Vulnérabilités de linux-ibm-5.15 · Page n° 173

tracepoint: balance regfunc() on func_add() failure in tracepoint_add_func()

In the Linux kernel, the following vulnerability has been resolved: tracepoint: balance regfunc() on func_add() failure in tracepoint_add_func() When a tracepoint goes through the 0 -> 1 transition, tracepoint_add_func() invokes the subsystem's ext->regfunc() before attempting to install the new probe via func_add(). If func_add() then fails (for example, when allocate_probes() cannot allocate a new probe array under memory pressure and returns -ENOMEM), the function returns the error without calling the matching ext->unregfunc(), leaving the side effects of regfunc() behind with no installed probe to justify them. For syscall tracepoints

• Mettez à jour vers 5.15.0-1111.115~20.04.1

smb: client: validate dacloffset before building DACL pointers

In the Linux kernel, the following vulnerability has been resolved: smb: client: validate dacloffset before building DACL pointers parse_sec_desc(), build_sec_desc(), and the chown path in id_mode_to_cifs_acl() all add the server-supplied dacloffset to pntsd before proving a DACL header fits inside the returned security descriptor. On 32-bit builds a malicious server can return dacloffset near U32_MAX, wrap the derived DACL pointer below end_of_acl, and then slip past the later pointer-based bounds checks. build_sec_desc() and id_mode_to_cifs_acl() can then dereference DACL fields from the wrapped pointer in the chmod/chown rewrite paths.

• Mettez à jour vers 5.15.0-1105.109~20.04.1

xfrm: ah: account for ESN high bits in async callbacks

In the Linux kernel, the following vulnerability has been resolved: xfrm: ah: account for ESN high bits in async callbacks AH allocates its temporary auth/ICV layout differently when ESN is enabled: the async ahash setup appends a 4-byte seqhi slot before the ICV or auth_data area, but the async completion callbacks still reconstruct the temporary layout as if seqhi were absent. With an async AH implementation selected, that makes AH copy or compare the wrong bytes on both the IPv4 and IPv6 paths. In UML repro on IPv4 AH with ESN and forced async hmac(sha1), ping fails with 100% packet loss, and the callback logs show the pre-fix drift:

• Mettez à jour vers 5.15.0-1111.115~20.04.1

fbcon: Avoid OOB font access if console rotation fails

In the Linux kernel, the following vulnerability has been resolved: fbcon: Avoid OOB font access if console rotation fails Clear the font buffer if the reallocation during console rotation fails in fbcon_rotate_font(). The putcs implementations for the rotated buffer will return early in this case. See [1] for an example. Currently, fbcon_rotate_font() keeps the old buffer, which is too small for the rotated font. Printing to the rotated console with a high-enough character code will overflow the font buffer. v2: - fix typos in commit message

• Mettez à jour vers 5.15.0-1111.115~20.04.1

RDMA/vmw_pvrdma: Fix double free on pvrdma_alloc_ucontext() error path

In the Linux kernel, the following vulnerability has been resolved: RDMA/vmw_pvrdma: Fix double free on pvrdma_alloc_ucontext() error path Sashiko points out that pvrdma_uar_free() is already called within pvrdma_dealloc_ucontext(), so calling it before triggers a double free.

• Mettez à jour vers 5.15.0-1106.110~20.04.1

wifi: rsi: fix kthread lifetime race between self-exit and external-stop

In the Linux kernel, the following vulnerability has been resolved: wifi: rsi: fix kthread lifetime race between self-exit and external-stop RSI driver use both self-exit(kthread_complete_and_exit) and external-stop (kthread_stop) when killing a kthread. Generally, kthread_stop() is called first, and in this case, no particular issues occur. However, in rare instances where kthread_complete_and_exit() is called first and then kthread_stop() is called, a UAF occurs because the kthread object, which has already exited and been freed, is accessed again. Therefore, to prevent this with minimal modification, you must remove kthread_stop() and

