KVM: SVM: Use the active VMCB's MSR bitmap when checking if MSR is intercepted
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Use the active VMCB's MSR bitmap when checking if MSR is intercepted
Use the MSR permission bitmap of the active VMCB instead of assuming that
KVM is always using vmcb02's bitmap when L2 is active, as KVM uses msrpm02
if and only if L1 wants to intercept MSR accesses, i.e. if and only if KVM
needs to merge msprm01 with msrpm12.
Don't bother tracking the virtual address of the bitmap that's being used,
as __va() is cheap on x86, and caching the virtual address would introduce
yet another source of potentially stale information.
KVM: SVM: Preserve TLB control (i.e. pending TLB flush) on failed VMRUN
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Preserve TLB control (i.e. pending TLB flush) on failed VMRUN
Don't reset the VMCB's TLB control back to "do nothing" on a failed VMRUN,
as empirical testing shows that the CPU performs the requested TLB flush if
and only if VMRUN is successful, i.e. clearing TLB control on a failed
VMRUN effectively drops a TLB flush.
Explicitly track the need to flush all ASIDs on a per-CPU basis, as the
ASID reuse condition is tied to the pCPU, not to the vCPU. As a bonus,
this also obviates the need to avoid clobbering FLUSH_ALL_ASID with
TLB_CONTROL_FLUSH_ASID, e.g. in svm_
KVM: SVM: Update control fields on #VMEXIT if and only if VMRUN succeeded
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Update control fields on #VMEXIT if and only if VMRUN succeeded
Leave control.erap_ctl and control.clean as-is in the VMCS if VMRUN fails,
because as per AMD:
there's no explicit architectural guarantee about the behavior in the
presence of VMRUN failures. So the best thing to do would be to assume
that if VMRUN fails, the actions requested in the control fields may not
have been performed.
wifi: cw1200: fix TX padding OOB read leaking heap data to device
In the Linux kernel, the following vulnerability has been resolved:
wifi: cw1200: fix TX padding OOB read leaking heap data to device
The TX path rounds the transfer size up to the bus alignment
(align_size(), up to 511 bytes for SDIO, 1 byte for SPI) but sends
the padded length straight from the frame buffer, which has no room
reserved for the padding. cw1200_data_write() therefore reads past
the end of the frame and the bus transfer carries those bytes to the
device. A bogus device can collect up to 511 bytes of kernel heap
data per TX frame.
The RX path does not have this problem: it allocates the skb with
the aligned length (alloc_le
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlegacy: 3945: free EEPROM data on remove
il3945_pci_probe() calls il_eeprom_init(), which allocates memory for
the EEPROM data. The probe failure paths release this allocation with
il_eeprom_free(), but the remove path does not free it after a
successful probe.
As a result, the EEPROM data is leaked when the PCI device is removed.
Free the EEPROM data in il3945_pci_remove() before releasing the
mac80211 hardware structure.
This issue was found by manual code inspection.
wifi: mac80211: count only matching reservations in reserved switch
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: count only matching reservations in reserved switch
ieee80211_vif_use_reserved_switch() validates a replacement by counting
assigned links on ctx->replace_ctx and treating reservations too
broadly. A link can still be assigned to the old channel context while
holding a reservation that belongs to a different replacement
operation.
That can make the current replacement appear complete too early. If
another link finalizes first, the function can free the
WILL_BE_REPLACED chanctx while the unmatched link and driver still use
it, leading to a use-after-free in
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: keep paired old chanctx alive
An in-place replacement keeps reciprocal replace_ctx pointers between
the old WILL_BE_REPLACED chanctx and the new REPLACES_OTHER chanctx.
However, the early free paths only consider assigned and reserved link
users when deciding whether to free the old chanctx.
That lets the old chanctx be freed too early while the replacement
partner still points back to it, either when the last assigned link is
released or when that link successfully reassigns to another existing
context. Later unreserve and switch-finalization paths can the
wifi: mac80211: shut down RX BA session timer on teardown
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: shut down RX BA session timer on teardown
Tearing down an RX BA session can leave the session timer queued on a
freed tid_rx. Later timer-wheel processing and the timer callback itself
then run against freed memory.
An RX BAR handler can dereference tid_rx under RCU before teardown
unpublishes it and stay in its read-side critical section while teardown
deletes the session timer. The stale handler can then rearm the timer
after timer_delete_sync() returns and before the RCU callback frees
tid_rx.
Use timer_shutdown_sync() so rearm attempts become ineffecti
wifi: mac80211: drain PS delivery work during station teardown
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: drain PS delivery work during station teardown
Removing an AP or mesh station can notify the driver and wake TXQs after
the station has already been removed from the driver, and can update
num_sta_ps and the power-save queues after station cleanup has purged
them.
sta_deliver_ps_frames() tests sta->dead only before it starts delivery. A
worker that passes that test can be delayed while teardown sets sta->dead
and removes the station from the driver; when it resumes it still runs the
full delivery.
