net: ethernet: mtk_eth_soc: unregister net_devices in case of probe failure
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_eth_soc: unregister net_devices in case of probe failure
If register_netdev() fails for one of the MTK_MAX_DEVS devices in
mtk_probe(), the error path jumps to err_deinit_ppe, skipping
mtk_unreg_dev(). The previously registered net_devices are then freed by
mtk_free_dev() while still in NETREG_REGISTERED state, hitting the
BUG_ON(dev->reg_state != NETREG_UNREGISTERED).
Route the register_netdev() failure to err_unreg_netdev so the net_devices
registered so far are properly unregistered before being freed.
sctp: avoid livelock while updating retransmit path
In the Linux kernel, the following vulnerability has been resolved:
sctp: avoid livelock while updating retransmit path
sctp_assoc_update_retran_path() can loop forever when every remaining
transport, including retran_path, is SCTP_UNCONFIRMED: the state check
runs before the wraparound test, so the loop cannot observe that it has
completed a full pass.
Fix this by considering a transport only when it is not UNCONFIRMED,
then checking whether the walk has returned to retran_path. This makes
the full-pass termination independent of the transport state while
preserving the existing fallback selection semantics.
Also restore the NULL guard a
net: usb: catc: bound the RX packet length in catc_rx_done()
In the Linux kernel, the following vulnerability has been resolved:
net: usb: catc: bound the RX packet length in catc_rx_done()
catc_rx_done() walks a multi-packet URB, reading a two-byte length from
each packet header. Its bound, pkt_len > urb->actual_length, ignores the
header offset and compares against the whole transfer rather than the
bytes left from pkt_start, so a crafted packet header makes
skb_copy_to_linear_data() read past the buffer.
A length below ETH_HLEN is also accepted, including zero, and
eth_type_trans() then reads a MAC header from the uninitialised tailroom
of a shorter skb. The is_f5u011 branch takes its length stra
net/sched: sch_hfsc: bound the classify inner-filter walk with a drift budget
In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_hfsc: bound the classify inner-filter walk with a drift budget
hfsc_classify() applies the "filter may only point downwards" level check
only when the filter result carries no bound class. A filter created with
a flowid gets res.class set once at bind time, so the check never runs for
it during classification. hfsc_adjust_levels() can later raise a class's
level without revalidating existing bindings, leaving two binds that were
each legal at bind time pointing at each other; the classify walk then
bounces between two interior classes forever with the qdisc l
drm/virtio: fix object leak when drm_gem_handle_create() fails
In the Linux kernel, the following vulnerability has been resolved:
drm/virtio: fix object leak when drm_gem_handle_create() fails
virtio_gpu_gem_create() owns the reference taken by
virtio_gpu_object_create(). On the drm_gem_handle_create() error path it
calls drm_gem_object_release() instead of dropping that reference.
drm_gem_object_release() is the inverse of drm_gem_object_init() and does
not touch the reference count or call obj->funcs->free(), so it is only
correct as the last step of a destructor, as in
virtio_gpu_cleanup_object(). Using it here leaves the bo at refcount 1
with no remaining reference, so virtio_gpu_free_object() ne
drm/virtio: fix object leak in virtio_gpu_resource_create_ioctl()
In the Linux kernel, the following vulnerability has been resolved:
drm/virtio: fix object leak in virtio_gpu_resource_create_ioctl()
virtio_gpu_resource_create_ioctl() calls drm_gem_object_release() on the
drm_gem_handle_create() error path instead of dropping the reference it
owns, so obj->funcs->free() never runs and the virtio_gpu_object, its
pages and sg table, the resource id and the host-side resource are
leaked.
Use drm_gem_object_put() instead.
