sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
sctp_auth_ep_add_chunkid() uses SCTP_NUM_CHUNK_TYPES (20) as the
capacity limit for ep->auth_chunk_list, allowing it to hold up to
20 chunk entries (param_hdr.length up to 24). However, the copy
destination asoc->c.auth_chunks in struct sctp_cookie is only
SCTP_AUTH_MAX_CHUNKS (16) entries (20 bytes). When more than 16
chunks are added, sctp_association_init() memcpy overflows the
destination by up to 4 bytes.
Fix by using SCTP_AUTH_MAX_CHUNKS as the capacity limit, matching
the destination capacity.
pds_core: fix deadlock between reset thread and remove
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix deadlock between reset thread and remove
pci_reset_function() acquires device_lock before performing the reset.
pdsc_remove() is called by the PCI core with device_lock already held.
If pdsc_pci_reset_thread() is running when pdsc_remove() is called,
destroy_workqueue() will block waiting for the work to complete, while
the work is blocked waiting for device_lock - deadlock.
Use pci_try_reset_function() which uses pci_dev_trylock() internally.
This acquires both the device lock and the PCI config access lock
without blocking - if either lock is contended, it
pds_core: fix use-after-free on workqueue during remove
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix use-after-free on workqueue during remove
In pdsc_remove(), the workqueue is destroyed before pdsc_teardown()
is called. This ordering allows two paths to queue work on the
destroyed workqueue:
1. If pdsc_teardown() -> pdsc_devcmd_reset() times out, the error
path in pdsc_devcmd_locked() queues health_work.
2. A NotifyQ event can trigger the ISR and queue work before free_irq()
is called in pdsc_teardown().
Fix by moving destroy_workqueue() after pdsc_teardown() so the
workqueue outlives every queuer; destroy_workqueue() then flushes any
work still pe
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix auxiliary device add/del races
Two paths add or delete the same slot (pf->vfs[vf_id].padev): a VF's
pdsc_reset_done() and the PF's devlink enable_vnet/disable_vnet handler.
They serialize on config_lock, but neither guards the slot under it
correctly.
add() registers and stores a new auxiliary device without first checking
the slot, so a second add of an already-populated slot leaks the first
device. del() makes that check outside config_lock, so two concurrent
dels can both pass it; the first clears the slot, and the second
dereferences a NULL pointer.
Chec
sctp: validate stream count in sctp_process_strreset_inreq()
In the Linux kernel, the following vulnerability has been resolved:
sctp: validate stream count in sctp_process_strreset_inreq()
When processing a RESET_IN_REQUEST from a peer,
sctp_process_strreset_inreq() derives the stream count from the
parameter length but does not check whether the resulting
RESET_OUT_REQUEST would exceed SCTP_MAX_CHUNK_LEN.
The OUT request header (sctp_strreset_outreq, 16 bytes) is 8 bytes
larger than the IN request header (sctp_strreset_inreq, 8 bytes).
Generally, the IP payload is bounded to 65535 bytes, so the stream
list cannot be large enough to trigger the overflow. However, on
interfaces with MTU > 65535 (e.g
net: mctp i3c: clean up notifier and buses if driver register fails
In the Linux kernel, the following vulnerability has been resolved:
net: mctp i3c: clean up notifier and buses if driver register fails
mctp_i3c_mod_init() registers the I3C bus notifier and then walks the
existing buses with i3c_for_each_bus_locked(mctp_i3c_bus_add_new, NULL)
before registering the I3C device driver. If i3c_driver_register()
fails, the function returns the error directly, leaving the notifier
registered and every mctp_i3c_bus object created for the existing buses
allocated. The notifier is left pointing into the module that failed to
load and the bus list is leaked.
