md: scope memalloc_noio to allocation critical sections
In the Linux kernel, the following vulnerability has been resolved:
md: scope memalloc_noio to allocation critical sections
Storing a memalloc_noio_save() token in mddev->noio_flags lets one task
save the token and another task restore it. With concurrent suspend sysfs
writes, task A can enter PF_MEMALLOC_NOIO, return to userspace still in
that scope, and later task B can restore A's saved token.
Avoid tying the token lifetime to mddev. Keep mddev_suspend() and
mddev_resume() only responsible for array suspension, and enter
PF_MEMALLOC_NOIO only in the MD paths that allocate memory after the array
has been suspended. Restore the token befo
iommu/dma: Check atomic pool allocation result directly
In the Linux kernel, the following vulnerability has been resolved:
iommu/dma: Check atomic pool allocation result directly
The non-blocking, non-coherent allocation path uses dma_alloc_from_pool(),
which returns the allocated page and fills cpu_addr only on success.
Do not rely on cpu_addr to detect allocation failure in this path. Check
the returned page directly before using it for the IOMMU mapping.
i3c: dw: avoid shift-out-of-bounds when DAA assigns no devices
In the Linux kernel, the following vulnerability has been resolved:
i3c: dw: avoid shift-out-of-bounds when DAA assigns no devices
On an empty bus ENTDAA assigns nothing, so cmd->rx_len (the count
of addresses left unassigned) equals master->maxdevs.
The GENMASK() index master->maxdevs - cmd->rx_len - 1 then becomes -1,
which trips up UBSAN. This happens every time on boot on a Gigabyte/AMD
server:
UBSAN: shift-out-of-bounds in drivers/i3c/master/dw-i3c-master.c:905:12
shift exponent 64 is too large for 64-bit type 'long unsigned int'
CPU: 7 UID: 0 PID: 963 Comm: (udev-worker) Not tainted 7.0.11-200.fc44.x86_64 #1 PREEMPT(lazy
md/raid1: create serial pool adding rdev to array with serialize_policy=1
In the Linux kernel, the following vulnerability has been resolved:
md/raid1: create serial pool adding rdev to array with serialize_policy=1
The following bug has been observed with kernel 7.1.3 after adding a new
rdev to an existing RAID1 array with serialize_policy enabled:
Oops: 0002 [#1]
CPU: 0 UID: 0 PID: 19639 Comm: ext4lazyinit Not tainted 7.1.3-1-default
RIP: _raw_spin_lock_irqsave+0x27/0x50
CR2: 0000000000004960
Call Trace:
wait_for_serialization+0xb9/0x260 [raid1]
raid1_make_request+0x762/0xaff [raid1]
md_handle_request+0x1c9/0x2e0 [md_mod]
The raid1.c code calls wait_for_serialization() if the MD_SERIALIZE_P
In the Linux kernel, the following vulnerability has been resolved:
misc: sgi-gru: remove interrupt-context page-table walks
The GRU TLB miss handler walks a process's page tables without holding
page-table locks or a reference to the mapped page. It also uses a kernel
page-table accessor on user page tables and supports only PMD-level large
mappings on x86-64.
Remove the direct walker. Send interrupt faults directly to user polling
mode so the existing call-OS fallback retries them in process context.
Remove the mmap-lock failure statistic that can no longer be incremented.
wifi: mt76: mt76x02: do not WARN on invalid rx descriptor length
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt76x02: do not WARN on invalid rx descriptor length
The MPDU length in the rx descriptor comes from the hardware. In
monitor mode with the fcsfail filter enabled, the hardware passes up
corrupted frames, and a corrupted frame can report a length larger
than the received buffer. The bounds check correctly discards such
frames, but its WARN_ON_ONCE wrapper means any over-the-air garbage
frame taints the kernel, and panics it on the first such frame when
panic_on_warn is set.
Drop the WARN and discard the frame silently, matching what
commit c2d4c8723dbf ("mt76x2
wifi: mt76: mt7921: Add PCIe AER handler support to prevent system crash
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7921: Add PCIe AER handler support to prevent system crash
When an AER error occurs and the bus is hung, the register reads return
0xFFFFFFFF, causing the DMA queue state to be corrupted and resulting in
an invalid memory access when accessing q->desc[] or q->entry[].
