KVM: arm64: nv: Write ESR_EL2 for injected nested SError exceptions
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: nv: Write ESR_EL2 for injected nested SError exceptions
kvm_inject_el2_exception() writes ESR_EL2 for synchronous exceptions
but not for SError. enter_exception64() does not write ESR_ELx for any
exception type, so the constructed syndrome is dropped. A guest L2
hypervisor taking a nested SError observes stale ESR_EL2.
This affects both kvm_inject_nested_serror() and the EASE path in
kvm_inject_nested_sea().
Write ESR_EL2 for except_type_serror, matching except_type_sync.
ALSA: hda/tas2781: Cancel async firmware request at unbind
In the Linux kernel, the following vulnerability has been resolved:
ALSA: hda/tas2781: Cancel async firmware request at unbind
TAS2781 HDA I2C and SPI queue RCA firmware loading from component
bind with request_firmware_nowait(). The firmware loader keeps the
callback module pinned and holds a device reference, but the callback
still uses driver-private HDA state.
Component unbind removes controls and DSP state immediately. Later
device removal tears down the TAS2781 private data, including
codec_lock. If the async firmware callback runs after unbind has
started, it can operate on state that is being torn down.
Cancel or synchronize the a
In the Linux kernel, the following vulnerability has been resolved:
crypto: xilinx-trng - Remove crypto_rng interface
Implementing the crypto_rng interface has no purpose, as it isn't used
in practice. It's being removed from other drivers too. Just remove
it. This leaves hwrng, which is actually used.
Tagging with 'Cc stable' due to the bugs that this removes:
- xtrng_trng_generate() sometimes returned success even when it didn't
fill in all the bytes.
- It was possible for xtrng_trng_generate() and
xtrng_hwrng_trng_read() to run concurrently and interfere with each
other, as the locking code in xtrng_hwrng_trng_read(
drm/amdkfd: Validate CRIU-restored IDs before idr_alloc
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Validate CRIU-restored IDs before idr_alloc
The KFD CRIU restore flow restores previously saved object IDs from
userspace.
For event restore:
kfd_criu_restore_event()
-> create_signal_event() / create_other_event()
-> allocate_event_notification_slot()
-> idr_alloc(..., *restore_id, *restore_id + 1, ...)
For BO restore:
criu_restore_memory_of_gpu()
-> idr_alloc(..., bo_priv->idr_handle, ...)
In both cases, the restored ID comes from userspace-provided CRIU data.
idr_alloc() expects the ID range values to fit within s
ntfs3: Allocate iomap inline_data using alloc_page
In the Linux kernel, the following vulnerability has been resolved:
ntfs3: Allocate iomap inline_data using alloc_page
This fixes a BUG reported in iomap_write_end_inline:
iomap_inline_data_valid checks that the inline_data fits within
a page. If the inline_data is allocated with kmemdup there's no
guarantee that it's page-aligned, so the check sometimes fails.
Allocate it with alloc_page to ensure it's page-aligned.
alpha/PCI: Add security_locked_down() check to pci_mmap_resource()
In the Linux kernel, the following vulnerability has been resolved:
alpha/PCI: Add security_locked_down() check to pci_mmap_resource()
Currently, Alpha's pci_mmap_resource() does not check
security_locked_down(LOCKDOWN_PCI_ACCESS) before allowing userspace to mmap
PCI BARs.
The generic version has had this check since commit eb627e17727e ("PCI:
Lock down BAR access when the kernel is locked down") to prevent DMA
attacks when the kernel is locked down.
Add the same check to Alpha's pci_mmap_resource().
In the Linux kernel, the following vulnerability has been resolved:
tipc: avoid busy looping in tipc_exit_net()
Blamed commit introduced a busy-wait loop in tipc_exit_net()
to wait for pending UDP bearer cleanup works to complete:
while (atomic_read(&tn->wq_count))
cond_resched();
This loop can busy-wait for a long time if cond_resched() is a NOP. This
typically happens if the netns exit is executed by a high priority task,
or under kernels configured without preemption (CONFIG_PREEMPT_NONE). In
such cases, it wastes CPU cycles and can lead to soft lockups.
Fix this by replacing the busy loop with wait_var_event(),
In the Linux kernel, the following vulnerability has been resolved:
bpf: Add missing access_ok call to copy_user_syms
As reported by sashiko we use __get_user without prior access_ok call on the
user space pointer. Adding the missing call for the whole pointer array.
