usb: host: ohci-tmio: check return value after calling platform_get_resource()
In the Linux kernel, the following vulnerability has been resolved:
usb: host: ohci-tmio: check return value after calling platform_get_resource()
It will cause null-ptr-deref if platform_get_resource() returns NULL,
we need check the return value.
net: dpaa2-eth: fix use-after-free in dpaa2_eth_remove
In the Linux kernel, the following vulnerability has been resolved:
net: dpaa2-eth: fix use-after-free in dpaa2_eth_remove
Access to netdev after free_netdev() will cause use-after-free bug.
Move debug log before free_netdev() call to avoid it.
scsi: lpfc: Fix list_add() corruption in lpfc_drain_txq()
In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Fix list_add() corruption in lpfc_drain_txq()
When parsing the txq list in lpfc_drain_txq(), the driver attempts to pass
the requests to the adapter. If such an attempt fails, a local "fail_msg"
string is set and a log message output. The job is then added to a
completions list for cancellation.
Processing of any further jobs from the txq list continues, but since
"fail_msg" remains set, jobs are added to the completions list regardless
of whether a wqe was passed to the adapter. If successfully added to
txcmplq, jobs are added to both lists resulting in list
thermal: Fix NULL pointer dereferences in of_thermal_ functions
In the Linux kernel, the following vulnerability has been resolved:
thermal: Fix NULL pointer dereferences in of_thermal_ functions
of_parse_thermal_zones() parses the thermal-zones node and registers a
thermal_zone device for each subnode. However, if a thermal zone is
consuming a thermal sensor and that thermal sensor device hasn't probed
yet, an attempt to set trip_point_*_temp for that thermal zone device
can cause a NULL pointer dereference. Fix it.
console:/sys/class/thermal/thermal_zone87 # echo 120000 > trip_point_0_temp
...
Unable to handle kernel NULL pointer dereference at virtual address 0000000000000020
...
Call trace:
iavf: free q_vectors before queues in iavf_disable_vf
In the Linux kernel, the following vulnerability has been resolved:
iavf: free q_vectors before queues in iavf_disable_vf
iavf_free_queues() clears adapter->num_active_queues, which
iavf_free_q_vectors() relies on, so swap the order of these two function
calls in iavf_disable_vf(). This resolves a panic encountered when the
interface is disabled and then later brought up again after PF
communication is restored.
cfg80211: call cfg80211_stop_ap when switch from P2P_GO type
In the Linux kernel, the following vulnerability has been resolved:
cfg80211: call cfg80211_stop_ap when switch from P2P_GO type
If the userspace tools switch from NL80211_IFTYPE_P2P_GO to
NL80211_IFTYPE_ADHOC via send_msg(NL80211_CMD_SET_INTERFACE), it
does not call the cleanup cfg80211_stop_ap(), this leads to the
initialization of in-use data. For example, this path re-init the
sdata->assigned_chanctx_list while it is still an element of
assigned_vifs list, and makes that linked list corrupt.
scsi: core: sysfs: Fix hang when device state is set via sysfs
In the Linux kernel, the following vulnerability has been resolved:
scsi: core: sysfs: Fix hang when device state is set via sysfs
This fixes a regression added with:
commit f0f82e2476f6 ("scsi: core: Fix capacity set to zero after
offlinining device")
The problem is that after iSCSI recovery, iscsid will call into the kernel
to set the dev's state to running, and with that patch we now call
scsi_rescan_device() with the state_mutex held. If the SCSI error handler
thread is just starting to test the device in scsi_send_eh_cmnd() then it's
going to try to grab the state_mutex.
We are then stuck, because when scsi_rescan_device() tries to
perf bpf: Avoid memory leak from perf_env__insert_btf()
In the Linux kernel, the following vulnerability has been resolved:
perf bpf: Avoid memory leak from perf_env__insert_btf()
perf_env__insert_btf() doesn't insert if a duplicate BTF id is
encountered and this causes a memory leak. Modify the function to return
a success/error value and then free the memory if insertion didn't
happen.
v2. Adds a return -1 when the insertion error occurs in
perf_env__fetch_btf. This doesn't affect anything as the result is
never checked.
btrfs: fix memory ordering between normal and ordered work functions
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix memory ordering between normal and ordered work functions
Ordered work functions aren't guaranteed to be handled by the same thread
which executed the normal work functions. The only way execution between
normal/ordered functions is synchronized is via the WORK_DONE_BIT,
unfortunately the used bitops don't guarantee any ordering whatsoever.