Bluetooth: bnep: fix out-of-bounds reads on short RX/TX frames and control fallthrough
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: bnep: fix out-of-bounds reads on short RX/TX frames and control fallthrough
Fix multiple out-of-bounds reads in Bluetooth BNEP frame processing:
1. In bnep_rx_frame() and bnep_ctrl_frame() (net/bluetooth/bnep/core.c),
use pskb_may_pull() to verify the BNEP header, control type byte,
filter count, and extension headers exist before reading them, and
return 0 after handling BNEP_CONTROL instead of falling through to
Ethernet frame submission when no extension headers follow.
2. In bnep_net_xmit() (net/bluetooth/bnep/netdev.c), verify skb->len >=
ETH
net: usb: sr9700: include receive overhead in the length check
In the Linux kernel, the following vulnerability has been resolved:
net: usb: sr9700: include receive overhead in the length check
The receive fixup subtracts the Ethernet CRC from the reported packet
length, but compares that payload length against the whole remaining
receive buffer. The following copy starts after the three-byte header,
and the cursor advance consumes both that header and the four-byte CRC.
Require the payload to fit after SR_RX_OVERHEAD before copying it or
advancing to the next packet. The loop already ensures that the
remaining buffer is larger than the overhead, so the subtraction is
safe.
The issue was found by our
In the Linux kernel, the following vulnerability has been resolved:
tg3: clean up PHYLIB resources on probe failure
tg3_get_invariants() can register an MDIO bus and connect a PHY for
USE_PHYLIB devices. If tg3_init_one() later fails, its common error path
releases the mappings and netdev without undoing those PHYLIB resources.
Disconnect the PHY and unregister the MDIO bus before the remaining
teardown. Guard PHY cleanup with USE_PHYLIB to match tg3_phy_init(), and
call tg3_mdio_fini() unconditionally to match tg3_mdio_init(). The existing
IS_CONNECTED and MDIOBUS_INITED flags make both helpers safe when
initialization only completed part
In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject pkt arguments in mutating subprogs
The verifier tracks changes in how PTR_TO_PACKET registers'
bounds are modified across subprog boundaries. PTR_TO_PACKET
registers are actually passed as PTR_TO_MEM, which is assumed
valid for the entire call. This is not the case with packet memory,
where a pskb_* call may invalidate its memory region.
Reject BPF code that passes PTR_TO_PACKET pointers to subprogs that
may mutate a packet. We cannot pass the pointer as a true PTR_TO_PACKET
because we would also need to somehow pass the PTR_TO_PACKET_META
or PTR_TO_PACKET_END
sctp: hold asoc or transport before mod_timer() in timer handlers
In the Linux kernel, the following vulnerability has been resolved:
sctp: hold asoc or transport before mod_timer() in timer handlers
Take the association or transport reference before rearming a timer in the
timer handlers.
The existing code calls mod_timer() before taking the reference needed by
the rearmed timer without holding the sock lock. This creates a race with
timer cleanup: if the timer is deleted after mod_timer() returns but before
the reference is taken, the cleanup path can drop the timer's reference and
destroy the transport or association. The timer handler then takes a
reference on the already freed object and eventually
nfc: nfcmrvl: validate helper command length before pull
In the Linux kernel, the following vulnerability has been resolved:
nfc: nfcmrvl: validate helper command length before pull
The firmware download receive path removes the NCI data header and
reads the helper command before validating the remaining packet length.
A short frame can therefore reach the data access before the malformed
packet is rejected.
Validate the complete helper command length before stripping the NCI
data header.
In the Linux kernel, the following vulnerability has been resolved:
nfc: st21nfca: validate received frame size
st21nfca_hci_i2c_repack() trims a received frame at its EOF marker
before removing byte stuffing. It then assumes the truncated frame
contains the LLC header and two CRC bytes, and it unconditionally reads
the byte after an escape marker.
A malformed frame can place EOF immediately after the start marker or can
end its data portion with an escape marker. The former leaves too few
bytes for check_crc(), while the latter makes the unstuffing loop read past
the current skb length.