The existing cancel_work_sync() sits near the end of
__clea
wifi: mac80211: account proxy paths against the mesh path limit
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: account proxy paths against the mesh path limit
Proxy-path churn can drive the interface path counter negative and let
later mesh path additions exceed MESH_MAX_MPATHS.
mesh_path_free_rcu() decrements the interface mpaths counter for entries
from both the mesh and proxy path tables, but mpp_path_add() never
reserves a slot in that counter. Removing or expiring a proxy path
therefore returns a slot that was never charged.
mesh_path_add() uses the same counter to enforce MESH_MAX_MPATHS, so once
it falls below the number of installed paths the limit no longe
wifi: mac80211: minstrel_ht: validate fixed rate index
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: minstrel_ht: validate fixed rate index
The fixed_rate_idx debugfs file is a plain u32 attribute, so any value
can be written to it. minstrel_ht_update_stats() then copies the value
into mi->max_tp_rate[] and mi->max_prob_rate, and
minstrel_ht_set_rate() uses MI_RATE_GROUP()/MI_RATE_IDX() to index
minstrel_mcs_groups[] (42 entries) and mi->groups[].rates[] (10 entries)
with it.
Writing e.g. 65535 selects group 4095 and rate index 15, far outside
both arrays. The out-of-bounds entries are dereferenced and updated as
struct minstrel_rate_stats (retry counts,
wifi: mac80211: release mesh path quota on failed additions
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: release mesh path quota on failed additions
Repeated failed or duplicate mesh path additions can exhaust
MESH_MAX_MPATHS while the path table holds fewer paths, which stops new
paths to reachable destinations from being created.
mesh_path_add() reserves a slot before allocating and inserting a path.
If allocation fails, the function returns without releasing the slot. If
the rhashtable insertion reports an error or an existing destination, the
function discards its candidate but retains the reservation. No new path
is installed in any of these cases.
Relea
USB: serial: fix dynamic id driver deregistration race
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix dynamic id driver deregistration race
Only free the dynamic ids after having deregistered the driver and
removed the "new_id" attribute to avoid leaking any id added by a racing
write to the attribute.
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix driver deregistration order
USB serial driver modules register one driver for the USB bus and one or
more drivers for the ports on the USB serial bus.
When unloading a driver module, the USB driver must be deregistered
before the USB serial bus drivers so that I/O is stopped before
unbinding the ports to avoid use-after-free in completion handlers
accessing port data.
Note that the "new_id" attributes must first be removed to prevent new
ids from being added and triggering a probe of the USB driver after it
has been deregistered.
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix ioctl hangup race
The tty ioctls can race with hangup and end up calling into a tty driver
for a device that is already gone or powered down.
Serialise the callbacks using the tty port mutex and add the missing
checks to make sure the port has not been hung up before accessing port
driver data or hardware.
This specifically avoids dereferencing a NULL-pointer if a device is
disconnected during lengthy break signalling.
Note that TIOCGICOUNT and TIOCMIWAIT do not access port driver data or
hardware and are therefore not affected by the race.
smb: client: split cifsFileInfo bitfields to avoid shared-byte RMW races
In the Linux kernel, the following vulnerability has been resolved:
smb: client: split cifsFileInfo bitfields to avoid shared-byte RMW races
The invalidHandle, swapfile, oplock_break_cancelled, offload,
and status_file_deleted fields are stored in the same bitfield byte
in struct cifsFileInfo, but are updated in different code paths that
may run simultaneously, and are protected by different locks. Since
bitfield assignments generate byte-level read-modify-write operations,
a modification to one flag can overwrite a concurrent modification to
another flag.
To avoid these races, convert these flags from a bitfield to
separate bool fields.
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: kxcjk-1013: reject duplicate event disable
The IIO core does not filter duplicate writes to the event enable
attribute. kxcjk1013_write_event_config() already ignores repeated
enable requests, but a repeated disable request still calls
kxcjk1013_set_power_state(data, false), dropping a runtime PM reference
that was not acquired for this request. This can underflow the runtime
PM usage count and trigger a "Runtime PM usage count underflow" warning.
Return early when the requested state already matches ev_enable_state.
iio: light: gp2ap020a00f: drain irq_work after free_irq
In the Linux kernel, the following vulnerability has been resolved:
iio: light: gp2ap020a00f: drain irq_work after free_irq
The threaded IRQ handler queues data->work through irq_work_queue() so
the trigger is polled from a per-CPU context. free_irq() does not flush
an irq_work the handler already queued, so after gp2ap020a00f_remove()
returns that work may still run and call iio_trigger_poll() on data->trig,
which the devm cleanup has already freed, causing a use-after-free.
Add irq_work_sync(&data->work) after free_irq() in remove() and in the
probe error path, mirroring commit 78601726d4a5 ("iio: trigger: sysfs:
fix use-after-free on r
KVM: s390: Add missing srcu in kvm_s390_set_irq_state()
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Add missing srcu in kvm_s390_set_irq_state()
Like kvm_s390_inject_vcpu(), kvm_s390_set_irq_state() also needs the
kvm->srcu or the slots lock when performing the Store status operation.
Fix by taking kvm->srcu in kvm_s390_set_irq_state().
squashfs: Add dictionary size range check to prevent shift-out-of-bounds
In the Linux kernel, the following vulnerability has been resolved:
squashfs: Add dictionary size range check to prevent shift-out-of-bounds
When an abnormal SquashFS image (COMP_OPTS flag is 1 but dictionary size
is 0) is mounted, and performs shift operations using dictionarysize, the
shift exponent is -1, causing a shift-out-of-bounds.
Detail as below:
squashfs_comp_opts(msblk, buffer, length)
squashfs_xz_comp_opts()
if (comp_opts)
n = ffs(opts->dict_size) - 1;<----opts->dict_size=0, n=-1
if (opts->dict_size != (1 << n) && opts->dict_size !=
(1 << n) + (1 << (n + 1))) <----shift-out-of-bounds
Fix it by adding a di