netfilter: nft_compat: ebtables emulation must reject non-bridge targets
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_compat: ebtables emulation must reject non-bridge targets
xtables targets return netfilter verdicts: NF_ACCEPT, NF_DROP, and so
on. ebtables targets return incompatible verdicts: EBT_ACCEPT,
EBT_DROP, ... We cannot allow fallback to NFPROTO_UNSPEC.
ebtables doesn't permit this since
11ff7288beb2 ("netfilter: ebtables: reject non-bridge targets")
but that commit missed the nft_compat layer.
net: dsa: sja1105: round up PTP perout pin duration
In the Linux kernel, the following vulnerability has been resolved:
net: dsa: sja1105: round up PTP perout pin duration
pin_duration is converted from the user-provided period to SJA1105
clock ticks and is later passed as the cycle_time argument to
future_base_time().
Very small period values may become zero after the conversion,
which can lead to a division by zero in future_base_time().
Round zero pin_duration up to 1 tick so that the smallest unsupported
periods use the minimum non-zero hardware duration instead of passing
zero to future_base_time().
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix err_chunk memory leaks in INIT handling
When sctp_verify_init() encounters unrecognized parameters, it allocates an
err_chunk to report them. However, this chunk is leaked in several code
paths:
1. In sctp_sf_do_5_1B_init(), if security_sctp_assoc_request() fails after
sctp_verify_init() has populated err_chunk, the function returns
immediately without freeing it.
2. In sctp_sf_do_unexpected_init(), the same leak occurs on the
security_sctp_assoc_request() failure path.
3. In sctp_sf_do_unexpected_init(), on the success path after copying
unrecogniz
In the Linux kernel, the following vulnerability has been resolved:
net: mvneta: re-enable percpu interrupt on resume
On Marvell MPIC platforms (Armada 370/XP/38x), mvneta uses a percpu
IRQ disable/enable scheme for NAPI: the ISR (mvneta_percpu_isr) calls
disable_percpu_irq() to mask the MPIC per-CPU interrupt and schedules
NAPI poll, which calls enable_percpu_irq() on completion to unmask.
If suspend occurs while NAPI poll is pending (between
disable_percpu_irq in the ISR and enable_percpu_irq in poll
completion), the interrupt is never re-enabled:
1. mvneta_percpu_isr: disable_percpu_irq() + napi_schedule()
=> MPIC masked, percpu
In the Linux kernel, the following vulnerability has been resolved:
net: sungem: fix probe error cleanup
gem_init_one() calls gem_remove_one() when register_netdev() fails.
gem_remove_one() unregisters and frees resources owned by the net_device,
including the DMA block, MMIO mapping, PCI regions, and the net_device
itself. gem_init_one() then falls through to its own cleanup labels and
frees the same resources again.
Keep the register_netdev() error path in gem_init_one(): clear drvdata so
PM/remove paths do not see a half-registered device, remove the NAPI
instance added during probe, and let the existing cleanup labels release
the resou
net: udp_tunnel: prevent double queueing in udp_tunnel_nic_device_sync
In the Linux kernel, the following vulnerability has been resolved:
net: udp_tunnel: prevent double queueing in udp_tunnel_nic_device_sync
Yue Sun reported a use-after-free and debugobjects warning in
udp_tunnel_nic_device_sync_work() during concurrent device operations.
The workqueue core clears the internal pending bit before invoking the
worker. At that point, a concurrent thread can queue the work again.
When the already running worker eventually clears the work_pending flag
to 0, it mistakenly clears the flag for the newly queued instance.
udp_tunnel_nic_unregister() then observes work_pending as 0 and frees
the structure while the se
tipc: fix UAF in cleanup_bearer() due to premature dst_cache_destroy()
In the Linux kernel, the following vulnerability has been resolved:
tipc: fix UAF in cleanup_bearer() due to premature dst_cache_destroy()
TIPC UDP media bearer teardown calls dst_cache_destroy() on its
replicast caches before calling synchronize_net() to wait for
concurrent RCU readers (transmitters) to finish:
static void cleanup_bearer(struct work_struct *work)
{
...
list_for_each_entry_safe(rcast, tmp, &ub->rcast.list, list) {
dst_cache_destroy(&rcast->dst_cache);
list_del_rcu(&rcast->list);
kfree_rcu(rcast, rcu);
}
...
dst_cache_destroy(&ub->rcast.dst_cache);
udp_tunnel_sock_release(ub->sk);
synchronize_net();
...
