LoongArch: Move jump_label_init() before parse_early_param()
In the Linux kernel, the following vulnerability has been resolved:
LoongArch: Move jump_label_init() before parse_early_param()
When enabling both CONFIG_MEM_ALLOC_PROFILING=y and
CONFIG_MEM_ALLOC_PROFILING_ENABLED_BY_DEFAULT=y, then diabling memory
profiling by adding the boot parameter 'sysctl.vm.mem_profiling=0' will
cause the kernel failed to boot.
After analysis, this is because jump_label_init() must be called before
parse_early_param(), the early param handlers may modify static keys by
static_branch_enable/disable().
Fix this by moving jump_label_init() to before parse_early_param(). The
solution is similar to other architectures
cdrom: fix stack out-of-bounds read in CDROMVOLCTRL
In the Linux kernel, the following vulnerability has been resolved:
cdrom: fix stack out-of-bounds read in CDROMVOLCTRL
mmc_ioctl_cdrom_volume() first reads the audio control mode page into a
32-byte stack buffer with cgc->buflen set to 24. If the device reports a
block descriptor, the function increases cgc->buflen to include that
descriptor and reads the page again.
For CDROMVOLCTRL, the function then builds a MODE SELECT parameter list
by moving cgc->buffer forward by offset - 8 bytes. This drops the block
descriptor from the outgoing payload and leaves a new 8-byte mode
parameter header in front of the audio control page. However, c
firmware: stratix10-svc: fix memory leaks and list corruption bugs
In the Linux kernel, the following vulnerability has been resolved:
firmware: stratix10-svc: fix memory leaks and list corruption bugs
Fix a memory leak when gen_pool_alloc() fails by freeing pmem on the error
path. Switch pmem allocation from devm_kzalloc() to kzalloc() with
explicit kfree() in the free path to match its list-managed lifetime.
Remove the erroneous list_del(&svc_data_mem) which corrupted the list head
on failed lookups.
comedi: comedi_parport: deal with premature interrupt
In the Linux kernel, the following vulnerability has been resolved:
comedi: comedi_parport: deal with premature interrupt
Syzbot reported a general protection fault in
`comedi_get_is_subdevice_running()`, which was called from the interrupt
handler `parport_interrupt()` in the "comedi_parport" driver, but it
does not currently have a C reproducer for the problem. It's
probably due to a premature interrupt for one of two reasons:
1. The driver sets up the interrupt handler before the comedi subdevices
used by the interrupt handler have been allocated, but does not
disable the interrupt in the parallel port's CTRL register first.
2. T
mei: bus: access mei_device under device_lock on cleanup
In the Linux kernel, the following vulnerability has been resolved:
mei: bus: access mei_device under device_lock on cleanup
Fix couple of problems in mei_cl_bus_dev_release():
mei_cl_flush_queues() is running without lock.
bus->file_list access after mei_dev_bus_put(bus) can become a
use-after-free if this was the last reference to bus.
Protect queues cleanup and WARN traversal by device lock there
to avoid the concurrent access problems.
Move WARN traversal before mei_dev_bus_put(bus).
This file uses bus variable name for mei_device, adjust
code of mei_cl_bus_dev_release() to use bus variable too.
In the Linux kernel, the following vulnerability has been resolved:
intel_th: fix MSC output device reference leak
intel_th_output_open() looks up the output device with
bus_find_device_by_devt(), which returns the device with a reference that
must be dropped after use.
commit 95fc36a234da ("intel_th: fix device leak on output open()")
attempted to drop the reference from intel_th_output_release(). However,
a successful open replaces file->f_op with the output driver file
operations before returning, so close runs the output driver release
callback instead.
For MSC outputs, close runs intel_th_msc_release(), which only removes
the per-fil
tracing: Fix mmiotrace possible NULL dereferencing of hiter->dev
In the Linux kernel, the following vulnerability has been resolved:
tracing: Fix mmiotrace possible NULL dereferencing of hiter->dev
If the mmio_pipe_open() fails to find a PCI device, the hiter->dev
will be assigned to NULL. The mmiotrace read() function dereferences the
hiter->dev if hiter exists.