This manifested as seemingly inexplicable crashes on ARM64, where
async_chunk::inode is seen as non-null in async_cow_submit which causes
submit_compressed_extents to be called and crash occurs because
async_chunk::inode sudd
arm64: dts: qcom: msm8998: Fix CPU/L2 idle state latency and residency
In the Linux kernel, the following vulnerability has been resolved:
arm64: dts: qcom: msm8998: Fix CPU/L2 idle state latency and residency
The entry/exit latency and minimum residency in state for the idle
states of MSM8998 were ..bad: first of all, for all of them the
timings were written for CPU sleep but the min-residency-us param
was miscalculated (supposedly, while porting this from downstream);
Then, the power collapse states are setting PC on both the CPU
cluster *and* the L2 cache, which have different timings: in the
specific case of L2 the times are higher so these ones should be
taken into account instead of the CPU ones.
This p
tty: tty_buffer: Fix the softlockup issue in flush_to_ldisc
In the Linux kernel, the following vulnerability has been resolved:
tty: tty_buffer: Fix the softlockup issue in flush_to_ldisc
When running ltp testcase(ltp/testcases/kernel/pty/pty04.c) with arm64, there is a soft lockup,
which look like this one:
Workqueue: events_unbound flush_to_ldisc
Call trace:
dump_backtrace+0x0/0x1ec
show_stack+0x24/0x30
dump_stack+0xd0/0x128
panic+0x15c/0x374
watchdog_timer_fn+0x2b8/0x304
__run_hrtimer+0x88/0x2c0
__hrtimer_run_queues+0xa4/0x120
hrtimer_interrupt+0xfc/0x270
arch_timer_handler_phys+0x40/0x50
handle_percpu_devid_irq+0x94/0x220
__handle_domain_irq+0x88/0xf0
gic
In the Linux kernel, the following vulnerability has been resolved:
i40e: Fix NULL ptr dereference on VSI filter sync
Remove the reason of null pointer dereference in sync VSI filters.
Added new I40E_VSI_RELEASING flag to signalize deleting and releasing
of VSI resources to sync this thread with sync filters subtask.
Without this patch it is possible to start update the VSI filter list
after VSI is removed, that's causing a kernel oops.
usb: musb: tusb6010: check return value after calling platform_get_resource()
In the Linux kernel, the following vulnerability has been resolved:
usb: musb: tusb6010: check return value after calling platform_get_resource()
It will cause null-ptr-deref if platform_get_resource() returns NULL,
we need check the return value.
NFSv4: Fix a NULL pointer dereference in pnfs_mark_matching_lsegs_return()
In the Linux kernel, the following vulnerability has been resolved:
NFSv4: Fix a NULL pointer dereference in pnfs_mark_matching_lsegs_return()
Commit de144ff4234f changes _pnfs_return_layout() to call
pnfs_mark_matching_lsegs_return() passing NULL as the struct
pnfs_layout_range argument. Unfortunately,
pnfs_mark_matching_lsegs_return() doesn't check if we have a value here
before dereferencing it, causing an oops.
I'm able to hit this crash consistently when running connectathon basic
tests on NFS v4.1/v4.2 against Ontap.
In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Fix sysfs leak in alloc_iommu()
iommu_device_sysfs_add() is called before, so is has to be cleaned on subsequent
errors.
iio: adc: ad7124: Fix potential overflow due to non sequential channel numbers
In the Linux kernel, the following vulnerability has been resolved:
iio: adc: ad7124: Fix potential overflow due to non sequential channel numbers
Channel numbering must start at 0 and then not have any holes, or
it is possible to overflow the available storage. Note this bug was
introduced as part of a fix to ensure we didn't rely on the ordering
of child nodes. So we need to support arbitrary ordering but they all
need to be there somewhere.
Note I hit this when using qemu to test the rest of this series.
Arguably this isn't the best fix, but it is probably the most minimal
option for backporting etc.
Alexandru's sign-off is here beca
In the Linux kernel, the following vulnerability has been resolved:
net: usb: fix memory leak in smsc75xx_bind
Syzbot reported memory leak in smsc75xx_bind().
The problem was is non-freed memory in case of
errors after memory allocation.
backtrace:
[<ffffffff84245b62>] kmalloc include/linux/slab.h:556 [inline]
[<ffffffff84245b62>] kzalloc include/linux/slab.h:686 [inline]
[<ffffffff84245b62>] smsc75xx_bind+0x7a/0x334 drivers/net/usb/smsc75xx.c:1460
[<ffffffff82b5b2e6>] usbnet_probe+0x3b6/0xc30 drivers/net/usb/usbnet.c:1728
USB: usbfs: Don't WARN about excessively large memory allocations
In the Linux kernel, the following vulnerability has been resolved:
USB: usbfs: Don't WARN about excessively large memory allocations
Syzbot found that the kernel generates a WARNing if the user tries to
submit a bulk transfer through usbfs with a buffer that is way too
large. This isn't a bug in the kernel; it's merely an invalid request
from the user and the usbfs code does handle it correctly.
In theory the same thing can happen with async transfers, or with the
packet descriptor table for isochronous transfers.
To prevent the MM subsystem from complaining about these bad
allocation requests, add the __GFP_NOWARN flag to the kmalloc c