Plus removing the err check in the error path, because it's not needed and
also we can return -ENOMEM directly from the first kvmalloc_array fail path.
[1] https://lore.kernel.org/bpf/[email protected]/
RDMA/rxe: Fix responder UAF on IB_QP_MAX_DEST_RD_ATOMIC modify_qp
In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Fix responder UAF on IB_QP_MAX_DEST_RD_ATOMIC modify_qp
rxe_qp_from_attr() handles IB_QP_MAX_DEST_RD_ATOMIC outside the
IB_QP_STATE path, so it holds no state_lock and runs while the responder
task rxe_receiver() (recv_task on rxe_wq) is live. A modify_qp() setting
only that attribute calls free_rd_atomic_resources() then
alloc_rd_atomic_resources(), swapping qp->resp.resources[] while
rxe_prepare_res()/find_resource() walk it; free_rd_atomic_resources()
also leaves the cached pointer qp->resp.res dangling. A local
unprivileged user can race the free/realloc into
In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Fix OOB in free_rd_atomic_resources()
free_rd_atomic_resources() iterates using qp->attr.max_dest_rd_atomic.
Updating max_dest_rd_atomic before freeing the old array can make the
free path walk past the old allocation and trigger a slab out-of-bounds
write catched by KASAN:
==================================================================
BUG: KASAN: slab-out-of-bounds in free_rd_atomic_resource drivers/infiniband/sw/rxe/rxe_qp.c:180 [inline]
BUG: KASAN: slab-out-of-bounds in free_rd_atomic_resources drivers/infiniband/sw/rxe/rxe_qp.c:171 [inline]
BUG: KASAN: sla
In the Linux kernel, the following vulnerability has been resolved:
nvme-tcp: fix usage of page_frag_cache
nvme uses page_frag_cache to preallocate PDU for each preallocated request
of block device. Block devices are created in parallel threads,
consequently page_frag_cache is used in not thread-safe manner.
That leads to incorrect refcounting of backstore pages and premature free.
That can be catched by !sendpage_ok inside network stack:
WARNING: CPU: 7 PID: 467 at ../net/core/skbuff.c:6931 skb_splice_from_iter+0xfa/0x310.
tcp_sendmsg_locked+0x782/0xce0
tcp_sendmsg+0x27/0x40
sock_sendmsg+0x8b/0xa0
nvme_tcp_try_send_cmd_pdu+0x149/0x2a
usb: xhci: bail out of setup if the controller is inaccessible
In the Linux kernel, the following vulnerability has been resolved:
usb: xhci: bail out of setup if the controller is inaccessible
xhci_gen_setup() locates the operational registers using the capability
length read from the very first register:
xhci->op_regs = hcd->regs +
HC_LENGTH(readl(&xhci->cap_regs->hc_capbase));
If the controller is dead or has dropped off the bus, that read returns
~0, HC_LENGTH() truncates it to 0xff, and op_regs ends up 0xff bytes
past the page-aligned MMIO base, i.e. unaligned. The first access
through it, xhci_halt() -> xhci_handshake() reading op_regs->status, is
then an unaligned readl() on device memory.
In the Linux kernel, the following vulnerability has been resolved:
fuse: fix race between interrupt and resend
After commit f8fce75fedf7 ("fuse: clear intr_entry in fuse_resend and
fuse_remove_pending_req") the WARN_ON(!list_empty(&req->intr_entry)) in
fuse_request_free() still triggers due to the following race:
In request_wait_answer()
if (test_bit(FR_SENT, &req->flags)) -> returns true
In fuse_chan_resend()
clear_bit(FR_SENT, &req->flags)
In request_wait_answer()
queue_interrupt(req)
Fix by:
- move clearing FR_SENT inside fpq->lock
- move setting FR_PENDING inside fiq->lock
- recheck FR_SENT after acquiring fiq->lock in
fuse: fix missing barrier when checking io-uring readiness
In the Linux kernel, the following vulnerability has been resolved:
fuse: fix missing barrier when checking io-uring readiness
fuse_block_alloc() reads fch->initialized and then fch->io_uring.
fch->io_uring is set before fch->initialized, ordered by the smp_wmb()
in fuse_chan_set_intialized(), but fuse_block_alloc() has no matching
read barrier between the two loads.