Change the test of the read to not only check hiter being NULL, but also
the hiter->dev before dereferencing it.
tracing: Fix resource leak on mmiotrace trace_pipe close
In the Linux kernel, the following vulnerability has been resolved:
tracing: Fix resource leak on mmiotrace trace_pipe close
The mmiotrace tracer was added May 12th 2008. At that time, resources
created in pipe_open() could not be freed because there was not
pipe_close function pointer of the tracer. The pipe_close function pointer
was added in December 7th, 2009, but the mmiotrace tracer was not updated.
mmio_pipe_open() allocates a header_iter and takes a pci_dev reference
when trace_pipe is opened. mmio_close() frees them, but it was only
wired to the tracer's .close callback.
tracing_release_pipe() invokes .pipe_close, not .close, whe
mptcp: pm: userspace: fix use-after-free in get_local_id
In the Linux kernel, the following vulnerability has been resolved:
mptcp: pm: userspace: fix use-after-free in get_local_id
In mptcp_pm_userspace_get_local_id(), the address entry is looked up under
spinlock, but its id is read after dropping the lock. A concurrent deletion
can free the entry between the unlock and the read, leading to UAF.
The race window is narrow. It was reproduced only with a locally
constructed stress test that repeatedly overlaps an MP_JOIN SYN with a
MPTCP_PM_CMD_SUBFLOW_DESTROY request.
However, the KASAN report below confirms that the race is reachable:
[ 666.319376] BUG: KASAN: slab-use-after-free in mptcp_
mm/damon/core: validate ranges in damon_set_regions()
In the Linux kernel, the following vulnerability has been resolved:
mm/damon/core: validate ranges in damon_set_regions()
DAMON core logic assumes zero length regions don't exist. However, a few
DAMON API callers including DAMON_SYSFS, DAMON_RECLAIM and DAMON_LRU_SORT
allow users to set empty monitoring target regions. This could result in
WARN_ONCE() on CONFIG_DAMON_DEBUG_SANITY enabled kernel, and
divide-by-zero from damon_merge_two_regions().
For example, the WANR_ONCE() can be triggered like below.
# grep DAMON_DEBUG_SANITY /boot/config-$(uname -r)
# CONFIG_DAMON_DEBUG_SANITY=y
# damo start
# cd /sys/kernel/mm/damon/
mm/damon/core: disallow overlapping input ranges for damon_set_regions()
In the Linux kernel, the following vulnerability has been resolved:
mm/damon/core: disallow overlapping input ranges for damon_set_regions()
damon_set_regions() assumes the input ranges are sorted by the address and
don't overlap each other. Hence the assumption was initially to be
explicitly validated. But commit 97d482f4592f ("mm/damon/sysfs: reuse
damon_set_regions() for regions setting") has mistakenly removed the
validation.
This can make DAMON behave in unexpected ways. At the best, the
monitoring results snapshot will just look weird since there will be
overlapping regions. DAMOS will also work weirdly, applying the same
action
sctp: avoid auth_enable sysctl UAF during netns teardown
In the Linux kernel, the following vulnerability has been resolved:
sctp: avoid auth_enable sysctl UAF during netns teardown
proc_sctp_do_auth() updates the SCTP control socket after changing
net.sctp.auth_enable. The handler gets the per-net SCTP state from
ctl->data, so an already opened sysctl file can still target a network
namespace while that namespace is being torn down.
SCTP previously registered its per-net sysctls from sctp_defaults_init(),
while the control socket is created later from sctp_ctrlsock_init(). This
exposed a window during initialization where auth_enable was writable
before net->sctp.ctl_sock existed, and a teardow
sctp: close UDP tunnel sockets during netns teardown
In the Linux kernel, the following vulnerability has been resolved:
sctp: close UDP tunnel sockets during netns teardown
proc_sctp_do_udp_port() starts per-net SCTP UDP tunneling sockets when
net.sctp.udp_port is set, and stops/restarts them when the sysctl value
changes. The netns exit path does not stop these sockets, so a namespace
can be torn down while its SCTP UDP tunnel sockets are still installed.
