af_unix: Fix UAF read of tail->len in unix_stream_data_wait()
In the Linux kernel, the following vulnerability has been resolved:
af_unix: Fix UAF read of tail->len in unix_stream_data_wait()
unix_stream_data_wait() does skb_peek_tail(&sk->sk_receive_queue) without
holding any lock that prevents SKBs on that queue from being dequeued and
freed.
This has been the case since commit 79f632c71bea ("unix/stream: fix
peeking with an offset larger than data in queue").
The first consequence of this is that the pointer comparison
`tail != last` can be false even if `last` semantically refers to an
already-freed SKB while `tail` is a new SKB allocated at the same address;
which can cause unix_stream_data_wait(
KVM: arm64: vgic-its: Reject restored DTE with out-of-range num_eventid_bits
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: vgic-its: Reject restored DTE with out-of-range num_eventid_bits
Userspace can restore an ITS Device Table Entry whose Size field encodes
more EventID bits than the virtual ITS supports. The live MAPD path
rejects that state, but vgic_its_restore_dte() accepts it and stores the
out-of-range value in dev->num_eventid_bits.
Reject restored DTEs with num_eventid_bits > VITS_TYPER_IDBITS before
allocating the device. This mirrors the MAPD check and prevents the
restored state from reaching vgic_its_restore_itt(), where the unchecked
value can be converted into an
scsi: isci: Fix use-after-free in device removal path
In the Linux kernel, the following vulnerability has been resolved:
scsi: isci: Fix use-after-free in device removal path
The ISCI completion tasklet is initialized in isci_host_alloc()
(drivers/scsi/isci/init.c:496) and scheduled from both MSI-X and legacy
interrupt handlers (drivers/scsi/isci/host.c:223,613).
isci_host_deinit() stops the controller and waits for stop completion,
but it never kills completion_tasklet before teardown continues. A
top-of-function tasklet_kill() is not sufficient here: interrupts are
only disabled when isci_host_stop_complete() runs, so until
wait_for_stop() returns the IRQ handlers can still requeue the
tas
RDMA/siw: Reject MPA FPDU length underflow before signed receive math
In the Linux kernel, the following vulnerability has been resolved:
RDMA/siw: Reject MPA FPDU length underflow before signed receive math
A malicious connected siw peer can send an iWARP FPDU whose MPA length
field (c_hdr->mpa_len, 16 bit big-endian, peer-controlled) is smaller
than the fixed DDP/RDMAP header for the announced opcode. Soft-iWARP
parses the full header in siw_get_hdr() based on iwarp_pktinfo[opcode]
.hdr_len, but never compares mpa_len against that header length.
siw_tcp_rx_data() then derives
srx->fpdu_part_rem = be16_to_cpu(mpa_len) - fpdu_part_rcvd
+ MPA_HDR_SIZE;
where fpdu_part_rcvd equal
drm/amd/display: Validate GPIO pin LUT table size before iterating
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Validate GPIO pin LUT table size before iterating
[Why&How]
The GPIO pin table parsers in get_gpio_i2c_info() and
bios_parser_get_gpio_pin_info() derive an element count from the VBIOS
table_header.structuresize field, then iterate over gpio_pin[] entries.
However, GET_IMAGE() only validates that the table header itself fits
within the BIOS image. If the VBIOS reports a structuresize larger than
the actual mapped data, the loop reads past the end of the BIOS image,
causing an out-of-bounds read.
Fix this by calling bios_get_image() to validate that the ful
batman-adv: mcast: fix use-after-free in orig_node RCU release
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: mcast: fix use-after-free in orig_node RCU release
batadv_mcast_purge_orig() removes entries from RCU-protected hlists but
does not wait for an RCU grace period before returning. Concurrent RCU
readers may still accesses references to those entries at the point of
removal. RCU-protected readers trying to operate on entries like
orig->mcast_want_all_ipv6_node will then access already freed memory.