This may lead a CPU to observe fch->initialized=1 but fch->io_uring=0,
and skip the check that blocks request allocation until the io-uring
queues are ready. This can reintroduce the lock-order inversion deadlock
that commit 3393ff964e0f prevents.
Add an smp_rmb() barrier to
fuse: publish io-uring queues with release semantics
In the Linux kernel, the following vulnerability has been resolved:
fuse: publish io-uring queues with release semantics
fuse_uring_create_queue() initializes a fuse_ring_queue and then
publishes the pointer into ring->queues[qid] with WRITE_ONCE() under the
fch->lock. There are several readers that may concurrently be fetching
that pointer locklessly and then deferencing it.
WRITE_ONCE() doesn't ensure ordering of the queue's field
initialization before the ring->queues[qid] pointer assignment. The
queue must be published with smp_store_release() so the field
initialization is guaranteed to happen before.
Readers in paths where the read
fuse: wait for FR_FINISHED on abort_on_kill to prevent use-after-free
In the Linux kernel, the following vulnerability has been resolved:
fuse: wait for FR_FINISHED on abort_on_kill to prevent use-after-free
The abort_on_kill path in request_wait_answer() calls fuse_abort_conn()
and returns without waiting for FR_FINISHED. If fuse_dev_do_write() is
concurrently processing the same request (FR_LOCKED set), the caller
frees req->args while it is still being accessed, causing a
use-after-free.
Fix this by jumping to the existing wait_event(FR_FINISHED) instead of
returning early. The wait will not hang because fuse_abort_conn()
ensures all requests are ended.
fuse: fix invalidate lock leak on setattr writeback failure
In the Linux kernel, the following vulnerability has been resolved:
fuse: fix invalidate lock leak on setattr writeback failure
fuse_do_setattr() takes filemap_invalidate_lock() for a DAX truncate
(fault_blocked = true) and releases it at the out:/error: labels. But
when a writeback flush is also needed, a write_inode_now() failure
returns directly and leaks the lock, so any later fault or truncate on
the file stalls on the stale rwsem.
For example, truncate(2) on a setuid file reaches fuse_do_setattr()
with both ATTR_SIZE and ATTR_MODE set:
truncate(2)
└─ do_truncate()
├─ dentry_needs_remove_privs() # S_ISUID
└─ no
fuse: fix invalidate lock leak on open O_TRUNC DAX failure
In the Linux kernel, the following vulnerability has been resolved:
fuse: fix invalidate lock leak on open O_TRUNC DAX failure
fuse_open() takes filemap_invalidate_lock() for a DAX truncate
(dax_truncate = true) and releases it before the out_inode_unlock
label. But when fuse_dax_break_layouts() fails, the goto
out_inode_unlock skips the unlock and leaks the rwsem, so any later
fault or truncate on the file stalls on the stale lock.
fuse_dax_break_layouts() can fail with -ERESTARTSYS when a signal
interrupts the wait for busy DAX pages to drain:
open("file", O_RDWR | O_TRUNC)
└─ fuse_open()
├─ filemap_invalidate_lock() #
usb: gadget: f_tcm: keep port count until LUN teardown completes
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_tcm: keep port count until LUN teardown completes
tcm_usbg_drop_nexus() permits session removal once tpg_port_count
reaches zero. However, usbg_port_unlink() currently decrements that
count from the fabric_pre_unlink() callback, before core_dev_del_lun()
waits for active se_lun references to drain.
If removal of the last LUN races a nexus removal, the latter can observe
a zero port count and call target_remove_session(). This frees
sess_cmd_map while an in-flight struct usbg_cmd, including its work item,
can still be accessed.
Overlapping the last-LUN unlin
tls: device: fix out-of-bounds write in tls_append_frag()
In the Linux kernel, the following vulnerability has been resolved:
tls: device: fix out-of-bounds write in tls_append_frag()
Found with syzkaller and a local syzbot instance running on top of a
netdevsim TLS offload emulation; tls_device.c is otherwise only reachable
on a machine with a NIC that implements the offload.
tls_push_data() only checks whether the open record still has room for
another frag at the bottom of its loop, and the MSG_MORE early break
skips that check. The record survives to the next syscall with the frag
count it already had, and tls_append_frag() does not check either, so
with TLS_TX_ZEROCOPY_RO every splice(SPLIC