firmware: arm_scmi: Avoid IDR updates while cleaning channels
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Avoid IDR updates while cleaning channels
scmi_cleanup_channels() walks the TX/RX channel IDRs with
idr_for_each() to free transport resources and destroy the dedicated
transport devices before calling idr_destroy().
The destroy callback removed each entry from the same IDR being walked.
That is not needed for this cleanup path, and it is unsafe because
idr_for_each() has not advanced its radix-tree iterator while the
callback is running. Removing the current entry from the callback can
invalidate the iterator state. The callback also cannot be protecte
firmware: arm_scmi: Reject out of range DT protocol IDs
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Reject out of range DT protocol IDs
SCMI protocol IDs carried in message headers are limited by
MSG_PROTOCOL_ID_MASK. The DT parsing paths noticed protocol IDs
outside that range, but only logged an error and then kept processing
the invalid value.
That lets a malformed 32-bit DT reg value reach helpers which take a u8
protocol ID, where it can be truncated and/or treated as a different
protocol.
For channel setup, two different out-of-range values can also be used as
distinct IDR keys while aliasing the generated SCMI protocol identity.
Skip DT proto
firmware: arm_scmi: Drop handle on protocol bind failures
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Drop handle on protocol bind failures
The SCMI bus notifier acquires an SCMI handle when the driver core emits
BUS_NOTIFY_BIND_DRIVER, before invoking the protocol driver probe
callback. The protocol probe path only checks whether sdev->handle is
set.
If device_link_add() fails after the handle has been acquired, the
protocol device can still bind with a valid handle but without the
dependency link to the SCMI parent. A concurrent parent unbind can then
miss the child and tear down the SCMI instance while the child still
holds a handle into it.
If the
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Unwind TX receiver mailbox setup failure
mailbox_chan_setup() can request an additional unidirectional TX
receiver channel after successfully acquiring the primary channel. If
that second request fails, the function returns immediately and leaves
the primary channel allocated.
Unwind the primary mailbox channel before returning the error so probe
deferral or other setup failures do not leave the channel busy for later
probe attempts.
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Fix SCMI device destroy lifetimes
scmi_child_dev_find() drops the reference returned by
device_find_child() before returning the scmi_device pointer. A
concurrent unregister can then release the device while the destroy path
is still using the returned pointer.
Make the lookup helper return the device_find_child() reference and keep
it until scmi_device_destroy() has finished unregistering the child.
Also split device_unregister() in __scmi_device_destroy() so the SCMI bus
ID is not made reusable until after device_del() has removed the old
scmi_dev.N
dax: read holder_ops once in dax_holder_notify_failure()
In the Linux kernel, the following vulnerability has been resolved:
dax: read holder_ops once in dax_holder_notify_failure()
dax_holder_notify_failure() reads dax_dev->holder_ops twice without
READ_ONCE() -- once for the NULL check and once for the indirect
notify_failure() call. A concurrent fs_put_dax() can clear holder_ops
between the two reads, so the check can observe a non-NULL pointer while
the call dereferences NULL. (kill_dax() also clears holder_ops, but only
after synchronize_srcu(), so it cannot race a reader that is inside
dax_read_lock(); fs_put_dax() does no such synchronization.)
Fetch holder_ops once into a local with READ
irqchip/renesas-irqc: Fix generic interrupt chip leak on remove
In the Linux kernel, the following vulnerability has been resolved:
irqchip/renesas-irqc: Fix generic interrupt chip leak on remove
The driver allocates domain generic chips probe. However, on driver
removal, the generic chips are not automatically freed when the interrupt
domain is removed because the domain flags do not include
IRQ_DOMAIN_FLAG_DESTROY_GC.
This causes both the domain generic chips structure and the associated
generic chips to be leaked. Additionally, the generic chips remain on the
global list and may later be accessed by generic interrupt chip suspend,
resume, or shutdown callbacks after the driver has been removed,
pote
drm/bridge: tc358767: clamp the reported AUX read size to the request
In the Linux kernel, the following vulnerability has been resolved:
drm/bridge: tc358767: clamp the reported AUX read size to the request
tc_aux_transfer() clamps an AUX read to the payload limit:
size_t size = min_t(size_t, DP_AUX_MAX_PAYLOAD_BYTES - 1, msg->size);
After the transfer it replaces size with the byte count the controller
reports in AUX_BYTES:
if (size)
size = FIELD_GET(AUX_BYTES, auxstatus);
AUX_BYTES is GENMASK(15, 8), so it can be up to 255. Nothing clamps it
back to the request. tc_aux_read_data() reads that many bytes into the
16-byte auxrdata stack buffer, then copies them into the caller buffer. A
reported count
wifi: iwlwifi: fix counter type in iwl_fwrt_dump_error_logs
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: fix counter type in iwl_fwrt_dump_error_logs
The loop counter 'count' was declared as u8 while num_pc is u32.
If firmware advertises more than 255 PC entries the counter wraps
back to zero and the loop never terminates potentially causing an
infinite loop or reading past the allocated pc_data array.
