In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: avoid force-completing uninitialized UVD rings
uvd_v7_0_sw_init() does not initialize the UVD decode ring for an
SR-IOV VF. However, amdgpu_uvd_resume() unconditionally force-completes
the decode ring when restoring its fence sequence.
Skip fence completion when the fence driver is not initialized.
drm/panel-edp: fix i2c adapter leak on probe failure
In the Linux kernel, the following vulnerability has been resolved:
drm/panel-edp: fix i2c adapter leak on probe failure
Make sure to drop the i2c adapter reference on probe failure (e.g.
probe deferral) and on driver unbind also if a devicetree redundantly
uses the 'ddc-i2c-bus' property to point to the aux ddc bus.
drm: fix race between partial drm_dev_register() failure and ioctl
In the Linux kernel, the following vulnerability has been resolved:
drm: fix race between partial drm_dev_register() failure and ioctl
If drm_dev_register() fails after registering a minor (e.g. render minor
registered, primary minor fails), userspace could have opened the first
minor and entered a drm_dev_enter() critical section. Since the
unplugged flag was never set, the ioctl proceeds while the error path
tears down device resources.
Fix this by introducing drm_dev_synchronize_unplug(), which sets the
unplugged flag and waits for the SRCU barrier, ensuring all in-flight
drm_dev_enter() critical sections complete before cleanup proceed
drm/i915: Guard against NULL driver_data in i915_pci_probe()
In the Linux kernel, the following vulnerability has been resolved:
drm/i915: Guard against NULL driver_data in i915_pci_probe()
pci_match_device() can return the dummy pci_device_id_any entry
when a device is force-bound via sysfs driver_override, in which
case ->driver_data is unset (NULL). i915_pci_probe() casts it to
struct intel_device_info * unconditionally and dereferences
intel_info->require_force_probe, causing a NULL-ptr-deref.
(cherry picked from commit 2727922084672cc274ecea726ea00363c2893731)
drm/amd/display: avoid divide-by-zero in __is_lut_linear()
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: avoid divide-by-zero in __is_lut_linear()
__is_lut_linear() computes the expected value of each entry with
expected = i * MAX_DRM_LUT_VALUE / (size - 1);
If it is ever called with a single-entry LUT, size - 1 is zero and the
kernel takes a divide error (#DE). A LUT with fewer than two entries
cannot describe a linear mapping anyway, so return false early instead
of dividing by zero.
drm/amd/display: validate plane degamma LUT size for private color prop
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: validate plane degamma LUT size for private color prop
Unlike the CRTC degamma path, which is guarded by
amdgpu_dm_verify_lut_sizes(), the per-plane degamma LUT size was never
validated before use. __set_dm_plane_degamma() passed the user-supplied
size straight into __is_lut_linear() and, for a non-linear LUT, into
__set_input_tf() -> __drm_lut_to_dc_gamma(), the latter always iterating
MAX_COLOR_LUT_ENTRIES entries regardless of the actual LUT size.
A malformed AMD_PLANE_DEGAMMA_LUT blob (e.g. a single entry) could thus
trigger a divide-by-zero in __is_lu
drm/amdgpu/vcn: fix integer overflow in dec_msg buffer count check
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vcn: fix integer overflow in dec_msg buffer count check
If the supplied msg[2] (num_buffers) is 0x3FFFFFFF, the expression
6 + num_buffers * 4 wraps to 2 and the bounds check passes, letting
the parser loop far past the end of the message BO. Triggering it
additionally requires a ~4GiB mapping so that msg[1] survives the
earlier "header does not fit in BO" check.
Rewrite the test in division form, which is overflow-free by
construction. Also update the message to reflect that msg is invalid.
drm/gud: NUL-terminate TV mode names read from the device
In the Linux kernel, the following vulnerability has been resolved:
drm/gud: NUL-terminate TV mode names read from the device
gud_connector_add_tv_mode() reads a buffer of fixed-size mode names from
the USB device and passes pointers into it to
drm_mode_create_tv_properties_legacy(), which calls strlen() on each one.