Require the minimum framing bytes both before and
nfc: llcp: Fix list corruption / refcount desync in nfc_llcp_recv_dm()
In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: Fix list corruption / refcount desync in nfc_llcp_recv_dm()
nfc_llcp_recv_dm() handles DM(NOBOUND)/DM(REJ) for a socket that is still
linked on local->connecting_sockets: it looks the socket up with
nfc_llcp_connecting_sock_get(), sets sk->sk_state = LLCP_CLOSED and
returns, without taking the socket lock and without unlinking the socket
from the connecting_sockets list.
llcp_sock_release() selects the list to unlink from by sk_state: a socket
in LLCP_CONNECTING is unlinked from connecting_sockets, otherwise from the
sockets list. Because recv_dm left the socke
nfc: llcp: Fix race condition in accept_queue lifecycle
In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: Fix race condition in accept_queue lifecycle
In nfc_llcp_socket_release(), sockets and listener accept queues are
walked under the local sockets rwlock and bh_lock_sock(). However,
bh_lock_sock() does not synchronise against process-context lock_sock()
held by nfc_llcp_accept_dequeue() during accept(). Because
socket_release() does not check sock_owned_by_user(), both paths can
concurrently unlink and release the same child socket, resulting in
use-after-free or a NULL pointer dereference of child->parent in
nfc_llcp_accept_unlink().
Fix this synchronisation r
nfc: llcp: fix sdreq TLV list leak on parse/alloc/send failure
In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: fix sdreq TLV list leak on parse/alloc/send failure
nfc_genl_llc_sdreq() builds a list of TLV nodes while walking nested
netlink attrs, but 3 error paths (nested-attr parse failure, TLV alloc
ENOMEM, nfc_llcp_send_snl_sdreq() failure) all skip freeing what was
already queued.
Route them through a new free_list label, mirroring the SDRES path in
the same file which already does this. Harmless on the success path
too -- send_snl_sdreq() drains the list as it moves nodes, so it's
already empty by the time free_list runs.
In the Linux kernel, the following vulnerability has been resolved:
nfc: st21nfca: validate ISO15693 inventory length
The ISO15693 inventory helper removes a two-byte prefix without checking
that it exists, then accepts a one-byte remainder before reading data[1] as
the DSFID.
Require the prefix and at least two remaining bytes before copying the UID
data and reading the DSFID.
nfc: llcp: fix WKS SAP hijacking via prefix match in nfc_llcp_wks_sap()
In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: fix WKS SAP hijacking via prefix match in nfc_llcp_wks_sap()
nfc_llcp_wks_sap() compares only service_name_len bytes, so a short
service_name like "u" matches longer WKS strings like "urn:nfc:sn:snep".
Fix by requiring exact length match before strncmp().
nfc: llcp: fix slab-out-of-bounds reads when logging service names
In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: fix slab-out-of-bounds reads when logging service names
nfc_llcp_wks_sap() and nfc_llcp_build_sdreq_tlv() pass non-null-
terminated strings to pr_debug() using the %s format specifier.
The buffers are allocated via kmemdup() or come from netlink
attributes and are not guaranteed to be null-terminated, causing
__dynamic_pr_debug() to read beyond the allocated region:
KASAN: slab-out-of-bounds Read in __dynamic_pr_debug
Fix both call sites by using %.*s with the explicit length to limit
the output to the actual length of the string.
nfc: pn533: fix OOB read in pn533_acr122_is_rx_frame_valid()
In the Linux kernel, the following vulnerability has been resolved:
nfc: pn533: fix OOB read in pn533_acr122_is_rx_frame_valid()
frame->ccid.datalen is read directly from the USB response frame
and used, unchecked, as an index into frame->data[]. A malicious or
malfunctioning device can set this field to an arbitrary value,
causing the driver to read far outside the received buffer.
Bound ccid.datalen against the maximum possible ACR122 frame size
before using it. This replaces the existing datalen == 0 check,
since datalen < 2 already covers that case and additionally
rejects datalen == 1, which would still underflow the
"datalen - 2" off