usb: host: max3421: Fix shift-out-of-bounds in max3421_hub_control()
In the Linux kernel, the following vulnerability has been resolved:
usb: host: max3421: Fix shift-out-of-bounds in max3421_hub_control()
The `max3421_hub_control()` function handles USB hub class requests
to the virtual root hub. In the `default` branches of both the
`ClearPortFeature` and `SetPortFeature` switch statements, it modifies
`max3421_hcd->port_status` by left shifting 1 by the request's `value`
parameter. However, it does not validate whether this shift will exceed
the width of `port_status`.
So if a malicious userspace task with access to the root hub via
/dev/bus/usb/.../001 issues a USBDEVFS_CONTROL ioctl with `wValue`
great
In the Linux kernel, the following vulnerability has been resolved:
iio: magnetometer: ak8975: fix potential kernel stack memory leak
Currently in the AK8975 driver there are four instances where potential
uninitialized kernel stack memory leaks can occur. If
i2c_smbus_read_i2c_block_data_or_emulated() returns a value less than
the size of the buffer, uninitialized bytes are retained in the buffer
and later the buffer is passed on to IIO buffers, potentially leaking
memory to userspace.
Fix this by adding checks whether the return value of the function is
equal to the size of the buffer and subsequently if the value is
lesser than zero to
iio: adc: xilinx-ams: fix out-of-bounds channel lookup in event handling
In the Linux kernel, the following vulnerability has been resolved:
iio: adc: xilinx-ams: fix out-of-bounds channel lookup in event handling
ams_event_to_channel() may return a pointer past the end of
dev->channels when no matching scan_index is found. This can lead
to invalid memory access in ams_handle_event().
Add a bounds check in ams_event_to_channel() and return NULL when
no channel is found. Also guard the caller to safely handle this
case.
iio: accel: mma8452: handle I2C read error(s) in mma8452_read()
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: mma8452: handle I2C read error(s) in mma8452_read()
Currently, If i2c_smbus_read_i2c_block_data() fails but
mma8452_set_runtime_pm_state() succeeds, mma8452_read() returns 0.
As a result, the caller mma8452_read_raw() assumes the read was
successful and proceeds to use a buffer containing uninitialized
stack memory.
Add proper checking of the I2C read return value and propagate errors
to the caller.
fs/ntfs3: add bounds check to run_get_highest_vcn()
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: add bounds check to run_get_highest_vcn()
run_get_highest_vcn() parses a packed NTFS mapping-pairs buffer without
any length bound, relying solely on a 0x00 terminator to stop. A
crafted $LogFile UpdateMappingPairs record whose embedded attribute
contains mapping-pairs runs without a terminator causes the function to
read past the slab allocation, triggering a KASAN slab-out-of-bounds
read on mount.
The sibling function run_unpack() received an analogous bounds-check in
commit b62567bca474 ("ntfs3: add buffer boundary checks to run_unpack()"),
but run_get_highes
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: Fix possible use after free
In dma_release_channel(), check chan->device->privatecnt after call
dma_chan_put(). However, dma_chan_put() call dma_device_put() which could
release the last reference of the device if the DMA provider is already
gone and hence free it.
Fixes it by moving dma_chan_put() after the check.
dmaengine: dma-axi-dmac: use DMA pool to manange DMA descriptor
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: dma-axi-dmac: use DMA pool to manange DMA descriptor
For architectures like Microblaze or arm64 (where this IP is used),
DMA_DIRECT_REMAP is set which means that dma_alloc_coherent() might
remap (and hence vmalloc()) some memory. This became visible in a design
where dma_direct_use_pool() is not possible.
With the above, when calling dma_free_coherent(), vunmap() would be
called from softirq context and thus leading to a BUG().
