btrfs: fix memory ordering between normal and ordered work functions
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix memory ordering between normal and ordered work functions
Ordered work functions aren't guaranteed to be handled by the same thread
which executed the normal work functions. The only way execution between
normal/ordered functions is synchronized is via the WORK_DONE_BIT,
unfortunately the used bitops don't guarantee any ordering whatsoever.
This manifested as seemingly inexplicable crashes on ARM64, where
async_chunk::inode is seen as non-null in async_cow_submit which causes
submit_compressed_extents to be called and crash occurs because
async_chunk::inode sudd
In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: core: Improve SCSI abort handling
The following has been observed on a test setup:
WARNING: CPU: 4 PID: 250 at drivers/scsi/ufs/ufshcd.c:2737 ufshcd_queuecommand+0x468/0x65c
Call trace:
ufshcd_queuecommand+0x468/0x65c
scsi_send_eh_cmnd+0x224/0x6a0
scsi_eh_test_devices+0x248/0x418
scsi_eh_ready_devs+0xc34/0xe58
scsi_error_handler+0x204/0x80c
kthread+0x150/0x1b4
ret_from_fork+0x10/0x30
That warning is triggered by the following statement:
WARN_ON(lrbp->cmd);
Fix this warning by clearing lrbp->cmd from the abort handler.
arm64: dts: qcom: msm8998: Fix CPU/L2 idle state latency and residency
In the Linux kernel, the following vulnerability has been resolved:
arm64: dts: qcom: msm8998: Fix CPU/L2 idle state latency and residency
The entry/exit latency and minimum residency in state for the idle
states of MSM8998 were ..bad: first of all, for all of them the
timings were written for CPU sleep but the min-residency-us param
was miscalculated (supposedly, while porting this from downstream);
Then, the power collapse states are setting PC on both the CPU
cluster *and* the L2 cache, which have different timings: in the
specific case of L2 the times are higher so these ones should be
taken into account instead of the CPU ones.
This p
tty: tty_buffer: Fix the softlockup issue in flush_to_ldisc
In the Linux kernel, the following vulnerability has been resolved:
tty: tty_buffer: Fix the softlockup issue in flush_to_ldisc
When running ltp testcase(ltp/testcases/kernel/pty/pty04.c) with arm64, there is a soft lockup,
which look like this one:
Workqueue: events_unbound flush_to_ldisc
Call trace:
dump_backtrace+0x0/0x1ec
show_stack+0x24/0x30
dump_stack+0xd0/0x128
panic+0x15c/0x374
watchdog_timer_fn+0x2b8/0x304
__run_hrtimer+0x88/0x2c0
__hrtimer_run_queues+0xa4/0x120
hrtimer_interrupt+0xfc/0x270
arch_timer_handler_phys+0x40/0x50
handle_percpu_devid_irq+0x94/0x220
__handle_domain_irq+0x88/0xf0
gic
In the Linux kernel, the following vulnerability has been resolved:
i40e: Fix NULL ptr dereference on VSI filter sync
Remove the reason of null pointer dereference in sync VSI filters.
Added new I40E_VSI_RELEASING flag to signalize deleting and releasing
of VSI resources to sync this thread with sync filters subtask.
Without this patch it is possible to start update the VSI filter list
after VSI is removed, that's causing a kernel oops.
usb: musb: tusb6010: check return value after calling platform_get_resource()
In the Linux kernel, the following vulnerability has been resolved:
usb: musb: tusb6010: check return value after calling platform_get_resource()
It will cause null-ptr-deref if platform_get_resource() returns NULL,
we need check the return value.
In the Linux kernel, the following vulnerability has been resolved:
x86, relocs: Ignore relocations in .notes section
When building with CONFIG_XEN_PV=y, .text symbols are emitted into
the .notes section so that Xen can find the "startup_xen" entry point.
This information is used prior to booting the kernel, so relocations
are not useful. In fact, performing relocations against the .notes
section means that the KASLR base is exposed since /sys/kernel/notes
is world-readable.
