wifi: brcmfmac: make release_scratchbuffers idempotent
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: make release_scratchbuffers idempotent
brcmf_pcie_release_scratchbuffers() frees the shared.scratch and
shared.ringupd DMA buffers with dma_free_coherent() but does not clear
the pointers afterwards, unlike the sibling release_ringbuffers() which
NULLs commonrings/flowrings/idxbuf on release.
Both the bus_reset .reset callback (brcmf_pcie_reset) and
brcmf_pcie_remove() call release_scratchbuffers. When reset teardown
has run before removal, remove's own teardown would call
dma_free_coherent() a second time on the already-freed DMA allocation.
NULL the poi
staging: rtl8723bs: fix OOB reads in rtw_get_wps_ie()
In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix OOB reads in rtw_get_wps_ie()
rtw_get_wps_ie() iterates over IE data from network frames without
validating that the IE header and payload fit within the remaining
buffer before reading them. Specifically:
- in_ie[cnt + 1] is read without checking cnt + 1 < in_len
- memcmp(&in_ie[cnt + 2], ...) accesses cnt + 2 without bounds check
- in_ie[cnt + 1] is used as length without verifying payload fits
Add bounds checks at the top of the loop body to break early if fewer
than 2 bytes remain for the IE header, or if the declared payload
extends past the e
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix session UAF in set_termios
rfcomm_tty_set_termios() tests dlc->session without rfcomm_mutex and
later passes the pointer to rfcomm_send_rpn(). The latter dereferences
both session->initiator and session->sock. Meanwhile, krfcommd can
unlink the DLC and free the session while holding rfcomm_mutex.
The race can proceed as follows:
TTY ioctl task krfcommd
-------------- --------
load dlc->session
enter rfcomm_send_rpn()
lock rfcomm_mutex
clear dlc-
exec: fix unsigned loop counter wrap in transfer_args_to_stack()
In the Linux kernel, the following vulnerability has been resolved:
exec: fix unsigned loop counter wrap in transfer_args_to_stack()
The stop value is derived from bprm->p >> PAGE_SHIFT. The index variable
is an unsigned long. If bprm->p drops below PAGE_SIZE and stop becomes
zero the loop condition index >= stop is always true.
After the index == 0 iteration the decrement wraps to ULONG_MAX and
bprm->page[ULONG_MAX] reads sizeof(void *) bytes in front of the array.
The pointer has wrapped to -1. That garbage pointer is then passed to
kmap_local_page() and PAGE_SIZE bytes are copied from wherever that
lands into the stack of the process be
binfmt_misc: set have_execfd only once the interpreter is opened
In the Linux kernel, the following vulnerability has been resolved:
binfmt_misc: set have_execfd only once the interpreter is opened
load_misc_binary() raises bprm->have_execfd as soon as it sees the 'O'
(or 'C') flag. This happens well before it opens the interpreter. If
that open fails the flag stays set on the bprm. binfmt_misc is at the
head of the format list so an interpreter open failure that returns
-ENOEXEC lets the search fall through to a later format. This means it
runs the matched binary directly having never staged an interpreter. So
bprm->executable is NULL while have_execfd falsely claims a descriptor
is present.
Consequent
cdrom: fix stack out-of-bounds read in CDROMVOLCTRL
In the Linux kernel, the following vulnerability has been resolved:
cdrom: fix stack out-of-bounds read in CDROMVOLCTRL
mmc_ioctl_cdrom_volume() first reads the audio control mode page into a
32-byte stack buffer with cgc->buflen set to 24. If the device reports a
block descriptor, the function increases cgc->buflen to include that
descriptor and reads the page again.
For CDROMVOLCTRL, the function then builds a MODE SELECT parameter list
by moving cgc->buffer forward by offset - 8 bytes. This drops the block
descriptor from the outgoing payload and leaves a new 8-byte mode
parameter header in front of the audio control page. However, c
firmware: stratix10-svc: fix memory leaks and list corruption bugs
In the Linux kernel, the following vulnerability has been resolved:
firmware: stratix10-svc: fix memory leaks and list corruption bugs
Fix a memory leak when gen_pool_alloc() fails by freeing pmem on the error
path. Switch pmem allocation from devm_kzalloc() to kzalloc() with
explicit kfree() in the free path to match its list-managed lifetime.
