ipv6: rpl: fix hdrlen overflow in ipv6_rpl_srh_decompress()
In the Linux kernel, the following vulnerability has been resolved:
ipv6: rpl: fix hdrlen overflow in ipv6_rpl_srh_decompress()
ipv6_rpl_srh_decompress() computes:
outhdr->hdrlen = (((n + 1) * sizeof(struct in6_addr)) >> 3);
hdrlen is __u8. For n >= 127 the result exceeds 255 and silently
truncates. With n=127 (cmpri=15, cmpre=15, pad=0, hdrlen=16):
(128 * 16) >> 3 = 256, truncated to 0 as __u8
The caller in ipv6_rpl_srh_rcv() then places the compressed header
at buf + ((ohdr->hdrlen + 1) << 3). With hdrlen=0 this is buf + 8,
but the decompressed region occupies buf[0..2055] (8-byte header
plus 128 full addresses). The compresse
net/sched: fix packet loop on netem when duplicate is on
In the Linux kernel, the following vulnerability has been resolved:
net/sched: fix packet loop on netem when duplicate is on
When netem duplicates a packet it re-enqueues the copy at the root qdisc.
If another netem sits in the tree the copy can be duplicated
again, recursing until the stack or memory is exhausted.
The original duplication guard temporarily zeroed q->duplicate around
the re-enqueue, but that does not cover all cases because it is
per-qdisc state shared across all concurrent enqueue paths
and is not safe without additional locking.
Use the skb tc_depth field introduced in an earlier patch:
- increment it on the duplicate
Bluetooth: l2cap: clear chan->ident on ECRED reconfiguration success
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: l2cap: clear chan->ident on ECRED reconfiguration success
l2cap_ecred_reconf_rsp() returns early on success without clearing
chan->ident. Every other L2CAP response handler (l2cap_ecred_conn_rsp,
l2cap_le_connect_rsp, l2cap_config_rsp) clears chan->ident after a
successful transaction to prevent the channel from matching subsequent
responses with the recycled ident value.
A remote attacker that completed a reconfiguration as the peer can
replay a failure response with the stale ident, causing the kernel to
match and destroy the already-established channel via
l2
Bluetooth: L2CAP: Fix possible crash on l2cap_ecred_conn_rsp
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Fix possible crash on l2cap_ecred_conn_rsp
If dcid is received for an already-assigned destination CID the spec
requires that both channels to be discarded, but calling l2cap_chan_del
may invalidate the tmp cursor created by list_for_each_entry_safe and
in fact it is the wrong procedure as the chan->dcid may be assigned
previously it really needs to be disconnected.
Calling l2cap_chan_clone directly may still lead to l2cap_chan_del so
instead schedule l2cap_chan_timeout with delay 0 to close the channel
asynchronously.
net: mana: Add NULL guards in teardown path to prevent panic on attach failure
In the Linux kernel, the following vulnerability has been resolved:
net: mana: Add NULL guards in teardown path to prevent panic on attach failure
When queue allocation fails partway through, the error cleanup frees
and NULLs apc->tx_qp and apc->rxqs. Multiple teardown paths such as
mana_remove(), mana_change_mtu() recovery, and internal error handling
in mana_alloc_queues() can subsequently call into functions that
dereference these pointers without NULL checks:
- mana_chn_setxdp() dereferences apc->rxqs[0], causing a NULL pointer
dereference panic (CR2: 0000000000000000 at mana_chn_setxdp+0x26).
- mana_destroy_vport() iterates apc->rxq
sctp: fix race between sctp_wait_for_connect and peeloff
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix race between sctp_wait_for_connect and peeloff
sctp_wait_for_connect() drops and re-acquires the socket lock while
waiting for the association to reach ESTABLISHED state. During this
window, another thread can peeloff the association to a new socket via
getsockopt(SCTP_SOCKOPT_PEELOFF), changing asoc->base.sk. After
re-acquiring the old socket lock, sctp_wait_for_connect() returns
success without noticing the migration — the caller then accesses
the association under the wrong lock in sctp_datamsg_from_user().
Add the same sk != asoc->base.sk check that sctp_wait
iio: imu: st_lsm6dsx: fix stack leak in tagged FIFO buffer
In the Linux kernel, the following vulnerability has been resolved:
iio: imu: st_lsm6dsx: fix stack leak in tagged FIFO buffer
The tagged FIFO path declares iio_buff on the stack with __aligned(8)
but no initializer, but there is a hole in the structure, which will
then leak to userspace as ST_LSM6DSX_SAMPLE_SIZE bytes (6) will be
copied, but the space between that and the timestamp are not
initialized.
Commit c14edb4d0bdc ("iio:imu:st_lsm6dsx Fix alignment and data leak
issues") moved the untagged FIFO path to a kzalloc'd buffer in hw->scan,
but for the tagged path it only added the alignment qualifier and not
the initializer :(
Fix this
usb: typec: ucsi: ccg: reject firmware images without a ':' record header
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: ucsi: ccg: reject firmware images without a ':' record header
do_flash() locates the first .cyacd record with
p = strnchr(fw->data, fw->size, ':');
while (p < eof) {
s = strnchr(p + 1, eof - p - 1, ':');
...
}
If the firmware image contains no ':' byte, strnchr() returns NULL.
NULL compares less than the valid kernel pointer eof, so the loop body
runs and strnchr() is called with p + 1 == (void *)1 and a length of
roughly (unsigned long)eof, causing a wonderful crash.
