team: Move team device type change at the end of team_port_add
In the Linux kernel, the following vulnerability has been resolved:
team: Move team device type change at the end of team_port_add
Attempting to add a port device that is already up will expectedly fail,
but not before modifying the team device header_ops.
In the case of the syzbot reproducer the gre0 device is
already in state UP when it attempts to add it as a
port device of team0, this fails but before that
header_ops->create of team0 is changed from eth_header to ipgre_header
in the call to team_dev_type_check_change.
Later when we end up in ipgre_header() struct ip_tunnel* points to nonsense
as the private data of the device still ho
atm/fore200e: Fix possible data race in fore200e_open()
In the Linux kernel, the following vulnerability has been resolved:
atm/fore200e: Fix possible data race in fore200e_open()
Protect access to fore200e->available_cell_rate with rate_mtx lock in the
error handling path of fore200e_open() to prevent a data race.
The field fore200e->available_cell_rate is a shared resource used to track
available bandwidth. It is concurrently accessed by fore200e_open(),
fore200e_close(), and fore200e_change_qos().
In fore200e_open(), the lock rate_mtx is correctly held when subtracting
vcc->qos.txtp.max_pcr from available_cell_rate to reserve bandwidth.
However, if the subsequent call to fore200e_activate_v
jbd2: avoid bug_on in jbd2_journal_get_create_access() when file system corrupted
In the Linux kernel, the following vulnerability has been resolved:
jbd2: avoid bug_on in jbd2_journal_get_create_access() when file system corrupted
There's issue when file system corrupted:
------------[ cut here ]------------
kernel BUG at fs/jbd2/transaction.c:1289!
Oops: invalid opcode: 0000 [#1] SMP KASAN PTI
CPU: 5 UID: 0 PID: 2031 Comm: mkdir Not tainted 6.18.0-rc1-next
RIP: 0010:jbd2_journal_get_create_access+0x3b6/0x4d0
RSP: 0018:ffff888117aafa30 EFLAGS: 00010202
RAX: 0000000000000000 RBX: ffff88811a86b000 RCX: ffffffff89a63534
RDX: 1ffff110200ec602 RSI: 0000000000000004 RDI: ffff888100763010
RBP: ffff888100763000 R08: 00000000000
locking/spinlock/debug: Fix data-race in do_raw_write_lock
In the Linux kernel, the following vulnerability has been resolved:
locking/spinlock/debug: Fix data-race in do_raw_write_lock
KCSAN reports:
BUG: KCSAN: data-race in do_raw_write_lock / do_raw_write_lock
write (marked) to 0xffff800009cf504c of 4 bytes by task 1102 on cpu 1:
do_raw_write_lock+0x120/0x204
_raw_write_lock_irq
do_exit
call_usermodehelper_exec_async
ret_from_fork
read to 0xffff800009cf504c of 4 bytes by task 1103 on cpu 0:
do_raw_write_lock+0x88/0x204
_raw_write_lock_irq
do_exit
call_usermodehelper_exec_async
ret_from_fork
value changed: 0xffffffff -> 0x00000001
Reported by Kernel Concurrency Sanitizer on:
CPU: 0
comedi: pcl818: fix null-ptr-deref in pcl818_ai_cancel()
In the Linux kernel, the following vulnerability has been resolved:
comedi: pcl818: fix null-ptr-deref in pcl818_ai_cancel()
Syzbot identified an issue [1] in pcl818_ai_cancel(), which stems from
the fact that in case of early device detach via pcl818_detach(),
subdevice dev->read_subdev may not have initialized its pointer to
&struct comedi_async as intended. Thus, any such dereferencing of
&s->async->cmd will lead to general protection fault and kernel crash.