To fix it, use a dma pool that is allocated in
.device_alloc_chan_resources() and allocate blocks from it. The key
point is that now dm
xprtrdma: Decouple req recycling from RPC completion
In the Linux kernel, the following vulnerability has been resolved:
xprtrdma: Decouple req recycling from RPC completion
rl_kref formerly served two distinct lifetimes through a single
refcount: it gated when a Reply could wake its RPC task, and it
gated when an rpcrdma_req could return to its free pool. The
marshal path took the Send-side reference only when SGEs needed
DMA-unmap (sc_unmap_count > 0), which made a Send carrying only
pre-registered buffers an exception: the Reply handler dropped
rl_kref from 1 to 0 and freed the req while the HCA might still
be DMA-reading from its send buffer.
Give rl_kref a narrower job. The RPC layer ta
nfs: use nfsi->rwsem to protect traversal of the file lock list
In the Linux kernel, the following vulnerability has been resolved:
nfs: use nfsi->rwsem to protect traversal of the file lock list
Lingfeng identified a bug and suggested two solutions, but both appear
to have issues.
Generally, we cannot release flc_lock while iterating over the file lock
list to avoid use-after-free (UAF) problems with file locks. However,
functions like nfs_delegation_claim_locks and nfs4_reclaim_locks cannot
adhere to this rule because recover_lock or nfs4_lock_delegation_recall
may take a long time. To resolve this, NFS switches to using nfsi->rwsem
for the same protection, and nfs_reclaim_locks follows this approach
fs/ntfs3: resize log->one_page_buf when adopting on-disk page size
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: resize log->one_page_buf when adopting on-disk page size
log_replay() allocates log->one_page_buf using the page size that was
chosen from the host PAGE_SIZE:
log->one_page_buf = kmalloc(log->page_size, GFP_NOFS);
Later, when a restart area is found, the log page size recorded on disk
is adopted:
t32 = le32_to_cpu(log->rst_info.r_page->sys_page_size);
if (log->page_size != t32) {
log->l_size = log->orig_file_size;
log->page_size = norm_file_page(t32, &log->l_size,
t32 == DefaultLogPageSize);
}
If the on-disk page size is larger than the size used
In the Linux kernel, the following vulnerability has been resolved:
xprtrdma: Fix ep kref imbalance on ADDR_CHANGE
rpcrdma_cm_event_handler() falls through to the disconnected: label
on RDMA_CM_EVENT_ADDR_CHANGE and calls rpcrdma_ep_put() with no
matching get when the event arrives before RDMA_CM_EVENT_ESTABLISHED.
The kref then underflows during connect teardown and
rpcrdma_xprt_disconnect() operates on a freed ep.
Reference counts across a normal connection lifecycle:
rpcrdma_ep_create() kref_init ->1
rpcrdma_xprt_connect() ep_get ->2 (before post_recvs)
RDMA_CM_EVENT_ESTABLISHED ep_get
In the Linux kernel, the following vulnerability has been resolved:
xprtrdma: Check frwr_wp_create() during connect
frwr_wp_create() creates the singleton Memory Region used to encode
padding for Write chunks whose payload length is not XDR-aligned. Its
failure paths return a negative errno and leave ep->re_write_pad_mr set
to NULL.
rpcrdma_xprt_connect() currently ignores that return value. If
frwr_wp_create() fails after the rest of the connection setup succeeds,
xprt_rdma_connect_worker() treats the connection attempt as successful
and sets XPRT_CONNECTED. A later NFS/RDMA read with a non-4-byte-aligned
receive page length reaches rpcrd
In the Linux kernel, the following vulnerability has been resolved:
xprtrdma: Fix bcall rep leak and unbounded peek
rpcrdma_is_bcall() decodes a reply's first words to decide whether
the frame is a backchannel call. Two issues in that decode path
let a short or malformed reply leak the receive buffer and drain
the Receive queue.
First, the speculative peek
p = xdr_inline_decode(xdr, 0);
/* five p++ reads follow */
asks xdr_inline_decode() for zero bytes, which returns xdr->p
without consulting xdr->end. The five subsequent __be32 reads can
then walk up to 20 bytes past the wire payload into stale regbuf
contents and misclassify t
xprtrdma: Repost Receive buffers for malformed replies
In the Linux kernel, the following vulnerability has been resolved:
xprtrdma: Repost Receive buffers for malformed replies
rpcrdma_wc_receive() decrements the transport's Receive count for
every completion before it dispatches a successful Receive to
rpcrdma_reply_handler(). The handler must post a replacement
Receive WR before returning unless ownership of the rep has moved
elsewhere, as on the backchannel path.