Fix this by moving batadv_mcast_purge_orig() to batadv_orig_node_release(),
just before the call_rcu() invocation. This ensures RCU readers that were
active at purge t
batman-adv: bla: avoid double decrement of bla.num_requests
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: avoid double decrement of bla.num_requests
The bla.num_requests is increased when no request_sent was in progress. And
it is decremented in various places (announcement was received, backbone is
purged, periodic work). But the check if the request_sent is actually set
to a specific state and the atomic_dec/_inc are not safe because they are
not atomic (TOCTOU) and multiple such code portions can run concurrently.
At the same time, it is necessary to modify request_sent (state) and
bla.num_requests atomically. Otherwise batadv_bla_send_request() might set
r
Media · CVSS 5.5EPSS 0,15%Sin corrección publicada
batman-adv: bla: avoid NULL-ptr deref for claim via dropped interface
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: avoid NULL-ptr deref for claim via dropped interface
Without rtnl_lock held, a hardif might be retrieved as primary interface of
a meshif, but then (while operating on this interface) getting decoupled
from the mesh interface. In this case, the meshif still exists but the
pointer from the primary hardif to the meshif is set to NULL.
The mesh_iface must be checked first to be non-NULL before continuing to
send an ARP request using meshif.
batman-adv: tp_meter: directly shut down timer on cleanup
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tp_meter: directly shut down timer on cleanup
batadv_tp_sender_cleanup() was calling timer_delete_sync() followed by
timer_delete() to guard against the timer handler re-arming itself between
the two calls. This double-deletion hack relied on the sending status being
set to 0 to suppress re-arming.
Replace both calls with a single timer_shutdown_sync(). This function both
waits for any running timer callback to complete (like timer_delete_sync())
and permanently disarms the timer so it cannot be re-armed afterwards,
making re-arming prevention unconditional and
batman-adv: tt: fix TOCTOU race for reported vlans
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix TOCTOU race for reported vlans
The local TT based TVLV is generated by first checking the number of VLANs
which have at least one TT entry. A new buffer with the correct size for
the VLANs is then allocated. Only then, the list of VLANs s used to fill
the VLAN entries in the buffer. During this time, the meshif_vlan_list_lock
is held. But the actual number of TT entries of each VLAN can still
increase during this time - just not the number of VLANs in the list.
But the prefilter used in the buffer size calculation might still cause an
increase of the nu
Media · CVSS 5.5EPSS 0,13%Sin corrección publicada
batman-adv: tt: avoid empty VLAN responses
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: avoid empty VLAN responses
The commit 16116dac2339 ("batman-adv: prevent TT request storms by not
sending inconsistent TT TLVLs") added checks to the local (direct) TT
response code. But the response can also be done indirectly by another node
using the global TT state. To avoid such inconsistency states reported in
the original fix, also avoid sending empty VLANs for replies from the
global TT state.
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix negative last_changeset_len
batadv_piv_tt::last_changeset_len len was declared as s16, but the field is
never intended to hold a negative value. When a value greater than 32767 is
assigned, it wraps to a negative signed integer.
In batadv_send_my_tt_response(), last_changeset_len is temporarily widened
to s32. The incorrectly negative s16 value propagates into the s32, causing
batadv_tt_prepare_tvlv_local_data() to allocate a full sized buffer but
populates only a small portion of it with the collected changeset. All
remaining bits are kept uninitialize
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix negative tt_buff_len
batadv_orig_node::tt_buff_len was declared as s16, but the field is never
intended to hold a negative value. When a value greater than 32767 is
assigned, it wraps to a negative signed integer.
In batadv_send_other_tt_response(), tt_buff_len is temporarily widened to
s32. The incorrectly negative s16 value propagates into the s32, causing
batadv_tt_prepare_tvlv_global_data() to allocate a full sized buffer but
populates only a small portion of it with the collected changeset. All
remaining bits are kept uninitialized.
Using an u16 a
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: cortina: Make RX SKB per-port
The SKB used to assemble packets from fragments in gmac_rx()
is static local, but the Gemini has two ethernet ports, meaning
there can be races between the ports on a bad day if a device
is using both.
Make the RX SKB a per-port variable and carry it over between
invocations in the port struct instead.