• Mettez à jour vers 5.15.0-1106.110~20.04.1

Bluetooth: virtio_bt: validate rx pkt_type header length

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: virtio_bt: validate rx pkt_type header length virtbt_rx_handle() reads the leading pkt_type byte from the RX skb and forwards the remainder to hci_recv_frame() for every event/ACL/SCO/ISO type, without checking that the remaining payload is at least the fixed HCI header for that type. After the preceding patch bounds the backend-supplied used.len to [1, VIRTBT_RX_BUF_SIZE], a one-byte completion still reaches hci_recv_frame() with skb->len already pulled to 0. If the byte happened to be HCI_ACLDATA_PKT, the ACL-vs-ISO classification fast-path in hci_dev_classify

• Mettez à jour vers 5.15.0-1106.110~20.04.1

sound: ua101: fix division by zero at probe

In the Linux kernel, the following vulnerability has been resolved: sound: ua101: fix division by zero at probe Add a missing sanity check for bNrChannels in detect_usb_format() to prevent a division by zero in playback_urb_complete() and capture_urb_complete(). USB core does not validate class-specific descriptor fields such as bNrChannels, so drivers must verify them before use. If a device provides bNrChannels = 0, frame_bytes becomes zero and is later used as a divisor in the URB completion handlers, leading to a kernel crash.

• Mettez à jour vers 5.15.0-1106.110~20.04.1

RDMA/mlx4: Fix mis-use of RCU in mlx4_srq_event()

In the Linux kernel, the following vulnerability has been resolved: RDMA/mlx4: Fix mis-use of RCU in mlx4_srq_event() Sashiko points out the radix_tree itself is RCU safe, but nothing ever frees the mlx4_srq struct with RCU, and it isn't even accessed within the RCU critical section. It also will crash if an event is delivered before the srq object is finished initializing. Use the spinlock since it isn't easy to make RCU work, use refcount_inc_not_zero() to protect against partially initialized objects, and order the refcount_set() to be after the srq is fully initialized.

wifi: brcmfmac: Fix potential use-after-free issue when stopping watchdog task

In the Linux kernel, the following vulnerability has been resolved: wifi: brcmfmac: Fix potential use-after-free issue when stopping watchdog task Watchdog task might end between send_sig() and kthread_stop() calls, what results in the use-after-free issue. Fix this by increasing watchdog task reference count before calling send_sig() and dropping it by switching to kthread_stop_put().

• Mettez à jour vers 5.15.0-1111.115~20.04.1

RDMA/mlx4: Fix resource leak on error in mlx4_ib_create_srq()

In the Linux kernel, the following vulnerability has been resolved: RDMA/mlx4: Fix resource leak on error in mlx4_ib_create_srq() Sashiko points out that mlx4_srq_alloc() was not undone during error unwind, add the missing call to mlx4_srq_free().

• Mettez à jour vers 5.15.0-1106.110~20.04.1

ipmi: Add limits to event and receive message requests

In the Linux kernel, the following vulnerability has been resolved: ipmi: Add limits to event and receive message requests The driver would just fetch events and receive messages until the BMC said it was done. To avoid issues with BMCs that never say they are done, add a limit of 10 fetches at a time. In addition, an si interface has an attn state it can return from the hardware which is supposed to cause a flag fetch to see if the driver needs to fetch events or message or a few other things. If the attn bit gets stuck, it's a similar problem. So allow messages in between flag fetches so the driver itself doesn't get stuck. This is a

• Mettez à jour vers 5.15.0-1106.110~20.04.1

f2fs: fix fsck inconsistency caused by FGGC of node block

In the Linux kernel, the following vulnerability has been resolved: f2fs: fix fsck inconsistency caused by FGGC of node block During FGGC node block migration, fsck may incorrectly treat the migrated node block as fsync-written data. The reproduction scenario: root@vm:/mnt/f2fs# seq 1 2048 | xargs -n 1 ./test_sync // write inline inode and sync root@vm:/mnt/f2fs# rm -f 1 root@vm:/mnt/f2fs# sync root@vm:/mnt/f2fs# f2fs_io gc_range // move data block in sync mode and not write CP SPO, "fsck --dry-run" find inode has already checkpointed but still with DENT_BIT_SHIFT set The root cause is that GC does not clear the dentry mark and fsync

x86/CPU/AMD: Prevent improper isolation of shared resources in Zen2's op cache

In the Linux kernel, the following vulnerability has been resolved: x86/CPU/AMD: Prevent improper isolation of shared resources in Zen2's op cache Make sure resources are not improperly shared in the op cache and cause instruction corruption this way.

