perf: RISC-V: store available counter mask as bitmap
In the Linux kernel, the following vulnerability has been resolved:
perf: RISC-V: store available counter mask as bitmap
The available-counter mask was a single unsigned long, but iteration
uses RISCV_MAX_COUNTERS, which is 64. On RV32 that reads past the object.
Filling with an unsigned-long bit at index 32 and above is also wrong.
Use DECLARE_BITMAP and set_bit/bitmap helpers. Walk each bitmap word
into CFG_MATCH when checking events, when allocating an index, and when
stopping all counters. Set the counter base to i times BITS_PER_LONG.
Share the CFG_MATCH ecall through a small helper so the 32-bit argument
split is not duplicated. On q
afs: Fix incorrect free in candidate cleanup in afs_lookup_server()
In the Linux kernel, the following vulnerability has been resolved:
afs: Fix incorrect free in candidate cleanup in afs_lookup_server()
Fix afs_lookup_server() to not free an existing server's endpoint state
when cleaning up a candidate server. The candidate record doesn't have an
endpoint state yet at this point, so the free for that can just be removed.
afs: Clear stale peer app data after address list changes
In the Linux kernel, the following vulnerability has been resolved:
afs: Clear stale peer app data after address list changes
afs_fs_probe_fileserver() fetches the current endpoint state under
server->fs_lock, but leaves old_alist as NULL. Consequently,
afs_set_peer_appdata() treats every address list replacement as initial
setup and only binds the new peers; it never unbinds peers removed from
the old list.
An address refresh can therefore proceed as follows. CPU 0 replaces
server S's list and drops Pold without clearing Pold->app_data. The
server destroyer then clears only S's current peers and lets S reach its
RCU callback. After th
hwmon: (gpio-fan) Fix use-after-free in alarm work
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (gpio-fan) Fix use-after-free in alarm work
fan_alarm_irq_handler() queues fan_data->alarm_work, but nothing
cancels it. fan_alarm_notify() dereferences fan_data and its hwmon
device. On unbind, devres frees the interrupt, which only waits for
the handler itself, and then releases the hwmon device and fan_data,
so a pending fan_alarm_notify() can run after those frees.
Replace INIT_WORK() with devm_work_autocancel(), registered before
devm_request_irq(). The devres cleanup then frees the interrupt
first, so no new work can be queued, and cancels the work while
fa
media: verisilicon: hantro: bound G2 HEVC tile loop to the buffer capacity
In the Linux kernel, the following vulnerability has been resolved:
media: verisilicon: hantro: bound G2 HEVC tile loop to the buffer capacity
prepare_tile_info_buffer() writes one entry per tile into the tile_sizes
DMA buffer, sized for a grid equal to the PPS uAPI array capacity. Use the
bounded v4l2_hevc_pps_num_tile_columns() / v4l2_hevc_pps_num_tile_rows()
helpers so the loops stay inside the buffer.
media: mediatek: vcodec: bound AV1 tile-start copy to the array capacity
In the Linux kernel, the following vulnerability has been resolved:
media: mediatek: vcodec: bound AV1 tile-start copy to the array capacity
vdec_av1_slice_setup_tile() copies tile_cols + 1 / tile_rows + 1 entries
into mi_col_starts[] / mi_row_starts[] from the bitstream tile_info. Bound
the copy to the array capacity.
media: verisilicon: rockchip: guard VPU981 AV1 divisor and tile buffer
In the Linux kernel, the following vulnerability has been resolved:
media: verisilicon: rockchip: guard VPU981 AV1 divisor and tile buffer
rockchip_vpu981_av1_dec_set_tile_info() divides context_update_tile_id by
tile_info->tile_cols and writes one descriptor per tile into the tile_info
DMA buffer, which holds AV1_MAX_TILES entries; tile_cols and tile_rows
come from the bitstream. Guard the division against a zero tile_cols by
initialising the context-update values to zero and computing them only
when tile_cols is non-zero, and stop the descriptor writes once the
tile_info buffer is full. The tile geometry written to the hardware
registers
media: verisilicon: rockchip: reject AV1 frames exceeding the tile capacity
In the Linux kernel, the following vulnerability has been resolved:
media: verisilicon: rockchip: reject AV1 frames exceeding the tile capacity
rockchip_vpu981_av1_dec_set_tile_info() indexes the tile group entry
array by tile1 * tile_cols + tile0, reading up to tile_cols * tile_rows
entries, lays out one descriptor per tile in the AV1_MAX_TILES tile_info
buffer, and programs the real tile_cols / tile_rows into the hardware.