The not_signed_fw fallthrough earlier in do_flash() and the chip-state
branches in c
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tcpm: validate VDO count in Discover Identity ACK handlers
Properly validate the count passed from a device when calling
svdm_consume_identity() or svdm_consume_identity_sop_prime() as the
device-controlled value could index off of the static arrays, which
could leak data.
usb: typec: tcpm: bound altmode_desc[] per iteration in svdm_consume_modes()
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tcpm: bound altmode_desc[] per iteration in svdm_consume_modes()
svdm_consume_modes() checks pmdata->altmodes against the array size once
before the loop over the count, but forgot to check the bound at every
point in the loop.
In the well-behaved SVDM discovery flow this is harmless because each of
at most SVID_DISCOVERY_MAX SVIDs contributes at most MODE_DISCOVERY_MAX
modes, exactly filling altmode_desc[ALTMODE_DISCOVERY_MAX]. But the
CMDT_RSP_ACK handler in tcpm_pd_svdm() does not correlate an incoming
ACK with any request the port actually sent. Once port
usb: typec: altmodes/displayport: validate count before reading Status Update VDO
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: altmodes/displayport: validate count before reading Status Update VDO
A broken/malicious device can send the incorrect count for a status
update VDO, which will cause the kernel to read uninitialized stack data
and send it off elsewhere.
Fix this up by correctly verifying the count for the update object.
usb: typec: wcove: don't write past struct pd_message in wcove_read_rx_buffer()
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: wcove: don't write past struct pd_message in wcove_read_rx_buffer()
wcove_read_rx_buffer() copies the PD RX FIFO into the caller's
struct pd_message with
for (i = 0; i < USBC_RXINFO_RXBYTES(info); i++)
regmap_read(wcove->regmap, USBC_RX_DATA + i, msg + i);
which has two problems:
USBC_RXINFO_RXBYTES() is a 5-bit field (max 31) while struct pd_message
is 30 bytes (__le16 header + __le32 payload[PD_MAX_PAYLOAD], packed).
The byte count latched in RXINFO is the number of bytes the port partner
put on the wire, so a malicious partner that transmits a 31-byte f
usb: typec: tcpm/tcpci_maxim: validate header NDO against RX_BYTE_CNT
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tcpm/tcpci_maxim: validate header NDO against RX_BYTE_CNT
A broken/malicious port can transmit a CRC-valid frame whose header
advertises up to seven data objects but whose body carries fewer than
that. Check for this, and rightfully reject the message, instead of
reading from uninitialized stack memory.
usb: typec: ucsi: validate connector number in ucsi_connector_change()
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: ucsi: validate connector number in ucsi_connector_change()
The connector number in a UCSI CCI notification is a 7-bit field
supplied by the PPM. ucsi_connector_change() uses it to index the
ucsi->connector[] array without checking it against the number of
connectors the PPM reported at init time, so a buggy or malicious PPM
(EC firmware, or an I2C-attached UCSI controller on the ccg / stm32g0 /
glink transports) can drive schedule_work() on memory past the end of
the array.
Reject connector numbers that are zero or exceed cap.num_connectors
before dereferencin
USB: serial: safe_serial: fix memory corruption with small endpoint
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: safe_serial: fix memory corruption with small endpoint
Make sure that the bulk-out buffer size is at least eight bytes to avoid
user-controlled slab corruption in "safe" mode should a malicious device
report a smaller size.
USB: serial: cypress_m8: fix memory corruption with small endpoint
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: cypress_m8: fix memory corruption with small endpoint
Make sure that the interrupt-out endpoint max packet size is at least
eight bytes to avoid user-controlled slab corruption or NULL-pointer
dereference should a malicious device report a smaller size.
In the Linux kernel, the following vulnerability has been resolved:
hpfs: fix a crash if hpfs_map_dnode_bitmap fails
If hpfs_map_dnode_bitmap fails, the code would call hpfs_brelse4 on
uninitialized quad buffer head, causing a crash.
Bluetooth: L2CAP: fix chan ref leak in l2cap_chan_timeout() on !conn
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: fix chan ref leak in l2cap_chan_timeout() on !conn
__set_chan_timer() takes a l2cap_chan reference via l2cap_chan_hold()
before scheduling the delayed work. The normal path in
l2cap_chan_timeout() drops this reference with l2cap_chan_put() at the
end, but the early return when chan->conn is NULL skips the put,
leaking the reference.
Add the missing l2cap_chan_put() before the early return.
Bluetooth: HIDP: fix missing length checks in hidp_input_report()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: fix missing length checks in hidp_input_report()
hidp_input_report() reads keyboard and mouse payload data from an skb
without first verifying that skb->len contains enough data.
hidp_recv_intr_frame() pulls the 1-byte HIDP header before dispatching
to hidp_input_report(). If a paired device sends a truncated packet,
the handler reads beyond the valid skb data, resulting in an
out-of-bounds read of skb data. The OOB bytes may be interpreted as
phantom key presses or spurious mouse movement.
Replace the open-coded length tracking and pointer arithmetic wit
parport: Fix race between port and client registration
In the Linux kernel, the following vulnerability has been resolved:
parport: Fix race between port and client registration
The parport subsystem registers port devices before they are fully
initialised, resulting in a race condition where client drivers such
as lp can attach to ports that are not completely initialised or even
being torn down.
When the port and client drivers are built as modules and loaded
around the same time during boot, this occasionally results in a
crash. I was able to make this happen reliably in a VM with a
PC-style parallel port by patching parport_pc to fail probing:
> --- a/drivers/parport/parport_pc.c
> +++ b