Unable to handle kernel paging request at virtual address
ffffffc01099eac0
pc : mt76_dma_add_buf+0x124/0x188 [mt76]
lr : mt76_dma_rx_fill+0x11c/0x1d8 [mt76]
sp : ffffffc016d9bbf0
x29: ffffffc016d9bc10 x28: 0000000000000000
x27: 0000000000000000 x26: ffffffb7855e50b8
x25: ffffffb80d04f000 x24: 00
wifi: mt76: mt792x: Fix memory leak in SDIO TX path
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt792x: Fix memory leak in SDIO TX path
When tx_prepare_skb() returns an error in the SDIO TX path, the
skb is not freed, leading to a memory leak. This can occur when
zero-length frames (such as WNM NULL frames) are dropped to prevent
potential hardware TX hangs.
Fix this by properly releasing the skb with ieee80211_tx_status_ext()
when tx_prepare_skb() fails.
wifi: mt76: fix non-AQL packet accounting for MLO stations
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: fix non-AQL packet accounting for MLO stations
__mt76_tx_queue_skb() overrides the wcid passed by the driver with
sta->drv_priv, so the wcid might incorrectly be changed after TX,
causing wcid->non_aql_packets to be counted on the wrong wcid. For
example, on the AP side, if a station's setup link is the 5G link and
the station uses 2G to transmit a frame, the value of non_aql_packets
is increased on the 5G wcid but decreased on the 2G wcid. Once the
inflated counter exceeds MT_MAX_NON_AQL_PKT, the TX scheduler
permanently refuses to service the station.
Drop th
wifi: mt76: mt7915: avoid nss underflow in mt7915_mcu_get_sta_nss
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: avoid nss underflow in mt7915_mcu_get_sta_nss
If a peer's VHT/HE MCS map has no supported spatial stream (all fields
0x3), the loop exits with nss == 0 and the function returned (u8)-1 (255),
which was then written into the firmware sta_rec_bf beamforming fields.
Clamp the result to 0.
wifi: mt76: cancel reset and rc work on device unregister
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: cancel reset and rc work on device unregister
Both drivers cancelled dump_work on unregister but left reset_work and
rc_work to be flushed only by destroy_workqueue() in mt76_free_device(),
which runs after the hw is unregistered and the hardware stopped. A
reset_work that fires in that window calls ieee80211_restart_hw() and
re-arms mac_work on an unregistered hw, and rc_work touches station state
being torn down. Cancel both up front, alongside dump_work.
In the Linux kernel, the following vulnerability has been resolved:
drm/msm/dsi: Drop dev_pm_opp_set_rate(0)
dev_pm_opp_set_rate(0) removes the vote specified in required-opps but
does not actually park the clock, making it run without the necessary
power backing. Drop the explicit call to it.
Every call site of ops->link_clk_disable() is followed by
pm_runtime_put(), so the power vote will be rescinded if deemed safe.
Patchwork: https://patchwork.freedesktop.org/patch/742783/
wifi: ath11k: fix leak in ath11k_service_ready_ext_event()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix leak in ath11k_service_ready_ext_event()
Currently, during ath11k_service_ready_ext_event() processing,
svc_rdy_ext.mac_phy_caps can be allocated during TLV parsing. This is a
temporary allocation that is freed on the success path, but not on the
error path. If parsing succeeds far enough to allocate mac_phy_caps and
then fails on a later TLV, the allocation leaks. So free the allocation
on the error path.