}
This i
In the Linux kernel, the following vulnerability has been resolved:
bpf: Mask pseudo pointer values in verifier logs
print_bpf_insn() masks ldimm64 immediates for pointer-bearing pseudo
sources when pointer leaks are not allowed, but the mask only covers
BPF_PSEUDO_MAP_FD and BPF_PSEUDO_MAP_VALUE.
BPF_PSEUDO_MAP_IDX, BPF_PSEUDO_MAP_IDX_VALUE, and BPF_PSEUDO_BTF_ID can
also be resolved to kernel pointer values before the verifier log prints
the instruction. Include them in the existing pointer classification so
the log prints 0x0 instead of the rewritten address.
seg6: validate SRH length before reading fixed fields
In the Linux kernel, the following vulnerability has been resolved:
seg6: validate SRH length before reading fixed fields
seg6_validate_srh() reads fixed SRH fields such as srh->type and
srh->hdrlen before checking that the supplied length covers the fixed
struct ipv6_sr_hdr fields.
The BPF SEG6 encap path reaches this with a BPF program-supplied pointer
and length: bpf_lwt_push_encap() and the SEG6 local BPF END_B6 and
END_B6_ENCAP actions call bpf_push_seg6_encap(), which forwards the
length to seg6_validate_srh() with no minimum-size guard. A 2-byte SEG6
encap header can therefore make the validator read srh->type at offset 2
beyond th
net: enetc: check the number of BDs needed for xdp_frame
In the Linux kernel, the following vulnerability has been resolved:
net: enetc: check the number of BDs needed for xdp_frame
The size of xdp_redirect_arr array is ENETC_MAX_SKB_FRAGS. However, the
number of fragments contained in xdp_frame may be greater than or equal
to ENETC_MAX_SKB_FRAGS, which will cause the access to xdp_redirect_arr
to be out of bounds.
sctp: add INIT verification after cookie unpacking
In the Linux kernel, the following vulnerability has been resolved:
sctp: add INIT verification after cookie unpacking
In SCTP handshake, the INIT chunk is initially processed by the server
and embedded into the cookie carried in INIT-ACK. The client then
returns this cookie via COOKIE-ECHO, where the server unpacks it and
reconstructs the original INIT chunk.
When cookie authentication is enabled, the cookie contents are protected
against tampering, so reusing the unpacked INIT without re-verification
is safe.
However, when cookie authentication is disabled, the reconstructed INIT
can no longer be trusted. In this case, the INIT must be
hwmon: (pmbus/core) honor vrm_version in pmbus_data2reg_vid()
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/core) honor vrm_version in pmbus_data2reg_vid()
pmbus_data2reg_vid() hardcoded the VR11 encoding regardless of the
vrm_version configured by the driver, while pmbus_reg2data_vid()
already switched on it. Any driver that selects a non-VR11 VID mode
and exposes a regulator (or hwmon vout setter) sent dangerously
wrong codes to PMBUS_VOUT_COMMAND -- e.g. an nvidia195mv part asked
for 200 mV got the VR11 clamp to 500 mV encoded as 0xB2, which the
chip interprets as 1080 mV.
Mirror pmbus_reg2data_vid() so writes round-trip with reads.
In the Linux kernel, the following vulnerability has been resolved:
hwmon: adm1275: Prevent reading uninitialized stack
While adding support for the ROHM BD127X0 hot-swap controllers, sashiko
reported an error in device-name comparison, which can lead to reading
uninitialized stack memory.
Quoting Sashiko:
This is a pre-existing issue, but I noticed that just before this block in
adm1275_probe(), there might be an out-of-bounds stack read:
ret = i2c_smbus_read_block_data(client, PMBUS_MFR_MODEL, block_buffer);
if (ret < 0) { ... }
for (mid = adm1275_id; mid->name[0]; mid++) {
if (!strncasecmp(mid->name, block_buff
ipv6: fib6: fix NULL deref in fib6_walk_continue() on multi-batch dump
In the Linux kernel, the following vulnerability has been resolved:
ipv6: fib6: fix NULL deref in fib6_walk_continue() on multi-batch dump
inet6_dump_fib() saves its progress in cb->args[1] as a positional
index within the current hash chain. Between batches, a concurrent
fib6_new_table() can insert a new table at the chain head, shifting
all existing entries. The saved index then lands on a different
table, causing fib6_dump_table() to set w->root to the wrong table
while w->node still points into the previous one.