Mitigate this problem by removing a call to pcl818_ai_cancel() from
pcl818_detach() altogether. This way, if the subdevice setups its
support for async commands, everything async-re
In the Linux kernel, the following vulnerability has been resolved:
comedi: c6xdigio: Fix invalid PNP driver unregistration
The Comedi low-level driver "c6xdigio" seems to be for a parallel port
connected device. When the Comedi core calls the driver's Comedi
"attach" handler `c6xdigio_attach()` to configure a Comedi to use this
driver, it tries to enable the parallel port PNP resources by
registering a PNP driver with `pnp_register_driver()`, but ignores the
return value. (The `struct pnp_driver` it uses has only the `name` and
`id_table` members filled in.) The driver's Comedi "detach" handler
`c6xdigio_detach()` unconditionally unregi
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: bmc150: Fix irq assumption regression
The code in bmc150-accel-core.c unconditionally calls
bmc150_accel_set_interrupt() in the iio_buffer_setup_ops,
such as on the runtime PM resume path giving a kernel
splat like this if the device has no interrupts:
Unable to handle kernel NULL pointer dereference at virtual
address 00000001 when read
PC is at bmc150_accel_set_interrupt+0x98/0x194
LR is at __pm_runtime_resume+0x5c/0x64
(...)
Call trace:
bmc150_accel_set_interrupt from bmc150_accel_buffer_postenable+0x40/0x108
bmc150_accel_buffer_postenable from __iio_upda
usb: renesas_usbhs: Fix synchronous external abort on unbind
In the Linux kernel, the following vulnerability has been resolved:
usb: renesas_usbhs: Fix synchronous external abort on unbind
A synchronous external abort occurs on the Renesas RZ/G3S SoC if unbind is
executed after the configuration sequence described above:
modprobe usb_f_ecm
modprobe libcomposite
modprobe configfs
cd /sys/kernel/config/usb_gadget
mkdir -p g1
cd g1
echo "0x1d6b" > idVendor
echo "0x0104" > idProduct
mkdir -p strings/0x409
echo "0123456789" > strings/0x409/serialnumber
echo "Renesas." > strings/0x409/manufacturer
echo "Ethernet Gadget" > strings/0x409/product
mkdir -p functions/ecm.usb0
mkdir -p configs/c.1
mkdir -p con
scsi: imm: Fix use-after-free bug caused by unfinished delayed work
In the Linux kernel, the following vulnerability has been resolved:
scsi: imm: Fix use-after-free bug caused by unfinished delayed work
The delayed work item 'imm_tq' is initialized in imm_attach() and
scheduled via imm_queuecommand() for processing SCSI commands. When the
IMM parallel port SCSI host adapter is detached through imm_detach(),
the imm_struct device instance is deallocated.
However, the delayed work might still be pending or executing
when imm_detach() is called, leading to use-after-free bugs
when the work function imm_interrupt() accesses the already
freed imm_struct memory.
The race condition can occur as follows:
CPU 0
page_pool: always add GFP_NOWARN for ATOMIC allocations
In the Linux kernel, the following vulnerability has been resolved:
page_pool: always add GFP_NOWARN for ATOMIC allocations
Driver authors often forget to add GFP_NOWARN for page allocation
from the datapath. This is annoying to users as OOMs are a fact
of life, and we pretty much expect network Rx to hit page allocation
failures during OOM. Make page pool add GFP_NOWARN for ATOMIC allocations
by default.
f2fs: fix to detect potential corrupted nid in free_nid_list
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix to detect potential corrupted nid in free_nid_list
As reported, on-disk footer.ino and footer.nid is the same and
out-of-range, let's add sanity check on f2fs_alloc_nid() to detect
any potential corruption in free_nid_list.
In the Linux kernel, the following vulnerability has been resolved:
usbnet: Prevents free active kevent
The root cause of this issue are:
1. When probing the usbnet device, executing usbnet_link_change(dev, 0, 0);
put the kevent work in global workqueue. However, the kevent has not yet
been scheduled when the usbnet device is unregistered. Therefore, executing
free_netdev() results in the "free active object (kevent)" error reported
here.
2. Another factor is that when calling usbnet_disconnect()->unregister_netdev(),
if the usbnet device is up, ndo_stop() is executed to cancel the kevent.
However, because the device is not up, ndo_stop()
can: gs_usb: gs_usb_xmit_callback(): fix handling of failed transmitted URBs
In the Linux kernel, the following vulnerability has been resolved:
can: gs_usb: gs_usb_xmit_callback(): fix handling of failed transmitted URBs
The driver lacks the cleanup of failed transfers of URBs. This reduces the
number of available URBs per error by 1. This leads to reduced performance
and ultimately to a complete stop of the transmission.
