net/packet: avoid fanout hook re-registration after unregister
In the Linux kernel, the following vulnerability has been resolved:
net/packet: avoid fanout hook re-registration after unregister
packet_set_ring() temporarily detaches a socket from packet delivery while
reconfiguring its ring. It records the previous running state, clears
po->num, unregisters the protocol hook when needed, drops po->bind_lock,
and later restores po->num and re-registers the hook from the saved
was_running value.
That unlocked window can race with NETDEV_UNREGISTER. The notifier can
observe the socket as not running, skip __unregister_prot_hook(), and
invalidate the per-socket binding by setting po->ifindex to -1 and cle
bpf: Reject redirect helpers without a bpf_net_context
In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject redirect helpers without a bpf_net_context
The bpf_redirect*() helpers and skb_do_redirect() obtain the per-task
bpf_redirect_info via bpf_net_ctx_get_ri(), which dereferences the
current->bpf_net_context unconditionally. That context is established
on the paths that run tc BPF such as sch_handle_{ingress,egress}(),
*except* for the case where {cls,act}_bpf was attached to a proper
qdisc. A program running from there reaches the NULL deref in two ways:
* It calls bpf_redirect() directly, which dereferences the context at
the top of the helper:
tc qdisc
bonding: fix devconf_all NULL dereference when IPv6 is disabled
In the Linux kernel, the following vulnerability has been resolved:
bonding: fix devconf_all NULL dereference when IPv6 is disabled
When booting with the 'ipv6.disable=1' parameter, the devconf_all is
never initialized because inet6_init() exits before addrconf_init() is
called which initializes it. bond_send_validate(), however, will still
call bond_ns_send_all() even ipv6 is indeed disabled. It will lead to
NULL derefence of net->ipv6.devconf_all in ip6_pol_route().
BUG: kernel NULL pointer dereference, address: 000000000000000c
[...]
Workqueue: bond0 bond_arp_monitor [bonding]
RIP: 0010:ip6_pol_route+0x69/0x480
[...]
Call Trace:
rds: drop incoming messages that cross network namespace boundaries
In the Linux kernel, the following vulnerability has been resolved:
rds: drop incoming messages that cross network namespace boundaries
rds_find_bound() looks up the destination socket using a global
rhashtable keyed solely on (addr, port, scope_id). Network namespaces
are not part of the key, so a sender in netns A can deliver an incoming
message (inc) to a socket that lives in a different netns B.
When this happens, inc->i_conn points to an rds_connection whose c_net
is netns A, but the receiving rs lives in netns B. Once the child
process that created netns A exits, cleanup_net() calls
rds_loop_exit_net() -> rds_loop_kill_conns() -> r
dpaa2-switch: put MAC endpoint device on disconnect
In the Linux kernel, the following vulnerability has been resolved:
dpaa2-switch: put MAC endpoint device on disconnect
fsl_mc_get_endpoint() returns the MAC endpoint device with a reference
taken through device_find_child(). The switch port connect path stores
that device in mac->mc_dev and keeps it for the lifetime of the connected
MAC object.
However, the disconnect path only closes the MAC and frees the dpaa2_mac
object. It does not drop the endpoint device reference stored in
mac->mc_dev, so every successful connect leaks that device reference when
the MAC is later disconnected.
Drop the endpoint device reference before freeing the d
In the Linux kernel, the following vulnerability has been resolved:
dpaa2-eth: put MAC endpoint device on disconnect
fsl_mc_get_endpoint() returns the MAC endpoint device with a reference
taken through device_find_child(). The Ethernet connect path stores that
device in mac->mc_dev and keeps it for the lifetime of the connected MAC
object.
However, the disconnect path only disconnects and closes the MAC before
freeing the dpaa2_mac object. It does not drop the endpoint device
reference stored in mac->mc_dev, so every successful connect leaks that
device reference when the MAC is later disconnected.