fib6_walk_continue() dereferences w->node->parent (NULL) and panics:
BUG: kernel NULL pointer dereference, address: 00000
net/sched: sch_teql: Introduce slaves_lock to avoid race condition and UAF
In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_teql: Introduce slaves_lock to avoid race condition and UAF
The teql master->slaves singly linked list is not protected against
multiple writes. It can be mod'ed concurently from teql_master_xmit(),
teql_dequeue(), teql_init() and teql_destroy() without holding any list
lock or RCU protection.
[email protected] has demonstrated that the qdisc is freed
after an RCU grace period, but teql_master_xmit() running on another
CPU can still hold a stale pointer into the list, resulting in a
slab-use-after-free:
BUG: KASAN: slab-use-after-free in teql_m
bridge: stp: Fix a potential use-after-free when deleting a bridge
In the Linux kernel, the following vulnerability has been resolved:
bridge: stp: Fix a potential use-after-free when deleting a bridge
The three STP timers are not supposed to be armed while the bridge is
administratively down. They are synchronously deactivated when the
bridge is put administratively down and the various call sites check for
'IFF_UP' before arming them.
This check is missing from br_topology_change_detection() and it is
possible to engineer a situation in which the topology change timer is
armed while the bridge is administratively down, resulting in a
use-after-free [1] when the bridge is deleted.
Fix by adding the miss
irqchip/ts4800: Fix missing chained handler cleanup on remove
In the Linux kernel, the following vulnerability has been resolved:
irqchip/ts4800: Fix missing chained handler cleanup on remove
The driver installs a chained handler for the parent interrupt during probe
using irq_set_chained_handler_and_data(), but the remove function does not
clear this handler. This leaves a dangling handler that may be called when
the parent interrupt fires after the driver has been removed, potentially
accessing freed memory and causing a kernel crash.
Additionally, the parent_irq obtained via irq_of_parse_and_map() is not
stored, making it inaccessible in the remove function. Moreover, interrupt
mappings created du
sctp: fix addr_wq_timer race in sctp_free_addr_wq()
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix addr_wq_timer race in sctp_free_addr_wq()
sctp_free_addr_wq() previously removed addr_wq_timer using timer_delete()
while holding addr_wq_lock. However, timer_delete() does not guarantee that
a currently running timer handler has completed.
This allows a race with sctp_addr_wq_timeout_handler(), where the handler
may still run after addr_waitq has been freed, acquire addr_wq_lock, and
access freed memory, leading to a use-after-free.
Fix this by calling timer_shutdown_sync() before taking addr_wq_lock. This
guarantees that any in-flight timer handler has finish
ksmbd: reject undersized DACLs before parsing ACEs
In the Linux kernel, the following vulnerability has been resolved:
ksmbd: reject undersized DACLs before parsing ACEs
parse_dacl() limits the attacker-controlled ACE count by comparing it
with the number of minimal ACEs that fit in the DACL size. The DACL size
field is 16 bits, but the expression subtracts sizeof(struct smb_acl).
Because sizeof() is unsigned, a DACL size smaller than the ACL header
underflows to a large size_t.
A malicious client can reach this with:
SMB2_SET_INFO (InfoType=SMB2_O_INFO_SECURITY)
-> smb2_set_info_sec()
-> set_info_sec()
-> parse_sec_desc()
-> parse_dacl()
-> init_acl_state(..., 0xffff)
-
xen/pvcalls: bound backend response req_id before indexing rsp[]
In the Linux kernel, the following vulnerability has been resolved:
xen/pvcalls: bound backend response req_id before indexing rsp[]
pvcalls_front_event_handler() takes req_id directly from the
backend-supplied ring response and uses it to index the fixed-size
bedata->rsp[] array for a memcpy() and a store, with no range check. A
malicious or buggy backend can set req_id past PVCALLS_NR_RSP_PER_RING
and drive an out-of-bounds write past the bedata allocation.
req_id was also declared int while the wire field rsp->req_id is u32, so
a range check on the signed value alone is insufficient: a backend
req_id of 0xffffffff becomes -1, passes a >