Close the UDP tunnel sockets from sctp_ctrlsock_exit() after unregistering
the per-net sysctl table. This prevents new sysctl writes from racing in
while the sockets are being released, and closes the sockets before the
control socket is
ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps()
In the Linux kernel, the following vulnerability has been resolved:
ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps()
ceph_handle_caps() reads snap_trace_len from the wire-format
ceph_mds_caps header and uses it unconditionally to build a fake
end pointer (snaptrace + snaptrace_len) that is later handed to
ceph_update_snap_trace() in the CEPH_CAP_OP_IMPORT case:
snaptrace = h + 1;
snaptrace_len = le32_to_cpu(h->snap_trace_len);
p = snaptrace + snaptrace_len;
...
case CEPH_CAP_OP_IMPORT:
if (snaptrace_len) {
...
if (ceph_update_snap_trace(mdsc, snaptr
libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE
In the Linux kernel, the following vulnerability has been resolved:
libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE
__decode_pg_temp() decodes an user-controlled length but only rejects
values large enough to overflow the allocation; it does not bound it to
CEPH_PG_MAX_SIZE. The helper backs both pg_temp and pg_upmap decoding, and
apply_upmap()/get_temp_osds() later copy the decoded list into the fixed-size
on-stack array struct ceph_osds.osds[CEPH_PG_MAX_SIZE]. A monitor that sends
an OSDMap with a pg_temp/pg_upmap entry longer than 32 thus causes a stack
out-of-bounds write.
An OSD set for a single PG can never exce
libceph: Fix multiplication overflow in decode_new_up_state_weight()
In the Linux kernel, the following vulnerability has been resolved:
libceph: Fix multiplication overflow in decode_new_up_state_weight()
If a message of type CEPH_MSG_OSD_MAP contains a (maliciously) corrupted
osdmap, out-of-bounds memory accesses may occur in
decode_new_up_state_weight(). This happens because the bounds check for
the new_state part is based on calculating its length depending on a len
value read from the incoming message. This calculation may overflow
leading to an incorrect bounds check. Subsequently, out-of-bounds reads
may occur when decoding this part.
This patch switches the multiplication to use check_mul_overflow()
In the Linux kernel, the following vulnerability has been resolved:
libceph: guard missing CRUSH type name lookup
Localized read selection can walk a parent bucket whose name exists in
the CRUSH map while its type has no matching entry in type_names.
get_immediate_parent() then dereferences a NULL type_cn and passes an
invalid pointer into strcmp(), causing a null-ptr-deref.
Skip such malformed parent buckets unless both the bucket name and type
name metadata are present. This keeps malformed hierarchy data from
crashing locality lookup and safely falls back to "not local".
[ idryomov: add WARN_ON_ONCE ]
libceph: refresh auth->authorizer_buf{,_len} after authorizer update
In the Linux kernel, the following vulnerability has been resolved:
libceph: refresh auth->authorizer_buf{,_len} after authorizer update
ceph_x_create_authorizer() caches au->buf->vec.iov_base and
au->buf->vec.iov_len in struct ceph_auth_handshake. These
cached values are then used by the messenger connect code when
sending the authorizer.
ceph_x_update_authorizer() can rebuild the authorizer when a newer
service ticket is available. If the rebuilt authorizer no longer
fits in the existing buffer, ceph_x_build_authorizer() drops its
reference to au->buf and allocates a new one. If this is the final
reference, ceph_buffer_put() frees the
In the Linux kernel, the following vulnerability has been resolved:
libceph: Reject monmaps advertising zero monitors
A message of type CEPH_MSG_MON_MAP contains a monmap that is sent from a
monitor to the client. This monmap contains information about the
existing monitors in the cluster. Currently, a monmap indicating that
there are zero monitors in the cluster is treated as valid. However, it
is impossible to have zero monitors in the cluster and still receive a
valid monmap from a monitor. Therefore, such a monmap must be corrupted
and should be treated as invalid. Furthermore, a monmap with a monitor
count of zero can subsequently cras
In the Linux kernel, the following vulnerability has been resolved:
libceph: reject zero bucket types in crush_decode
CRUSH bucket type 0 is reserved for devices. The mapper relies on
that invariant and uses type 0 to identify leaf devices.
If crush_decode() accepts a bucket with type 0, a malformed CRUSH map
can make the mapper treat a negative bucket ID as a device and pass it
to is_out(), which then indexes the OSD weight array with a negative
value.
Reject zero bucket types while decoding the CRUSH map so the invalid
state never reaches the mapper.