdown() uses dev->tty_dev without checking it:
drm/fb-helper: defer setup when fbdev_probe() fails, not just on -EAGAIN
In the Linux kernel, the following vulnerability has been resolved:
drm/fb-helper: defer setup when fbdev_probe() fails, not just on -EAGAIN
__drm_fb_helper_initial_config_and_unlock() calls
drm_client_modeset_probe() first, which already fills in each
mode_set->mode/num_connectors for every connected output, and only
afterwards calls drm_fb_helper_single_fb_probe() to create
fb_helper->fb and wire it into those mode_sets via
drm_setup_crtcs_fb().
If drm_fb_helper_single_fb_probe() fails with anything other than
-EAGAIN (e.g. dev->driver->fbdev_probe() itself fails), the function
bails out before drm_setup_crtcs_fb() runs and before settin
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gem: Prevent overstepping exec array boundary
It is possible for eb_relocate_parse_slow() to call kvfree() on
entries outside the original exec array during following
scenario inside eb_relocate_parse_slow():
1) eb_copy_relocations() allocates as many as eb->buffer_count
copies for exec entries;
2) eb_parse() appends up to two VMAs, right after incrementing
eb->buffer_count;
3) cleanup under "out" label uses this incremented buffer_count
to release relocation pointers from exec array via kvfree(),
not from VMA array.
To amend this problem, ensure that
drm/i915/gt: Unmask interrupts only when ACTIVE is true
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gt: Unmask interrupts only when ACTIVE is true
There is a small race window between intel_rps_boost() reading
a stale ACTIVE state and queuing rps->work, where ACTIVE may be
changed via asynchronous calls triggered by wakeref drop.
This means that rps_work() could be triggered after the GT has
been parked, so unmasking RPS PM interrupts would happen without
holding PM wakelock. This sequence of events may be observed
during live_rc6_ctx_wa() selftest:
1) live_rc6_ctx_wa()
-> intel_engine_pm_put()
-> wakeref_put()
ASYNC1) wakeref_put() callback
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: validate pitch coming from userspace
Validate the pitch, alongside the box dimensions before trying
to copy data from the underlying surface. Fixes possible
out of bounds reads with cursor snooping.