xfrm: xfrm_interface: require CAP_NET_ADMIN in the device netns for changelink
In the Linux kernel, the following vulnerability has been resolved:
xfrm: xfrm_interface: require CAP_NET_ADMIN in the device netns for changelink
xfrmi_changelink() operates on at most two netns, dev_net(dev) and the
interface link netns xi->net. They differ once the device is created in
or moved to a netns other than the one the request runs in. The rtnl
changelink path checks CAP_NET_ADMIN only against dev_net(dev), so a
caller privileged there but not in xi->net can rewrite an interface that
lives in xi->net.
Gate xfrmi_changelink() on rtnl_dev_link_net_capable() at its top,
before any attribute is parsed.
In the Linux kernel, the following vulnerability has been resolved:
tpm: Make the TPM character devices non-seekable
The TPM character devices expose a sequential command/response
interface, but their open handlers leave FMODE_PREAD and FMODE_PWRITE
enabled.
After a command leaves a response pending, pread(fd, buf, 16, 0x1400)
passes 0x1400 as *off to tpm_common_read(). The transfer length is
bounded by response_length, but the offset is used unchecked when
forming data_buffer + *off. A sufficiently large offset therefore causes
an out-of-bounds heap read through copy_to_user() and, if the copy
succeeds, an out-of-bounds zero-write through
spi: uniphier: Fix completion initialization order before devm_request_irq()
In the Linux kernel, the following vulnerability has been resolved:
spi: uniphier: Fix completion initialization order before devm_request_irq()
The driver calls devm_request_irq() before initializing the completion
used by the interrupt handler. Because the interrupt may occur immediately
after devm_request_irq(), the handler may execute before init_completion().
This may result in calling complete() on an uninitialized completion,
causing undefined behavior. This has been observed with KASAN.
Fix this by initializing the completion before registering the IRQ.
nvmet-rdma: handle inline data with a nonzero offset
In the Linux kernel, the following vulnerability has been resolved:
nvmet-rdma: handle inline data with a nonzero offset
nvmet_rdma_use_inline_sg() maps the host-controlled inline data offset
into the per-command inline scatterlist. The bounds check admits any
offset with off + len <= inline_data_size, but the mapping still assumes
the data begins in the first inline page:
sg->offset = off;
sg->length = min_t(int, len, PAGE_SIZE - off);
When a port is configured with inline_data_size > PAGE_SIZE (settable up
to max(SZ_16K, PAGE_SIZE)), an offset in (PAGE_SIZE, inline_data_size]
makes "PAGE_SIZE - off" underflow, so sg->length is set to
can: bcm: defer rx_op deallocation to workqueue to fix thrtimer UAF
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: defer rx_op deallocation to workqueue to fix thrtimer UAF
Commit f1b4e32aca08 ("can: bcm: use call_rcu() instead of costly
synchronize_rcu()") replaced synchronize_rcu() in bcm_delete_rx_op()
with call_rcu() and introduced the RX_NO_AUTOTIMER flag.
However, this flag check was omitted for thrtimer in the packet rx
fast-path. During BCM RX operation teardown, a concurrent RCU reader
(bcm_rx_handler) can race and re-arm thrtimer via
bcm_rx_update_and_send() after call_rcu() has been scheduled. Once
the RCU grace period elapses, bcm_op is freed. The subsequently
f
can: bcm: fix lockless bound/ifindex race and silent RX_SETUP failure
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix lockless bound/ifindex race and silent RX_SETUP failure
bcm_sendmsg() reads bo->ifindex and checks bo->bound before taking
lock_sock(), while bcm_notify(), bcm_connect() and bcm_release() all
mutate both fields under that same lock. Because the lockless reads
and the locked writes are unordered with respect to each other, a
racing bcm_notify() (device unregister) or bcm_connect() (concurrent
bind on another thread sharing the socket) can make bcm_sendmsg()
observe an inconsistent combination, e.g. a stale bound=1 together
with the now-cleared ifindex=0, silent
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix CAN frame rx/tx statistics
KCSAN detected a data race within the bcm_rx_handler() when two CAN frames
have been simultaneously received and processed in a single rx op by two
different CPUs.
Use atomic operations with (signed) long data types to access the
statistics in the hot path to fix the KCSAN complaint.
Additionally simplify the update and check of statistics overflow by
using the atomic operations in separate bcm_update_[rx|tx]_stats()
functions. The rx variant runs under bcm_rx_update_lock to prevent
races when resetting the two rx counters; the tx
can: bcm: fix data race on rx_stamp/rx_ifindex in bcm_rx_handler()
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix data race on rx_stamp/rx_ifindex in bcm_rx_handler()
For an rx op subscribed on all interfaces (ifindex == 0), the same op
is registered once in the shared per-netns wildcard filter list, so
bcm_rx_handler() can run concurrently on different CPUs for frames
arriving on different net devices.
op->rx_stamp and op->rx_ifindex were written before bcm_rx_update_lock was
taken, allowing concurrent writers to race each other - including a torn
store of the 64-bit rx_stamp on 32-bit platforms.
Beyond a torn store bcm_send_to_user() must report the timestamp/ifindex
can: bcm: fix stale rx/tx ops after device removal
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix stale rx/tx ops after device removal
RX: an RX_SETUP update(!) for an existing op skipped can_rx_register()
unconditionally, even when a concurrent NETDEV_UNREGISTER had already
torn down its registration (op->rx_reg_dev == NULL). This silently
did not re-enable frame delivery for that updated filter. bcm_rx_setup()
now re-registers in that case, while leaving rx_ops with ifindex = 0
(all CAN devices) which never carry a tracked rx_reg_dev registered as-is.