Nothing guarantees the device NUL-terminates a name, so strlen() can run
past the end of a slot and, for the last mode, past the end of the
allocation.
Terminate each name at the end of its slot before use.
drm: Fix drm_crtc_commit leak if signaled when PAGE_FLIP_EVENT is used
In the Linux kernel, the following vulnerability has been resolved:
drm: Fix drm_crtc_commit leak if signaled when PAGE_FLIP_EVENT is used
Commit 1c6ceeee6ebb ("drm/atomic: Fix memleak on ERESTARTSYS during
non-blocking commits") fixed a very similar issue when the event was
allocated by drm_atomic_helper_setup_commit() itself.
However, if the event is allocated in prepare_signaling(), it will also be
set to NULL in complete_signaling(), which prevents drm_crtc_commit from
being put in __drm_atomic_helper_crtc_destroy_state().
Dropping the reference when the event is set to NULL at
complete_signaling() fixes the leak.
The leak can be rep
drm/amdgpu: force complete the KIQ ring fences on reset
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: force complete the KIQ ring fences on reset
Like the MES scheduler ring, the KIQ ring sets no_scheduler = true and uses a
polling fence, so it is skipped by the force-completion loop in
amdgpu_device_pre_asic_reset(). Its hw fence value lives in wb (GTT) memory and
survives a MODE1 reset while fence_drv.sync_seq keeps advancing, so after a
reset the first KIQ submission can poll forever on a seq that is never written
back.
Force complete the KIQ ring fences too so their hw fence is realigned to
sync_seq.
drm/amdkfd: Add TLB flush after MES queue eviction/suspension
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Add TLB flush after MES queue eviction/suspension
MES (Micro Engine Scheduler) does not perform heavy-weight TLB
invalidation after unmapping queues, unlike HWS which does this
automatically. This causes a race condition where in-flight DMA
descriptors can access memory that has been unmapped, leading to page
faults and GPU queue hangs during SVM page migration.
The issue manifests as KFDSVMRangeTest.MultiThreadMigrationTest
failures on gfx1151 (Strix Point) with XNACK mode 1 enabled - the GPU
compute queue hangs with packets submitted but never consumed.
Add
drm/amdkfd: Fix error path at svm_migrate_copy_to_ram
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Fix error path at svm_migrate_copy_to_ram
If page migration from device to sys ram fails for some reasons driver needs
release and unlock allocated system pages. To do that driver should use page
physical address, or pfn, then get struct page*. Current driver uses dma
address(for adev) that is not correct with IOMMU enabled, or even in general.
The patch releases and unlocks allocated system pages based on where migration
failed by struct page* of sys ram pages. Also dma_unmap correspodent system
ram pages at error path.
drm/amdkfd: Fix the case that vm range is hole at svm_migrate_copy_to_vram
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Fix the case that vm range is hole at svm_migrate_copy_to_vram
When migration vm range is hole at cpu side(MIGRATE_PFN_MIGRATE set +
MIGRATE_PFN_VALID unset) driver still allocates device pages. There is no
dma map of src pages and migration. j is 0 and svm_migrate_copy_memory_gart()
will return an uninitialized r. That can trigger out_free_vram_pages to drop
all VRAM just set up.
Initialize r and only call the last svm_migrate_copy_memory_gart if j > 0.
Current code postponed the last page to the final copy. This patch flushes on
the last page when reach to t
drm/sysfb: ofdrm: Fix integer overflow in fb_size calculation
In the Linux kernel, the following vulnerability has been resolved:
drm/sysfb: ofdrm: Fix integer overflow in fb_size calculation
The framebuffer size calculation `fb_size = linebytes * height` can
overflow when both values are large (e.g., 46341 * 46341 > INT_MAX).
Since linebytes and height are both int types, the multiplication is
performed as int * int, which results in undefined behavior on overflow.