Commit 2ae50ad68cd7 ("xprtrdma: Close window between waking RPC
senders and posting Receives") moved the Receive refill out of
rpcrdma_wc_receive(), where it had run ahead of every reply, into
rpcrdma_reply_handler() so that the r
xfrm: Fix dev use-after-free in xfrm async resumption
In the Linux kernel, the following vulnerability has been resolved:
xfrm: Fix dev use-after-free in xfrm async resumption
xfrm async resumption hold skb->dev refcnt until after transport_finish.
However, xfrm_rcv_cb may modify skb->dev to tunnel dev without taking
device reference, such as vti_rcv_cb. The subsequent async resumption
will decrement the tunnel device's reference count, which lead to uaf
of tunnel dev and refcnt leak of orig dev as below:
unregister_netdevice: waiting for vti1 to become free. Usage count = -2
Stash the original skb->dev to fix refcnt imbalance. The new skb->dev set
by xfrm_rcv_cb can race with device teardow
apparmor: check label build before no_new_privs test
In the Linux kernel, the following vulnerability has been resolved:
apparmor: check label build before no_new_privs test
aa_change_profile() builds a replacement label with
fn_label_build_in_scope() before the no_new_privs subset check. The build
helper can fail and return NULL or an ERR_PTR, but the result was passed
to aa_label_is_unconfined_subset() before the existing IS_ERR_OR_NULL()
check.
Reuse the existing target-label build failure handling immediately after
the build. This preserves the current audit handling while preventing the
subset helper from dereferencing an invalid label.
apparmor: aa_label_alloc use aa_label_free on alloc failure
In the Linux kernel, the following vulnerability has been resolved:
apparmor: aa_label_alloc use aa_label_free on alloc failure
aa_label_alloc() allocates a secid before allocating or taking the label
proxy. If the later proxy step fails, the error path only freed the label
memory, leaking any resources initialized by aa_label_init().
Use aa_label_free() on the failure path so partially initialized labels
release their secid and other label resources before the backing memory is
freed.
i3c: mipi-i3c-hci: Fix race in i3c_hci_addr_to_dev()
In the Linux kernel, the following vulnerability has been resolved:
i3c: mipi-i3c-hci: Fix race in i3c_hci_addr_to_dev()
i3c_hci_addr_to_dev() walks bus->devs.i3c, which is protected by
bus.lock (rwsem). However, it is invoked from the MIPI I3C HCI IRQ
handler, which cannot take bus.lock. This allows concurrent device
addition/removal in the I3C core to modify the list while it is being
traversed, potentially leading to use-after-free or crashes.
Remove the dependency on the bus device list and introduce a dedicated
lookup table. Add an ibi_devs[] array indexed by DAT entry, maintained
under hci->lock. Update the array when IBIs are en
In the Linux kernel, the following vulnerability has been resolved:
xfrm: Fix xfrm state cache insertion race
The xfrm input state cache insertion code checks the validity of
the state before acquiring the global xfrm_state_lock. Thus it's
possible for someone else to kill the state after it passed the
validity check, and then the insertion will add the dead state
to the cache.
Fix this by moving the validity check inside the lock.
This entire function is called on the input path, where BH must
be off (e.g., the caller of this function xfrm_input acquires
its spinlocks without disabling BH).
So there is no need to disable BH here or tak
xfrm: validate selector family and prefixlen during match
In the Linux kernel, the following vulnerability has been resolved:
xfrm: validate selector family and prefixlen during match
syzbot reported a shift-out-of-bounds in xfrm_selector_match()
due to AF_UNSPEC selector with large prefixlen (e.g. 128) matched
against IPv4 flow (when XFRM_STATE_AF_UNSPEC is set).
Fix this by:
- Rejecting mismatched families in xfrm_selector_match.
- Returning false in addr4_match if prefixlen > 32.
- Returning false in addr_match if prefixlen > 128 (prevents overflow).