wifi: brcmfmac: Fix memory leak in brcmf_sdio_read_control()
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: Fix memory leak in brcmf_sdio_read_control()
The memory allocated for buf is not freed in some of the error paths in
brcmf_sdio_read_control(). Fix that by adding vfree() calls.
[arend: rework as suggested by Johannes]
wifi: iwlwifi: dvm: fix memory leak in iwl_op_mode_dvm_start()
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: dvm: fix memory leak in iwl_op_mode_dvm_start()
In iwl_op_mode_dvm_start(), jumping to out_free_eeprom currently bypasses
the out_free_eeprom_blob label. Consequently, error paths triggered after
successfully parsing the EEPROM free priv->nvm_data but leak
priv->eeprom_blob.
Fix this memory leak by reordering the error handling labels so
that out_free_eeprom falls through to out_free_eeprom_blob.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under d
wifi: rtl8xxxu: fix use-after-free from rx_urb_wq on stop
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtl8xxxu: fix use-after-free from rx_urb_wq on stop
rtl8xxxu arms rx_urb_wq from the RX completion path:
rtl8xxxu_rx_complete() hands the URB to rtl8xxxu_queue_rx_urb(), which
queues it on rx_urb_pending_list and, once the list grows past
RTL8XXXU_RX_URB_PENDING_WATER, schedules rx_urb_wq. The worker
rtl8xxxu_rx_urb_work() drains rx_urb_pending_list, recovers priv through
container_of, and resubmits each URB through rtl8xxxu_submit_rx_urb(),
which anchors it on rx_anchor and dereferences priv->udev.
rtl8xxxu_stop() cancels the sibling work items (c2hcmd_work, ra_wat
wifi: mwifiex: Detach sync cmd buffer on interrupted wait
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: Detach sync cmd buffer on interrupted wait
mwifiex synchronous commands keep the caller-provided data buffer in
cmd_node->data_buf. Several callers pass stack-allocated objects there.
If wait_event_interruptible_timeout() is interrupted, the caller can
return and release that stack object while the firmware command is still
the current command. A late firmware response then reaches the normal
response handler, which can copy data through cmd_node->data_buf into the
stale stack address.
This fixes a stack corruption observed during repeated association and
d
wifi: rtw88: Fix potential memory leak in rtw_txq_push_skb()
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: Fix potential memory leak in rtw_txq_push_skb()
The skb passed to the rtw_hci_tx_write() is expected to be freed when
the function fails, but the error path in rtw_txq_push_skb() does not
free the skb before returning. This can lead to a memory leak in
rtw_txq_push() where a dequeued skb is passed to rtw_txq_push_skb().
wifi: mt76: mt7615: avoid waiting for mac work under the mt76 mutex
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7615: avoid waiting for mac work under the mt76 mutex
mt7615_suspend() acquired the mt76 mutex and then called
cancel_delayed_work_sync() on mac_work. mt7615_mac_work() acquires the
same mutex via mt7615_mutex_acquire() at the top of the worker, so if
mac_work is already running and blocked on the mutex, the suspend path
deadlocks waiting for the work it holds the mutex against.
Flush scan_work and mac_work before taking the mutex, matching the
suspend paths in mt7921 and mt7925. scan_work only takes the mt76
spinlock, but moving it keeps the sequence consi
wifi: mt76: mt7915: bound the device EEPROM address before the EFUSE copy
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: bound the device EEPROM address before the EFUSE copy
mt7915_mcu_get_eeprom() copies a fixed EFUSE block into the driver's
dev->mt76.eeprom.data buffer at the offset reported by the MCU response
(res->addr, a device-controlled __le32) without checking it against the
buffer size. A malicious or malfunctioning device can report an arbitrary
address and drive a 16-byte out-of-bounds write past eeprom.data.
Reject a response whose address would place the copy outside eeprom.data
before deriving the destination pointer. Devices that echo the requested
in-bou
In the Linux kernel, the following vulnerability has been resolved:
vsock/virtio: flush works in dependency order
virtio_vsock_remove() stops the virtqueues and then flushes each work
item before freeing the enclosing virtio_vsock. The current order does
not account for dependencies between those items: tx_work may queue
send_pkt_work, and send_pkt_work may queue rx_work.