Use check_mul_overflow() to detect and prevent this overflow, consistent
with the approach used in simpledrm.c and corebootdrm.c.
drm/nouveau: unsubscribe the channel-kill event before the fence context
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau: unsubscribe the channel-kill event before the fence context
nouveau_channel_del() tears the fence context down first and only drops
the channel-kill subscription later, in the middle of the nvif object
teardown:
if (chan->fence)
nouveau_fence(chan->cli->drm)->context_del(chan);
...
nvif_object_dtor(&chan->vram);
nvif_event_dtor(&chan->kill);
The subscribed handler is nouveau_channel_killed(), which calls
nouveau_channel_kill() and from there nouveau_fence_context_kill() on
chan->fence. A kill event delivered in that window takes fctx->lock and
walks fct
drm/nouveau/uvmm: fix NULL deref unwinding an OP_MAP_SPARSE op
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/uvmm: fix NULL deref unwinding an OP_MAP_SPARSE op
Each bind_job_op is zeroed by kzalloc_obj() in bind_job_op_from_uop(),
and the OP_MAP_SPARSE case in nouveau_uvmm_bind_job_submit() only creates
a region, so op->ops stays NULL for a successfully processed sparse map.
If a later op in the same job fails, the reverse unwind loop revisits that
op and calls drm_gpuva_ops_free(&uvmm->base, op->ops) unconditionally.
drm_gpuva_ops_free() dereferences its argument right away
(list_for_each_entry_safe on &ops->list), so a NULL op->ops oopses. The
path is reachable by a
drm/nouveau/uvmm: fix premature region free on failed OP_UNMAP_SPARSE
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/uvmm: fix premature region free on failed OP_UNMAP_SPARSE
In nouveau_uvmm_bind_job_submit()'s OP_UNMAP_SPARSE arm, op->reg is set
from nouveau_uvma_region_find(), which only looks the region up and takes
no reference; a region's sole reference is its membership in
uvmm->region_mt. Two failure paths leave op->reg set: the -ENOENT check
when the region is busy, and the drm_gpuvm_sm_unmap_ops_create() failure.
The sibling nouveau_uvmm_sm_unmap_prepare() failure just below clears
op->reg; these two do not.
unwind_continue steps back one op, so the failing op is ski
drm/nouveau/uvmm: clear the dirty flag when unwinding an OP_UNMAP_SPARSE
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/uvmm: clear the dirty flag when unwinding an OP_UNMAP_SPARSE
A successful OP_UNMAP_SPARSE marks its region dirty with
nouveau_uvma_region_dirty() and defers the teardown to
nouveau_uvmm_bind_job_cleanup(); it does not remove the region from
uvmm->region_mt.
If a later op in the job fails, the unwind path never clears reg->dirty
(set in one place, cleared nowhere) and sets op->reg = NULL, so cleanup
skips the teardown. The region is left in the tree with dirty set and its
completion never signalled. Later binds over that range then fail
permanently -- -ENOENT or
In the Linux kernel, the following vulnerability has been resolved:
bpf: Disable preemption in bpf_get_stackid
The get_perf_callchain call needs disabled preemption plus we need
it disabled as long as we access its returned trace entries buffer.
Note the bpf_get_stackid_pe function is executed already with
preemption disabled.
power: supply: ab8500_fg: fix use-after-free on remove
In the Linux kernel, the following vulnerability has been resolved:
power: supply: ab8500_fg: fix use-after-free on remove
ab8500_fg_remove() destroys the driver workqueue while the threaded
interrupt handlers are still armed; they are devm-managed and freed
only after ->remove() returns, so a handler that fires in that
window queues work on the freed workqueue.
Tear the workqueue down through devm instead, registering its cleanup
after the power supply and before the interrupt requests. devm then
frees the interrupts first, so the handlers can no longer queue work,
before disabling the delayed and plain work items and destroying the
work