Drop the endpoint device reference after
iommu/amd: Wait for completion instead of returning early in iommu_completion_wait()
In the Linux kernel, the following vulnerability has been resolved:
iommu/amd: Wait for completion instead of returning early in iommu_completion_wait()
need_sync is a per-IOMMU flag shared by all domains and devices behind
that IOMMU. It is set whenever a command is queued with sync == true and
cleared when a completion-wait (CWAIT) command is queued. However, a
cleared need_sync only means that a covering CWAIT has been queued, not
that all previously queued commands have actually completed in hardware.
iommu_completion_wait() read need_sync locklessly and returned early
when it was false. This breaks the "block until all previously queu
In the Linux kernel, the following vulnerability has been resolved:
nfp: Check resource mutex allocation
nfp_cpp_resource_find() allocates a CPP mutex handle for the matching
resource-table entry and then reports success. nfp_resource_try_acquire()
immediately passes that handle to nfp_cpp_mutex_trylock().
However, nfp_cpp_mutex_alloc() returns NULL on failure. If that happens
for a matching table entry, the resource lookup still returns success and
the following trylock dereferences a NULL mutex pointer while opening the
resource.
nfp_resource_acquire() already treats failure to allocate the table mutex
as -ENOMEM. Do the same for the
In the Linux kernel, the following vulnerability has been resolved:
wan: wanxl: Only reset hardware after BAR mapping
wanxl_pci_init_one() stores the freshly allocated card in driver data
before the PLX BAR is mapped. Several early probe failures then unwind
through wanxl_pci_remove_one(), including failure to allocate the coherent
status area or to restore the DMA mask.
wanxl_pci_remove_one() unconditionally calls wanxl_reset(), and
wanxl_reset() dereferences card->plx. On those early failures card->plx
is still NULL, so the error path can dereference a NULL MMIO pointer.
Only issue the hardware reset once the BAR mapping exists. The
wifi: mwifiex: bound uAP association event IEs to the event buffer
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: bound uAP association event IEs to the event buffer
mwifiex_process_uap_event() handles EVENT_UAP_STA_ASSOC by exposing the
(re)association request IEs that the firmware copies into the event:
sinfo->assoc_req_ies = &event->data[len];
len = (u8 *)sinfo->assoc_req_ies - (u8 *)&event->frame_control;
sinfo->assoc_req_ies_len = le16_to_cpu(event->len) - (u16)len;
event->len is supplied by the device firmware and is never validated,
and the subtraction is unchecked. assoc_req_ies points into
adapter->event_body[MAX_EVENT_SIZE], a fixed-size array embedded in
In the Linux kernel, the following vulnerability has been resolved:
iommu/amd: Bound the early ACPI HID map
The ivrs_acpihid command-line parser appends entries to a fixed
four-element early_acpihid_map array. Unlike the sibling IOAPIC and HPET
parsers, it does not reject a fifth entry before incrementing the map size.
Check the capacity at the common found label before parsing the HID and
UID or writing the entry.
iommu/intel: Fix out-of-bounds memset in dmar_latency_disable()
In the Linux kernel, the following vulnerability has been resolved:
iommu/intel: Fix out-of-bounds memset in dmar_latency_disable()
dmar_latency_disable() intends to zero out only the single
latency_statistic entry for the given type, but the memset size was
computed as sizeof(*lstat) * DMAR_LATENCY_NUM, which clears the entire
array starting from &lstat[type].
When type > 0, this writes beyond the end of the allocated array,
corrupting adjacent memory.
Fix by using sizeof(*lstat) to clear only the target entry.
In the Linux kernel, the following vulnerability has been resolved:
tipc: serialize udp bearer replicast list updates
tipc_udp_rcast_add() and cleanup_bearer() both update ub->rcast.list with
list_add_rcu() / list_del_rcu(), but nothing serializes them. The add runs
from the encap receive softirq (via tipc_udp_rcast_disc()) without
rtnl_lock(), so it can race the cleanup delete and corrupt the list:
list_del corruption. prev->next should be ffff8880298d7ab8,
but was ffff88802449ad38. (prev=ffff888027e3ec98)
kernel BUG at lib/list_debug.c:62!