The tile group entry control is a dynamic array sized to the number of
entries userspace submitted, independent of tile_cols / tile_rows, so a
frame that claims more tiles than entries reads past the array. A frame
tha
In the Linux kernel, the following vulnerability has been resolved:
media: v4l2-ctrls: validate HEVC tile counts
The stateless HEVC decoders read num_tile_columns_minus1 + 1 entries from
column_width_minus1[] and num_tile_rows_minus1 + 1 from row_height_minus1[]
and use them as tile-loop bounds, but std_validate_compound() does not
bound these u8 counts. Reject a V4L2_CTRL_TYPE_HEVC_PPS with tiling
enabled whose tile counts exceed the uAPI array capacity, mirroring the
existing compound-control range checks.
In the Linux kernel, the following vulnerability has been resolved:
media: v4l2-ctrls: validate AV1 tile counts
The stateless AV1 decoders use tile_info.tile_cols and tile_rows as loop
bounds and as indices into the mi_*_starts[] and *_in_sbs_minus_1[]
arrays, as the divisor for context_update_tile_id, and their product
bounds the per-tile descriptor buffers, but std_validate_compound() does
not bound these u8 fields. Reject a V4L2_CTRL_TYPE_AV1_FRAME whose
tile_cols or tile_rows exceeds V4L2_AV1_MAX_TILE_COLS / _ROWS, or whose
product exceeds V4L2_AV1_MAX_TILE_COUNT. A zero tile count is left to the
consuming driver so the zero-initialised
bnxt_en: Handle buffer allocation failure in bnxt_rx_ring_reset()
In the Linux kernel, the following vulnerability has been resolved:
bnxt_en: Handle buffer allocation failure in bnxt_rx_ring_reset()
bnxt_rx_ring_reset() frees the ring buffers and then reallocates them,
ignoring the result.
bnxt_alloc_one_rx_ring() can fail in bnxt_alloc_one_tpa_info_data(), which
returns -ENOMEM on the first failed allocation and leaves the remaining
rxr->rx_tpa[] entries zeroed.
The error isn't propagated up, so the loop in bnxt_rx_ring_reset
continues and at the end the code re-enables TPA with partially
unallocated rx_tpa array.
This means that when the agg_id from hardware is mapped to a SW index in
rxr->rx_tpa[],
bnxt_en: Propagate RX ring init failures in bnxt_init_nic()
In the Linux kernel, the following vulnerability has been resolved:
bnxt_en: Propagate RX ring init failures in bnxt_init_nic()
bnxt_init_rx_rings() returns an error when bnxt_alloc_one_rx_ring()
fails, but bnxt_init_nic() discards that return value and calls
bnxt_init_chip(), which enables TPA.
If an allocation fails, this could leave rxr->rx_tpa[] partially zeroed
and TPA would be enabled over an array with zeroed entries. This would
lead to a zeroed DMA address being handed out if the agg_idx is
translated to a SW index at a zeroed entry.
Fix this by propagating the error out of bnxt_init_nic(). Both callers
already check its return va
mptcp: syncookies: remember the request backup flag
In the Linux kernel, the following vulnerability has been resolved:
mptcp: syncookies: remember the request backup flag
Instead of using an uninitialised bit when copying the info in
subflow_ulp_clone().
To fix this, no need to extend the join_entry structure: backup is
coming from struct mptcp_subflow_request_sock, only one bit. Do the same
here by using one bit for both.