To avoid leaking the KASLR base without breaking unprivileged tools that
are expecting to read /sys/kernel/notes, skip performing relocations in
the .notes section. Th
vfio/pci: Disable auto-enable of exclusive INTx IRQ
In the Linux kernel, the following vulnerability has been resolved:
vfio/pci: Disable auto-enable of exclusive INTx IRQ
Currently for devices requiring masking at the irqchip for INTx, ie.
devices without DisINTx support, the IRQ is enabled in request_irq()
and subsequently disabled as necessary to align with the masked status
flag. This presents a window where the interrupt could fire between
these events, resulting in the IRQ incrementing the disable depth twice.
This would be unrecoverable for a user since the masked flag prevents
nested enables through vfio.
Instead, invert the logic using IRQF_NO_AUTOEN such that exclusive INTx
is ne
In the Linux kernel, the following vulnerability has been resolved:
vfio/platform: Create persistent IRQ handlers
The vfio-platform SET_IRQS ioctl currently allows loopback triggering of
an interrupt before a signaling eventfd has been configured by the user,
which thereby allows a NULL pointer dereference.
Rather than register the IRQ relative to a valid trigger, register all
IRQs in a disabled state in the device open path. This allows mask
operations on the IRQ to nest within the overall enable state governed
by a valid eventfd signal. This decouples @masked, protected by the
@locked spinlock from @trigger, protected via the @igate mu
In the Linux kernel, the following vulnerability has been resolved:
vfio/pci: Create persistent INTx handler
A vulnerability exists where the eventfd for INTx signaling can be
deconfigured, which unregisters the IRQ handler but still allows
eventfds to be signaled with a NULL context through the SET_IRQS ioctl
or through unmask irqfd if the device interrupt is pending.
Ideally this could be solved with some additional locking; the igate
mutex serializes the ioctl and config space accesses, and the interrupt
handler is unregistered relative to the trigger, but the irqfd path
runs asynchronous to those. The igate mutex cannot be acquired fr
In the Linux kernel, the following vulnerability has been resolved:
vfio/pci: Lock external INTx masking ops
Mask operations through config space changes to DisINTx may race INTx
configuration changes via ioctl. Create wrappers that add locking for
paths outside of the core interrupt code.
In particular, irq_type is updated holding igate, therefore testing
is_intx() requires holding igate. For example clearing DisINTx from
config space can otherwise race changes of the interrupt configuration.
This aligns interfaces which may trigger the INTx eventfd into two
camps, one side serialized by igate and the other only enabled while
INTx is c
netlink: Fix kernel-infoleak-after-free in __skb_datagram_iter
In the Linux kernel, the following vulnerability has been resolved:
netlink: Fix kernel-infoleak-after-free in __skb_datagram_iter
syzbot reported the following uninit-value access issue [1]:
netlink_to_full_skb() creates a new `skb` and puts the `skb->data`
passed as a 1st arg of netlink_to_full_skb() onto new `skb`. The data
size is specified as `len` and passed to skb_put_data(). This `len`
is based on `skb->end` that is not data offset but buffer offset. The
`skb->end` contains data and tailroom. Since the tailroom is not
initialized when the new `skb` created, KMSAN detects uninitialized
memory area when copying the data.
This patch
In the Linux kernel, the following vulnerability has been resolved:
net: ip_tunnel: prevent perpetual headroom growth
syzkaller triggered following kasan splat:
BUG: KASAN: use-after-free in __skb_flow_dissect+0x19d1/0x7a50 net/core/flow_dissector.c:1170
Read of size 1 at addr ffff88812fb4000e by task syz-executor183/5191
[..]
kasan_report+0xda/0x110 mm/kasan/report.c:588
__skb_flow_dissect+0x19d1/0x7a50 net/core/flow_dissector.c:1170
skb_flow_dissect_flow_keys include/linux/skbuff.h:1514 [inline]
___skb_get_hash net/core/flow_dissector.c:1791 [inline]
__skb_get_hash+0xc7/0x540 net/core/flow_dissector.c:1856
skb_get_hash include/linux
Bluetooth: Avoid potential use-after-free in hci_error_reset
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: Avoid potential use-after-free in hci_error_reset
While handling the HCI_EV_HARDWARE_ERROR event, if the underlying
BT controller is not responding, the GPIO reset mechanism would
free the hci_dev and lead to a use-after-free in hci_error_reset.