In particular, send_pkt_work can set restart_rx and release tx_lock.
The remove path can then stop the queues and flush rx_work before
send_pkt_work queues it. Although the later send_pkt_work flush waits
for that producer to finish, nothing waits for the newly queued r
w1: ds28e17: reject an oversize length on an I2C block read
In the Linux kernel, the following vulnerability has been resolved:
w1: ds28e17: reject an oversize length on an I2C block read
w1_f19_i2c_master_transfer() is the master_xfer for the DS28E17 1-Wire
to I2C bridge. On an I2C_M_RECV_LEN read, it takes the length from the
device. The downstream slave puts a length byte in buf[0]. The driver
then reads that many bytes into buf[1] with w1_f19_i2c_read().
buf[0] is controlled by the device and can be 0 to 255.
w1_f19_i2c_read() only rejects a zero count. The caller buffer is
I2C_SMBUS_BLOCK_MAX + 2, so 34 bytes. A length above 32 makes the read
run past it, up to about 222 bytes out of bounds.
In the Linux kernel, the following vulnerability has been resolved:
tpm: tpm_i2c_nuvoton: disable IRQ on wait timeout
i2c_nuvoton_wait_for_stat() enables the IRQ before waiting for the
interrupt handler to report a status change. If the wait times out, or is
interrupted before the handler runs, the function returns without
balancing the enable_irq() call.
Disable the IRQ before leaving the failed wait path. Also preserve an
interrupted wait's original error code instead of converting it to
-ETIMEDOUT inside the helper.
smack: fix cred UAF in smack_file_send_sigiotask()
In the Linux kernel, the following vulnerability has been resolved:
smack: fix cred UAF in smack_file_send_sigiotask()
When inspecting the credentials of another task, objective credentials
(->real_cred, accessed with __task_cred()) must always be used.
Accessing ->cred on a non-current task is forbidden unless that task is
being created or destroyed; a task is allowed to change its own ->cred
pointer with no synchronization, and changing ->cred should only affect the
current syscall.
smack_file_send_sigiotask() was accessing both sets of credentials: First
tsk->cred, then __task_cred(tsk).
Fix it, always access the objective credentials
vlan: fix skb_under_panic and races when toggling HW VLAN offload
In the Linux kernel, the following vulnerability has been resolved:
vlan: fix skb_under_panic and races when toggling HW VLAN offload
Toggling hardware VLAN TX offload (NETIF_F_HW_VLAN_CTAG_TX or
NETIF_F_HW_VLAN_STAG_TX) on a lower device invokes vlan_transfer_features(),
which dynamically changed vlandev->hard_header_len.
This causes two issues:
1. Lockless TX paths (e.g. packet_snd in af_packet.c, ip6_finish_output2)
read dev->hard_header_len without holding RTNL lock. Mutating
hard_header_len dynamically under RTNL creates a data race where upper
layers reserve insufficient headroom based on a stale hard_header_len,
resultin
xhci: dbgtty: Fix unregister on tty_register_driver() failure
In the Linux kernel, the following vulnerability has been resolved:
xhci: dbgtty: Fix unregister on tty_register_driver() failure
If tty_register_driver() fails, it drops the reference, but fails to set
the global dbc_tty_driver to NULL, causing the unregister to be called
again when module exits.
On module unload dbc_tty_exit() only gates its cleanup on the driver
pointer being non-NULL, so it operates on the already-freed driver:
module_init(xhci_hcd_init)
xhci_hcd_init()
xhci_dbc_init() [return value ignored]
dbc_tty_init()
tty_register_driver() fails
tty_drive
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: vsie: zero stale crypto bits
When shadowing crypto access bits from a format0 apcb (crycb 0 or 1),
the bits 64..255 are unchanged from whatever is in the vsie page in the
crycb and thus in the apcb. This gives a nested guest potential access
to a device no longer available. Zero out the remaining bits.