TX: bcm_notify() only handled bo->rx_ops on NETDEV_UNREGISTER, leaving
tx_ops with an active cyclic tra
can: bcm: track a single source interface for ANYDEV timeout/throttle ops
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: track a single source interface for ANYDEV timeout/throttle ops
An ANYDEV rx op (ifindex == 0) with an active RX timeout and/or
throttle timer has no defined semantics when matching frames arrive
from several interfaces: bcm_rx_handler() can run concurrently for
the same op on different CPUs, racing hrtimer_cancel()/
bcm_rx_starttimer() against bcm_rx_timeout_handler() and causing
spurious RX_TIMEOUT notifications and last_frames corruption. The
same concurrency lets throttled multiplex frames from different
interfaces clobber the single rx_ifindex/rx_stamp fields
can: bcm: validate frame length in bcm_rx_setup() for RTR replies
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: validate frame length in bcm_rx_setup() for RTR replies
bcm_tx_setup() validates cf->len against the CAN/CAN FD DLC limits
before installing frames for TX_SETUP, but bcm_rx_setup() never did
the same for the RTR-reply frame configured via RX_SETUP with
RX_RTR_FRAME.
can: bcm: add missing device refcount for CAN filter removal
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: add missing device refcount for CAN filter removal
sashiko-bot remarked a problem with a concurrent device unregistration
in isotp.c which also is present in the bcm.c code. A former fix for raw.c
commit c275a176e4b6 ("can: raw: add missing refcount for memory leak fix")
introduced a netdevice_tracker which solves the issue for bcm.c too.
bcm_release(), bcm_delete_rx_op() and bcm_notifier() relied on
dev_get_by_index(ifindex) to re-find the device for an rx_op before
unregistering its filter. If a concurrent NETDEV_UNREGISTER has already
unlisted the device from
dm thin metadata: fix metadata snapshot consistency on commit failure
In the Linux kernel, the following vulnerability has been resolved:
dm thin metadata: fix metadata snapshot consistency on commit failure
__reserve_metadata_snap() and __release_metadata_snap() modify the
superblock's held_root directly in the block_manager's buffer. If the
subsequent metadata commit fails, the held_root gets flushed to disk
through the abort_transaction path, resulting in inconsistent metadata.
Reproducer 1: __reserve_metadata_snap()
1. Create a 2 MiB metadata device and make the region after the 14th
block inaccessible, to trigger metadata commit failure in the
subsequent reserve_metadata_snap operation. The 14th
dm era: fix out-of-bounds memory access for non-zero start sector
In the Linux kernel, the following vulnerability has been resolved:
dm era: fix out-of-bounds memory access for non-zero start sector
dm-era tracks writes in target-relative blocks, but era_map() calculates
the writeset block before applying the target offset. Tables with a
non-zero start sector can therefore pass an absolute mapped-device block
to metadata_current_marked().
If the absolute block is beyond the current writeset size,
writeset_marked() tests past the end of the in-core bitset. KASAN reports
this as a vmalloc-out-of-bounds access.
Apply the target offset before calculating the era block so writeset
lookups use the target-r
dm-ioctl: fix a possible overflow in list_version_get_info
In the Linux kernel, the following vulnerability has been resolved:
dm-ioctl: fix a possible overflow in list_version_get_info
sizeof(tt->version) is 12 bytes, but the code writes 16 bytes into the
output buffer - info->vers->version[0], info->vers->version[1],
info->vers->version[2] and info->vers->next. This can cause buffer
overflow.
Fix this buffer overflow by replacing "sizeof(tt->version)" with
"sizeof(struct dm_target_versions)".
dm_early_create: fix freeing used table on dm_resume failure
In the Linux kernel, the following vulnerability has been resolved:
dm_early_create: fix freeing used table on dm_resume failure
If dm_resume fails, the kernel attempts to free table with
dm_table_destroy, but the table was already instantiated with
dm_swap_table. This commit skips the call to dm_table_destroy in this
case.
In the Linux kernel, the following vulnerability has been resolved:
dm-verity: fix buffer overflow in FEC calculation
There's a buffer overflow in dm-verity-fec:
if (neras && *neras <= v->fec->roots)
fio->erasures[(*neras)++] = i;
This allows *neras to reach roots + 1 (the post-increment pushes it past
roots). This value is then passed as no_eras to decode_rs8(). Inside the
RS decoder (lib/reed_solomon/decode_rs.c:113-121), the erasure locator
polynomial loop writes lambda[j] where j can reach nroots + 1 — one
element past the end of lambda[] (which is sized nroots + 1, valid
indices 0..nroots). The out-of-bounds write lands on syn[0], c
In the Linux kernel, the following vulnerability has been resolved:
dm-verity: make error counter atomic
The error counter "v->corrupted_errs" was not atomic, thus it could be
subject to race conditions. The call to
dm_audit_log_target("max-corrupted-errors") may be skipped due to the
races.
scsi: hpsa: Fix DMA mapping leak on IOACCEL2 reset path
In the Linux kernel, the following vulnerability has been resolved:
scsi: hpsa: Fix DMA mapping leak on IOACCEL2 reset path
If phys_disk->in_reset is set, the function returns directly without
undoing the resources acquired for the command. Add the missing error
cleanup by unmapping the IOACCEL2 SG chain block when needed, unmapping
the SCSI command, and dropping the outstanding IOACCEL command count
before returning.
scsi: lpfc: Fix memory leak in lpfc_sli4_driver_resource_setup()
In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Fix memory leak in lpfc_sli4_driver_resource_setup()
The memory allocated for mboxq using mempool_alloc() is not freed in
some of the early exit error paths. Fix that by moving the
mempool_free() call to an earlier point after last use.