Here's the call trace observed on a ChromeOS device with Intel AX201:
queue_work_on+0x3e/0x6c
__hci_cmd_sync_sk+0x2ee/0x4c0 [bluetooth <HASH:3b4a6>]
? init_wait_entry+0x31/0x31
__hci_cmd_sync+0x16/0x20 [bluetooth <HASH:3b4a 6>]
hci_error_reset+0x4f/0xa4 [bluetooth <HASH:3b4a 6>]
process_one_work+0x1d8/0
tls: fix use-after-free on failed backlog decryption
In the Linux kernel, the following vulnerability has been resolved:
tls: fix use-after-free on failed backlog decryption
When the decrypt request goes to the backlog and crypto_aead_decrypt
returns -EBUSY, tls_do_decryption will wait until all async
decryptions have completed. If one of them fails, tls_do_decryption
will return -EBADMSG and tls_decrypt_sg jumps to the error path,
releasing all the pages. But the pages have been passed to the async
callback, and have already been released by tls_decrypt_done.
The only true async case is when crypto_aead_decrypt returns
-EINPROGRESS. With -EBUSY, we already waited so we can tell
tls_sw_recv
gtp: fix use-after-free and null-ptr-deref in gtp_newlink()
In the Linux kernel, the following vulnerability has been resolved:
gtp: fix use-after-free and null-ptr-deref in gtp_newlink()
The gtp_link_ops operations structure for the subsystem must be
registered after registering the gtp_net_ops pernet operations structure.
Syzkaller hit 'general protection fault in gtp_genl_dump_pdp' bug:
[ 1010.702740] gtp: GTP module unloaded
[ 1010.715877] general protection fault, probably for non-canonical address 0xdffffc0000000001: 0000 [#1] SMP KASAN NOPTI
[ 1010.715888] KASAN: null-ptr-deref in range [0x0000000000000008-0x000000000000000f]
[ 1010.715895] CPU: 1 PID: 128616 Comm: a.out Not tainted 6.8.0-r
In the Linux kernel, the following vulnerability has been resolved:
btrfs: dev-replace: properly validate device names
There's a syzbot report that device name buffers passed to device
replace are not properly checked for string termination which could lead
to a read out of bounds in getname_kernel().
Add a helper that validates both source and target device name buffers.
For devid as the source initialize the buffer to empty string in case
something tries to read it later.
This was originally analyzed and fixed in a different way by Edward Adam
Davis (see links).
dmaengine: fsl-qdma: fix SoC may hang on 16 byte unaligned read
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: fsl-qdma: fix SoC may hang on 16 byte unaligned read
There is chip (ls1028a) errata:
The SoC may hang on 16 byte unaligned read transactions by QDMA.
Unaligned read transactions initiated by QDMA may stall in the NOC
(Network On-Chip), causing a deadlock condition. Stalled transactions will
trigger completion timeouts in PCIe controller.
Workaround:
Enable prefetch by setting the source descriptor prefetchable bit
( SD[PF] = 1 ).
Implement this workaround.
dmaengine: fsl-qdma: init irq after reg initialization
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: fsl-qdma: init irq after reg initialization
Initialize the qDMA irqs after the registers are configured so that
interrupts that may have been pending from a primary kernel don't get
processed by the irq handler before it is ready to and cause panic with
the following trace:
Call trace:
fsl_qdma_queue_handler+0xf8/0x3e8
__handle_irq_event_percpu+0x78/0x2b0
handle_irq_event_percpu+0x1c/0x68
handle_irq_event+0x44/0x78
handle_fasteoi_irq+0xc8/0x178
generic_handle_irq+0x24/0x38
__handle_domain_irq+0x90/0x100
gic_handle_irq+0x5c/0xb8
el1_i