In the Linux kernel, the following vulnerability has been resolved:
mptcp: prevent race between disconnect() and rtx
Sashiko noted that the two event can race, leading to inconsistent
status. Prevent the race using the synchronous timer stop operation.
mptcp: pm: kernel: drop pending ADD_ADDR when removing ID0
In the Linux kernel, the following vulnerability has been resolved:
mptcp: pm: kernel: drop pending ADD_ADDR when removing ID0
The in-kernel MPTCP path manager can leave a stale ADD_ADDR announcement
entry alive when removing the id 0 endpoint. This happens because the id 0
removal path does not tear down pending announcements, unlike the non-zero
id path.
When the PM later reselects id 0 after adding another signal endpoint, it
finds the stale anno_list entry and hits WARN_ON_ONCE(mptcp_pm_is_kernel())
in mptcp_pm_announced_alloc().
Root cause: asymmetry between removal paths.
- Non-zero id path: mptcp_nl_remove_subflow_and_signal_addr()
smb: client: reject short READ responses in CIFSSMBRead()
In the Linux kernel, the following vulnerability has been resolved:
smb: client: reject short READ responses in CIFSSMBRead()
CIFSSMBRead() reads DataLengthHigh, DataLength and DataOffset out of
the READ_RSP returned by the server without first checking that a
whole READ_RSP was actually received. The length of the response is
recorded in rsp_iov.iov_len, but nothing constrains it to be at least
read_rsp_size before those fields are dereferenced.
A malicious or compromised SMB1 server can return a response shorter
than the READ_RSP header, so that parsing the header itself reads past
the end of the receive buffer. SMB1 is not negotiated by
In the Linux kernel, the following vulnerability has been resolved:
smb: client: reject userspace cifs.idmap descriptions
cifs.idmap key descriptions carry authority-bearing fields (owner and
group SIDs and uid/gid values in "os:"/"gs:"/"oi:"/"gi:" form) that the
cifs.idmap upcall helper treats as kernel-originating inputs. Unlike
its sibling cifs.spnego, the cifs.idmap key type has no vet_description
hook, so userspace can create keys of this type through
request_key(2)/add_key(2) and supply those fields without CIFS origin.
A request_key(2) call with a non-NULL callout then drives a root
usermodehelper upcall (/sbin/request-key -> cifs.i
smb: client: reject out-of-bounds DataOffset in CIFSSMBRead()
In the Linux kernel, the following vulnerability has been resolved:
smb: client: reject out-of-bounds DataOffset in CIFSSMBRead()
The SMB1 synchronous read helper CIFSSMBRead() validates the server's
DataLength against CIFSMaxBufSize and the caller's count, but never
validates DataOffset. The copy source is formed as
&pSMBr->hdr.Protocol + le16_to_cpu(pSMBr->DataOffset)
and memcpy()'d for DataLength bytes with no check that the
[DataOffset, DataOffset + DataLength) range lies within the response
actually received from the server.
A malicious or compromised SMB1 server can return a response carrying
an in-range DataLength and a large Dat
smb: client: pin DFS superblock in iterator callback
In the Linux kernel, the following vulnerability has been resolved:
smb: client: pin DFS superblock in iterator callback
tcon_super_cb() stores a raw superblock pointer, but __cifs_get_super()
takes its active reference only after iterate_supers_type() has dropped
s_umount and its passive reference. Concurrent DFS automount expiry can
therefore free the superblock before cifs_sb_active() uses it.
A deterministic KASAN test reproduces the race as:
BUG: KASAN: slab-use-after-free in cifs_sb_active+0x77/0x80
The same test passes with this change applied.
Take the active reference in the callback while iterate_supers_type()
still holds s_
smb: client: honor forceuid/forcegid when mapping SIDs to uid/gid
In the Linux kernel, the following vulnerability has been resolved:
smb: client: honor forceuid/forcegid when mapping SIDs to uid/gid
When the administrator mounts with forceuid or forcegid (uid=/gid=
mount options), they expect all files to appear owned by the specified
user/group. However, several code paths unconditionally called
sid_to_id() to overwrite cf_uid/cf_gid with server-provided values,
ignoring the administrator's explicit override:
- smb311_posix_info_to_fattr() (stat via POSIX extensions)
- cifs_posix_to_fattr() (readdir via POSIX extensions)
- parse_sec_desc() (CIFS ACL ownership mapping)
This allowed an untrusted