If the sending of a bulk URB fails do proper cleanup:
- increase netdev stats
- mark the echo_sbk as free
- free the driver's context and do accounting
- wake the send queue
In the Linux kernel, the following vulnerability has been resolved:
platform/x86: intel: punit_ipc: fix memory corruption
This passes the address of the pointer "&punit_ipcdev" when the intent
was to pass the pointer itself "punit_ipcdev" (without the ampersand).
This means that the:
complete(&ipcdev->cmd_complete);
in intel_punit_ioc() will write to a wrong memory address corrupting it.
net: sxgbe: fix potential NULL dereference in sxgbe_rx()
In the Linux kernel, the following vulnerability has been resolved:
net: sxgbe: fix potential NULL dereference in sxgbe_rx()
Currently, when skb is null, the driver prints an error and then
dereferences skb on the next line.
To fix this, let's add a 'break' after the error message to switch
to sxgbe_rx_refill(), which is similar to the approach taken by the
other drivers in this particular case, e.g. calxeda with xgmac_rx().
Found during a code review.
drm, fbcon, vga_switcheroo: Avoid race condition in fbcon setup
In the Linux kernel, the following vulnerability has been resolved:
drm, fbcon, vga_switcheroo: Avoid race condition in fbcon setup
Protect vga_switcheroo_client_fb_set() with console lock. Avoids OOB
access in fbcon_remap_all(). Without holding the console lock the call
races with switching outputs.
VGA switcheroo calls fbcon_remap_all() when switching clients. The fbcon
function uses struct fb_info.node, which is set by register_framebuffer().
As the fb-helper code currently sets up VGA switcheroo before registering
the framebuffer, the value of node is -1 and therefore not a legal value.
For example, fbcon uses the value within set_con2
smb: client: fix memory leak in cifs_construct_tcon()
In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix memory leak in cifs_construct_tcon()
When having a multiuser mount with domain= specified and using
cifscreds, cifs_set_cifscreds() will end up setting @ctx->domainname,
so it needs to be freed before leaving cifs_construct_tcon().
This fixes the following memory leak reported by kmemleak:
mount.cifs //srv/share /mnt -o domain=ZELDA,multiuser,...
su - testuser
cifscreds add -d ZELDA -u testuser
...
ls /mnt/1
...
umount /mnt
echo scan > /sys/kernel/debug/kmemleak
cat /sys/kernel/debug/kmemleak
unreferenced object 0xffff8881203c3f08 (siz
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_eem: Fix memory leak in eem_unwrap
The existing code did not handle the failure case of usb_ep_queue in the
command path, potentially leading to memory leaks.
Improve error handling to free all allocated resources on usb_ep_queue
failure. This patch continues to use goto logic for error handling, as the
existing error handling is complex and not easily adaptable to auto-cleanup
helpers.
kmemleak results:
unreferenced object 0xffffff895a512300 (size 240):
backtrace:
slab_post_alloc_hook+0xbc/0x3a4
kmem_cache_alloc+0x1b4/0x358
skb_clon
usb: storage: Fix memory leak in USB bulk transport
In the Linux kernel, the following vulnerability has been resolved:
usb: storage: Fix memory leak in USB bulk transport
A kernel memory leak was identified by the 'ioctl_sg01' test from Linux
Test Project (LTP). The following bytes were mainly observed: 0x53425355.
When USB storage devices incorrectly skip the data phase with status data,
the code extracts/validates the CSW from the sg buffer, but fails to clear
it afterwards. This leaves status protocol data in srb's transfer buffer,
such as the US_BULK_CS_SIGN 'USBS' signature observed here. Thus, this can
lead to USB protocols leaks to user space through SCSI generic (/dev/sg*)
interfac
usb: dwc3: Fix race condition between concurrent dwc3_remove_requests() call paths
In the Linux kernel, the following vulnerability has been resolved:
usb: dwc3: Fix race condition between concurrent dwc3_remove_requests() call paths
This patch addresses a race condition caused by unsynchronized
execution of multiple call paths invoking `dwc3_remove_requests()`,
leading to premature freeing of USB requests and subsequent crashes.
Three distinct execution paths interact with `dwc3_remove_requests()`:
Path 1:
Triggered via `dwc3_gadget_reset_interrupt()` during USB reset
handling. The call stack includes:
- `dwc3_ep0_reset_state()`
- `dwc3_ep0_stall_and_restart()`
- `dwc3_ep0_out_start()`
- `dwc3_remove_requests()`
- `dwc3