PatchFirst · Vulnérabilités récentes
Vulnérabilités publiées pour linux-intel-iotg au cours des 30 derniers jours : 648. Présentes dans le catalogue KEV : 0.
Vulnérabilités : 11002
In the Linux kernel, the following vulnerability has been resolved: ALSA: es1938: check snd_ctl_new1() return value snd_ctl_new1() can return NULL when memory allocation fails. snd_es1938_mixer() does not check the return value before dereferencing the pointer, which can lead to a NULL pointer dereference. Add a NULL check after snd_ctl_new1() and return -ENOMEM if it fails.
In the Linux kernel, the following vulnerability has been resolved: ALSA: firewire: isight: bound the sample count to the packet payload isight_packet() takes the frame count from the device iso packet and checks it only against the device claimed iso length. count = be32_to_cpu(payload->sample_count); if (likely(count <= (length - 16) / 4)) isight_samples(isight, payload->samples, count); length is the iso header data_length. It can be up to 0xffff. So the gate allows a count up to about 16379. isight_samples() then copies count frames out of payload->samples into the PCM DMA buffer. payload->samples holds only 2 * MAX_FRAMES_PER_PA
In the Linux kernel, the following vulnerability has been resolved: ALSA: usb-audio: avoid kobject path lookup in DualSense match The DualSense jack-detection input handler verifies that a matching input device belongs to the same physical controller by building kobject path strings for both the input device and the USB audio device, then comparing the path prefix. This was observed when a weak physical connection caused the controller to rapidly disconnect and reconnect. During that repeated hotplug, snd_dualsense_ih_match() can run while the controller's USB device is being disconnected. kobject_get_path() walks ancestor kobjects and der
In the Linux kernel, the following vulnerability has been resolved: vfio/pci: Release the VGA arbiter client on register_device() failure The re-order in the Fixes commit below displaced vfio_pci_vga_init() as the last failure point of what is now vfio_pci_core_register_device() without introducing an unwind for the VGA arbiter registration. In current kernels this is mostly benign because vfio_pci_set_decode() only uses pci_dev state, but the original failure path could leave a callback with a freed vdev cookie. The stale registration also becomes unsafe again once the callback follows drvdata to the vfio device. Add the required VGA un
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: btusb: fix use-after-free on registration failure Make sure to release the sibling interfaces in case controller registration fails to avoid use-after-free and double-free when they are eventually disconnected. This issue was reported by Sashiko while reviewing a fix for a wakeup source leak in the btusb probe errors paths.
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: btusb: fix use-after-free on marvell probe failure Make sure to stop any TX URBs submitted during Marvell OOB wakeup configuration on later probe failures to avoid use-after-free in the completion callback. This issue was reported by Sashiko while reviewing a fix for a wakeup source leak in the btusb probe errors paths.
In the Linux kernel, the following vulnerability has been resolved: binder: fix UAF in binder_thread_release() When a thread exits, binder_thread_release() walks its transaction stack to clear the t->from and t->to_proc that correspond with the exiting thread. However, a process dying in parallel might attempt to kfree some of these transactions. And if one of them has no associated t->to_proc, the t->to_proc->inner_lock will not be acquired. This means that transaction accesses in binder_thread_release() after t->to_proc has been cleared might race with binder_free_transaction() and cause a use-after-free error as reported by KASAN: ==
In the Linux kernel, the following vulnerability has been resolved: binder: fix UAF in binder_free_transaction() In binder_free_transaction(), the t->to_proc is read under the t->lock. However, once the t->lock is dropped, the to_proc can die in parallel. This leads to a use-after-free error when we attempt to acquire its inner lock right afterwards: ================================================================== BUG: KASAN: slab-use-after-free in _raw_spin_lock+0xe4/0x1a0 Write of size 4 at addr ffff00001125da70 by task B/672 CPU: 20 UID: 0 PID: 672 Comm: B Not tainted 7.1.0-rc6-00284-g8e65320d91cd #4 PREEMPT Hardware name:
In the Linux kernel, the following vulnerability has been resolved: usb: xhci: Fix sleep in atomic context in xhci_free_streams() When a USB device with active stream endpoints is disconnected, xhci_free_streams() is called from the hub_event workqueue to free the stream resources. It calls xhci_free_stream_info() while holding xhci->lock with irqs disabled. xhci_free_stream_info() invokes xhci_free_stream_ctx(), which calls dma_free_coherent() for large stream context arrays. dma_free_coherent() can sleep (e.g. via vunmap), triggering a BUG when called from atomic context. Call trace: dma_free_attrs+0x174/0x220 xhci_free_stream_info+
In the Linux kernel, the following vulnerability has been resolved: usb: typec: tcpci_rt1711h: unregister TCPCI port with devres rt1711h_probe() registers the TCPCI port before requesting the interrupt and enabling alert interrupts. If either of those later steps fails, the probe function returns without unregistering the TCPCI port. The explicit unregister currently only happens from the remove callback. Register a devres action immediately after tcpci_register_port() succeeds, so tcpci_unregister_port() runs on later probe failures and on driver detach. Drop the remove callback to avoid unregistering the same port twice. This issue was
In the Linux kernel, the following vulnerability has been resolved: PCI: altera: Fix resource leaks on probe failure The chained IRQ handler is set during probe, but is only removed during the driver remove(). If pci_host_probe() fails, the handler and INTx IRQ domain remain set even though the devm-managed host bridge storage containing struct altera_pcie will be released, leaving the handler with a stale data pointer. Interrupts are also enabled before pci_host_probe() is called. If probe fails after that point, the controller interrupt source should be disabled before the chained handler and INTx domain are removed. So set the chained