Mirror the module exit path on this failure: unregiste
tipc: fix infinite loop in __tipc_nl_compat_dumpit
In the Linux kernel, the following vulnerability has been resolved:
tipc: fix infinite loop in __tipc_nl_compat_dumpit
cmd->dumpit callback can return a negative errno, causing an infinite
loop due to the while(len) condition. As the loop never terminates,
genl_mutex is never released, and other tasks waiting on it starve in D
state.
Check dumpit's return value, propagate it and jump to err_out on error.
cifs: fix cifsFileInfo leak on kmalloc failure in deferred close drain paths
In the Linux kernel, the following vulnerability has been resolved:
cifs: fix cifsFileInfo leak on kmalloc failure in deferred close drain paths
In cifs_close_deferred_file(), cifs_close_all_deferred_files(), and
cifs_close_deferred_file_under_dentry(), when a pending deferred close
is cancelled via cancel_delayed_work(), the subsequent kmalloc_obj() to
add the file to the local processing list may fail under memory pressure.
The loop breaks immediately, but the cancelled work is no longer pending
(it would have called _cifsFileInfo_put()), and the cfile is never added
to file_head for processing. The cifsFileInfo reference and the open
se
wifi: mt76: mt7925: guard link STA in decap offload
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: guard link STA in decap offload
mt7925_sta_set_decap_offload() iterates over the vif valid_links mask
when updating decap offload state for an MLO station. The station may not
have a link STA for every valid link of the vif, so mt792x_sta_to_link()
can return NULL for a link that belongs to the vif but not to the station.
The function currently dereferences mlink before checking whether the
link WCID is ready. If mlink is NULL, setting or clearing
MT_WCID_FLAG_HDR_TRANS dereferences a NULL pointer.
Skip links without a station link before touching mlin
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: guard HE capability lookups
mt7915_mcu_bss_he_tlv() and mt7915_mcu_sta_bfer_tlv() both run after
checking HE support, then dereference the HE PHY capability returned by
mt76_connac_get_he_phy_cap(). That helper can return NULL when no
capability entry matches the vif type.
Fetch the capability before appending the TLV and skip the HE-specific
setup when no matching capability is available.
wifi: mt76: connac: fix possible NULL-pointer deref in mt76_connac_mcu_uni_bss_he_tlv()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: connac: fix possible NULL-pointer deref in mt76_connac_mcu_uni_bss_he_tlv()
mt76_connac_get_he_phy_cap routine can theoretically return NULL so
check cap pointer before dereferencing it.
wifi: mt76: mt7996: check pointer returned by mt76_connac_get_he_phy_cap()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: check pointer returned by mt76_connac_get_he_phy_cap()
mt76_connac_get_he_phy_cap routine can theoretically return NULL so
check cap pointer before dereferencing it.
wifi: mt76: mt7925: fix crash in reset link replay
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: fix crash in reset link replay
During reset recovery, mt7925_vif_connect_iter() replays firmware state
for links tracked in mvif->valid_links. After MLO link changes or MCU
timeout recovery, the driver bitmap can temporarily contain a link whose
mac80211 bss_conf has already gone away.
This can pass a NULL bss_conf to mt76_connac_mcu_uni_add_dev(), matching
the crash where x1, the second argument, is NULL:
pc : mt76_connac_mcu_uni_add_dev+0x8c/0x1f8 [mt76_connac_lib]
lr : mt7925_vif_connect_iter+0x9c/0x168 [mt7925_common]
x2 : ffffff80a77f6018 x1 : 000
wifi: mt76: mt7996: fix possible NULL-pointer deref in mt7996_mcu_sta_bfer_eht()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: fix possible NULL-pointer deref in mt7996_mcu_sta_bfer_eht()
mt76_connac_get_eht_phy_cap routine can theoretically return NULL so
check cap pointer before dereferencing it.
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: fix 802.1X-SHA256 call trace warning
Based on wpa_auth as 1x_256 mode, need to set up
"use_fwsup" with BRCMF_PROFILE_FWSUP_1X.
Or it will happen trace warning when call brcmf_cfg80211_set_pmk().