Zero the pointer once we call napi_gro_frags(), on error (after
calling napi_free_frags()) or if the port is stopped.
Zero it in some place where not strictly necessary just to
emphasize what is going on.
This was found by Sash
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: cortina: Carry over frag counter
The gmac_rx() NAPI poll function assembles packets in an
SKB from a ring buffer.
If the ring buffer gets completely emptied during a poll cycle,
we exit gmac_rx(), but the packet is not yet completely
assembled in the SKB, yet the fragment counter frag_nr is
reset to zero on the next invocation.
Solve this by making the RX fragment counter a part of the
port struct, and carry it over between invocations.
Reset the fragment counter only right after calling
napi_gro_frags(), on error (after calling napi_free_frags())
or if st
net: tls: fix off-by-one in sg_chain entry count for wrapped sk_msg ring
In the Linux kernel, the following vulnerability has been resolved:
net: tls: fix off-by-one in sg_chain entry count for wrapped sk_msg ring
When an sk_msg scatterlist ring wraps (sg.end < sg.start),
tls_push_record() chains the tail portion of the ring to the head
using sg_chain(). An extra entry in the sg array is reserved for
this:
struct sk_msg_sg {
[...]
/* The extra two elements:
* 1) used for chaining the front and sections when the list becomes
* partitioned (e.g. end < start). The crypto APIs require the
* chaining;
* 2) to chain tailer SG entries after the message.
net: tls: prevent chain-after-chain in plain text SG
In the Linux kernel, the following vulnerability has been resolved:
net: tls: prevent chain-after-chain in plain text SG
Sashiko points out that if end = 0 (start != 0) the current
code will create a chain link to content type right after
the wrap link:
This would create a chain where the wrap link points directly
to another chain link. The scatterlist API sg_next iterator
does not recursively resolve consecutive chain links.
meaning this is illegal input to crypto.
The wrapping link is unnecessary if end = 0. end is the entry after
the last one used so end = 0 means there's nothing pushed after
the wrap:
end start
net: mana: Fix TOCTOU double-fetch of hwc_msg_id from DMA buffer
In the Linux kernel, the following vulnerability has been resolved:
net: mana: Fix TOCTOU double-fetch of hwc_msg_id from DMA buffer
In mana_hwc_rx_event_handler(), resp->response.hwc_msg_id is read from
DMA-coherent memory and bounds-checked, then mana_hwc_handle_resp()
re-reads the same field from the same DMA buffer for test_bit() and
pointer arithmetic.
DMA-coherent memory is mapped uncacheable on x86 and is shared,
unencrypted, in Confidential VMs (SEV-SNP/TDX), so each load goes
directly to host-visible memory. A H/W can modify the value
between the check and the use, bypassing the bounds validation.
Fix this by reading hwc_msg_id e
rxrpc: Fix DATA decrypt vs splice() by copying data to buffer in recvmsg
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix DATA decrypt vs splice() by copying data to buffer in recvmsg
This improves the fix for CVE-2026-43500.
Fix the pagecache corruption from in-place decryption of a DATA packet
transmitted locally by splice() by getting rid of the packet sharing in the
I/O thread and unconditionally extracting the packet content into a bounce
buffer in which the buffer is decrypted. recvmsg() (or the kernel
equivalent) then copies the data from the bounce buffer to the destination
buffer. The sk_buff then remains unmodified.
This has an additional advantage in that the packet i
net: mana: validate rx_req_idx to prevent out-of-bounds array access
In the Linux kernel, the following vulnerability has been resolved:
net: mana: validate rx_req_idx to prevent out-of-bounds array access
In mana_hwc_rx_event_handler(), rx_req_idx is derived from
sge->address in DMA-coherent memory. In Confidential VMs
(SEV-SNP/TDX), this memory is shared unencrypted and HW can modify
WQE contents at any time. No bounds check exists on rx_req_idx,
which can lead to an out-of-bounds access into reqs[].
Add bounds check on rx_req_idx in mana_hwc_rx_event_handler() before
using it to index the reqs[] array.