Remove the erroneous list_del(&svc_data_mem) which corrupted the list head
on failed lookups.
comedi: comedi_parport: deal with premature interrupt
In the Linux kernel, the following vulnerability has been resolved:
comedi: comedi_parport: deal with premature interrupt
Syzbot reported a general protection fault in
`comedi_get_is_subdevice_running()`, which was called from the interrupt
handler `parport_interrupt()` in the "comedi_parport" driver, but it
does not currently have a C reproducer for the problem. It's
probably due to a premature interrupt for one of two reasons:
1. The driver sets up the interrupt handler before the comedi subdevices
used by the interrupt handler have been allocated, but does not
disable the interrupt in the parallel port's CTRL register first.
2. T
In the Linux kernel, the following vulnerability has been resolved:
intel_th: fix MSC output device reference leak
intel_th_output_open() looks up the output device with
bus_find_device_by_devt(), which returns the device with a reference that
must be dropped after use.
commit 95fc36a234da ("intel_th: fix device leak on output open()")
attempted to drop the reference from intel_th_output_release(). However,
a successful open replaces file->f_op with the output driver file
operations before returning, so close runs the output driver release
callback instead.
For MSC outputs, close runs intel_th_msc_release(), which only removes
the per-fil
tracing: Fix mmiotrace possible NULL dereferencing of hiter->dev
In the Linux kernel, the following vulnerability has been resolved:
tracing: Fix mmiotrace possible NULL dereferencing of hiter->dev
If the mmio_pipe_open() fails to find a PCI device, the hiter->dev
will be assigned to NULL. The mmiotrace read() function dereferences the
hiter->dev if hiter exists.
Change the test of the read to not only check hiter being NULL, but also
the hiter->dev before dereferencing it.
tracing: Fix resource leak on mmiotrace trace_pipe close
In the Linux kernel, the following vulnerability has been resolved:
tracing: Fix resource leak on mmiotrace trace_pipe close
The mmiotrace tracer was added May 12th 2008. At that time, resources
created in pipe_open() could not be freed because there was not
pipe_close function pointer of the tracer. The pipe_close function pointer
was added in December 7th, 2009, but the mmiotrace tracer was not updated.
mmio_pipe_open() allocates a header_iter and takes a pci_dev reference
when trace_pipe is opened. mmio_close() frees them, but it was only
wired to the tracer's .close callback.
tracing_release_pipe() invokes .pipe_close, not .close, whe
sctp: avoid auth_enable sysctl UAF during netns teardown
In the Linux kernel, the following vulnerability has been resolved:
sctp: avoid auth_enable sysctl UAF during netns teardown
proc_sctp_do_auth() updates the SCTP control socket after changing
net.sctp.auth_enable. The handler gets the per-net SCTP state from
ctl->data, so an already opened sysctl file can still target a network
namespace while that namespace is being torn down.
SCTP previously registered its per-net sysctls from sctp_defaults_init(),
while the control socket is created later from sctp_ctrlsock_init(). This
exposed a window during initialization where auth_enable was writable
before net->sctp.ctl_sock existed, and a teardow
sctp: close UDP tunnel sockets during netns teardown
In the Linux kernel, the following vulnerability has been resolved:
sctp: close UDP tunnel sockets during netns teardown
proc_sctp_do_udp_port() starts per-net SCTP UDP tunneling sockets when
net.sctp.udp_port is set, and stops/restarts them when the sysctl value
changes. The netns exit path does not stop these sockets, so a namespace
can be torn down while its SCTP UDP tunnel sockets are still installed.