[ 4481.831101] ------------[ cut here ]------------
[ 4481.831102] WARNING: CPU: 1 PID: 2997 at
drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c:7242 brcmf_cfg80211_set_pmk+0x77/0xd0 [brcmfmac]
[...]
[ 4481.831202] Call Trace:
[ 4481.831204] <TASK>
[ 4481.831205] nl80211_set_pmk+0x183/0x250 [cfg80211]
[ 4481.831233] genl_family_rcv_msg_doit+0xea/0x150
In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: hvs/v3d: Fix null dereference in unbind
The hvs and v3d drivers use dev_get_drvdata(master) in their unbind
functions. Since the vc4-drm gets removed before its dependent drivers
(vc4_hvs/vc4_v3d) the vc4_hvs_unbind/vc4_v3d_unbind functions try to
get drvdata of its master and fails with a null dereference error.
Use the data pointer passed to the unbind functions directly instead of
dev_get_drvdata(master). This avoids using potentially freed memory.
In the Linux kernel, the following vulnerability has been resolved:
amt: re-read skb header pointers after every pull
Several AMT receive and transmit paths cache a pointer into the skb head
(ip_hdr(), ipv6_hdr(), eth_hdr() or the AMT message header) and then call
a helper that can reallocate that head before the cached pointer is used
again. pskb_may_pull(), ip_mc_may_pull(), ipv6_mc_may_pull(),
iptunnel_pull_header(), ip_mc_check_igmp() and ipv6_mc_check_mld() can all
free the old head and move the data, so a pointer taken before the call
dangles afterwards and the later access is a use-after-free of the freed
head.
The affected sites a
net: hsr: fix memory leak on slave unregistration by removing synced VLANs
In the Linux kernel, the following vulnerability has been resolved:
net: hsr: fix memory leak on slave unregistration by removing synced VLANs
When an HSR master device is brought UP, it auto-adds VLAN 0 via
vlan_vid0_add(), which propagates VID 0 to its slave devices (slave A and B).
If a slave device is later unregistered while HSR is active (e.g., during
netns cleanup or interface destruction), hsr_del_port() is called to
detach the slave port from the HSR master. However, hsr_del_port() currently
does not delete the VLAN IDs that were synced to the slave device by HSR.
As a result, the slave device retains a refcount on VID 0 (and any
sctp: auth: verify auth requirement when auth_chunk is NULL
In the Linux kernel, the following vulnerability has been resolved:
sctp: auth: verify auth requirement when auth_chunk is NULL
sctp_auth_chunk_verify() returns true unconditionally when
chunk->auth_chunk is NULL, silently skipping authentication.
This is incorrect when:
1. skb_clone() failed in the BH receive path, leaving auth_chunk
NULL. In sctp_endpoint_bh_rcv() asoc is NULL for new
connections, so the early sctp_auth_recv_cid() check cannot
catch this.
2. No AUTH chunk precedes COOKIE-ECHO, so skb_clone() is never
called and auth_chunk remains NULL.
Fix by checking sctp_auth_recv_cid() when auth_chunk is NULL:
if authent
vmxnet3: fix BUG_ON in vmxnet3_get_hdr_len() for Geneve packets
In the Linux kernel, the following vulnerability has been resolved:
vmxnet3: fix BUG_ON in vmxnet3_get_hdr_len() for Geneve packets
vmxnet3_get_hdr_len() assumes gdesc->rcd.v4/v6/tcp always describe the
outer header, but for a Geneve-encapsulated packet the device can set
them based on the inner header instead, signalled by the
VMXNET3_RCD_HDR_INNER_SHIFT bit in the completion descriptor. Since the
function never skips the outer encapsulation, this mismatch triggers:
- BUG_ON(hdr.ipv4->protocol != IPPROTO_TCP), because the outer
protocol is UDP (Geneve), not TCP.
- BUG_ON(hdr.eth->h_proto != ...), when the tunnel's outer and inner
IP v