Change the declaration to u32 to match num_pc.
wifi: iwlwifi: mvm: fix off-by-one in TXF key sanitiser
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: fix off-by-one in TXF key sanitiser
iwl_mvm_frob_txf_key_iter() tracks the last matched byte position
in loop variable 'i'. When a full key match is found (match ==
keylen), 'i' points at the last byte of the matched key. The
memset start offset should therefore be i + 1 - keylen, not
i - keylen; the current code zeroes one byte before the match
and leaves the final key byte un-sanitised.
wifi: iwlwifi: mei: check SAP message length before reading it
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mei: check SAP message length before reading it
Verify the SAP message size is not larger than the local buffer before
reading the message to avoid buffer overflow.
wifi: iwlwifi: guard against division by zero in iwl_dbg_tlv_alloc_fragments
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: guard against division by zero in iwl_dbg_tlv_alloc_fragments
Make sure we don't end-up with a num_frags = 0 situation.
For that, check that the required size is not 0 and put a checker on
num_frags as well.
gpu: host1x: Avoid stack over-read in debug output helpers
In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Avoid stack over-read in debug output helpers
host1x_debug_output() and host1x_debug_cont() used vsnprintf(), which
returns the length the formatted string would have reached with an
unbounded buffer. That return value was passed straight to o->fn as
the number of bytes to emit.
This could cause a read past end of the output buffer if a call to
host1x_debug_* produced a string longer than 256 bytes. This only
affected the debugfs files as the printk debug sink ignores the
number of bytes. In practice, this is very unlikely to occur.
Fix by switching to vscnpr
drm/msm: Only fini scheduler after successful init
In the Linux kernel, the following vulnerability has been resolved:
drm/msm: Only fini scheduler after successful init
msm_ringbuffer_new() destroys a partially initialized ring through
msm_ringbuffer_destroy() when an allocation or scheduler setup step
fails.
If drm_sched_init() fails before it finishes initializing the scheduler,
the failure path still calls drm_sched_fini(). That teardown path assumes
the scheduler work items, lists, and workqueue state were initialized.
Track successful scheduler initialization and call drm_sched_fini() only
after drm_sched_init() returned 0.
This issue was found by a static analysis checker and conf
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_uac1_legacy: remove broken string configfs attributes
The UAC1_STR_ATTRIBUTE macro defines configfs show/store handlers for
the fn_play, fn_cap, and fn_cntl string options. The store function
contains an inverted null check on the kstrndup() return value.
This means every write attempt returns -ENOMEM on success and
dereferences a NULL pointer on allocation failure. The attributes
have been broken and unused for many years.
Remove the UAC1_STR_ATTRIBUTE macro and the three attributes it
generated. The internal defaults (FILE_PCM_PLAYBACK, FILE_PCM_CAPTURE,
In the Linux kernel, the following vulnerability has been resolved:
UDF symlink pathComponent header OOB read
udf_symlink_filler() can enter udf_pc_to_char() with a partial pathComponent header.
Validate that enough input remains for a complete pathComponent header
before accessing it. Reject malformed symlink data that would otherwise
make udf_pc_to_char() perform an out-of-bounds read.
uio: Fix stale info pointer in failed registration path
In the Linux kernel, the following vulnerability has been resolved:
uio: Fix stale info pointer in failed registration path
After device_add(), the UIO device is visible to userspace and /dev/uioX
can be opened. If a later setup step fails, __uio_register_device()
unwinds the device but leaves idev->info pointing at the caller-owned
struct uio_info.
That is unsafe when an opener races with the failed registration path.
The open file keeps a reference to the uio_device, while the caller sees
registration failure and may free its struct uio_info. Later file
operations can then follow idev->info and dereference freed memory.
Handle post-devi
speakup: keyhelp: guard letter_offsets possible out-of-range indexing
In the Linux kernel, the following vulnerability has been resolved:
speakup: keyhelp: guard letter_offsets possible out-of-range indexing
help_init() builds letter_offsets[] by using the first byte of each
function name as an index via `(start & 31) - 1`. If function_names are
overridden from sysfs (root) with a name starting outside [a–z], the
index underflows or exceeds the array, leading to OOB write.
Function names can be overridden with the following commands as root:
modprobe speakup_soft
echo "0 _bad" > /sys/accessibility/speakup/i18n/function_names
# then press Insert+2 on /dev/tty
This fix checks the first letter in
In the Linux kernel, the following vulnerability has been resolved:
misc: bcm-vk: Use acquire/release for msgq_inited
bcm_vk_sync_msgq() fills the message queue information and then sets
msgq_inited. Readers call bcm_vk_drv_access_ok() before accessing the
message queues and their cached queue information.
atomic_set()/atomic_read() do not order those accesses. A reader can see
msgq_inited set while still seeing stale queue information. Use release
when publishing the initialized queues and acquire when checking the gate.
Keep the clear in bcm_vk_blk_drv_access() as atomic_set(). It closes the
gate and does not publish queue state to read
misc: ad525x_dpot: use driver core groups for sysfs files
In the Linux kernel, the following vulnerability has been resolved:
misc: ad525x_dpot: use driver core groups for sysfs files
ad_dpot_probe() creates per-RDAC sysfs files manually and then
optionally creates the command sysfs group. This leaves probe responsible
for rolling back partial sysfs state and makes remove responsible for
matching every file that probe created.
Move the device attributes into driver core dev_groups for the I2C and
SPI drivers and use an is_visible() callback to expose only the
attributes supported by the probed device. With this shape, the driver
core creates the sysfs files only after probe succeeds and removes t