Compile tested only.
regulator: core: use system_freezable_wq for init complete work
In the Linux kernel, the following vulnerability has been resolved:
regulator: core: use system_freezable_wq for init complete work
schedule_delayed_work() uses system_wq, which is non-freezable, allowing
regulator_init_complete_work to run concurrently with system suspend. This
work fires ~30s after boot to disable unused regulators via I2C. When it
races with PM suspend, the I2C adapter may already be suspended, triggering
a -ESHUTDOWN warning in __i2c_transfer():
WARNING: ... at __i2c_transfer+0x36c/0x3c8
Call trace:
__i2c_transfer
i2c_transfer
regmap_i2c_write
_regmap_update_bits
regulator_disable_regmap
_regulato
bpf: Reject >8 byte return values on return-reading trampoline paths
In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject >8 byte return values on return-reading trampoline paths
btf_distill_func_proto() builds the function model used for the
fentry/fexit/fmod_ret/fsession trampolines and struct_ops. It has
accepted a 16-byte __int128 return value since the trampoline was
introduced: __get_type_size() returns the integer's type size, and the
return-type check only rejected ret < 0.
But the BPF trampoline preserves only 8 bytes of the return value (RAX on
x86, i.e. R0). For an attach type that reads the target's return value the
second half (RDX / R3) is neither saved nor restored,
wifi: ath10k: snoc: use memcpy_fromio() for MSA ramdump
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath10k: snoc: use memcpy_fromio() for MSA ramdump
On WCN3990/SNOC the MSA region is mapped with devm_memremap(MEMREMAP_WT).
On arm64 such a mapping is not Normal-cacheable, so unaligned accesses to
it are not permitted. ath10k_msa_dump_memory() copies the region with a
plain memcpy(), whose optimized __pi_memcpy_generic implementation issues
wide/unaligned loads. This triggers an alignment fault (FSC=0x21) Oops in
ath10k_snoc_fw_crashed_dump() while collecting the devcoredump:
Unable to handle kernel paging request ... FSC=0x21: alignment fault
pc : __pi_memcpy_g
arm64: ptrace: Keep 'orig_x0' in-sync with x0 on syscall entry
In the Linux kernel, the following vulnerability has been resolved:
arm64: ptrace: Keep 'orig_x0' in-sync with x0 on syscall entry
Commit e057b9477232 ("arm64: syscall: Ensure saved x0 is kept in-sync
with tracer updates") attempted to resolve a long-standing issue with
syscall entry tracing, where a tracer is able to manipulate the first
syscall argument without being subjected to seccomp or audit checking.
Unfortunately, that fix was incomplete [1], as it failed to update
'orig_x0' between a tracer updating x0 during a seccomp ptrace exit
(SECCOMP_RET_TRACE) and the seccomp filter being re-evaluated.
Rather than add hooks to the core se
Media · CVSS 6.7EPSS 0,21%Sin corrección publicada
wifi: brcmfmac: fix P2P action frame handling without device vif
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: fix P2P action frame handling without device vif
Some P2P action frame paths assume the P2P device vif is always
available. That is not true when userspace sends non-P2P public action
frames through the primary interface, or when action-frame abort runs
after the P2P device vif has not been created.
Fall back to the primary vif when aborting an action frame without a P2P
device vif, and guard P2P device saved IE access before using it for
peer channel search.
wifi: cfg80211: stop PMSR before P2P and NAN teardown
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: stop PMSR before P2P and NAN teardown
PMSR request teardown must abort active measurements while the
wireless_dev is still present in the driver. cfg80211_leave_locked() and
cfg80211_stop_pd() already do this before invoking the driver's stop
callback, but cfg80211_stop_p2p_device() and cfg80211_stop_nan() do not.
Those helpers are also called directly by nl80211, rfkill shutdown, and
wireless_dev unregister paths. If one of these paths stops a P2P device
or NAN interface with a pending request, it removes the mac80211
subinterface from the driver first. Su
In the Linux kernel, the following vulnerability has been resolved:
firmware: coreboot: Validate table bounds
The existing coreboot_table_populate() bounds checks limit individual
entries to the mapped length. However, coreboot_table_probe() replaces
the platform resource length with header and table sizes supplied by
firmware before mapping the full table.
A malformed table can overflow the 32-bit size addition or advertise an
extent beyond the resource, causing the driver to map and parse memory
outside the resource. A resource shorter than the fixed header is also
mapped as though it contained a complete header.
Reject resources shor