RIP: __list_del_entry_valid_or_report+0x17a/0x200
Workqueue: events cleanup_bearer
Ca
rds: Fix inet6_addr_lst NULL dereference when IPv6 is disabled
In the Linux kernel, the following vulnerability has been resolved:
rds: Fix inet6_addr_lst NULL dereference when IPv6 is disabled
When booting with the 'ipv6.disable=1' parameter, inet6_addr_lst
is never initialized because inet6_init() exits before addrconf_init()
is called to initialize it. An attempt to bind an RDS socket to
an ipv6 address results in a crash in __ipv6_chk_addr_and_flags()
KASAN: null-ptr-deref in range [0x0000000000000008-0x000000000000000f]
RIP: 0010:__ipv6_chk_addr_and_flags+0x1df/0x7e0
Call Trace:
<TASK>
ipv6_chk_addr+0x3b/0x50
rds_tcp_laddr_check+0x155/0x3b0 [rds_tcp]
rds_trans_get_preferred+0x15d/0x2d0 [rds]
sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
sctp_auth_ep_add_chunkid() uses SCTP_NUM_CHUNK_TYPES (20) as the
capacity limit for ep->auth_chunk_list, allowing it to hold up to
20 chunk entries (param_hdr.length up to 24). However, the copy
destination asoc->c.auth_chunks in struct sctp_cookie is only
SCTP_AUTH_MAX_CHUNKS (16) entries (20 bytes). When more than 16
chunks are added, sctp_association_init() memcpy overflows the
destination by up to 4 bytes.
Fix by using SCTP_AUTH_MAX_CHUNKS as the capacity limit, matching
the destination capacity.
pds_core: fix deadlock between reset thread and remove
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix deadlock between reset thread and remove
pci_reset_function() acquires device_lock before performing the reset.
pdsc_remove() is called by the PCI core with device_lock already held.
If pdsc_pci_reset_thread() is running when pdsc_remove() is called,
destroy_workqueue() will block waiting for the work to complete, while
the work is blocked waiting for device_lock - deadlock.
Use pci_try_reset_function() which uses pci_dev_trylock() internally.
This acquires both the device lock and the PCI config access lock
without blocking - if either lock is contended, it
pds_core: fix use-after-free on workqueue during remove
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix use-after-free on workqueue during remove
In pdsc_remove(), the workqueue is destroyed before pdsc_teardown()
is called. This ordering allows two paths to queue work on the
destroyed workqueue:
1. If pdsc_teardown() -> pdsc_devcmd_reset() times out, the error
path in pdsc_devcmd_locked() queues health_work.
2. A NotifyQ event can trigger the ISR and queue work before free_irq()
is called in pdsc_teardown().
Fix by moving destroy_workqueue() after pdsc_teardown() so the
workqueue outlives every queuer; destroy_workqueue() then flushes any
work still pe
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix auxiliary device add/del races
Two paths add or delete the same slot (pf->vfs[vf_id].padev): a VF's
pdsc_reset_done() and the PF's devlink enable_vnet/disable_vnet handler.
They serialize on config_lock, but neither guards the slot under it
correctly.
add() registers and stores a new auxiliary device without first checking
the slot, so a second add of an already-populated slot leaks the first
device. del() makes that check outside config_lock, so two concurrent
dels can both pass it; the first clears the slot, and the second
dereferences a NULL pointer.
Chec
sctp: validate stream count in sctp_process_strreset_inreq()
In the Linux kernel, the following vulnerability has been resolved:
sctp: validate stream count in sctp_process_strreset_inreq()
When processing a RESET_IN_REQUEST from a peer,
sctp_process_strreset_inreq() derives the stream count from the
parameter length but does not check whether the resulting
RESET_OUT_REQUEST would exceed SCTP_MAX_CHUNK_LEN.
The OUT request header (sctp_strreset_outreq, 16 bytes) is 8 bytes
larger than the IN request header (sctp_strreset_inreq, 8 bytes).
Generally, the IP payload is bounded to 65535 bytes, so the stream
list cannot be large enough to trigger the overflow. However, on
interfaces with MTU > 65535 (e.g
net: mctp i3c: clean up notifier and buses if driver register fails
In the Linux kernel, the following vulnerability has been resolved:
net: mctp i3c: clean up notifier and buses if driver register fails
mctp_i3c_mod_init() registers the I3C bus notifier and then walks the
existing buses with i3c_for_each_bus_locked(mctp_i3c_bus_add_new, NULL)
before registering the I3C device driver. If i3c_driver_register()
fails, the function returns the error directly, leaving the notifier
registered and every mctp_i3c_bus object created for the existing buses
allocated. The notifier is left pointing into the module that failed to
load and the bus list is leaked.
Mirror the module exit path on this failure: unregiste