io_uring: defer eventfd signaling when queued from a wakeup handler
In the Linux kernel, the following vulnerability has been resolved:
io_uring: defer eventfd signaling when queued from a wakeup handler
io_req_local_work_add() signals the CQ ring eventfd inline when it is the
one to push the first entry onto ->work_list. For DEFER_TASKRUN rings that
add is frequently done from a waitqueue wakeup handler, where an
arbitrary waitqueue lock is held.
eventfd_signal_mask() only refuses to recurse when current->in_eventfd
is set, but that bit is set by eventfd_signal_mask() itself. If the wake
chain starts somewhere else, signal goes out inline and can feed back
into epoll.
Add IOU_F_TWQ_IN_WAKE, set it on the
HID: core: fix number/pointer type confusion on long items
In the Linux kernel, the following vulnerability has been resolved:
HID: core: fix number/pointer type confusion on long items
When fetch_item() is called by hid_scan_report() on an item with
HID_ITEM_TAG_LONG, it stores a pointer to the item data in
item->data.longdata instead of storing a value directly in
item->data.{u8/u16/u32}.
When item_udata() or item_sdata() encounters such an item, it incorrectly
assumes that the item is in short format, and therefore returns the lower
part of a kernel pointer reinterpreted as a number.
When a HID device is connected whose descriptor contains a
HID_GLOBAL_ITEM_TAG_REPORT_SIZE encoded in long form
PCI: host-generic: Fix NULL pointer dereference on 32-bit CAM systems
In the Linux kernel, the following vulnerability has been resolved:
PCI: host-generic: Fix NULL pointer dereference on 32-bit CAM systems
On 32-bit systems the config space is too large to ioremap in one go, so
pci_ecam_create() maps each bus segment separately and relies on the
->add_bus callback (pci_ecam_add_bus) to populate the per-bus mapping in
cfg->winp[]. pci_ecam_map_bus() then uses that mapping as the base for
every config access.
The generic ECAM ops (pci_generic_ecam_ops) already provide the ->add_bus
and ->remove_bus callbacks, but the CAM (legacy) ops in pci-host-generic.c
do not. As a result, on a 32-bit host using "pci-host
kcov: fix data corruption and race conditions on PREEMPT_RT
In the Linux kernel, the following vulnerability has been resolved:
kcov: fix data corruption and race conditions on PREEMPT_RT
syzbot is reporting KCOV state corruption on PREEMPT_RT kernels, for the
temporary storage used for saving/restoring remote KCOV state is currently
allocated as the per-CPU area.
On PREEMPT_RT kernels, softirq handlers run as preemptible task threads
(e.g., ksoftirqd). If a softirq context preempts a task running a remote
KCOV session, it safely saves the task's state into the per-CPU area.
However, if that softirq thread is subsequently preempted by a higher-
priority softirq thread on the same CPU, the second so
Bluetooth: ISO: fix use-after-free of listener socket in iso_conn_ready
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: fix use-after-free of listener socket in iso_conn_ready
iso_conn_ready() looks up the BIS listener socket with iso_get_sock(),
which takes a reference, and then, without re-checking its state,
creates a child socket from it:
parent = iso_get_sock(hdev, ...);
if (!parent)
return;
lock_sock(parent);
sk = iso_sock_alloc(sock_net(parent), NULL, BTPROTO_ISO, ...);
...
iso_chan_add(conn, sk, parent);
...
release_sock(parent);
sock_put(parent);
If the listener socket is closed concurrently, between iso_get_sock()
and l
selinux: require every boolean value to be defined
In the Linux kernel, the following vulnerability has been resolved:
selinux: require every boolean value to be defined
p_bools.nprim comes from the policy image independently of how many
booleans follow it, and cond_index_bool() fills bool_val_to_struct[] at
value - 1, so a count larger than the values present leaves NULL entries.
Every user of that array then walks it by index and dereferences each
entry: cond_evaluate_expr() on the access-vector path,
security_get_bools() and security_get_bool_value() behind selinuxfs, and
security_set_bools(). A sparse class value is absorbed by
policydb_class_isvalid() and its siblings; booleans have no