In the Linux kernel, the following vulnerability has been resolved: PCI: mediatek: Fix IRQ domain leak when port fails to enable When mtk_pcie_enable_port() fails, mtk_pcie_port_free() removes the port from pcie->ports and frees the port structure. However, the IRQ domains set up earlier by mtk_pcie_init_irq_domain() are never freed. Fix this by refactoring mtk_pcie_irq_teardown() into a per-port helper, mtk_pcie_irq_teardown_port(), and calling it from mtk_pcie_setup() when mtk_pcie_enable_port() fails. Since the IRQ teardown must only happen in the probe error path (during resume, child devices may have active MSI mappings and the NOIRQ
In the Linux kernel, the following vulnerability has been resolved: hwrng: virtio: clamp device-reported used.len at copy_data() random_recv_done() stores the device-reported used.len directly into vi->data_avail. copy_data() then indexes vi->data[] using vi->data_idx (advanced by previous copy_data() calls) and issues a memcpy() without re-validating either value against the posted buffer size sizeof(vi->data) (SMP_CACHE_BYTES bytes, typically 32 or 64). A malicious or buggy virtio-rng backend can set used.len beyond sizeof(vi->data), steering the memcpy() past the end of the inline array into adjacent kmalloc-1k slab bytes. hwrng_fillf
In the Linux kernel, the following vulnerability has been resolved: USB: chaoskey: Fix slab-use-after-free in chaoskey_release() The chaoskey driver has a use-after-free bug in its release routine. If the user closes the device file after the USB device has been unplugged, a debugging log statement will try to access the usb_interface structure after it has been deallocated: BUG: KASAN: slab-use-after-free in dev_driver_string (drivers/base/core.c:2406) Read of size 8 at addr ffff888168e8a0b8 by task chaoskey_raw_re/10106 Hardware name: QEMU Ubuntu 24.04 PC v2 (i440FX + PIIX, arch_caps fix, 1996), BIOS 1.16.3-debian-1.16.3-2 04/01/2014
In the Linux kernel, the following vulnerability has been resolved: usb: dwc3: run gadget disconnect from sleepable suspend context dwc3_gadget_suspend() takes dwc->lock with IRQs disabled and then calls dwc3_disconnect_gadget(). For async callbacks that helper only uses plain spin_unlock()/spin_lock(), so the gadget ->disconnect() callback still runs with IRQs disabled and any sleepable callback trips Lockdep. This issue was found by our static analysis tool and then manually reviewed against the current tree. The grounded PoC kept the dwc3_gadget_suspend() -> dwc3_disconnect_gadget() -> gadget_driver->disconnect() chain, and Lockdep re
In the Linux kernel, the following vulnerability has been resolved: 6lowpan: fix NHC entry use-after-free on error path lowpan_nhc_do_uncompression() looks up an NHC descriptor while holding lowpan_nhc_lock. If the descriptor has no uncompress callback, the error path drops the lock before printing nhc->name. lowpan_nhc_del() removes descriptors under the same lock and then relies on synchronize_net() before the owning module can be unloaded. That only waits for net RX RCU readers. lowpan_header_decompress() is also exported and can be reached from callers that are not necessarily covered by the net core RX critical section, for example
In the Linux kernel, the following vulnerability has been resolved: tipc: fix out-of-bounds read in broadcast Gap ACK blocks A broadcast PROTOCOL/STATE_MSG can carry a Gap ACK blocks record in its data area. tipc_get_gap_ack_blks() only verifies that the record's len field is self-consistent with its ugack_cnt/bgack_cnt counts (sz == struct_size(p, gacks, ugack_cnt + bgack_cnt)); it does not check that the record actually fits in the message data area, msg_data_sz(). The unicast caller tipc_link_proto_rcv() bounds it ("if (glen > dlen) break;"), but the broadcast caller tipc_bcast_sync_rcv() discards the returned size, so tipc_link_advance
In the Linux kernel, the following vulnerability has been resolved: staging: vme_user: bound slave read/write to the kern_buf size The SLAVE-path helpers buffer_to_user() and buffer_from_user() copy 'count' bytes into/out of the fixed-size kern_buf (size_buf == PCI_BUF_SIZE == 0x20000, 128 KiB) using *ppos as the offset, without bounding *ppos + count against size_buf. vme_user_write()/vme_user_read() only clamp count to the VME window size (image_size = vme_get_size(resource)), which VME_SET_SLAVE sets from the user-supplied slave.size -- validated against the VME address space (up to VME_A32_MAX = 4 GiB), not against PCI_BUF_SIZE. When
In the Linux kernel, the following vulnerability has been resolved: smb: client: restrict implied bcc[0] exemption to responses without data area smb2_check_message() has a long-standing quirk that accepts a response whose calculated length is one byte larger than the bytes actually received ("server can return one byte more due to implied bcc[0]"). This was introduced to accommodate servers that omit the trailing bcc[0] overlap byte when no data area is present. However, the exemption is applied unconditionally, regardless of whether the command actually carries a data area (has_smb2_data_area[]). When a response with a data area is subj
In the Linux kernel, the following vulnerability has been resolved: staging: rtl8723bs: fix heap buffer overflow in rtw_cfg80211_set_wpa_ie() supplicant_ie is a 256-byte array in struct security_priv. The WPA and WPA2 IE copy paths use: memcpy(padapter->securitypriv.supplicant_ie, &pwpa[0], wpa_ielen + 2); where wpa_ielen is the raw IE length field (u8, 0-255). When a local user supplies a connect request via nl80211 with a crafted WPA IE of length 255, wpa_ielen + 2 equals 257, overflowing the 256-byte buffer by one byte into the adjacent last_mic_err_time field. rtw_parse_wpa_ie() does not prevent this: its length consistency check
Comparez votre pile et les versions installées aux bases de vulnérabilités actuelles.