Close the UDP tunnel sockets from sctp_ctrlsock_exit() after unregistering
the per-net sysctl table. This prevents new sysctl writes from racing in
while the sockets are being released, and closes the sockets before the
control socket is
ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps()
In the Linux kernel, the following vulnerability has been resolved:
ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps()
ceph_handle_caps() reads snap_trace_len from the wire-format
ceph_mds_caps header and uses it unconditionally to build a fake
end pointer (snaptrace + snaptrace_len) that is later handed to
ceph_update_snap_trace() in the CEPH_CAP_OP_IMPORT case:
snaptrace = h + 1;
snaptrace_len = le32_to_cpu(h->snap_trace_len);
p = snaptrace + snaptrace_len;
...
case CEPH_CAP_OP_IMPORT:
if (snaptrace_len) {
...
if (ceph_update_snap_trace(mdsc, snaptr
libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE
In the Linux kernel, the following vulnerability has been resolved:
libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE
__decode_pg_temp() decodes an user-controlled length but only rejects
values large enough to overflow the allocation; it does not bound it to
CEPH_PG_MAX_SIZE. The helper backs both pg_temp and pg_upmap decoding, and
apply_upmap()/get_temp_osds() later copy the decoded list into the fixed-size
on-stack array struct ceph_osds.osds[CEPH_PG_MAX_SIZE]. A monitor that sends
an OSDMap with a pg_temp/pg_upmap entry longer than 32 thus causes a stack
out-of-bounds write.
An OSD set for a single PG can never exce
libceph: Fix multiplication overflow in decode_new_up_state_weight()
In the Linux kernel, the following vulnerability has been resolved:
libceph: Fix multiplication overflow in decode_new_up_state_weight()
If a message of type CEPH_MSG_OSD_MAP contains a (maliciously) corrupted
osdmap, out-of-bounds memory accesses may occur in
decode_new_up_state_weight(). This happens because the bounds check for
the new_state part is based on calculating its length depending on a len
value read from the incoming message. This calculation may overflow
leading to an incorrect bounds check. Subsequently, out-of-bounds reads
may occur when decoding this part.
This patch switches the multiplication to use check_mul_overflow()
In the Linux kernel, the following vulnerability has been resolved:
libceph: guard missing CRUSH type name lookup
Localized read selection can walk a parent bucket whose name exists in
the CRUSH map while its type has no matching entry in type_names.
get_immediate_parent() then dereferences a NULL type_cn and passes an
invalid pointer into strcmp(), causing a null-ptr-deref.
Skip such malformed parent buckets unless both the bucket name and type
name metadata are present. This keeps malformed hierarchy data from
crashing locality lookup and safely falls back to "not local".
[ idryomov: add WARN_ON_ONCE ]
libceph: refresh auth->authorizer_buf{,_len} after authorizer update
In the Linux kernel, the following vulnerability has been resolved:
libceph: refresh auth->authorizer_buf{,_len} after authorizer update
ceph_x_create_authorizer() caches au->buf->vec.iov_base and
au->buf->vec.iov_len in struct ceph_auth_handshake. These
cached values are then used by the messenger connect code when
sending the authorizer.
ceph_x_update_authorizer() can rebuild the authorizer when a newer
service ticket is available. If the rebuilt authorizer no longer
fits in the existing buffer, ceph_x_build_authorizer() drops its
reference to au->buf and allocates a new one. If this is the final
reference, ceph_buffer_put() frees the
In the Linux kernel, the following vulnerability has been resolved:
libceph: Reject monmaps advertising zero monitors
A message of type CEPH_MSG_MON_MAP contains a monmap that is sent from a
monitor to the client. This monmap contains information about the
existing monitors in the cluster. Currently, a monmap indicating that
there are zero monitors in the cluster is treated as valid. However, it
is impossible to have zero monitors in the cluster and still receive a
valid monmap from a monitor. Therefore, such a monmap must be corrupted
and should be treated as invalid. Furthermore, a monmap with a monitor
count of zero can subsequently cras
In the Linux kernel, the following vulnerability has been resolved:
libceph: reject zero bucket types in crush_decode
CRUSH bucket type 0 is reserved for devices. The mapper relies on
that invariant and uses type 0 to identify leaf devices.
If crush_decode() accepts a bucket with type 0, a malformed CRUSH map
can make the mapper treat a negative bucket ID as a device and pass it
to is_out(), which then indexes the OSD weight array with a negative
value.
Reject zero bucket types while decoding the CRUSH map so the invalid
state never reaches the mapper.