• Mettez à jour vers 5.15.0-1106.110~20.04.1

ipv6: xfrm6: release dst on error in xfrm6_rcv_encap()

In the Linux kernel, the following vulnerability has been resolved: ipv6: xfrm6: release dst on error in xfrm6_rcv_encap() xfrm6_rcv_encap() performs an IPv6 route lookup when the skb does not already have a dst attached. ip6_route_input_lookup() returns a referenced dst entry even when the lookup resolves to an error route. If dst->error is set, xfrm6_rcv_encap() drops the skb without attaching the dst to the skb and without releasing the reference returned by the lookup. Repeated packets hitting this path therefore leak dst entries. Release the dst before jumping to the drop path.

• Mettez à jour vers 5.15.0-1106.110~20.04.1

mptcp: pm: ADD_ADDR rtx: free sk if last

In the Linux kernel, the following vulnerability has been resolved: mptcp: pm: ADD_ADDR rtx: free sk if last When an ADD_ADDR is retransmitted, the sk is held in sk_reset_timer(), and released at the end. If at that moment, it was the last reference being held, the sk would not be freed. sock_put() should then be called instead of __sock_put(). But that's not enough: if it is the last reference, sock_put() will call sk_free(), which will end up calling sk_stop_timer_sync() on the same timer, and waiting indefinitely to finish. So it is needed to mark that the timer is done at the end of the timer handler when it has not been rescheduled,

• Mettez à jour vers 5.15.0-1113.117~20.04.1

hfsplus: fix uninit-value by validating catalog record size

In the Linux kernel, the following vulnerability has been resolved: hfsplus: fix uninit-value by validating catalog record size Syzbot reported a KMSAN uninit-value issue in hfsplus_strcasecmp(). The root cause is that hfs_brec_read() doesn't validate that the on-disk record size matches the expected size for the record type being read. When mounting a corrupted filesystem, hfs_brec_read() may read less data than expected. For example, when reading a catalog thread record, the debug output showed: HFSPLUS_BREC_READ: rec_len=520, fd->entrylength=26 HFSPLUS_BREC_READ: WARNING - entrylength (26) < rec_len (520) - PARTIAL READ! hfs_brec_

• Mettez à jour vers 5.15.0-1111.115~20.04.1

mptcp: fix scheduling with atomic in timestamp sockopt

In the Linux kernel, the following vulnerability has been resolved: mptcp: fix scheduling with atomic in timestamp sockopt Using lock_sock_fast() (atomic context) around sock_set_timestamp() and sock_set_timestamping() is unsafe, as both helpers can sleep. Replace lock_sock_fast() with sleepable lock_sock()/release_sock() to avoid scheduling while atomic panic.

• Mettez à jour vers 5.15.0-1106.110~20.04.1

usb: usblp: fix uninitialized heap leak via LPGETSTATUS ioctl

In the Linux kernel, the following vulnerability has been resolved: usb: usblp: fix uninitialized heap leak via LPGETSTATUS ioctl Just like in a previous problem in this driver, usblp_ctrl_msg() will collapse the usb_control_msg() return value to 0/-errno, discarding the actual number of bytes transferred. Ideally that short command should be detected and error out, but many printers are known to send "incorrect" responses back so we can't just do that. statusbuf is kmalloc(8) at probe time and never filled before the first LPGETSTATUS ioctl. usblp_read_status() requests 1 byte. If a malicious printer responds with zero bytes, *statusbuf

• Mettez à jour vers 5.15.0-1106.110~20.04.1

wifi: b43legacy: enforce bounds check on firmware key index in RX path

In the Linux kernel, the following vulnerability has been resolved: wifi: b43legacy: enforce bounds check on firmware key index in RX path Same fix as b43: the firmware-controlled key index in b43legacy_rx() can exceed dev->max_nr_keys. The existing B43legacy_WARN_ON is non-enforcing in production builds, allowing an out-of-bounds read of dev->key[]. Make the check enforcing by dropping the frame for invalid indices.

• Mettez à jour vers 5.15.0-1106.110~20.04.1